Comparison of Calculated Skin Doses in Cineradiography and Four Dimensional Kinematic Computed Tomography of the Wrist

Purpose Evaluation of skin organ doses in six different cone-beam computed tomography scanners (CBCT) dedicated to dentomaxillofacial imaging. Our hypothesis is that the dose varies between different devices, protocols and skin areas. Materials and methods An anthropomorphic adult head and neck phantom was used to which a dosimeter (Waterproof Farmer® Chamber, PTW, Freiburg, Germany) was attached to anatomic landmarks of both parotid glands, both ocular lenses, the thyroid gland and the neurocranium. CBCT examinations were performed on six different CBCT devices dedicated to dentomaxillofacial imaging with standard settings and, if available, also in high dose settings. Measurements were repeated five times each. Results The measured mean skin doses ranged from 0.48 to 2.21 mGy. The comparison of the region based dose evaluation showed a high correlation between the single measurements. Furthermore, the distribution of doses between regions was similar in all devices, except that four devices showed side differences for the dose of the parotid region and one device showed side differences for the lens region. The directly exposed regions, such as the parotid glands, showed significant higher values than the more distant regions like the neurocranium. When comparing examination protocols, a significant difference between the standard dose and the high dose acquisitions could be detected. But also a significant dose difference between the different CBCTs could be shown. 3D Accuitomo 170 (Morita, Osaka, Japan) showed the highest absorbed mean dose value for standard settings with 2.21 mGy, especially at the directly exposed regions and their adjacent organs. The lowest mean value for standard settings was achieved with VGi evo (NewTom, Verona, Italy) with 0.48 mGy. Conclusion Repeated measurements of skin organ doses in six different CBCT scanners using a surface dosimeter showed side differences in distribution of dose in five devices for the parotid and lens region. Additionally, significant dose differences between the devices could be detected. Further studies should be performed to confirm these results.

Download Full-text

ESTIMATION OF PATIENT LENS DOSE ASSOCIATED WITH C-ARM CONE-BEAM COMPUTED TOMOGRAPHY USAGE DURING INTERVENTIONAL NEURORADIOLOGY

Radiation Protection Dosimetry ◽

10.1093/rpd/ncy188 ◽

2018 ◽

Vol 184 (2) ◽

pp. 138-147 ◽

Cited By ~ 3

Author(s):

Satoru Kawauchi ◽

Koichi Chida ◽

Takashi Moritake ◽

Yuji Matsumaru ◽

Yusuke Hamada ◽

...

Keyword(s):

Computed Tomography ◽

Clinical Study ◽

High Resolution ◽

Cone Beam Computed Tomography ◽

Interventional Neuroradiology ◽

Cone Beam ◽

Contribution Ratio ◽

Dose Ratio ◽

Skin Doses ◽

The Right

Abstract The purpose of this study was to investigate the dose distribution and lens doses associated with C-arm cone-beam computed tomography (CBCT), using a head phantom, and to estimate the contribution ratio of C-arm CBCT to each patient’s lens dose during interventional neuroradiology (‘lens dose ratio’) in 109 clinical cases. In the phantom study, the peak skin doses and respective right and left lens doses of C-arm CBCT were as follows: 63.0 ± 1.9 mGy, 19.7 ± 1.4 mGy and 21.9 ± 0.8 mGy in whole brain C-arm CBCT and 39.2 ± 1.4 mGy, 4.7 ± 0.9 mGy and 3.6 ± 0.3 mGy in high-resolution C-arm CBCT. In the clinical study, the lens dose ratios were 25.4 ± 8.7% in the right lens and 19.1 ± 9.8% in the left lens. This study shows that, on average, ~25% of patients’ total lens dose was contributed by C-arm CBCT.

Download Full-text

X-ray microtomography

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100107058 ◽

1988 ◽

Vol 46 ◽

pp. 998-999

Author(s):

H.W. Deckman ◽

B.F. Flannery ◽

J.H. Dunsmuir ◽

K.D' Amico

Keyword(s):

Computed Tomography ◽

Internal Structure ◽

Imaging Technique ◽

Three Dimensional ◽

Tissue Structure ◽

Individual Element ◽

X Ray ◽

Non Invasive ◽

Panoramic Imaging ◽

Three Dimensional Images

We have developed a new X-ray microscope which produces complete three dimensional images of samples. The microscope operates by performing X-ray tomography with unprecedented resolution. Tomography is a non-invasive imaging technique that creates maps of the internal structure of samples from measurement of the attenuation of penetrating radiation. As conventionally practiced in medical Computed Tomography (CT), radiologists produce maps of bone and tissue structure in several planar sections that reveal features with 1mm resolution and 1% contrast. Microtomography extends the capability of CT in several ways. First, the resolution which approaches one micron, is one thousand times higher than that of the medical CT. Second, our approach acquires and analyses the data in a panoramic imaging format that directly produces three-dimensional maps in a series of contiguous stacked planes. Typical maps available today consist of three hundred planar sections each containing 512x512 pixels. Finally, and perhaps of most import scientifically, microtomography using a synchrotron X-ray source, allows us to generate maps of individual element.

Download Full-text