scholarly journals Experimental Research on Longitudinal Steel Bar Bond Properties in Modified Recycled Aggregate Concrete Beam-Column Interior Joint under Cyclic Loading

2017 ◽  
Vol 2017 ◽  
pp. 1-13 ◽  
Author(s):  
Jia-Li Fu ◽  
Bing-Kang Liu ◽  
Jun-Wei Ma
Keyword(s):  
Fly Ash ◽  
Cyclic Loading ◽  
Bond Strength ◽  
Compressive Stress ◽  
Bond Stress ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Aggregate Concrete ◽  
Steel Bar ◽  
Stress Hysteresis

Three recycled aggregate concrete (RAC) beam-column interior-joint specimens (including two modified recycled aggregate concrete interior joints with replacement of fly ash ratio of 15%) were tested under cyclic loading in order to study the bond behavior of the longitudinal steel bar at RAC joint. The tests obtained load-strain hysteresis curves of longitudinal bars. The relative bond strength of longitudinal bar in characteristic stages was calculated. The test results indicated that the longitudinal steel bar in RAC joint is able to supply a stable bond stress both in the full crack stage and in the ultimate stage, meaning that the requirements of stress transferring and displacement coordinating between RAC and reinforcements can be satisfied. The larger the diameter of steel bar, the more serious the bond strength degradation. The RAC with fly ash can improve the interface compactness and bond strength of recycled aggregate in full crack stage. When beam-column interface of concrete compression zone reaches ultimate strain, the compressive stress of the longitudinal reinforcement cannot be exerted. The bond stress of the steel bar cannot realize the pull and compressive stress conversion in the length of the core area of the joint owing to the stress hysteresis of the compression rebars.

scholarly journals Bond Behavior of CRACFST Columns after Exposure to Elevated Temperatures

2019 ◽  
Vol 2019 ◽  
pp. 1-8
Author(s):  
Peng Hu ◽  
Jiong-Feng Liang
Keyword(s):  
Bond Strength ◽  
Concrete Strength ◽  
Steel Tube ◽  
Bond Stress ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Aggregate Concrete ◽  
Bond Behavior ◽  
Circular Steel Tube ◽  
Push Out

The bond behavior of post-heated circular recycled aggregate concrete-filled steel tube (CRACFST) columns is experimentally investigated in this paper. A total of 24 heated push-out CRACFST specimens are prepared; at the same time, 3 unheated specimens are also prepared and tested for comparison. This paper investigates the effects of five variable parameters, namely, temperature, exposure period, recycled coarse aggregate (RCA) replacement ratio, concrete strength, and interface length-to-diameter ratio, on the bond stress-slip curves and bond strength. The results show that the push-out CRACFST specimens exhibit some differences in bond stress-slip curves at both ambient and high temperature. The bond strength increases with increasing temperature. Other parameters also have influence to some extent. On the basis of a regression analysis of the experimental data, a revised bond strength model is proposed to predict the post-heated bond behavior between recycled aggregate concrete and circular steel tube.

scholarly journals Effect of Mineral Admixtures on the Performance of Low-Quality Recycled Aggregate Concrete

Crystals ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 596
Author(s):  
Yasuhiro Dosho
Keyword(s):  
Blast Furnace ◽  
Fly Ash ◽  
Blast Furnace Slag ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Mineral Admixtures ◽  
Structural Concrete ◽  
Aggregate Concrete ◽  
Granulated Blast Furnace Slag ◽  
Furnace Slag

To improve the application of low-quality aggregates in structural concrete, this study investigated the effect of multi-purpose mineral admixtures, such as fly ash and ground granulated blast-furnace slag, on the performance of concrete. Accordingly, the primary performance of low-quality recycled aggregate concrete could be improved by varying the replacement ratio of the recycled aggregate and using appropriate mineral admixtures such as fly ash and ground granulated blast-furnace slag. The results show the potential for the use of low-quality aggregate in structural concrete.

scholarly journals Experimental Study on the Mechanical Properties and Compression Size Effect of Recycled Aggregate Concrete

Materials ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2323
Author(s):  
Yubing Du ◽  
Zhiqing Zhao ◽  
Qiang Xiao ◽  
Feiting Shi ◽  
Jianming Yang ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Size Effect ◽  
Compressive Stress ◽  
Failure Modes ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Aggregate Concrete ◽  
Substitution Ratio ◽  
The Impact

To explore the basic mechanical properties and size effects of recycled aggregate concrete (RAC) with different substitution ratios of coarse recycled concrete aggregates (CRCAs) to replace natural coarse aggregates (NCA), the failure modes and mechanical parameters of RAC under different loading conditions including compression, splitting tensile resistance and direct shear were compared and analyzed. The conclusions drawn are as follows: the failure mechanisms of concrete with different substitution ratios of CRCAs are similar; with the increase in substitution ratio, the peak compressive stress and peak tensile stress of RAC decrease gradually, the splitting limit displacement decreases, and the splitting tensile modulus slightly increases; with the increase in the concrete cube’s side length, the peak compressive stress of RAC declines gradually, but the integrity after compression is gradually improved; and the increase in the substitution ratio of the recycled aggregate reduces the impact of the size effect on the peak compressive stress of RAC. Furthermore, an influence equation of the coupling effect of the substitution ratio and size effect on the peak compressive stress of RAC was quantitatively established. The research results are of great significance for the engineering application of RAC and the strength selection of RAC structure design.

