Effect of Substrate Temperature on the Crystalline State of Ba2ErCu3O7-xSuperconducting Thin Films by rf Magnetron Sputtering

1988 ◽  
Vol 27 (Part 2, No. 9) ◽  
pp. L1679-L1682 ◽  
Author(s):  
Takashi Mochiku ◽  
Yoko Kanke ◽  
Zhongmin Wen ◽  
Ienari Iguchi ◽  
Eiso Yamaka
Keyword(s):  
Thin Films ◽  
Magnetron Sputtering ◽  
Substrate Temperature ◽  
Crystalline State ◽  
Rf Magnetron Sputtering

Substrate Temperature and La0.9Sr0.1Ga0.8Mg0.2O3-δ Electrolyte Film Growth by Radio Frequency Magnetron Sputtering

2015 ◽  
Vol 833 ◽  
pp. 127-133
Author(s):  
Jie Yu ◽  
Jie Xing ◽  
Xiu Hua Chen ◽  
Wen Hui Ma ◽  
Rui Li ◽  
...  
Keyword(s):  
Thin Films ◽  
Magnetron Sputtering ◽  
Substrate Temperature ◽  
Radio Frequency ◽  
Film Growth ◽  
Rf Magnetron Sputtering ◽  
X Ray Diffraction ◽  
X Ray ◽  
Electrolyte Film ◽  
Porous Anode

La0.9Sr0.1Ga0.8Mg0.2O3-δ (LSGM) electrolyte thin films were fabricated on La0.7Sr0.3Cr0.5Mn0.5O2.75 (LSCM) porous anode substrates by Radio Frequency (RF) magnetron sputtering method. The compatibility between LSGM and LSCM was examined. Microstructures of LSGM thin films fabricated were observed by scanning electron microscope (SEM). The effect of substrate temperature on LSGM thin films was clarified by X-ray Diffraction (XRD). Deposition rate increases firstly at the range of 50°C~150°C, and then decreases at the range of 150°C ~300°C. After annealing, perovskite structure with the same growth orientation forms at different substrate temperature. Crystallite size decreases at first, to the minimum point at 150°C, then increases as substrate temperature rises.

Effect of substrate temperature on the properties of Nb 2 O 5 :MoO 3 (90:10) thin films prepared by rf magnetron sputtering technique

2015 ◽  
Vol 649 ◽  
pp. 112-121 ◽  
Author(s):  
N. Usha ◽  
R. Sivakumar ◽  
C. Sanjeeviraja ◽  
Y. Kuroki
Keyword(s):  
Thin Films ◽  
Magnetron Sputtering ◽  
Substrate Temperature ◽  
Rf Magnetron Sputtering

INFLUENCE OF SUBSTRATE TEMPERATURE ON STRUCTURAL, ELECTRICAL AND OPTICAL PROPERTIES OF ITO THIN FILMS PREPARED BY RF MAGNETRON SPUTTERING

2013 ◽  
Vol 20 (05) ◽  
pp. 1350045 ◽  
Author(s):  
BO HE ◽  
LEI ZHAO ◽  
JING XU ◽  
HUAIZHONG XING ◽  
SHAOLIN XUE ◽  
...  
Keyword(s):  
Thin Films ◽  
Optical Properties ◽  
Magnetron Sputtering ◽  
Substrate Temperature ◽  
Visible Region ◽  
Rf Magnetron Sputtering ◽  
Electrical And Optical Properties ◽  
High Quantum Efficiency ◽  
Ito Thin Films ◽  
Ito Films

In this paper, we investigated indium-tin-oxide (ITO) thin films on glass substrates deposited by RF magnetron sputtering using ceramic target to find the optimal condition for fabricating optoelectronic devices. The structural, electrical and optical properties of the ITO films prepared at various substrate temperatures were investigated. The results indicate the grain size increases with substrate temperature increases. As the substrate temperature grew up, the resistivity of ITO films greatly decreased. The ITO film possesses high quality in terms of electrode functions, when substrate temperature is 480°C. The resistivity is as low as 9.42 × 10-5 Ω• cm , while the carrier concentration and mobility are as high as 3.461 × 1021 atom∕cm3 and 19.1 cm2∕V⋅s, respectively. The average transmittance of the film is about 95% in the visible region. The novel ITO/np-Silicon frame, which prepared by RF magnetron sputtering at 480°C substrate temperature, can be used not only for low-cost solar cell, but also for high quantum efficiency of UV and visible lights enhanced photodetector for various applications.

