Improved Aluminum Nitride Thin Films Grown By Mocvd From Tritertiarybutylaluminum And Ammonia

1996 ◽  
Vol 423 ◽  
Author(s):  
T. Metzger ◽  
E. Born ◽  
R. Stimmer ◽  
W. Rieger ◽  
R. Dimitrov ◽  
...  

AbstractAIN thin films were grown on c-plane sapphire by metalorganic chemical vapor deposition from tritertiarybutylaluminum and ammonia at 1050°C. These films exhibit a full width at half maximum of the 002 X-ray rocking curve below 200 arcsec indicating high epitaxial quality. By measuring asymmetric reflections, a structural disorder of the lattice mainly due to edge dislocations can be observed. For further investigations, atomic force microscopy and photothermal deflection spectroscopy were performed. In order to study the effect of increasing AIN layer thickness on the optical and structural properties of GaN in an AIN/GaN heterostructure, AIN thin films with increasing thickness ranging from 0.02 to 0.36 μm were used as sublayers for the deposition of 0.75 μm thick GaN layers. Photoluminescence, micro- Raman and X-ray diffraction measurements confirm the relaxation of biaxial compressive stress in the GaN layers due to different thermal expansion coefficients by increasing AIN layer thickness. The pressure dependence of the band gap shift was determined as 24 meV/GPa for biaxial compressive stress. Our results indicate that the growth of AIN with metal organic chemical vapor deposition from tritertiarybutylaluminum and ammonia is a promising method for obtaining high quality epitaxial films.

2005 ◽  
Vol 902 ◽  
Author(s):  
Serhiy Matichyn ◽  
Marco Lisker ◽  
Edmund P. Burte

AbstractIn this study lead zirkonat titanate (PZT) thin films were deposited using direct liquid injection metal organic chemical vapor deposition (DLI-MOCVD).The chemical states and the stoichiometry of PZT-films were characterized using X-ray photoelectron spectroscopy (XPS). The crystal structure of the films was investigated by X-ray diffraction (XRD).The surface composition of the films was Pb : Zr : Ti = 1.05 : 0.52 : 0.48, which indicates that the deposited films had a stoichiometric PZT composition. 130 nm thick PZT films deposited on Ir showed <110> preferred orientation.The main role for formation of the perovsktive PZT films plays the content of the lead in the deposited films. Lead deficiency causes the formation of the pyrochlore phase with poor electrical properties. In films with a significant excess of lead a second PbO phase appeared that can be observed even with naked eyes. Negligible excess of lead can be reduced by post-deposition annealing at 500-600 °C.The Ir/PZT/Ir capacitor showed large values of the remanent polarisation of about 60μC/cm2 at an applied voltage of 3 V. So high value of the remanent polarisation can be induced by structural stress in the films. After ten switch impulses the values of the remanent polarisation have significantly decreased. This is probably due to a relaxation of crystal cells.


1993 ◽  
Vol 335 ◽  
Author(s):  
Bruce J. Hinds ◽  
Jon L. Schindler ◽  
Bin Han ◽  
Deborah A. Neumayer ◽  
Donald C. Degroot ◽  
...  

AbstractSuperconducting thin films of Tl2Ba2Ca2Cu3O10−x (TL-2223) have been grown on single crystal (110) LaAlO3 using a two-step process. Ba2Ca2Cu3Ox precursor films are deposited via metal-organic chemical vapor deposition (MOCVD) in a horizontal hot walled reactor. The second generation precursors Ba(hfa)2•tet, Ca(hfa)2•tet, and Cu(hfa)2 (hfa = hexafluoroacetylacetonate, tet = tetraglyme) were used as volatile metal sources due to their superior volatility and stability. Tl was introduced into the film via a high temperature post anneal in the presence of a Tl2O3:BaO:CaO:CuO pellet (1:2:2:3 ratio). Low O2 partial pressures were used to reduce the temperature in which the TI-2223 phase forms and to improve the surface morphology associated with a liquid phase intermediate. Films are highly oriented with the c-axis perpendicular to the substrate and a-b axis epitaxy is seen from x-ray φ- scans. The best films have a resistively measured Tc of 115K and a magnetically derived Jc of 6×105 A/cm2 (77K, 0 T). Preliminary surface resistance measurements, using parallel plate techniques, give Rs = 0.35 mΩ at 5K (ω = 10 GHz).


1992 ◽  
Vol 275 ◽  
Author(s):  
D. L. Schulzi ◽  
B. Hano ◽  
D. Neumayer ◽  
B. J. Hinds ◽  
T. J. Markst ◽  
...  

ABSTRACTThe synthesis of superconducting Tl-Ba-Ca-Cu-O thin films on metal foils (Au and Ag) by metal-organic chemical vapor deposition (MOCVD) has been investigated. Ba-Ca-Cu-O-(F) films are first prepared via MOCVD using fluorinated “second generation” metal-organic precursors. After an intermediate anneal with water vapor-saturated oxygen to promote removal of F, Tl is introduced by annealing in the presence of a mixture of oxides (Tl2O3, BaO, CaO, CuO) of a specific composition. Characterization of the thin films by scanning electron microscopy, EDX, x-ray diffraction, and variable temperature magnetization measurements has been carried out. High temperature superconductor (HTS) films of Tl2Ba2Ca1Cu2O8−x on Au foil exhibit a magnetically derived Tc = 80K and a high degree of texturing with the crystallite c-axes oriented perpendicular to the substrate surface as evidenced by enhanced (000 x-ray diffraction reflections. Thin film coverage on Ag foil becomes non-contiguous during the (Tl2O3, BaO, CaO, CuO) mixture anneal.


2007 ◽  
Vol 515 (5) ◽  
pp. 2921-2925 ◽  
Author(s):  
Chunyu Wang ◽  
Volker Cimalla ◽  
Genady Cherkashinin ◽  
Henry Romanus ◽  
Majdeddin Ali ◽  
...  

2003 ◽  
Vol 42 (Part 1, No. 5A) ◽  
pp. 2839-2842 ◽  
Author(s):  
Jeong Hoon Park ◽  
Kug Sun Hong ◽  
Woon Jo Cho ◽  
Jang-Hoon Chung

1994 ◽  
Vol 361 ◽  
Author(s):  
D.L. Kaiser ◽  
M.D. Vaudin ◽  
L.D. Rotter ◽  
Z.L. Wang ◽  
J.P. Cline ◽  
...  

ABSTRACTMetalorganic chemical vapor deposition (MOCVD) was used to deposit epitaxial BaTiO3 thin films on (100) MgO substrates at 600°C. The metalorganic precursors employed in the deposition experiments were hydrated Ba(thd)2 (thd = C11H19O2) and titanium isopropoxide. The films were analyzed by means of transmittance spectroscopy, wavelength dispersive x-ray spectrometry, secondary ion mass spectrometry depth profiling, x-ray diffraction, high resolution transmission electron microscopy, selected area electron diffraction, nanoscale energy dispersive x-ray spectrometry and second harmonic generation measurements. There was no evidence for interdiffusion between the film and substrate. The x-ray and electron diffraction studies showed that the films were oriented with the a-axis normal to the substrate surface, whereas second harmonic generation measurements showed that the films had some c-axis character.


Sign in / Sign up

Export Citation Format

Share Document