scholarly journals New Surface Properties in Porcelain Gres Tiles with a Look to Human and Environmental Safety

2012 ◽  
Vol 2012 ◽  
pp. 1-8 ◽  
Author(s):  
C. L. Bianchi ◽  
C. Pirola ◽  
S. Gatto ◽  
S. Nucci ◽  
A. Minguzzi ◽  
...  

Traditional photocatalysis is here brought forward for both the use of nanosized TiO2crystallites and the possibility to have a release of TiO2particles during the final use of the manufactured products. In the present paper both the preparation and characterization of a new generation of photocatalytic tiles are presented. The originality of these products is the surface presence of microsized TiO2as it is not clear yet the impact of the nanoparticles on both human and environmental safety. TiO2is here mixed with a silica compound and the final thermal treatment at 680°C allows the complete surface vitrification which, in turn, makes the tiles surface strongly resistant to abrasion. Photocatalytic efficiency towards the degradation ofNOxin gas phase was measured in both a batch and a plug-flow reactor. The latter reactor configuration was also modeled by digital simulations.

Energies ◽  
2020 ◽  
Vol 13 (23) ◽  
pp. 6467
Author(s):  
Jakub Mularski ◽  
Norbert Modliński

This paper examines the impact of different chemistry–turbulence interaction approaches on the accuracy of simulations of coal gasification in entrained flow reactors. Infinitely fast chemistry is compared with the eddy dissipation concept considering the influence of turbulence on chemical reactions. Additionally, ideal plug flow reactor study and perfectly stirred reactor study are carried out to estimate the accuracy of chosen simplified chemical kinetic schemes in comparison with two detailed mechanisms. The most accurate global approach and the detailed one are further implemented in the computational fluid dynamics (CFD) code. Special attention is paid to the water–gas shift reaction, which is found to have the key impact on the final gas composition. Three different reactors are examined: a pilot-scale Mitsubishi Heavy Industries reactor, a laboratory-scale reactor at Brigham Young University and a Conoco-Philips E-gas reactor. The aim of this research was to assess the impact of gas phase reaction model accuracy on simulations of the entrained flow gasification process. The investigation covers the following issues: impact of the choice of gas phase kinetic reactions mechanism as well as influence of the turbulence–chemistry interaction model. The advanced turbulence–chemistry models with the complex kinetic mechanisms showed the best agreement with the experimental data.


1993 ◽  
Vol 26 (S1) ◽  
pp. 168-170 ◽  
Author(s):  
L. Lian ◽  
F. Akhtar ◽  
J. M. Parsons ◽  
P. A. Hackett ◽  
D. M. Rayner

2014 ◽  
Vol 12 (1) ◽  
pp. 163-179
Author(s):  
Florent Allain ◽  
Jean-François Portha ◽  
Laurent Falk

Abstract This paper focuses on the impact of reactant staging on conversion for one single reversible reaction in a two-stage, isothermal, continuous reactor. The analytical expression of global conversion has been derived for a series of two continuously stirred-tank reactors. Improvements in the overall conversion and yield by staging can be obtained for low Damköhler number systems leading to low conversions, when the volumetric flow rate of the staged reactant has a higher value than that of the other one. The example of triolein transesterification involving three reversible reactions in a two-stage plug flow reactor is also studied as a concrete example of a consecutive/parallel reversible reactions system. Results are obtained by using a pseudo-homogeneous model and are compared with those obtained with a heterogeneous model from a previous study.


2010 ◽  
Vol 68 ◽  
pp. 159-164 ◽  
Author(s):  
Fumitaka Hayashi ◽  
Masakazu Iwamoto

Mesoporous silicon oxynitride and nitride were prepared through nitridation of various mesoporous silica, MCM-41, -48, and SBA-15 with ammonia in a plug flow reactor. The nitrogen contents were dependent on the reaction temperature and the amount of ammonia supplied per sample weight. The appropriate nitridation temperature was 1273 K and the maximum contents of nitrogen were 35-39 wt % which correspond to 88-98% of that of Si3N4. Various physicochemical characterization of the resulting silicon (oxy)nitiride indicated that the pore structures were not changed upon the nitridation though the lattice constants and the pore diameters decreased and the wall thickness increased. The nitridation mechanism was discussed on the basis of 29Si MAS NMR and XPS experiments.


Author(s):  
Waldemar Gadek ◽  
Angelika Łyczkowska ◽  
Alexander Scherrmann ◽  
Hans-Joachim Gehrmann ◽  
Andrzej Szlęk ◽  
...  

