scholarly journals A Study of the Flow Field Surrounding Interacting Line Fires

2016 ◽  
Vol 2016 ◽  
pp. 1-12 ◽  
Author(s):  
Trevor Maynard ◽  
Marko Princevac ◽  
David R. Weise
Keyword(s):  
Flow Field ◽  
Cross Correlation ◽  
Fire Behavior ◽  
Flame Length ◽  
Adjacent Line ◽  
Momentum Imbalance ◽  
Predicted Values ◽  
Simple Potential ◽  
In Fire ◽  
Potential Flow Model

The interaction of converging fires often leads to significant changes in fire behavior, including increased flame length, angle, and intensity. In this paper, the fluid mechanics of two adjacent line fires are studied both theoretically and experimentally. A simple potential flow model is used to explain the tilting of interacting flames towards each other, which results from a momentum imbalance triggered by fire geometry. The model was validated by measuring the velocity field surrounding stationary alcohol pool fires. The flow field was seeded with high-contrast colored smoke, and the motion of smoke structures was analyzed using a cross-correlation optical flow technique. The measured velocities and flame angles are found to compare reasonably with the predicted values, and an analogy between merging fires and wind-blown flames is proposed.

scholarly journals FIRE BEHAVIOR PREDICTING MODELS EFFICIENCY IN BRAZILIAN COMMERCIAL EUCALYPT PLANTATIONS

CERNE ◽  
2016 ◽  
Vol 22 (4) ◽  
pp. 389-396 ◽  
Author(s):  
Benjamin Leonardo Alves White ◽  
Larissa Alves Secundo White ◽  
Genésio Tâmara Ribeiro ◽  
Rosemeri Melo Souza
Keyword(s):  
Fire Suppression ◽  
Fire Behavior ◽  
Fire Spread ◽  
Flame Length ◽  
Eucalypt Plantations ◽  
Spread Model ◽  
Experimental Laboratory ◽  
Predicted Values ◽  
In Fire ◽  
Better Than

ABSTRACT Knowing how a wildfire will behave is extremely important in order to assist in fire suppression and prevention operations. Since the 1940’s mathematical models to estimate how the fire will behave have been developed worldwide, however, none of them, until now, had their efficiency tested in Brazilian commercial eucalypt plantations nor in other vegetation types in the country. This study aims to verify the accuracy of the Rothermel (1972) fire spread model, the Byram (1959) flame length model, and the fire spread and length equations derived from the McArthur (1962) control burn meters. To meet these objectives, 105 experimental laboratory fires were done and their results compared with the predicted values from the models tested. The Rothermel and Byram models predicted better than McArthur’s, nevertheless, all of them underestimated the fire behavior aspects evaluated and were statistically different from the experimental data.

Microplot Sampling of Fire Behavior on Populus tremuloides Stands in North-Central Colorado

1993 ◽  
Vol 3 (2) ◽  
pp. 85 ◽  
Author(s):  
JK Smith ◽  
RD Laven ◽  
PN Omi
Keyword(s):  
Populus Tremuloides ◽  
Fire Behavior ◽  
Fire Effects ◽  
Flame Length ◽  
Fire Intensity ◽  
Total Heat Release ◽  
Spread Rate ◽  
North Central ◽  
Area Burned ◽  
In Fire

Fire behavior research has traditionally used whole burns as sampling units. Numerous burns were required to quantify relationships between pre-burn descriptors, fire behavior, and fire effects. Recent studies have used small plots within burns (called microplots) as the sampling units. This study measured pre-burn descriptors and fire behavior on 0.75-m2 microplots in two Populus tremuloides Michx. burns in north-central Colorado. Microplot estimates of woody fuels, spread rate, and area burned were comparable with measurements from whole burns. Two methods of estimating fire intensity on microplots produced inconsistent results. Juniperus communis L. patches burned more intensely and released more heat than herbaceous areas. Duff characteristics were the most useful pre-burn descriptors for predicting area burned, spread rate, flame length, and total heat release. Microplot sampling on two bums enabled us to relate variability in fire behavior to pre-burn characteristics and to obtain replicate estimates of these relationships.