Influence of Substrate Temperature on Physical Structure of AlN Thin Films Prepared on Polycrystalline MoSi2by rf Magnetron Sputtering

1995 ◽  
Vol 78 (12) ◽  
pp. 3304-3308 ◽  
Author(s):  
Morito Akiyama ◽  
Hamid Reza Kokabi ◽  
Kazuhiro Nonaka ◽  
Kazuhisa Shobu ◽  
Tadahiko Watanabe
Keyword(s):  
Thin Films ◽  
Magnetron Sputtering ◽  
Substrate Temperature ◽  
Rf Magnetron Sputtering ◽  
Physical Structure ◽  
Influence Of Substrate

Effect of Substrate Temperature on the Opto-Electrical Propertites of Ti Doped ITO Films Deposited by RF Magnetron Sputtering

2012 ◽  
Vol 602-604 ◽  
pp. 1399-1403
Author(s):  
Rui Xin Ma ◽  
Shi Na Li ◽  
Guo Quan Suo
Keyword(s):  
Thin Films ◽  
Optical Properties ◽  
Magnetron Sputtering ◽  
Substrate Temperature ◽  
Absorption Edge ◽  
Blue Shift ◽  
Rf Magnetron Sputtering ◽  
Electrical And Optical Properties ◽  
Glass Substrates ◽  
Visible Wavelengths

Ti doped ITO (ITO:Ti) thin films were fabricated on glass substrates by RF magnetron sputtering using only one piece of ITO:Ti ceramic target at different substrate temperature (Ts). The effect of substrate temperature on structural, electrical, and optical properties of the films was investigated. It is confirmed that the resistivity of the films decreases with the increase of Ts till the minimum value of 2.5×10-4 Ω•cm and the transmittance in visible wavelengths is higher than 90%. "Blue shift" and "red shift" of UV absorption edge of the film were observed when Ts200 °CHeaders and footers

Investigation on AZO Films Deposited by Radio-Frequency Reactive Magnetron Sputtering

2013 ◽  
Vol 320 ◽  
pp. 35-39
Author(s):  
Cheng Long Kang ◽  
Jin Xiang Deng ◽  
Min Cui ◽  
Chao Man ◽  
Le Kong ◽  
...  
Keyword(s):  
Thin Films ◽  
Electron Microscope ◽  
Magnetron Sputtering ◽  
Substrate Temperature ◽  
Rf Magnetron Sputtering ◽  
Reactive Magnetron ◽  
X Ray Diffraction ◽  
X Ray ◽  
Doped Zno ◽  
Scanning Electron

The Al2O3-doped ZnO(AZO) films were deposited on the glasses by means of RF magnetron sputtering technology. The films were characterized by scanning electron microscope (SEM), X-ray diffraction (XRD) and Profile-system respectively. The effect of substrate temperature on the structure of the AZO films is investigated.As a result, the properties of the AZO thin films are remarkably influenced by the substrate temperature , especially in the range of 200°C to 500 °C. The film prepared at the substrate temperature of 400°C possesses the best crystalline.

Electrical and Optical Properties of ZnO-Doped Zr0.8Sn0.2TiO4 Thin Films on ITO/Glass Substrates by RF Magnetron Sputtering

2011 ◽  
Vol 687 ◽  
pp. 70-74
Author(s):  
Cheng Hsing Hsu ◽  
His Wen Yang ◽  
Jenn Sen Lin
Keyword(s):  
Thin Films ◽  
Optical Properties ◽  
Magnetron Sputtering ◽  
Substrate Temperature ◽  
Visible Region ◽  
Rf Magnetron Sputtering ◽  
Rf Power ◽  
Electrical And Optical Properties ◽  
Glass Substrates ◽  
Ito Glass

Electrical and optical properties of 1wt% ZnO-doped (Zr0.8Sn0.2)TiO4thin films prepared by rf magnetron sputtering on ITO/Glass substrates at different rf power and substrate temperature were investigated. The surface structural and morphological characteristics analyzed by X-ray diffraction (XRD) and atomic force microscope (AFM) were found to be sensitive to the deposition conditions, such as rf power and substrate temperature. The selected-area diffraction pattern showed that the deposited films exhibited a polycrystalline microstructure. All films exhibited ZST (111) orientation perpendicular to the substrate surface and the grain size as well as the deposition rate of the film increased with the increase in both the rf power and the substrate temperature. Optical transmittance spectroscopy further revealed high transparency (over 60%) in the visible region of the spectrum.

Sign in / Sign up

Export Citation Format

Share Document