Preparation and Characterization of Sol-Gel Derived Heteroepitaxial LiNbO3 and LiTaO3 Thin Films

1993 ◽  
Vol 310 ◽  
Author(s):  
Keiichi Nashimoto
Keyword(s):  
Thin Films ◽  
Sol Gel ◽  
Metal Alkoxide ◽  
Bulk Single Crystal ◽  
Rocking Curve ◽  
X Ray ◽  
Sapphire Substrates ◽  
Sol Gel Process ◽  
Alkoxide Precursors

AbstractDense epitaxial LiNbO3 thin films without any misoriented plane on sapphire substrates were obtained with a sol-gel process utilizing 2-methoxyethanol based metal alkoxide precursors without pre-hydrolysis and rapid thermal annealing. Epitaxial LiNbO3 films annealed at 700°C were transparent and showed refractive indices close to bulk single crystal values. Epitaxial and transparent LiTaO3 films crystallized successfully on sapphire substrates with single orientations with the present process. X-ray rocking curve full widths at half maximum of epitaxial LiNbO3 and LiTaO3 films on sapphire (110) substrates and annealed at 700°C were less than 0.4 degree.

Preparation and Characterization of Metal Alkoxide Derived Epitaxial Lead Titanate Based Thin Films

1994 ◽  
Vol 361 ◽  
Author(s):  
Keiichi Nashimoto ◽  
Shigetoshi Nakamura
Keyword(s):  
Thin Films ◽  
Lead Titanate ◽  
Solid Phase ◽  
Sol Gel ◽  
Pyrochlore Phase ◽  
Guided Wave ◽  
Metal Alkoxide ◽  
Rocking Curve ◽  
Sol Gel Process

ABSTRACTEpitaxial and highly oriented lead titanate based thin films were prepared by a sol-gel process using non-hydrolyzed methoxyethoxide precursors and RTA process. PbTiO3 crystallized with preferred (001) or (100) orientation on SrTiO3 (100) and MgO (100). Solid phase (001) oriented epitaxial growth of PZT on SrTio3 was observed at 425°C, directly from the amorphous phase. That of PZT on MgO was observed at temperatures above 550°C, after the formation of pyrochlore phase. The PZT on SrTiO3 had a single (001) orientation and rocking curve full width at half maximum less than 0.08°. PZT showed a weak preferred (111) orientation on sapphire (0001) substrates, while highly (111) oriented PLT thin films were obtained on them. The guided wave modes were excited by a prism coupling for PZT thin films crystallized on SrTiO3 and MgO. Electrical properties of epitaxial PZT and PLT thin films on Nb-SrTiO3 substrates were characterized.

Sol-gel derived Ba(Mg1/3Ta2/3)O3 thin films: Preparation and structure

1997 ◽  
Vol 12 (3) ◽  
pp. 596-599 ◽  
Author(s):  
Ji Zhou ◽  
Qing-Xin Su ◽  
K. M. Moulding ◽  
D. J. Barber
Keyword(s):  
Thin Films ◽  
Annealing Temperature ◽  
Volume Fraction ◽  
Sol Gel ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Sol Gel Process ◽  
Small Grains

Ba(Mg1/3Ta2/3)O3 thin films were prepared by a sol-gel process involving the reaction of barium isopropoxide, tantalum ethoxide, and magnesium acetate in 2-methoxyethanol and subsequently hydrolysis, spin-coating, and heat treatment. Transmission electron microscopy, x-ray diffraction, and Raman spectroscopy were used for the characterization of the thin films. It was shown that the thin films tend to crystallize with small grains sized below 100 nm. Crystalline phase with cubic (disordered) perovskite structure was formed in the samples annealed at a very low temperature (below 500 °C), and well-crystallized thin films were obtained at 700 °C. Although disordered perovskite is dominant in the thin films annealed below 1000 °C, a low volume fraction of 1 : 2 ordering domains was found in the samples and grows with an increase of annealing temperature.