Compressive stress–strain behavior of steel fiber reinforced-recycled aggregate concrete

2014 ◽  
Vol 46 ◽  
pp. 65-72 ◽  
Author(s):  
Jodilson Amorim Carneiro ◽  
Paulo Roberto Lopes Lima ◽  
Mônica Batista Leite ◽  
Romildo Dias Toledo Filho
Keyword(s):  
Compressive Stress ◽  
Steel Fiber ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Fiber Reinforced ◽  
Stress Strain ◽  
Aggregate Concrete ◽  
Strain Behavior

Recycling of Waste Concrete and Fly Ash for Recycled Aggregate Concrete: Fundamental Characteristics Evaluation

2009 ◽  
Vol 620-622 ◽  
pp. 255-258 ◽  
Author(s):  
Cheol Woo Park
Keyword(s):  
Fly Ash ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Experimental Program ◽  
Concrete Aggregate ◽  
Fine Aggregate ◽  
Recycled Concrete Aggregate ◽  
Aggregate Concrete ◽  
Waste Concrete

As the amount of waste concrete has been increased and recycling technique advances, this study investigates the applicability of recycled concrete aggregate for concrete structures. In addition fly ash, the industrial by-product, was considered in the concrete mix. Experimental program performed compressive strength and chloride penetration resistance tests with various replacement levels of fine recycled concrete aggregate and fly ash. In most case, the design strength, 40MPa, was obtained. It was known that the replacement of the fine aggregate with fine RCA may have greater influence on the strength development rather than the addition of fly ash. It is recommended that when complete coarse aggregate is replaced with RCA the fine RCA replacement should be less than 60%. The recycled aggregate concrete can achieve sufficient resistance to the chloride ion penetration and the resistance can be more effectively controlled by adding fly ash. It I finally conclude that the recycled concrete aggregate can be successfully used in the construction field and the recycling rate of waste concrete and flay ash should be increased without causing significant engineering problems.

scholarly journals Experimental study on the compressive strength, damping and interfacial transition zone properties of modified recycled aggregate concrete

2019 ◽  
Vol 6 (12) ◽  
pp. 190813
Author(s):  
Bin Lei ◽  
Huajian Liu ◽  
Zhimin Yao ◽  
Zhuo Tang
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Transition Zone ◽  
Loss Factor ◽  
Steel Fibre ◽  
Interfacial Transition Zone ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Damping Properties ◽  
Aggregate Concrete

At present, many modification methods have been proposed to improve the performance of recycled aggregate concrete (RAC). In this study, tests on the compressive strength and damping properties of modified RAC with the addition of different proportions of recycled coarse aggregate (RCA) (0, 50, 100%), rubber powder (10, 15, 20%), steel fibre (5, 7.5, 10%) and fly ash (15, 20, 5%) are carried out. To elucidate the effect of the modification method on the interfacial transition zone (ITZ) performance of RAC, model ITZ specimens are used for push-out tests. The results show that when the replacement rate of RCA reaches 100%, the loss factor of the RAC is 6.0% higher than that of natural aggregate concrete; however, the compressive strength of the RAC decreases by 22.6%. With the addition of 20% rubber powder, the damping capacity of the modified RAC increases by 213.7%, while the compressive strength of the modified RAC decreases by 47.5%. However, with the addition of steel fibre and fly ash, both the compressive strength and loss factor of the RAC specimens increase. With a steel fibre content of 10 wt%, the compressive strength and loss factor of the RAC increase by 21.9% and 15.2%, respectively. With a fly ash content of 25 wt%, the compressive strength and loss factor of the RAC increase by 8.6% and 6.9%, respectively. This demonstrates that steel fibre and fly ash are effective in improving both the damping properties and compressive strength of RAC, and steel fibre is more effective than fly ash. Two methods were used for modification of the RAC: reinforcing the RCA through impregnation with a 0.5% polyvinyl alcohol (PVA) emulsion and nano-SiO 2 solution, and strengthening the RAC integrally through the addition of fly ash as an admixture. Both of these techniques can improve the ITZ bond strength between the RAC and new mortar. Replacing 10% of the cement with fly ash in the new mortar is shown to be the best method to improve the ITZ strength.

scholarly journals Sulfate Resistance of Recycled Aggregate Concrete with GGBS and Fly Ash-Based Geopolymer

Materials ◽  
2019 ◽  
Vol 12 (8) ◽  
pp. 1247 ◽  
Author(s):  
Jianhe Xie ◽  
Jianbai Zhao ◽  
Junjie Wang ◽  
Chonghao Wang ◽  
Peiyan Huang ◽  
...  
Keyword(s):  
Fly Ash ◽  
Construction Projects ◽  
High Performance ◽  
High Performance Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Aggregate Concrete ◽  
Sulfate Resistance ◽  
Coarse Aggregates

There is a constant drive for the development of ultra-high-performance concrete using modern green engineering technologies. These concretes have to exhibit enhanced durability and incorporate energy-saving and environment-friendly functions. The object of this work was to develop a green concrete with an improved sulfate resistance. In this new type of concrete, recycled aggregates from construction and demolition (C&D) waste were used as coarse aggregates, and granulated blast furnace slag (GGBS) and fly ash-based geopolymer were used to totally replace the cement in concrete. This study focused on the sulfate resistance of this geopolymer recycled aggregate concrete (GRAC). A series of measurements including compression, X-ray diffraction (XRD), and scanning electron microscopy (SEM) tests were conducted to investigate the physical properties and hydration mechanisms of the GRAC after different exposure cycles in a sulfate environment. The results indicate that the GRAC with a higher content of GGBS had a lower mass loss and a higher residual compressive strength after the sulfate exposure. The proposed GRACs, showing an excellent sulfate resistance, can be used in construction projects in sulfate environments and hence can reduce the need for cement as well as the disposal of C&D wastes.

Sign in / Sign up

Export Citation Format

Share Document