Green synthesis of cobalt oxide nanoparticles using Citrus medica leaves extract: characterization and photo-catalytic activity

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Mohsin Siddique ◽  
Noor Muhammad Khan ◽  
Muhammad Saeed ◽  
Sajid Ali ◽  
Zarbad Shah

AbstractThe study deals with the green and eco-friendly synthesis and characterization of cobalt oxide nanoparticles using leaf extract of Citrus medica plant. The crystalline nature and functional groups analysis of cobalt oxide Nps was confirmed by X-ray diffraction and diffused reflectance infra-red spectroscopy respectively. The band gap of the Nps was calculated using Tauc plot. Scanning microscope analysis was carried out to get an insight to the structural morphology of the catalyst. The catalyst was found to be very active for the degradation of methyl orange dye using a very small amount of catalyst (0.006 g) using ultra violet radiation source. Approximately, 90% of the dye (Initial Conc. 10 mg L−1) was degraded in 60 min at natural pH (6.5). The dye degradation increased with increase in pH of the solution, due to the enhanced production of OH radicals, at higher pH values. Different experimental parameters like catalyst amount, agitation speed, initial pH of the solution, initial concentration of dye and recycling of the catalyst were varied to test the performance of the catalyst.

2021 ◽  
Author(s):  
Sherif Elbasuney ◽  
Shukri Ismael ◽  
M. Yehia ◽  
Hesham Tantawy ◽  
Ahmed Saleh ◽  
...  

Abstract HMX is considered one of the most powerful energetic materials; however HMX experiences low sensitivity. Cobalt oxide particles can expose active surface sites; low coordination surface oxygen has remarkable capability to act as electron donor to electron deficient explosive materials. Furthermore, cobalt oxide hydrous surface could release active ȮH radicals that could attack HMX heterocyclic ring. Consequently cobalt oxide can experience potential catalyzing ability. Highly crystalline, mono-dispersed cobalt oxide nanoparticles (NPs) of 20 nm were fabricated using hydrothermal processing. Cobalt oxide demonstrated stable colloidal particles; these particles were re-dispersed in organic solvent and integrated into HMX matrix via co-precipitation technique. Enhanced particle dispersion into energetic matrix was verified using SEM. The effectiveness of cobalt oxide on HMX decomposition was evaluated using DSC and TGA. Cobalt oxide NPs demonstrated superior catalytic activity; with an increase in HMX decomposition enthalpy by 53 % using DSC. The main decomposition temperature was decreased by 10 0C. Cobalt oxide NPs offered enhanced reaction propagation index by 56 %; additionally HMX activation energy was decreased by 41 % and 37 % using Kissinger and KAS models respectively.


2020 ◽  
pp. 113-126
Author(s):  
Biswajit Chowdhury ◽  
Sitangshu Shekhar Pradhan ◽  
Hari Sankar Das ◽  
Bhaskar Biswas

Considering the impact of organic dyes as industrial effluents on the environment, this research study describes the synthesis, structural and morphological characterization, and visible light induced photo-catalytic studies of cobalt oxide nanoparticles (CoONPs). In order to synthesize the CoONPs, a tetra-nuclear cobalt(III)-Schiff base complex was prepared in crystalline phase and employed to produce CoONPs through thermal decomposition of the synthetic precursor. The morphology of the nanoparticle has been delineated with different spectroscopic and analytic methods. Scanning and transmission electron microscopy (FE-SEM and HR-TEM) analyses estimate the cauliflower structured CoONPs with an average size ~80 nm. The photo-catalytic behavior of CoONPs has been tested against murexide and titan yellow dye in aqueous phase. This CoONPs ensure more than 90% of degradation for murexide while ~60% degradation has been observed for titan yellow (TY) in aqueous phase for a same time interval. MX and TY adopt different structures which bring the variation in rate of photosensitization for the synthetic CoONPs photocatalyst and account on the different photocatalytic efficiency towards the degradation of MX and TY in presence of visible light.


