Polycrystalline Silicon Emitter Contacts Formed by Rapid Thermal Annealing

1989 ◽  
Vol 136 (1) ◽  
pp. 215-224 ◽  
Author(s):  
M. Delfino ◽  
J. G. de Groot ◽  
K. N. Ritz ◽  
P. Maillot
Keyword(s):  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Polycrystalline Silicon

Silicon Recrystallization in Sipos Material Obtained by Disilane

1995 ◽  
Vol 403 ◽  
Author(s):  
J. J. Pedroviejo ◽  
B. Garrido ◽  
J. C. Ferrer ◽  
A. Cornet ◽  
E. Scheid ◽  
...  
Keyword(s):  
Chemical Vapor Deposition ◽  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Vapor Deposition ◽  
Polycrystalline Silicon ◽  
Chemical Vapor ◽  
Low Pressure ◽  
Thermal Treatments ◽  
Structural Modifications ◽  
Pressure Chemical

AbstractConventional and Rapid Thermal Annealing of Semi-Insulating Polycrystalline Silicon layers obtained by Low Pressure Chemical Vapor Deposition (LPCVD) from disilane Si2H6 have been performed in order to determine the structural modifications induced on the layers by these thermal treatments. The study of these modifications has been carried out by several analysis methods like FTIR, XPS, TEM, RAMAN and ellipsometry. The results obtained are presented, contrasted and discussed in this work.

Formation of Silicides by Rapid Thermal Annealing Over Polycrystalline Silicon

1985 ◽  
Vol 54 ◽  
Author(s):  
J. Narayan ◽  
T. A. Stephenson ◽  
T. Brat ◽  
D. Fathy ◽  
S. J. Pennycook
Keyword(s):  
Titanium Oxide ◽  
Sheet Resistance ◽  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Polycrystalline Silicon ◽  
Annealing Treatment ◽  
External Layer ◽  
Rich Mixture ◽  
Thermal Annealing Treatment ◽  
Rapid Thermal Annealing Treatment

ABSTRACTThe formation of titanium suicide over polycrystalline silicon has been investigated after rapid thermal annealing treatment in nitrogen and argon ambients. After rapid thermal annealing 300 Å thick titanium overlayer at 900°C for 10 seconds, the sheet resistance of about 3 Ω/□ was achieved, which decreased to 2 Ω/□ after 1100°C / 10s treatment. The TiSi2 Phase was found to be stable after RTA treatments up to 1100°C /10s with no or negligible migration of titanium along the grain boundaries in polycrystalline silicon. In the nitrogen ambient, an external layer (titanium rich, mixture of titanium oxide and nitride) was observed to form after the RTA treatment, but the surface was found clean in the argon ambient.

Influence of Rapid Thermal Annealing on Recombination Properties of Polycrystalline Silicon

1992 ◽  
Vol 262 ◽  
Author(s):  
M. Kittler ◽  
W. Seifert
Keyword(s):  
Beneficial Effect ◽  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Polycrystalline Silicon ◽  
Minority Carrier ◽  
Diffusion Length ◽  
Minority Carrier Diffusion Length ◽  
Carrier Diffusion

ABSTRACTRapid thermal annealing was shown by EBIC to increase the minority-carrier diffusion length in cast polycrystalline silicon. The beneficial effect is due to a deactivation of intragrain defects (mainly dislocations) and is stable against post-RTA annealing up to at least 600 °C/ 10 min.

Thin-Film Transistors with Polycrystalline Silicon Films Prepared by Two-Step Rapid Thermal Annealing

2000 ◽  
Vol 39 (Part 2, No. 1A/B) ◽  
pp. L19-L21 ◽  
Author(s):  
Huang-Chung Cheng ◽  
Chun-Yao Huang ◽  
Fang-Shing Wang ◽  
Kuen-Hsien Lin ◽  
Fu-Gow Tarntair
Keyword(s):  
Thin Film ◽  
Thermal Annealing ◽  
Rapid Thermal Annealing ◽  
Thin Film Transistors ◽  
Polycrystalline Silicon ◽  
Silicon Films ◽  
Polycrystalline Silicon Films
Sign in / Sign up

Export Citation Format

Share Document