Evaluation of energy generation in Iraqi territory by solar photovoltaic power plants with a capacity of 20 MW

2022 ◽  
Vol 0 (0) ◽  
Author(s):  
Qusay Hassan ◽  
Saadoon Abdul Hafedh ◽  
Ali Hasan ◽  
Marek Jaszczur
Keyword(s):  
Experimental Data ◽  
Wind Speed ◽  
Power Plant ◽  
Ambient Temperature ◽  
Solar Irradiance ◽  
Electricity Generation ◽  
Power Plants ◽  
Solar Photovoltaic ◽  
Photovoltaic Power ◽  
Plant Capacity

Abstract The study evaluates the visibility of solar photovoltaic power plant construction for electricity generation based on a 20 MW capacity. The assessment was performed for four main cities in Iraq by using hourly experimental weather data (solar irradiance, wind speed, and ambient temperature). The experimental data was measured for the period from 1st January to 31st December of the year 2019, where the simulation process was performed at a 1 h time step resolution at the same resolution as the experimental data. There are two positionings considered for solar photovoltaic modules: (i) annual optimum tilt angle and (ii) two-axis tracking system. The effect of the ambient temperature and wind on the overall system energy generated was taken into consideration. The study is targeted at evaluating the potential solar energy in Iraq and the viability of electricity generation using a 20 MW solar photovoltaic power plant. The results showed that the overall performance of the suggested power plant capacity is highly dependent on the solar irradiance intensity and the ambient temperature with wind speed. The current 20 MW solar photovoltaic power plant capacity shows the highest energy that can be generated in the mid-western region and the lowest in the northeast regions. The greatest influence of the ambient temperature on the energy genrated by power plants is observed in the southern regions.

scholarly journals Economic feasibility of developing large scale solar photovoltaic power plants in Spain

2019 ◽  
Vol 122 ◽  
pp. 02004 ◽  
Author(s):  
Javier Menéndez ◽  
Jorge Loredo
Keyword(s):  
Power Plant ◽  
Power Plants ◽  
Large Scale ◽  
Economic Feasibility ◽  
Solar Irradiation ◽  
Solar Photovoltaic ◽  
Solar Pv ◽  
Photovoltaic Energy ◽  
Profitability Analysis ◽  
Photovoltaic Power

In 2017, electricity generation from renewable sources contributed more than one quarter (30.7%) to total EU-28 gross electricity consumption. Wind power is for the first time the most important source, followed closely by hydro power. The growth in electricity from photovoltaic energy has been dramatic, rising from just 3.8 TWh in 2007, reaching a level of 119.5 TWh in 2017. Over this period, the contribution of photovoltaic energy to all electricity generated in the EU-28 from renewable energy sources increased from 0.7% to 12.3%. During this period the investment cost of a photovoltaic power plant has decreased considerably. Fundamentally, the cost of solar panels and inverters has decreased by more than 50%. The solar photovoltaic energy potential depends on two parameters: global solar irradiation and photovoltaic panel efficiency. The average solar irradiation in Spain is 1,600 kWh m-2. This paper analyzes the economic feasibility of developing large scale solar photovoltaic power plants in Spain. Equivalent hours between 800-1,800 h year-1 and output power between 100-400 MW have been considered. The profitability analysis has been carried out considering different prices of the electricity produced in the daily market (50-60 € MWh-1). Net Present Value (NPV) and Internal Rate of Return (IRR) were estimated for all scenarios analyzed. A solar PV power plant with 400 MW of power and 1,800 h year-1, reaches a NPV of 196 M€ and the IRR is 11.01%.

scholarly journals Model Based Generation Prediction of SPV Power Plant Due to Weather Stressed Soiling

Energies ◽  
2021 ◽  
Vol 14 (17) ◽  
pp. 5305
Author(s):  
Saheli Sengupta ◽  
Aritra Ghosh ◽  
Tapas K. Mallick ◽  
Chandan Kumar Chanda ◽  
Hiranmay Saha ◽  
...  
Keyword(s):  
Power Plant ◽  
Energy Management ◽  
Power Plants ◽  
Economic Loss ◽  
Climatic Conditions ◽  
Photovoltaic System ◽  
Solar Photovoltaic ◽  
Dust Deposition ◽  
Photovoltaic Power ◽  
Single Location

Solar energy is going to be a major component of global energy generation. Loss due to dust deposition has raised a great concern to the investors in this field. Pre-estimation of this reduced generation and hence the economic loss will help the operators’ readiness for efficient and enhanced economic energy management of the system. In an earlier article, a physics–based model is proposed for assessment of dust accumulation under various climatic conditions which is validated by data of a single location. In this paper, the universality of this model is established and is used to demonstrate the effect of generation loss due to dust deposition and of cleaning. Variation in the soiling pattern due to climatic covariates has also been studied. Generation loss is calculated for Solar Photovoltaic power plants of different capacities at various locations in India. Finally this model has also been extended to predict the generation accounting for the soiling loss in Photovoltaic system. All the calculated and predicted results are validated with the measured values of the above plants.

