Synthesis and Characterization of LiFeBO3/C Composite By Spray Pyrolysis with Heat Treatment

2014 ◽  
Keyword(s):  
Heat Treatment ◽  
Spray Pyrolysis ◽  
Synthesis And Characterization

scholarly journals Synthesis and characterization of one-dimensional titanate structure

2008 ◽  
Vol 2 (2) ◽  
pp. 109-114 ◽  
Author(s):  
Ljubica Nikolic ◽  
Marija Maletin ◽  
Paula Ferreira ◽  
Paula Vilarinho
Keyword(s):  
Heat Treatment ◽  
Structural Characteristics ◽  
Hydrothermal Process ◽  
Synthesis And Characterization ◽  
One Dimensional ◽  
Treatment Conditions ◽  
Alkaline Conditions ◽  
The Stability ◽  
Simple Hydrothermal Process

One-dimensional titania structures were synthesized trough a simple hydrothermal process in a highly alkaline conditions. The aim of this work was to elucidate the effect of time on the formation of 1D titanates as well on its structural characteristics (morphology, phase composition, surface area). Apart from that, the effect of heat treatment conditions on the stability of titanate based 1D samples has been investigated. The results have revealed that it is possible to form one-dimensional titanates already after 1 hour of hydrothermal synthesis. Although the composition of titanates is still under debate, the results probably correspond to the layered sodium titanates. The 1D prepared structures show a remarkable stability during heating, remaining the basic morphology and composition even up to 700?C.

scholarly journals Synthesis and characterization of apatite silicated powders with wet precipitation method

2021 ◽  
Vol 234 ◽  
pp. 00106
Author(s):  
Houda Labjar ◽  
Hassan Chaair
Keyword(s):  
Electron Microscopy ◽  
Heat Treatment ◽  
Analytical Techniques ◽  
Precipitation Method ◽  
Synthesis And Characterization ◽  
X Ray Diffraction ◽  
X Ray ◽  
Wet Precipitation ◽  
Scanning Electron

The synthesis of apatite silicated Ca10(PO4)6-x(SiO4)x(OH)2-x (SiHA) with 0≤x≤2 was investigated using a wet precipitation method followed by heat treatment using calcium carbonate CaCO3 and phosphoric acid H3PO4 and silicon tetraacetate SiC8H20O4 (TEOS) in medium of water ethanol, with three different silicate concentrations. After drying, the samples are ground and then characterized by different analytical techniques like X-ray Diffraction (XRD), Fourier Transform Infrared Spectroscopy (FTIR) and Scanning electron Microscopy (SEM) and chemical analysis.

Spray pyrolysis synthesis and characterization of Mg1-xSrxMoO4 heterostructure with white light emission

2020 ◽  
Vol 813 ◽  
pp. 152235 ◽  
Author(s):  
A.A.G. Santiago ◽  
R.L. Tranquilin ◽  
P. Botella ◽  
F.J. Manjón ◽  
D. Errandonea ◽  
...  
Keyword(s):  
Spray Pyrolysis ◽  
White Light ◽  
Light Emission ◽  
White Light Emission ◽  
Synthesis And Characterization ◽  
Pyrolysis Synthesis

Synthesis and characterization of macroporous europium-doped Ca12Al14O33 (C12A7:Eu3+) and its application in metal ion detection

2019 ◽  
Vol 43 (21) ◽  
pp. 8315-8324
Author(s):  
Hui Yang ◽  
Rui Wang ◽  
Yaozu Wang ◽  
Jianzhong Jiang ◽  
Xingzhong Guo
Keyword(s):  
Heat Treatment ◽  
Metal Ion ◽  
Sol Gel ◽  
Synthesis And Characterization ◽  
Practical Application ◽  
Ion Detection ◽  
Gel Method ◽  
Sol Gel Method ◽  
Metal Ion Detection

Macroporous europium-doped Ca12Al14O33 (C12A7:Eu3+) was prepared via a sol–gel method followed by heat-treatment, and the resultant macroporous C12A7:Eu3+ shows potential for practical application in metal ion detection and has a good response to Pb2+ ions.

Synthesis and characterization of manganese sulphide thin films deposited by spray pyrolysis

2011 ◽  
Vol 46 (3) ◽  
pp. 267-271 ◽  
Author(s):  
M. R. I. Chowdhury ◽  
J. Podder ◽  
A. B. M. O. Islam
Keyword(s):  
Thin Films ◽  
Spray Pyrolysis ◽  
Synthesis And Characterization
Sign in / Sign up

Export Citation Format

Share Document