DEPENDENCE OF IN‐SITU COMPRESSIONAL‐WAVE VELOCITY ON POROSITY IN UNSATURATED ROCKS

Geophysics ◽  
1972 ◽  
Vol 37 (1) ◽  
pp. 29-35 ◽  
Author(s):  
Joel S. Watkins ◽  
Lawrence A. Walters ◽  
Richard H. Godson
Keyword(s):  
Wave Velocity ◽  
Seismic Refraction ◽  
Compressional Wave ◽  
Unconsolidated Sediments ◽  
Compressional Wave Velocity ◽  
Near Surface ◽  
Least Squares Fit ◽  
Water Saturated ◽  
Porosity Range

The relation of in‐situ compressional‐wave velocities to porosities, determined by seismic refraction for unsaturated near‐surface rocks from different areas in Arizona, New Mexico, and California, is grossly similar to relations determined by other investigators for water‐saturated rock and unconsolidated sediments. The principal difference is that in the porosity range 0.0–0.2, compressional waves travel somewhat more slowly in unsaturated rocks than in water‐saturated rocks, and much more slowly, in the porosity range 0.2–0.8. The function, ϕ=−0.175 ln (α)+1.56, where ϕ is the fractional porosity and α is the compressional‐wave velocity, was obtained as a least squares fit to the experimental data. Bulk densities are reported for all samples; moisture contents are reported in some instances.

scholarly journals THE LITHOSTRATIGRAPHY OF THE NEAR-SURFACE IN PART OF SEDIMENTARY KOLMANI FIELD IN NORTHERN BENUE TROUGH, NIGERIA, USING SOIL CORE AND SEISMIC REFRACTION DATA

2020 ◽  
Vol 4 (2) ◽  
pp. 53-59
Author(s):  
Glory G. Akpan ◽  
Etim D. Uko ◽  
Owajiokiche D. Ngerebara
Keyword(s):  
Wave Velocity ◽  
Seismic Refraction ◽  
Compressional Wave ◽  
Soil Samples ◽  
Soil Core ◽  
Compressional Wave Velocity ◽  
Near Surface ◽  
Weathered Layer ◽  
Seismic Refraction Data ◽  
Refraction Data

Soil samples from 31 shallow boreholes were acquired at depths 0m, 1m, 2m, 3m, 4m, 5m, 7m, 10m, 15m, 20m, 25m, 30m, 35m, 40m, 45m, 50m, 55m, and 60m in Pingida (Kolmani Field) in Ako LGA, Gombe State, Nigeria. Using the same boreholes, seismic refraction data was also acquired. The aim of the survey was to delineate the near-surface lithology and velocity layering. The boreholes were drilled using rotary drilling rig and the core samples acquired and described using Wentworth Scale. Seismic refraction data acquired using a single trace Stratavisor NZXP portable digital recorder. The recording spread consisted of a single SM4- 10Hz geophone positioned at depths where the soil samples were taken. A hammer was used as the energy source and placed 3m away from the hole to obtain the first breaks. The refraction data was interpreted using UDISYS Version 1.0.0.0 software. The soil layers in the Kolmani Field have three distinct layers specified as follows, namely, top weathered and sub-consolidated layers made up of intercalation of sandstone, gravel ash clay and muddy coal shale. The lithologic strata do not correlate throughout the field resulting from the highly variable elevation which ranged from 317m and 524m with average of 389.16m. The top weathered layer of laterite intercalated with cobblestones with compressional wave velocity ranging from 342 ms-1 to 517 ms-1 with an average of 405.03 ms-1. Beneath the weathered layer is the sub-consolidated Clay layer intercalated with silt and laterite of compressional wave velocity ranging from 440 ms-1 to 1854 ms-1 of average of 826 ms-1. The underlying consolidated layer is the shale and coal layer having compressional wave velocity ranging from 1518 ms-1 to 4201 ms-1 with an average of 2162.65 ms-1. The dominant lithologic sequences encountered are laterite, clay, silt, sand, gravel, coal and shale. The results of this work can be used for static corrections in seismic reflection processing, planning and assessing risk for engineering structures, and for groundwater exploration. The laterite, clay, silt, sand, gravel, coal and shale can be utilized in agriculture, construction, process industries, and environmental remediation.

Seismic refraction shooting in an area of the Eastern Atlantic

1952 ◽  
Vol 244 (890) ◽  
pp. 561-594 ◽  
Keyword(s):  
Wave Velocity ◽  
Deep Sea ◽  
Sea Water ◽  
Seismic Refraction ◽  
Compressional Wave ◽  
Crystalline Rock ◽  
Compressional Wave Velocity ◽  
Compressional Waves ◽  
A Value ◽  
Sedimentary Layer

