A Polarographic study of Pb (П) complexes with Bupropion hydrochloride in 40% ethanol-water mixture

2012 ◽  
Vol 3 (5) ◽  
pp. 43-45
Author(s):  
Sharda Sharda ◽  
◽  
Rajayashree Pandey
Keyword(s):  
Water Mixture ◽  
Polarographic Study

Formation of high temperature phase in flash-evaporated SnSe films

1990 ◽  
Vol 48 (4) ◽  
pp. 698-699
Author(s):  
J.P.S. Hanjra
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Energy Gap ◽  
Dominant Role ◽  
Fine Powder ◽  
High Temperature Phase ◽  
Temperature Phase ◽  
Water Mixture ◽  
Flash Evaporation ◽  
Photovoltaic Applications

Tin mono selenide (SnSe) with an energy gap of about 1 eV is a potential material for photovoltaic applications. Various authors have studied the structure, electronic and photoelectronic properties of thin films of SnSe grown by various deposition techniques. However, for practical photovoltaic junctions the electrical properties of SnSe films need improvement. We have carried out investigations into the properties of flash evaporated SnSe films. In this paper we report our results on the structure, which plays a dominant role on the electrical properties of thin films by TEM, SEM, and electron diffraction (ED).Thin films of SnSe were deposited by flash evaporation of SnSe fine powder prepared from high purity Sn and Se, onto glass, mica and KCl substrates in a vacuum of 2Ø micro Torr. A 15% HF + 2Ø% HNO3 solution was used to detach SnSe film from the glass and mica substrates whereas the film deposited on KCl substrate was floated over an ethanol water mixture by dissolution of KCl. The floating films were picked up on the grids for their EM analysis.

Controlling porosity and density of nanocellulose aerogels for superhydrophobic light materials

TAPPI Journal ◽  
2018 ◽  
Vol 17 (03) ◽  
pp. 145-153 ◽  
Author(s):  
Chengua Yu ◽  
Feng Wang ◽  
Shiyu Fu ◽  
Lucian Lucia
Keyword(s):  
Contact Angle ◽  
Freeze Drying ◽  
Engine Oil ◽  
High Porosity ◽  
Water Mixture ◽  
Waste Engine Oil ◽  
Hydrophobically Modified ◽  
Static Contact ◽  
Oil Water ◽  
Hydrophobic Material

A very low-density oil-absorbing hydrophobic material was fabricated from cellulose nanofiber aerogels–coated silane substances. Nanocellulose aerogels (NCA) superabsorbents were prepared by freeze drying cellulose nanofibril dispersions at 0.2%, 0.5%, 0.8%, 1.0%, and 1.5% w/w. The NCA were hydrophobically modified with methyltrimethoxysilane. The surface morphology and wettability were characterized by scanning electron microscopy and static contact angle. The aerogels displayed an ultralow density (2.0–16.7 mg·cm-3), high porosity (99.9%–98.9%), and superhydrophobicity as evidenced by the contact angle of ~150° that enabled the aerogels to effectively absorb oil from an oil/water mixture. The absorption capacities of hydrophobic nanocellulose aerogels for waste engine oil and olive oil could be up to 140 g·g-1 and 179.1 g·g-1, respectively.

Studies of Acoustic Properties of Substituted Heterocyclic Drugs in Dioxane & Dioxane-Water Mixture At 290C

2011 ◽  
Vol 4 (7) ◽  
pp. 75-78
Author(s):  
Y. K. Meshram Y. K. Meshram ◽  
◽  
K.N.Sonune K.N.Sonune ◽  
Rohinee R Dharamkar
Keyword(s):  
Acoustic Properties ◽  
Water Mixture

Rheological Study of Paraffin-Water Mixture in Horizontal Rectangular Channel

2011 ◽  
Vol 38 (2) ◽  
pp. 93-110
Author(s):  
Mohamed Najib El Boujaddaini ◽  
Philippe Haberschill ◽  
Abdelaziz Mimet
Keyword(s):  
Rectangular Channel ◽  
Water Mixture ◽  
Rheological Study

Heat Transfer Enhancement in Separation Process of Ethanol from Ethanol Water Mixture by Using Surfactants

2020 ◽  
pp. 9-14 ◽  
Author(s):  
Acharya Anil Ramchandra ◽  
R. Kadam ◽  
A. T. Pise
Keyword(s):  
Heat Transfer ◽  
Ammonium Chloride ◽  
Sodium Dodecyl ◽  
Water Mixture ◽  
Transfer Enhancement ◽  
Surface Tension Reduction ◽  
Surface Active Agents ◽  
Surface Active ◽  
Time Required

Here the investigations are done while distillation of ethanol-water mixture for separating ethanol from fermentation process. Focus is to study reduction in time required and hence saving in energy for the distillation process of ethanol-water mixture under the influence of surface-active agents (Surfactants). This novelty is from observation of these surfactants to enhance heat transfer rate because of surface tension reduction in aqueous solutions. SDS (Sodium Dodecyl Sulphate), NH4Cl (Ammonium Chloride) and SLBS (Sodium lauryl benzene sulphonate) surfactants in different concentration are experimented. The concentration of these surfactant is varied from 1700 ppm to 2800 ppm. This range is decided by observing critical micelle concentration of used surfactants. Results showed that time is reduced and hence energy consumption is also reduced. Results shown by NH4Cl are found to be more useful as it is ecofriendly surfactant which is not affecting ethanol-water mixture. Use of ammonium chloride as surfactant in distillation is actually useful to reduce energy without hampering the quality of process is the novelty of this work.