scholarly journals Optimization of a Small Wind Power Plant for Annual Wind Speed Distribution

Energies ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1587
Author(s):  
Krzysztof Wrobel ◽  
Krzysztof Tomczewski ◽  
Artur Sliwinski ◽  
Andrzej Tomczewski
Keyword(s):  
Wind Speed ◽  
Power Plant ◽  
Wind Power ◽  
Power Plants ◽  
Control Method ◽  
Wind Power Plant ◽  
Switched Reluctance ◽  
Wind Speeds ◽  
Wind Speed Distribution ◽  
And Control

This article presents a method to adjust the elements of a small wind power plant to the wind speed characterized by the highest annual level of energy. Tests were carried out on the basis of annual wind distributions at three locations. The standard range of wind speeds was reduced to that resulting from the annual wind speed distributions in these locations. The construction of the generators and the method of their excitation were adapted to the characteristics of the turbines. The results obtained for the designed power plants were compared with those obtained for a power plant with a commercial turbine adapted to a wind speed of 10 mps. The generator structure and control method were optimized using a genetic algorithm in the MATLAB program (Mathworks, Natick, MA, USA); magnetostatic calculations were carried out using the FEMM program; the simulations were conducted using a proprietary simulation program. The simulation results were verified by measurement for a switched reluctance machine of the same voltage, power, and design. Finally, the yields of the designed generators in various locations were determined.

7E analysis of a conceptual utility-scale land-based solar photovoltaic power plant

Energy ◽  
2021 ◽  
Vol 219 ◽  
pp. 119610
Author(s):  
S. Sreenath ◽  
K. Sudhakar ◽  
Yusop AF
Keyword(s):  
Power Plant ◽  
Solar Photovoltaic ◽  
Photovoltaic Power ◽  
Utility Scale

Numerical Investigation of Thermal Flow Field of Air-Cooled Condensers for Yongshou Plant

2012 ◽  
Vol 248 ◽  
pp. 391-394
Author(s):  
Wen Zhou Yan ◽  
Wan Li Zhao ◽  
Qiu Yan Li
Keyword(s):  
Fluid Dynamics ◽  
Computational Fluid Dynamics ◽  
Wind Speed ◽  
Power Plant ◽  
Flow Field ◽  
Wind Direction ◽  
Rotational Speed ◽  
Power Plants ◽  
Thermal Flow ◽  
Air Cooled Condensers

By using the computational fluid dynamics code, FLUENT, Numerically simulation is investigated for Youngshou power plant. Under the constant ambient temperature, the effects of different wind speed and wind direction on the thermal flow field are qualitatively considered. It was found that when considering about the existing and normally operating power plants, the thermal flow field is more sensitive to wind direction and wind speed. Based on the above results, three improved measures such as: increasing the wind-wall height and accelerating the rotational speed of the fans near the edge of the ACC platform and lengthen or widen the platform are developed to effectively improving the thermal flow field, and enhanced the heat dispersal of ACC.

scholarly journals A Project To Estimate The Power Capacity Of Geothermal Power Plants Based On The Enthalpy Of Geothermal Fluid And Plant Design

2021 ◽  
Author(s):  
Obumneme Oken
Keyword(s):  
Power Plant ◽  
Geothermal Energy ◽  
Electricity Generation ◽  
Power Plants ◽  
Hot Water ◽  
Power Capacity ◽  
Geothermal Fluid ◽  
Direct Heating ◽  
Single Flash ◽  
Geothermal Power

Nigeria has some surface phenomena that indicate the presence of viable geothermal energy. None of these locations have been explored extensively to determine the feasibility of sustainable geothermal energy development for electricity generation or direct heating. In this context, the present study aims to provide insight into the energy potential of such development based on the enthalpy estimation of geothermal reservoirs. This particular project was conducted to determine the amount of energy that can be gotten from a geothermal reservoir for electricity generation and direct heating based on the estimated enthalpy of the geothermal fluid. The process route chosen for this project is the single-flash geothermal power plant because of the temperature (180℃) and unique property of the geothermal fluid (a mixture of hot water and steam that exists as a liquid under high pressure). The Ikogosi warm spring in Ekiti State, Nigeria was chosen as the site location for this power plant. To support food security efforts in Africa, this project proposes the cascading of a hot water stream from the flash tank to serve direct heat purposes in agriculture for food preservation, before re-injection to the reservoir. The flowrate of the geothermal fluid to the flash separator was chosen as 3125 tonnes/hr. The power output from a single well using a single flash geothermal plant was evaluated to be 11.3 MW*. This result was obtained by applying basic thermodynamic principles, including material balance, energy balance, and enthalpy calculations. This particular project is a prelude to a robust model that will accurately determine the power capacity of geothermal power plants based on the enthalpy of fluid and different plant designs.

Sign in / Sign up

Export Citation Format

Share Document