1990 ◽  
Vol 5 (1) ◽  
pp. 143-150 ◽  
Author(s):  
R. Fantoni ◽  
E. Borsella ◽  
S. Piccirillo ◽  
R. Ceccato ◽  
S. Enzo

High purity, ultrafine SiC powders have been produced from gas phase reactants (SiH4, C2H2) in a CO2 laser induced process. The flow reactor designed to operate with a medium power (10–50 W) continuous wave CO2 laser source is described. The mechanism of gas phase reactions involved has been investigated by means of on-line optical diagnostics. Powders produced have been characterized by means of conventional chemical and spectroscopic methods. The x-ray results point out a growth mechanism by coalescence; i.e., whole islands move in the flame to take part in binary collisions, analogously to that observed for particles produced by inert gas evaporation.


2017 ◽  
Vol 17 (15) ◽  
pp. 9237-9259 ◽  
Author(s):  
Prettiny K. Ma ◽  
Yunliang Zhao ◽  
Allen L. Robinson ◽  
David R. Worton ◽  
Allen H. Goldstein ◽  
...  

Abstract. Secondary organic aerosol (SOA) is an important contributor to fine particulate matter (PM) mass in polluted regions, and its modeling remains poorly constrained. A box model is developed that uses recently published literature parameterizations and data sets to better constrain and evaluate the formation pathways and precursors of urban SOA during the CalNex 2010 campaign in Los Angeles. When using the measurements of intermediate-volatility organic compounds (IVOCs) reported in Zhao et al. (2014) and of semi-volatile organic compounds (SVOCs) reported in Worton et al. (2014) the model is biased high at longer photochemical ages, whereas at shorter photochemical ages it is biased low, if the yields for VOC oxidation are not updated. The parameterizations using an updated version of the yields, which takes into account the effect of gas-phase wall losses in environmental chambers, show model–measurement agreement at longer photochemical ages, even though some low bias at short photochemical ages still remains. Furthermore, the fossil and non-fossil carbon split of urban SOA simulated by the model is consistent with measurements at the Pasadena ground site. Multi-generation oxidation mechanisms are often employed in SOA models to increase the SOA yields derived from environmental chamber experiments in order to obtain better model–measurement agreement. However, there are many uncertainties associated with these aging mechanisms. Thus, SOA formation in the model is compared to data from an oxidation flow reactor (OFR) in order to constrain SOA formation at longer photochemical ages than observed in urban air. The model predicts similar SOA mass at short to moderate photochemical ages when the aging mechanisms or the updated version of the yields for VOC oxidation are implemented. The latter case has SOA formation rates that are more consistent with observations from the OFR though. Aging mechanisms may still play an important role in SOA chemistry, but the additional mass formed by functionalization reactions during aging would need to be offset by gas-phase fragmentation of SVOCs. All the model cases evaluated in this work show a large majority of the urban SOA (70–83 %) at Pasadena coming from the oxidation of primary SVOCs (P-SVOCs) and primary IVOCs (P-IVOCs). The importance of these two types of precursors is further supported by analyzing the percentage of SOA formed at long photochemical ages (1.5 days) as a function of the precursor rate constant. The P-SVOCs and P-IVOCs have rate constants that are similar to highly reactive VOCs that have been previously found to strongly correlate with SOA formation potential measured by the OFR. Finally, the volatility distribution of the total organic mass (gas and particle phase) in the model is compared against measurements. The total SVOC mass simulated is similar to the measurements, but there are important differences in the measured and modeled volatility distributions. A likely reason for the difference is the lack of particle-phase reactions in the model that can oligomerize and/or continue to oxidize organic compounds even after they partition to the particle phase.


2021 ◽  
Vol 14 (1) ◽  
pp. 66-78
Author(s):  
Blažej Horváth ◽  
Matúš Petrík ◽  
Dana Gašparovičová ◽  
Tomáš Soták

Abstract Utilization of a low-cost biomaterial, such as bioethanol, to produce value–added compounds for current industry has been investigated. This work is focused on the catalytic transformation of bioethanol into industrially significant alkenes. Catalytic transformation of ethanol was studied using catalysts based mainly on nanostructured materials as Mg-Al hydrotalcites, sepiolites and zeolites doped with Cu, K, Sr, Zn and Mn. The catalytic tests were carried out in a plug-flow reactor in the temperature range of 350—550 °C. Undoped zeolites promote acid-catalyzed dehydration of ethanol, while in case of basic catalysts, such as hydrotalcites, the product distribution is shifted toward butadiene. The impact of the hydrotalcites preparation method on their structure and catalytic activity is reported. It was found that hydrotalcite with well-developed layered structure, prepared by slow hydrolysis, promotes the formation of butadiene (with butadiene yield of 28.2 % at 400 °C vs. ethylene yield of 17.2 % at 550 °C).


Sign in / Sign up

Export Citation Format

Share Document