For the experiments described in this paper a new method of seismic refraction shooting was developed. With this method hydrophones suspended at a depth of about 100 ft. below the surface of the sea acted as receivers for the compressional waves developed by depth charges exploding at a depth of approximately 900 ft. The hydrophones were connected with sono-radio buoys which radio-transmitted the electrical signals to a recording system in the ship from which the charges were dropped. Four buoys were in use simultaneously, distributed at differing ranges from the ship. The experiments were carried out at three positions in an area of the eastern Atlantic around the point 53° 50' N, 18° 40' W, where the water depth is approximately 1300 fm. (2400 m). The results showed that the uncrystalline sedimentary layer in this area varied in thickness from 6200 ft. to 9700 ft. (1900 to 3000 m), and that the velocity of compressional waves in it increased from the value for sea water, 4900 ft./s (1.5 km/s), at the surface with an approximately constant gradient of 2.5/s to a limiting value of 8200 ft./s (2.5 km/s). Below the sedimentary layer there was a crystalline rock with compressional wave velocity of approximately 16500 ft./s (5.0 km/s) and of thickness varying between 8800 ft. (2700 m) and 11100 ft. (3400 m). The base of this layer was in both determinations at approximately 25500 ft. (7800 m) below sea-level. The lowest layer concerning which information was obtained gave a value for the compressional wave velocity of about 20500 ft./s (6.3 km/s), but was of undetermined thickness. The characteristics of the sedimentary layer were such as might be expected for a continuous succession of deep-sea sediments, the thickness on this basis being such as to indicate the long existence of the ocean in this area. On the other hand, it is possible that it represents a downwarped continental shelf. The layer below the sedimentary layer has a compressional wave velocity which is low for an igneous rock at this depth, and it is probable that it represents a crystalline sedimentary rock. From the evidence it is not possible to determine whether this rock is of continental or deep-sea origin. The lowest layer of these experiments is unlikely to have a constitution similar to that of the European granitic layer, since the compressional wave velocity in it would, on this hypothesis, be exceptionally high. The value is, however, close to that calculated by Jeffreys for the intermediate layer.

PHYSICAL ANALYSIS OF DEEP SEA SEDIMENTS

Geophysics ◽  
1957 ◽  
Vol 22 (4) ◽  
pp. 779-812 ◽  
Author(s):  
George H. Sutton ◽  
Hans Berckhemer ◽  
John E. Nafe
Keyword(s):  
Grain Size ◽  
Wave Velocity ◽  
Deep Sea ◽  
Compressional Wave ◽  
Coarse Grained ◽  
Unconsolidated Sediments ◽  
Physical Analysis ◽  
Seismic Velocities ◽  
Compressional Wave Velocity ◽  
Wide Range

A sonic pulse system, similar to that used at Lamont Geological Observatory for seismic model experiments, was used aboard the Research Vessel VEMA during the summer of 1954 to determine high frequency seismic velocities in fresh deep sea sediment cores. Velocity profiles were obtained from 26 cores covering a wide range of lithologies and ages (Recent to Miocene). Density, porosity, median grain size, sorting, carbonate content, and salt content were also measured. The compressional wave velocity in the ocean‐bottom unconsolidated sediments studied is well represented by the equation: [Formula: see text] where v′=compressional wave velocity in km/sec ϕ=median grain size in phi units γ=percentage of HCl soluble material η=porosity. Many measurements gave velocities less than the velocity of sound in sea water. Most of the low carbonate samples followed a velocity‐porosity relation given by the Wood (1941) equation. The regression coefficient, −.44η, agrees well with the average slope of the Wood equation over the observed porosity range. High carbonate and large median grain size samples gave velocities above that predicted by the Wood equation. These higher velocities are explained as the combined result of shear strength and low effective porosity in the samples. The highest velocities were found in slowly deposited sediments. The degrees of sorting of the sediments had no observable effect on the seismic velocities except that unexplained variations were greater for more poorly sorted materials. No correlation between velocity and age was evident in the sediments studied. The effect of temperature, between 40 and 80°F. on compressional velocity in sediments may be explained by changes in elastic properties of the water fraction alone. The effect of compaction in the upper 15 or 20 feet of homogeneous sediments produced a change in seismic velocity not greater than 1 or 2 percent. Attenuation was greater in the coarse‐grained high‐velocity sediments than in sediments of smaller grain size.

scholarly journals Near surface shear wave velocity in Bucharest, Romania

2008 ◽  
Vol 8 (6) ◽  
pp. 1299-1307 ◽  
Author(s):  
M. von Steht ◽  
B. Jaskolla ◽  
J. R. R. Ritter
Keyword(s):  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Seismic Velocity ◽  
Seismic Refraction ◽  
Compressional Wave ◽  
Seismic Zone ◽  
Surface Shear ◽  
Near Surface ◽  
Surface Shear Wave

Abstract. Bucharest, the capital of Romania with nearly 2 1/2 million inhabitants, is endangered by the strong earthquakes in the Vrancea seismic zone. To obtain information on the near surface shear-wave velocity Vs structure and to improve the available microzonations we conducted seismic refraction measurements in two parks of the city. There the shallow Vs structure is determined along five profiles, and the compressional-wave velocity (Vp) structure is obtained along one profile. Although the amount of data collected is limited, they offer a reasonable idea about the seismic velocity distribution in these two locations. This knowledge is useful for a city like Bucharest where seismic velocity information so far is sparse and poorly documented. Using sledge-hammer blows on a steel plate and a 24-channel recording unit, we observe clear shear-wave arrivals in a very noisy environment up to a distance of 300 m from the source. The Vp model along profile 1 can be correlated with the known near surface sedimentary layers. Vp increases from 320 m/s near the surface to 1280 m/s above 55–65 m depth. The Vs models along all five profiles are characterized by low Vs (<350 m/s) in the upper 60 m depth and a maximum Vs of about 1000 m/s below this depth. In the upper 30 m the average Vs30 varies from 210 m/s to 290 m/s. The Vp-Vs relations lead to a high Poisson's ratio of 0.45–0.49 in the upper ~60 m depth, which is an indication for water-saturated clayey sediments. Such ground conditions may severely influence the ground motion during strong Vrancea earthquakes.

Sign in / Sign up

Export Citation Format

Share Document