Nickel-phosphorus-boron amorphous alloy nanotubes improves the selective hydrogenation of furfural to furfuryl alcohol

2021 ◽  
Vol 11 (7) ◽  
pp. 1214-1222
Author(s):  
Min Mo ◽  
Jiansheng Tang ◽  
Qi Lu ◽  
Youyi Xun

Ni–P–B (NPB) amorphous alloy nanotubes were prepared for the selective liquid-phase hydrogenation of furfural to furfuryl alcohol. The content of P in NPB amorphous alloy nanotubes was adjusted by the initial NaH2PO2-containing liquid crystal system of non-ionic/anionic mixed surfactants. The promotion effect of an appropriate amount of P was mainly characterized by its large active surface area, ability for greater absorption of H, strong synergistic interaction, better stability, high conversion and catalytic selectivity. The NPB nanotubes exhibited higher hydrogenation activity when compared with the corresponding NPB nanoparticles, which might be dependent on the specific surface area, uniform active sites and tubular morphology of the catalysts.

2019 ◽  
Vol 7 (31) ◽  
pp. 18338-18347 ◽  
Author(s):  
Shuai Chang ◽  
Xiaolei Huang ◽  
Chun Yee Aaron Ong ◽  
Liping Zhao ◽  
Liqun Li ◽  
...  

3D printing of a tailor-designed support architecture with a tunable electrochemically active surface area for improving catalyst loading contributions to catalytic activity.


Author(s):  
Kailun Yang ◽  
Recep Kas ◽  
Wilson A. Smith

<p>This study evaluated the performance of the commonly used strong buffer electrolytes, i.e. phosphate buffers, during CO<sub>2</sub> electroreduction in neutral pH conditions by using in-situ surface enhanced infrared absorption spectroscopy (SEIRAS). Unfortunately, the buffers break down a lot faster than anticipated which has serious implications on many studies in the literature such as selectivity and kinetic analysis of the electrocatalysts. Increasing electrolyte concentration, surprisingly, did not extend the potential window of the phosphate buffers due to dramatic increase in hydrogen evolution reaction. Even high concentration phosphate buffers (1 M) break down within the potentials (-1 V vs RHE) where hydrocarbons are formed on copper electrodes. We have extended the discussion to high surface area electrodes by evaluating electrodes composed of copper nanowires. We would like highlight that it is not possible to cope with high local current densities on these high surface area electrodes by using high buffer capacity solutions and the CO<sub>2</sub> electrocatalysts are needed to be evaluated by casting thin nanoparticle films onto inert substrates as commonly employed in fuel cell reactions and up to now scarcely employed in CO<sub>2</sub> electroreduction. In addition, we underscore that normalization of the electrocatalytic activity to the electrochemical active surface area is not the ultimate solution due to concentration gradient along the catalyst layer.This will “underestimate” the activity of high surface electrocatalyst and the degree of underestimation will depend on the thickness, porosity and morphology of the catalyst layer. </p> <p> </p>


2020 ◽  
Vol 4 (4) ◽  
pp. 1747-1753 ◽  
Author(s):  
Yuanyuan Ma ◽  
Wenjie Zang ◽  
Afriyanti Sumboja ◽  
Lu Mao ◽  
Ximeng Liu ◽  
...  

Hollow structuring of active components is an effective strategy to improve the kinetics of oxygen electrode catalysts, arising from the increased the active surface area, the defects on the exposed surface, and the accessible active sites.


2012 ◽  
Vol 12 (6) ◽  
pp. 4919-4927 ◽  
Author(s):  
Nithi Atthi ◽  
Jakrapong Supadech ◽  
Gaetan Dupuy ◽  
On-uma Nimittrakoolchai ◽  
Apirak Pankiew ◽  
...  

2018 ◽  
Vol 8 (10) ◽  
pp. 2672-2685 ◽  
Author(s):  
Rhiyaad Mohamed ◽  
Tobias Binninger ◽  
Patricia J. Kooyman ◽  
Armin Hoell ◽  
Emiliana Fabbri ◽  
...  

Synthesis of Sb–SnO2 supported Pt nanoparticles with an outstanding ECSA for the oxygen reduction reaction.


2016 ◽  
Vol 16 (20) ◽  
pp. 13359-13378 ◽  
Author(s):  
Hassan Beydoun ◽  
Michael Polen ◽  
Ryan C. Sullivan

Abstract. Heterogeneous ice nucleation remains one of the outstanding problems in cloud physics and atmospheric science. Experimental challenges in properly simulating particle-induced freezing processes under atmospherically relevant conditions have largely contributed to the absence of a well-established parameterization of immersion freezing properties. Here, we formulate an ice active, surface-site-based stochastic model of heterogeneous freezing with the unique feature of invoking a continuum assumption on the ice nucleating activity (contact angle) of an aerosol particle's surface that requires no assumptions about the size or number of active sites. The result is a particle-specific property g that defines a distribution of local ice nucleation rates. Upon integration, this yields a full freezing probability function for an ice nucleating particle. Current cold plate droplet freezing measurements provide a valuable and inexpensive resource for studying the freezing properties of many atmospheric aerosol systems. We apply our g framework to explain the observed dependence of the freezing temperature of droplets in a cold plate on the concentration of the particle species investigated. Normalizing to the total particle mass or surface area present to derive the commonly used ice nuclei active surface (INAS) density (ns) often cannot account for the effects of particle concentration, yet concentration is typically varied to span a wider measurable freezing temperature range. A method based on determining what is denoted an ice nucleating species' specific critical surface area is presented and explains the concentration dependence as a result of increasing the variability in ice nucleating active sites between droplets. By applying this method to experimental droplet freezing data from four different systems, we demonstrate its ability to interpret immersion freezing temperature spectra of droplets containing variable particle concentrations. It is shown that general active site density functions, such as the popular ns parameterization, cannot be reliably extrapolated below this critical surface area threshold to describe freezing curves for lower particle surface area concentrations. Freezing curves obtained below this threshold translate to higher ns values, while the ns values are essentially the same from curves obtained above the critical area threshold; ns should remain the same for a system as concentration is varied. However, we can successfully predict the lower concentration freezing curves, which are more atmospherically relevant, through a process of random sampling from g distributions obtained from high particle concentration data. Our analysis is applied to cold plate freezing measurements of droplets containing variable concentrations of particles from NX illite minerals, MCC cellulose, and commercial Snomax bacterial particles. Parameterizations that can predict the temporal evolution of the frozen fraction of cloud droplets in larger atmospheric models are also derived from this new framework.


Sign in / Sign up

Export Citation Format

Share Document