2018 ◽  
Vol 21 (4) ◽  
pp. 271-280 ◽  
Author(s):  
Mohammad A. Ghasemzadeh ◽  
Mohammad H. Abdollahi-Basir ◽  
Zahra Elyasi

Aim and Objective: The multi-component condensation of benzil, primary amines, ammonium acetate and various aldehydes was efficiently catalyzed using cobalt oxide nanoparticles under ultrasonic irradiation. This approach describes an effective and facile method for the synthesis of some novel 1,2,4,5-tetrasubstituted imidazole derivatives with several advantages such as high yields and short reaction times and reusability of the catalyst. Moreover, the prepared heterocyclic compounds showed high antibacterial activity against some pathogenic strains. Materials and Method: The facile and efficient approaches for the preparation of Co3O4 nanoparticles were carried out by one step method. The synthesized heterogeneous nanocatalyst was characterized by spectroscopic analysis including EDX, FE-SEM, VSM, XRD and FT-IR analysis. The as-synthesized cobalt oxide nanoparticles showed paramagnetic behaviour in magnetic field. In addition, the catalytic influence of the nanocatalyst was examined in the one-pot reaction of primary amines, benzil, ammonium acetate and diverse aromatic aldehydes under ultrasonic irradiation. All of the 1,2,4,5-tetrasubstituted imidazoles were investigated and checked with m.p., 1H NMR, 13C NMR and FT-IR spectroscopy techniques. The antibacterial properties of the heterocycles were evaluated in vitro by the disk diffusion against pathogenic strains such as Escherichia coli (EC), Bacillus subtillis (BS), Staphylococcus aureus (SA), Salmonellatyphi (ST) and Shigella dysentrae (SD) species. Results: In this research cobalt oxide nanostructure was used as a robust and green catalyst in the some novel imidazoles. The average particle size measured from the FE-SEM image is found to be 20-30 nm which confirmed to the obtained results from XRD pattern. Various electron-donating and electron-withdrawing aryl aldehydes were efficiently reacted in the presence of Co3O4 nanoparticles. The role of the catalyst as a Lewis acid is promoting the reactions with the increase in the electrophilicity of the carbonyl and double band groups. To investigate the reusability of the catalyst, the model study was repeated using recovered cobalt oxide nanoparticles. The results showed that the nanocatalyst could be reused for five times with a minimal loss of its activity. Conclusion: We have developed an efficient and environmentally friendly method for the synthesis of some tetrasubstituted imidazoles via three-component reaction of benzil, primary amines, ammonium acetate and various aldehydes using Co3O4 NPs. The present approach suggests different benefits such as: excellent yields, short reaction times, simple workup procedure and recyclability of the magnetic nanocatalyst. The prepared 1,2,4,5-tetrasubstituted imidazoles revealed high antibacterial activities and can be useful in many biomedical applications.


2019 ◽  
Vol 9 (3) ◽  
pp. 362-370 ◽  
Author(s):  
D. Vaya ◽  
Meena ◽  
B.K. Das

Background: The properties of the material are altered when material size shifted towards nano-regime. This feature could be used for wastewater treatment process using model pollutant such as dyes. Recently, nanoparticles are synthesized by a green chemical route using different capping agents. This is the reason we adopt starch as green capping agent along with sol-gel method. Objective: To synthesize cobalt oxide nanoparticles by green chemical route and utilized it in degradation of dyes. Methods: Synthesis of cobalt oxide nanoparticles by sol-gel method using starch as a capping agent. The characteristics of surface modifications were investigated by UV-VIS, TEM, SEM, XRD and FTIR techniques. Results: Cobalt oxide nanoparticles synthesized and inhibited photocatalytic activity. Conclusion: Deactivation of photocatalytic activity due to complex nature of starch. This property can be used elsewhere as in light shielding applications to coat and protect surfaces in order to keep them cool and safe from damage as in the painting of vehicles, roofs, buildings, water tanks, etc.


2021 ◽  
Author(s):  
R. R. Samal ◽  
Aneeya K. Samantara ◽  
S. Mahalik ◽  
J. N. Behera ◽  
B. Dash ◽  
...  

Correction for ‘An anionic and cationic surfactant-assisted hydrothermal synthesis of cobalt oxide nanoparticles as the active electrode material for supercapacitors’ by R. R. Samal et al., New J. Chem., 2021, 45, 2795–2803; DOI: 10.1039/D0NJ05088A.


Author(s):  
Banzeer Ahsan Abbasi ◽  
Javed Iqbal ◽  
Zaibunisa Khan ◽  
Riaz Ahmad ◽  
Siraj Uddin ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document