Since the 1980s, the ASME Code has made numerous improvements in elevated-temperature structural integrity technology. These advances have been incorporated into Section II, Section VIII, Code Cases, and particularly Subsection NH of Section III of the Code, “Components in Elevated Temperature Service.” The current need for designs for very high temperature and for Gen IV systems requires the extension of operating temperatures from about 1400°F (760°C) to about 1742°F (950°C) where creep effects limit structural integrity, safe allowable operating conditions, and design life. Materials that are more creep and corrosive resistant are needed for these higher operating temperatures. Material models are required for cyclic design analyses. Allowable strains, creep fatigue and creep rupture interaction evaluation methods are needed to provide assurance of structural integrity for such very high temperature applications. Current ASME Section III design criteria for lower operating temperature reactors are intended to prevent through-wall cracking and leaking and corresponding criteria are needed for high temperature reactors. Subsection NH of Section III was originally developed to provide structural design criteria and limits for elevated-temperature design of Liquid-Metal Fast Breeder Reactor (LMFBR) systems and some gas-cooled systems. The U.S. Nuclear Regulatory Commission (NRC) and its Advisory Committee for Reactor Safeguards (ACRS) reviewed the design limits and procedures in the process of reviewing the Clinch River Breeder Reactor (CRBR) for a construction permit in the late 1970s and early 1980s, and identified issues that needed resolution. In the years since then, the NRC, DOE and various contractors have evaluated the applicability of the ASME Code and Code Cases to high-temperature reactor designs such as the VHTGRs, and identified issues that need to be resolved to provide a regulatory basis for licensing. The design lifetime of Gen IV Reactors is expected to be 60 years. Additional materials including Alloy 617 and Hastelloy X need to be fully characterized. Environmental degradation effects, especially impure helium and those noted herein, need to be adequately considered. Since cyclic finite element creep analyses will be used to quantify creep rupture, creep fatigue, creep ratcheting and strain accumulations, creep behavior models and constitutive relations are needed for cyclic creep loading. Such strain- and time-hardening models must account for the interaction between the time-independent and time-dependent material response. This paper describes the evolving structural integrity evaluation approach for high temperature reactors. Evaluation methods are discussed, including simplified analysis methods, detailed analyses of localized areas, and validation needs. Regulatory issues including weldment cracking, notch weakening, creep fatigue/creep rupture damage interactions, and materials property representations for cyclic creep behavior are also covered.
Design and Selection of Innovative Primary Circulation Pumps for GEN-IV Lead Fast Reactors