Influence of Pumps on Salinity of a Coastal Aquifer with Legal Protection (A Zone in the North of Isla Cristina, Huelva, Spain)

1991 ◽  
Vol 24 (11) ◽  
pp. 251-260 ◽  
Author(s):  
A. González ◽  
E. Romero
Keyword(s):  
Coastal Aquifer ◽  
Salt Water ◽  
Legal Protection ◽  
Hydraulic Gradient ◽  
Water Mixture ◽  
Residual Flow ◽  
Legal Requirements ◽  
The North ◽  
North Side ◽  
Rational Distribution

In this article we show that the legal measures for protection of aquifers are not enough to lessen the pumping if the users are not associated and determined to have a rational distribution of water. The expansive agriculture on the North side of Isla Cristina (Huelva, Spain), based on citrus and strawberry growing, uses high volumes of groundwater that comes from a tertiary age detritic coastal aquifer with a significant lack of resources. This causes a decrease of the residual flow to the sea, deep pumpcones, and an inversion of the hydraulic gradient, which initiates the progressive salinization of the aquifer northwards, in the sense that the fresh-salt water mixture zone is moving. The problem is worsening because the number of uncontrolled pump-works in the areais increasing. This problem could be alleviated if a Users Community for the whole aquifer were created, itself to watch over the fulfilment of the legal requirements and to regulate the water extractions.

Features of spatial shock-wave flows in vapor-gas-liquid mixtures

2014 ◽  
Vol 10 ◽  
pp. 27-31
Author(s):  
R.Kh. Bolotnova ◽  
U.O. Agisheva ◽  
V.A. Buzina
Keyword(s):  
Shock Wave ◽  
High Pressure ◽  
Shock Waves ◽  
Liquid Mixture ◽  
Liquid Mixtures ◽  
Pressure Vessels ◽  
Water Mixture ◽  
Two Dimensional ◽  
Nonstationary Processes ◽  
Two Phase

The two-phase model of vapor-gas-liquid medium in axisymmetric two-dimensional formulation, taking into account vaporization is constructed. The nonstationary processes of boiling vapor-water mixture outflow from high-pressure vessels as a result of depressurization are studied. The problems of shock waves action on filled by gas-liquid mixture volumes are solved.

Comparison of extraction efficiency of various methods to extract L-DOPA from Mucuna pruriens (L.) DC.

2017 ◽  
Vol 6 (04) ◽  
pp. 5343
Author(s):  
Ragni Vora ◽  
Ambika N. Joshi* ◽  
Nitesh C. Joshi
Keyword(s):  
Extraction Efficiency ◽  
Soxhlet Extraction ◽  
Extraction Methods ◽  
Mucuna Pruriens ◽  
Water Mixture ◽  
Uv Detector ◽  
Pharmacological Activities ◽  
Hplc Mobile Phase ◽  
Plant Sources ◽  
Seed Extracts

Mucuna pruriens seeds are noted to be a natural source of L-DOPA and are also used as a substitute for the synthetic L-DOPA. In the present study; attempts are made to develop suitable method(s) for extraction of L-DOPA from the powdered seeds of Mucuna pruriens using different solvents and conditions. The Seed powder was subjected to 7 different extraction methods and Method 1 was subjected to various solvent concentrations. Some methods used de-fatting procedure, either the method was cold maceration or in high temperature. Soxhlet extraction was also used in one of the extraction methods. All the extracts were analyzed using RP-HPLC. Mobile Phase used was Water: Methanol: AcetoNitrile (100:60:40) (v/v) containing 0.2% Triethylamine, pH = 3.3 and monitored at 280 nm with variable wavelength UV detector. The extraction was best with Methanol Water mixture in a cold maceration technique and overall gives good extraction efficiency of 13.36 % L-DOPA and id the best method giving highest extraction efficiency. The De-fatting method was the 2nd best methods giving approximately 8.8% L-DOPA and Method 5 viz, heat reflux method gives 8.7% L-DOPA making it the 3rd best method. There are not many studies done for optimization of extraction technique for L-DOPA despite an extensive work is reported for isolation, identification and pharmacological activities of L-DOPA from various plant sources. Keeping this in view, present investigation was done to study the extraction efficiency of various extraction methods of L-DOPA content in seed extracts of Mucuna pruriens and compare it.

Sign in / Sign up

Export Citation Format

Share Document