Characterization of Sol-Gel Derived (Pb,Ba)(Zr,Ti,Nb)O3 Thin Films for Optical Waveguide Development

1994 ◽  
Vol 343 ◽  
Author(s):  
P. F. Baude ◽  
J. S. Wright ◽  
C. Ye ◽  
L. F. Francis ◽  
D. L. Polla
Keyword(s):  
Thin Films ◽  
Sol Gel ◽  
Silicon Substrates ◽  
X Ray Diffraction ◽  
X Ray ◽  
Sapphire Substrates ◽  
Solution Preparation ◽  
Transmission Measurements ◽  
Gel Technique

ABSTRACT(PbBa)(ZrTiNb)03 thin films and powders have been prepared using the sol-gel technique. Solutions were synthesized in 2-methoxyethanol based upon our previous PZT solution preparation. Three different approaches were used for incorporating barium into PZT alkoxide solutions. Thermal analysis and x-ray diffraction results indicated that barium methoxypropoxide gave the best results. PBZTN (71% Pb and 71% Zr) was deposited onto sapphire substrates as well as oxidized silicon substrates. Optical transmission measurements showed greater than 80% transmission for wavelengths longer than 400 nm. Films with thickness of 3000 Å on sapphire exhibited a refractive index of 2.19 at λ=633 nm.

Effect of Annealing temperature on the Structural and Magnetic Properties of TbxY3-xFe5O12(x = 0.0, 1.0, 2.0) Thin Films Prepared by Sol-Gel Process

2012 ◽  
Vol 501 ◽  
pp. 236-241 ◽  
Author(s):  
Ftema W. Aldbea ◽  
Noor Bahyah Ibrahim ◽  
Mustafa Hj. Abdullah ◽  
Ramadan E. Shaiboub
Keyword(s):  
Thin Films ◽  
Magnetic Properties ◽  
Room Temperature ◽  
Annealing Temperature ◽  
Sol Gel ◽  
Vibrating Sample Magnetometer ◽  
X Ray ◽  
Garnet Phase ◽  
Sol Gel Process ◽  
Amorphous Structures

Thin films nanoparticles TbxY3-xFe5O12 (x=0.0, 1.0, 2.0) were prepared by the sol-gel process followed by annealing process at various annealing temperatures of 700° C, 800° C and 900° C in air for 2 h. The results obtained from X-ray diffractometer (XRD) show that the films annealed below 900°C exhibit peaks of garnet mixed with small amounts of YFeO3 and Fe2O3. Pure garnet phase has been detected in the films annealed at 900°C. Before annealing the films show amorphous structures. The particles sizes measurement using the field emission scanning electron microscope (FE-SEM) showed that the particles sizes increased as the annealing temperature increased. The magnetic properties were measured at room temperature using the vibrating sample magnetometer (VSM). The saturation magnetization (Ms) of the films also increased with the annealing temperature. However, different behavior of coercivity (Hc) has been observed as the annealing temperature was increased.

Sol-Gel derived Bi4-xNdxTi3O12 Thin Films and Their Characterization

2002 ◽  
Vol 737 ◽  
Author(s):  
R.E. Melgarejo ◽  
M.S. Tomar ◽  
A. Hidalgo ◽  
R.S. Katiyar
Keyword(s):  
Thin Films ◽  
Spin Coating ◽  
Bismuth Titanate ◽  
Sol Gel ◽  
X Ray Diffraction ◽  
X Ray ◽  
Complete Solid Solution ◽  
Sol Gel Process ◽  
Ferroelectric Memory ◽  
Initial Results

ABSTRACTNd substituted bismuth titanate Bi4-xNdxTi3O12 were synthesized by sol-gel process and thin films were deposited on Pt substrate (Pt/TiO2/SiO2/Si) by spin coating. Thin films, characterized by X-ray diffraction and Raman spectroscopy, shows complete solid solution up to the composition x < 1. Initial results indicate that the ferroelectric polarization increases with increasing Nd content in the film with 2Pr = 50μC/cm2 for x = 0.46, which may have application in non-volatile ferroelectric memory devices.

