Studies of Nonthermal Effects During Intense Microwave Heating of Crystalline Solids

1992 ◽  
Vol 269 ◽  
Author(s):  
John H. Booske ◽  
Reid F. Cooper ◽  
Leon McCaughan ◽  
Sam Freeman ◽  
Binshen Meng

ABSTRACTReports of enhanced sintering rates associated with microwave heating may be due to nonthermal lattice fluctuation statistics. Recent theoretical analyses reviewed in this paper confirm the feasibility of this phenomenon for a wide variety of situations involving very different microwave absorption mechanisms. For materials with weak microwave absorption coefficients, the effect is expected to be uniformly distributed throughout the volume. For strongly absorbing materials, however, the effect is expected to be concentrated near the material surface, with a characteristic exponential penetration depth of Lnt ∼ 10 - 100 μm. An “observable” nonthermal effect depends on the relative magnitude of the microwave electric field strength |E| and the lattice ion energy relaxation rate γ with the most pronounced effects occurring for larger values of |E| and smaller values of γ.

1960 ◽  
Vol 10 ◽  
pp. 719-720
Author(s):  
A. N. Kazantsev

AbstractOne of the methods used in the treatment of the results obtained during radio observations of Earth satellites consists of determining the radio-wave absorption coefficients by measurements of the electric-field strength at comparable positions.Over the territory of the Soviet Union the Earth satellites sometimes passed below the maximum of the .F2-layer, sometimes above it, and sometimes near it.


2020 ◽  
Vol 20 (4) ◽  
pp. 497-505
Author(s):  
Wenxing Zheng ◽  
Wenyu Zheng ◽  
Xinhou Wang

AbstractCylindrical-electrode-assisted solution blowing spinning (CSBS) is a novel nanofiber preparation method. The electric field of CSBS not only is one of the main innovations of this technology but also plays a key role in the preparation of nanofibers. In this article, the electric field of CSBS and the influences of electric field on the preparation of nanofibers were studied systematically for the first time by simulations, theoretical analyses, and experiments. This paper innovatively established the coaxial capacitor model for studying the CSBS electric field. The effects of electric field on the preparation and morphology of CSBS nanofibers were theoretically investigated by using this model. The theoretical formulas that can express the relationships between the various electric field variables were obtained. The electric field strength distribution, voltage distribution, and the relationships between the electric field parameters of CSBS were obtained by finite element simulations. The simulations’ results show that reducing the diameter of cylinder (DC) or increasing the voltage increase the electric field strength of the jet surface. Experimental results reveal that increasing voltage or reducing DC can reduce the diameter of nanofibers. The experimental and simulation results prove the correctness of the theoretical research conclusions. The theoretical and simulation conclusions of this paper lay a theoretical foundation for further study of CSBS electric field. The experimental conclusions can directly guide the controllable preparation of CSBS nanofibers.


2016 ◽  
Vol 136 (10) ◽  
pp. 1420-1421
Author(s):  
Yusuke Tanaka ◽  
Yuji Nagaoka ◽  
Hyeon-Gu Jeon ◽  
Masaharu Fujii ◽  
Haruo Ihori

2016 ◽  
Vol 50 (2) ◽  
pp. 321-330 ◽  
Author(s):  
Z.-M. Tang ◽  
K.-M. Huang ◽  
Y.-H. Liao ◽  
T. Hong ◽  
H.-C. Zhu

2021 ◽  
Vol 87 (2) ◽  
Author(s):  
Swati Baruah ◽  
U. Sarma ◽  
R. Ganesh

Lane formation dynamics in externally driven pair-ion plasma (PIP) particles is studied in the presence of external magnetic field using Langevin dynamics (LD) simulation. The phase diagram obtained distinguishing the no-lane and lane states is systematically determined from a study of various Coulomb coupling parameter values. A peculiar lane formation-disintegration parameter space is identified; lane formation area extended to a wide range of Coulomb coupling parameter values is observed before disappearing to a mixed phase. The different phases are identified by calculating the order parameter. This and the critical parameters are calculated directly from LD simulation. The critical electric field strength value above which the lanes are formed distinctly is obtained, and it is observed that in the presence of the external magnetic field, the PIP system requires a higher value of the electric field strength to enter into the lane formation state than that in the absence of the magnetic field. We further find out the critical value of electric field frequency beyond which the system exhibits a transition back to the disordered state and this critical frequency is found as an increasing function of the electric field strength in the presence of an external magnetic field. The movement of the lanes is also observed in a direction perpendicular to that of the applied electric and magnetic field directions, which reveals the existence of the electric field drift in the system under study. We also use an oblique force field as the external driving force, both in the presence and absence of the external magnetic field. The application of this oblique force changes the orientation of the lane structures for different applied oblique angle values.


Author(s):  
Dhaval Solanki ◽  
Zeynab Rezaee ◽  
Anirban Dutta ◽  
Uttama Lahiri

Abstract Background Investigation of lobule-specific electric field effects of cerebellar transcranial direct current stimulation (ctDCS) on overground gait performance has not been performed, so this study aimed to investigate the feasibility of two lobule-specific bilateral ctDCS montages to facilitate overground walking in chronic stroke. Methods Ten chronic post-stroke male subjects participated in this repeated-measure single-blind crossover study, where we evaluated the single-session effects of two bilateral ctDCS montages that applied 2 mA via 3.14 cm2 disc electrodes for 15 min targeting (a) dentate nuclei (also, anterior and posterior lobes), and (b) lower-limb representations (lobules VIIb-IX). A two-sided Wilcoxon rank-sum test was performed at a 5% significance level on the percent normalized change measures in the overground gait performance. Partial least squares regression (PLSR) analysis was performed on the quantitative gait parameters as response variables to the mean lobular electric field strength as the predictors. Clinical assessments were performed with the Ten-Meter walk test (TMWT), Timed Up & Go (TUG), and the Berg Balance Scale based on minimal clinically important differences (MCID). Results The ctDCS montage specific effect was found significant using a two-sided Wilcoxon rank-sum test at a 5% significance level for 'Step Time Affected Leg' (p = 0.0257) and '%Stance Time Unaffected Leg' (p = 0.0376). The changes in the quantitative gait parameters were found to be correlated to the mean electric field strength in the lobules based on PLSR analysis (R2 statistic = 0.6574). Here, the mean electric field strength at the cerebellar lobules, Vermis VIIIb, Ipsi-lesional IX, Vermis IX, Ipsi-lesional X, had the most loading and were positively related to the 'Step Time Affected Leg' and '%Stance Time Unaffected Leg,' and negatively related to the '%Swing Time Unaffected Leg,' '%Single Support Time Affected Leg.' Clinical assessments found similar improvement in the TMWT (MCID: 0.10 m/s), TUG (MCID: 8 s), and BBS score (MCID: 12.5 points) for both the ctDCS montages. Conclusion Our feasibility study found an association between the lobular mean electric field strength and the changes in the quantitative gait parameters following a single ctDCS session in chronic stroke. Both the ctDCS montages improved the clinical outcome measures that should be investigated with a larger sample size for clinical validation. Trial registration: Being retrospectively registered.


2019 ◽  
Vol 58 (SC) ◽  
pp. SCCB09 ◽  
Author(s):  
George M. Christian ◽  
Stefan Schulz ◽  
Simon Hammersley ◽  
Menno J. Kappers ◽  
Martin Frentrup ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document