Flashover and instabilities in fire behavior

1980 ◽  
Vol 38 ◽  
pp. 159-171 ◽  
Author(s):  
P.H. Thomas ◽  
M.L. Bullen ◽  
J.G. Quintiere ◽  
B.J. McCaffrey
Keyword(s):  
Fire Behavior ◽  
In Fire

Effects of Acoustic Excitation on a Swirling Diffusion Flame

2010 ◽  
Vol 132 (12) ◽  
Author(s):  
Michael E. Loretero ◽  
Rong F. Huang
Keyword(s):  
Flow Field ◽  
Bluff Body ◽  
Excitation Frequency ◽  
Excitation Amplitude ◽  
Mie Scattering ◽  
Flame Length ◽  
Laser Doppler Velocimeter ◽  
Scattering Method ◽  
Acoustic Excitation ◽  
Characteristic Modes

A swirling double concentric jet is commonly used for nonpremixed gas burner application for safety reasons and to improve the combustion performance. Fuel is generally spurted at the central jet while the annular coflowing air is swirled. They are normally separated by a blockage disk where the bluff-body effects further enhance the recirculation of hot gas at the reaction zone. This paper aims to experimentally investigate the behavior of flame and flow in a double concentric jet combustor when the fuel supply is acoustically driven. Laser-light sheet assisted Mie scattering method has been used to visualize the flow, while the flame lengths were measured by a conventional photography technique. The fluctuating velocity at the jet exit was measured by a two-component laser Doppler velocimeter. Flammability and stability at first fuel tube resonant frequency are reported and discussed. The evolution of flame profile with excitation level is presented and discussed, together with the reduction in flame length. The flame in the unforced reacting axisymmetric wake is classified into three characteristic modes, which are weak swirling flame, lifted flame, and transitional reattached flame. These terms reflect their primary features of flame appearances, and when the acoustic excitation is applied, the flame behaviors change with the excitation frequency and amplitude. Four additional characteristic modes are identified; e.g., at low excitation amplitudes, wrinkling flame with a blue annular film is observed because the excitation induces vortices in the central fuel jet and hence gives rise to the wrinkling of flame. The central jet vortices become larger with the increase in excitation amplitude and thus lead to a wider and shorter flame. If the excitation amplitude is increased above a certain value, the central jet vortices change the rotation direction and pacing with the annular jet vortices. These changes in the flow field induce large turbulent intensity and mixing and therefore make the flame looks blue and short. Further increase in the excitation amplitude would lift the flame because the flow field would be dramatically modified.

Changes in fire behavior caused by fire exclusion and fuel build-up vary with topography in California montane forests, USA

2022 ◽  
Vol 304 ◽  
pp. 114255
Author(s):  
Catherine Airey-Lauvaux ◽  
Andrew D. Pierce ◽  
Carl N. Skinner ◽  
Alan H. Taylor
Keyword(s):  
Fire Behavior ◽  
Montane Forests ◽  
Fire Exclusion ◽  
In Fire

Numerical Analysis of Fire Behavior of a Large Space Pre-Stressed Steel Structure under Fire

2011 ◽  
Vol 71-78 ◽  
pp. 3729-3732
Author(s):  
Ming Zhou ◽  
Zhi Guo Xie ◽  
Xin Tang Wang
Keyword(s):  
Numerical Analysis ◽  
Fire Behavior ◽  
Thermal Response ◽  
Structural Response ◽  
Steel Structure ◽  
Large Space ◽  
Fire Source ◽  
Lattice Shell ◽  
In Fire ◽  
Influence Degree

The computational model of numerical analysis of a suspended pre-stressed steel reticulated shell subjected to fire load is established with using the software Marc. Based on the model presented here, numerical analysis of thermal response and structural response of the pre-stressed steel structure are computed. The different space height and different rise-span ratio are considered for analysis of response temperature, displacements and stresses of the pre-stressed lattice shell under fire for one fire source. It is also shown that displacement of the node right above the inner cable is the maximum among the four nodes presented here as the fire source is located at the position right below the second-ring cable of the structure. It is concluded that the influence degree of space height of the structure on the fire response of the structure is not great, but rise-span ratio has obvious and great effect on displacements and stresses of the pre-stressed steel structure with large span in fire.

Effects of wind velocity and slope on flame properties

1996 ◽  
Vol 26 (10) ◽  
pp. 1849-1858 ◽  
Author(s):  
David R. Weise ◽  
Gregory S. Biging
Keyword(s):  
Froude Number ◽  
Wind Velocity ◽  
Fire Behavior ◽  
Flame Length ◽  
Parameter Estimates ◽  
Combined Effects ◽  
Field Scale ◽  
Support Theory ◽  
Length Data ◽  
Flame Angle

The combined effects of wind velocity and percent slope on flame length and angle were measured in an open-topped, tilting wind tunnel by burning fuel beds composed of vertical birch sticks and aspen excelsior. Mean flame length ranged from 0.08 to 1.69 m; 0.25 m was the maximum observed flame length for most backing fires. Flame angle ranged from −46° to 50°. Observed flame angle and length data were compared with predictions from several models applicable to fires on a horizontal surface. Two equations based on the Froude number underestimated flame angle for most wind and slope combinations; however, the data support theory that flame angle is a function of the square root of the Froude number. Discrepancies between data and predictions were attributed to measurement difficulties and slope effects. An equation based on Byram's convection number accounted for nearly half of the observed variation in flame angle (R2 = 0.46). Byram's original equation relating fireline intensity to flame length overestimated flame length. New parameter estimates were derived from the data. Testing of observed fire behavior under a wider range of conditions and at field scale is recommended.

