Primary treatment of anaerobic landfill leachate using activated carbon and limestone: batch and column studies

2009 ◽  
Vol 4 (3/4) ◽  
pp. 282 ◽  
Author(s):  
Ahmed Abu Foul ◽  
Hamidi Abdul Aziz ◽  
Mohamed Hasnain Isa ◽  
Yung Tse Hung
Catalysts ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 337
Author(s):  
Sara Mesa Medina ◽  
Ana Rey ◽  
Carlos Durán-Valle ◽  
Ana Bahamonde ◽  
Marisol Faraldos

Two commercial activated carbon were functionalized with nitric acid, sulfuric acid, and ethylenediamine to induce the modification of their surface functional groups and facilitate the stability of corresponding AC-supported iron catalysts (Fe/AC-f). Synthetized Fe/AC-f catalysts were characterized to determine bulk and surface composition (elemental analysis, emission spectroscopy, XPS), textural (N2 isotherms), and structural characteristics (XRD). All the Fe/AC-f catalysts were evaluated in the degradation of phenol in ultrapure water matrix by catalytic wet peroxide oxidation (CWPO). Complete pollutant removal at short reaction times (30–60 min) and high TOC reduction (XTOC = 80 % at ≤ 120 min) were always achieved at the conditions tested (500 mg·L−1 catalyst loading, 100 mg·L−1 phenol concentration, stoichiometric H2O2 dose, pH 3, 50 °C and 200 rpm), improving the results found with bare activated carbon supports. The lability of the interactions of iron with functionalized carbon support jeopardizes the stability of some catalysts. This fact could be associated to modifications of the induced surface chemistry after functionalization as a consequence of the iron immobilization procedure. The reusability was demonstrated by four consecutive CWPO cycles where the activity decreased from 1st to 3rd, to become recovered in the 4th run. Fe/AC-f catalysts were applied to treat two real water matrices: the effluent of a wastewater treatment plant with a membrane biological reactor (WWTP-MBR) and a landfill leachate, opening the opportunity to extend the use of these Fe/AC-f catalysts for complex wastewater matrices remediation. The degradation of phenol spiked WWTP-MBR effluent by CWPO using Fe/AC-f catalysts revealed pH of the reaction medium as a critical parameter to obtain complete elimination of the pollutant, only reached at pH 3. On the contrary, significant TOC removal, naturally found in complex landfill leachate, was obtained at natural pH 9 and half stoichiometric H2O2 dose. This highlights the importance of the water matrix in the optimization of the CWPO operating conditions.


2017 ◽  
Vol 19 (4) ◽  
pp. 59-64 ◽  
Author(s):  
Dorota Downarowicz ◽  
Katarzyna Ziętarska

Abstract The study examined the adsorption of propan-1-ol (1PN) vapour on Sorbonorit 4 (S4) activated carbon in cyclic Electrothermal Temperature Swing Adsorption (ETSA) process. Dynamic adsorption capacity and breakthrough time were determined based on column studies. Thomas model was used to describe experimental breakthrough curves. Adsorption isotherms for 1PN vapour on S4 activated carbon were tested at 293 to 413 K. The experimental data were examined by using three multi-temperature isotherm models: Toth, Sips and hybrid Langmuir-Sips. Results indicate that S4 activated carbon is a heterogeneous adsorbent and the hybrid Langmuir-Sips model provides the best-fit experimental data. The energy requirement for 1PN electrothermal desorption from S4 bed (ca. 170–200 kJ/mol) was about 3 to 3.5 times larger than the isosteric heat of adsorption (56.8 kJ/mol), which was calculated using Toth adsorption isotherm.


Author(s):  
Rajani Ghaju Shrestha ◽  
Daisuke Inoue ◽  
Michihiko Ike

Abstract A constructed wetland (CW) is a low-cost, eco-friendly, easy-to-maintain, and widely applicable technology for treating various pollutants in the waste landfill leachate. This study determined the effects of the selection and compiling strategy of substrates used in CWs on the treatment performance of a synthetic leachate containing bisphenol A (BPA) as a representative recalcitrant pollutant. We operated five types of lab-scale vertical-flow CWs using only gravel (CW1), a sandwich of gravel with activated carbon (CW2) or brick crumbs (CW3), and two-stage hybrid CWs using gravel in one column and activated carbon (CW4) or brick crumbs (CW5) in another to treat synthetic leachate containing BPA in a 7-d sequential batch mode for 5 weeks. CWs using activated carbon (CW2 and CW4) effectively removed ammonium nitrogen (NH4-N) (99–100%), chemical oxygen demand (COD) (93–100%), and BPA (100%), indicating that the high adsorption capacity of activated carbon was the main mechanism involved in their removal. CW5 also exhibited higher pollutant removal efficiencies (NH4-N: 94–99%, COD: 89–98%, BPA: 89–100%) than single-column CWs (CW1 and CW3) (NH4-N: 76–100%, COD: 84–100%, BPA: 51–100%). This indicates the importance of the compiling strategy along with the selection of an appropriate substrate to improve the pollutant removal capability of CWs.


2021 ◽  
Vol 237 ◽  
pp. 88-96
Author(s):  
Fan Zeng ◽  
Keqiang Ding ◽  
Jiawei Lu ◽  
Minghan Luo ◽  
Danping Pan ◽  
...  

2019 ◽  
Vol 54 (3) ◽  
pp. 168-178 ◽  
Author(s):  
Jasmina Nikić ◽  
Jasmina Agbaba ◽  
Malcolm A. Watson ◽  
Aleksandra Tubić ◽  
Marko Šolić ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document