Synthesis and Characterizations of Strontium Substituted Hydroxyapatite Thin Films

2010 ◽  
Vol 93-94 ◽  
pp. 231-234
Author(s):  
B. Hongthong ◽  
Satreerat K. Hodak ◽  
Sukkaneste Tungasmita
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Chemical Composition ◽  
Spin Coating ◽  
Phase Structure ◽  
Sol Gel ◽  
Cross Linking ◽  
X Ray Diffraction ◽  
X Ray ◽  
Sol Gel Process

Strontium substituted hydroxyapatite(SrHAp) were fabricated both in the form of powder as reference and thin film by using inorganic precursor reaction. The sol-gel process has been used for the deposition of SrHAp layer on stainless steal 316L substrate by spin coating technique, after that the films were annealed in air at various temperatures. The chemical composition of SrHAp is represented (SrxCa1-x)5(PO4)3OH, where x is equal to 0, 0.5 and 1.0. Investigations of the phase structure of SrHAp were carried out by using X-ray diffraction technique (XRD). The results showed that strontium is incorporated into hydroxyapatite where its substitution for calcium increases in the lattice parameters, and Sr3(PO4)2 can be detected at 900°C. The SEM micrographs showed that SrHAp films exhibited porous structure before develop to a cross-linking structure.

Microstructural Evolution of Epitaxial LiNbO3 Thin Films Derived From Metal Alkoxide Solutions

1990 ◽  
Vol 202 ◽  
Author(s):  
Keiichi Nashimoto ◽  
Michael J. Cima ◽  
Wendell E. Rhine
Keyword(s):  
Thin Films ◽  
Grain Growth ◽  
Single Phase ◽  
Sol Gel ◽  
Precursor Solution ◽  
Epitaxial Films ◽  
Metal Alkoxide ◽  
High Annealing Temperature ◽  
Sapphire Substrates ◽  
High Annealing

ABSTRACTThe evolution of the microstructure of sol-gel derived LiNbO3 thin films was investigated to understand the growth of epitaxial films. LiNbO3 films were prepared from a precursor solution of lithium ethoxide and niobium pentaethoxide. Prehydrolysis promoted the development of polycrys-talline LiNbO3 films, whereas nonhydrolysis produced solid-state epitaxial growth of LiNbO3 films on sapphire substrates. Although the films looked smooth after annealing at 400°C, the morphology of the films changed, depending on substrates and precursors, due to grain growth at high annealing temperature. Prehydrolysis of the alkoxides caused a decrease in the temperature at which grain growth occurred, whereas the film prepared from the nonhydrolyzed precursor on a sapphire substrate showed denser texture and contained abnormally large domains that appeared to be single phase.

scholarly journals Sol-Gel Template Synthesis and Characterization of Lu2O3:Eu3+ Nanowire Arrays

Micromachines ◽  
2018 ◽  
Vol 9 (11) ◽  
pp. 601
Author(s):  
Yahua Hu ◽  
Mu Gu ◽  
Xiaolin Liu ◽  
Juannan Zhang ◽  
Shiming Huang ◽  
...  
Keyword(s):  
Sol Gel ◽  
Nanowire Arrays ◽  
X Ray Diffraction ◽  
Aao Template ◽  
X Ray ◽  
Selected Area Electron Diffraction ◽  
Sol Gel Process ◽  
Optical Luminescence ◽  
Uniform Diameter

Uniform Lu2O3:Eu3+ nanowire arrays were successfully prepared by the sol-gel process using anodic aluminum oxide (AAO) templates. The as-synthesized nanowires are homogeneous, highly ordered, and dense and have a uniform diameter of ~300 nm defined by the AAO templates. The X-ray diffraction and selected area electron diffraction results show that the Lu2O3:Eu3+ nanowires have a polycrystalline cubic structure, and the crystallite size of the Lu2O3:Eu3+ nanowires is confined by the AAO template. The nanowires within the AAO template showed good photoluminescence and X-ray-excited optical luminescence performances for Lu2O3:Eu3+. The emission peaks were attributed to the 5D0 → 7FJ transitions of Eu3+ (J = 0, 1, 2, 3).

Sign in / Sign up

Export Citation Format

Share Document