scholarly journals Thermodynamics of Pyrocumulus: A Conceptual Study

2018 ◽  
Vol 146 (8) ◽  
pp. 2579-2598 ◽  
Author(s):  
Kevin J. Tory ◽  
William Thurston ◽  
Jeffrey D. Kepert
Keyword(s):  
Full Range ◽  
Fire Behavior ◽  
Atmospheric Conditions ◽  
Neutral Buoyancy ◽  
Lightning Strikes ◽  
Plume Temperature ◽  
Conceptual Study ◽  
Lifting Condensation Level ◽  
In Fire ◽  
Insight Into

Abstract In favorable atmospheric conditions, fires can produce pyrocumulonimbus cloud (pyroCb) in the form of deep convective columns resembling conventional thunderstorms, which may be accompanied by strong inflow, dangerous downbursts, and lightning strikes that can produce dangerous changes in fire behavior. PyroCb formation conditions are not well understood and are difficult to forecast. This paper presents a theoretical study of the thermodynamics of fire plumes to better understand the influence of a range of factors on plume condensation. Plume gases are considered to be undiluted at the fire source and approach 100% dilution at the plume top (neutral buoyancy). Plume condensation height changes are considered for this full range of dilution and for a given set of factors that include environmental temperature and humidity, fire temperature, and fire-moisture-to-heat ratios. The condensation heights are calculated and plotted as saturation point (SP) curves on thermodynamic diagrams. The position and slope of the SP curves provide insight into how plume condensation is affected by the environment thermodynamics and ratios of fire heat to moisture production. Plume temperature traces from large-eddy model simulations added to the diagrams provide additional insight into plume condensation heights and plume buoyancy at condensation. SP curves added to a mixed layer lifting condensation level on standard thermodynamic diagrams can be used to identify the minimum plume condensation height and buoyancy required for deep, moist, free convection to develop, which will aid pyroCb prediction.

scholarly journals The Impact of Fuel Treatments on Wildfire Behavior in North American Boreal Fuels: A Simulation Study Using FIRETEC

Fire ◽  
2020 ◽  
Vol 3 (2) ◽  
pp. 18 ◽  
Author(s):  
Ginny Marshall ◽  
Dan Thompson ◽  
Kerry Anderson ◽  
Brian Simpson ◽  
Rodman Linn ◽  
...  
Keyword(s):  
Black Spruce ◽  
Treatment Options ◽  
Fire Behavior ◽  
Fire Spread ◽  
Natural Forests ◽  
Spread Rate ◽  
Multiple Components ◽  
In Fire ◽  
The Impact ◽  
Common Tree

Current methods of predicting fire spread in Canadian forests are suited to large wildfires that spread through natural forests. Recently, the use of mechanical and thinning treatments of forests in the wildland-urban interface of Canada has increased. To assist in community wildfire protection planning in forests not covered by existing operational fire spread models, we use FIRETEC to simulate fire spread in lowland black spruce fuel structures, the most common tree stand in Canada. The simulated treatments included the mechanical mulching of strips, and larger, irregularly shaped areas. In all cases, the removal of fuel by mulch strips broke up the fuels, but also caused wind speed increases, so little decrease in fire spread rate was modelled. For large irregular clearings, the fire spread slowly through the mulched wood chips, and large decreases in fire spread and intensity were simulated. Furthermore, some treatments in the black spruce forest were found to be effective in decreasing the distance and/or density of firebrands. The simulations conducted can be used alongside experimental fires and documented wildfires to examine the effectiveness of differing fuel treatment options to alter multiple components of fire behavior.

Fire Protection of High-Performance Concrete Using Protective Lining

2011 ◽  
Vol 82 ◽  
pp. 758-763
Author(s):  
Eike Wolfram Klingsch ◽  
Andrea Frangi ◽  
Mario Fontana
Keyword(s):  
High Performance ◽  
Input Data ◽  
High Performance Concrete ◽  
Fire Behavior ◽  
Explosive Spalling ◽  
Protective Lining ◽  
In Fire ◽  
Concrete Elements ◽  
Basic Input ◽  
Fire Design

The paper presents results of experimental and numerical analyses on the fire behavior of concrete elements protected by sprayed protective linings. Particular attention is given to high- (HPC) and ultrahigh performance concrete (UHPC), as HPC and UHPC tend to exhibit explosive spalling in fire due to low porosity. The results provide basic input data for the development of simplified rules for the fire design of concrete structures protected by sprayed protective linings.

Sign in / Sign up

Export Citation Format

Share Document