Performance of CuGaSe2 Solar Cells Grown By Co-Evaporation Process

2005 ◽  
Vol 865 ◽  
Author(s):  
Jae Ho Yun ◽  
R.B.V. Chalapathy ◽  
Seok Ki Kim ◽  
Jeong Chul Lee ◽  
Jinsoo Song ◽  
...  
Keyword(s):  
Secondary Phase ◽  
Soda Lime ◽  
Soda Lime Glass ◽  
Optimal Conditions ◽  
The Third ◽  
Third Stage ◽  
A Cell ◽  
In The Beginning ◽  
Enhanced Surface ◽  
Resultant Film

AbstractCuGaSe2 absorber layers were prepared by evaporating elemental Cu, Ga and Se in three stage on Molybdenum coated soda lime glass. The composition of the resultant film was studied by monitoring the substrate temperature, which decreased when a Cu-Se secondary phase was formed. As the Ga supplement increased during the third stage the void that formed in the beginning of the third stage was removed, while a small grain Ga-rich layer was formed on the surface, resulting in a Cu deficient surface. Therefore, the Voc was improved because of the enhanced surface morphology and the Jsc was reduced, due to the Ga rich layer on of the surface. Under optimal conditions, we achieved a cell performance of Voc = 780 mV, Jsc = 12.9 mA/cm2, ff = 62.5 and ν = 7.3 %.

Low Temperature Growth of CIGS Thin Films for Flexible Solar Cells

2001 ◽  
Vol 668 ◽  
Author(s):  
D. Rudmann ◽  
F.-J. Haug ◽  
M. Kaelin ◽  
H. Zogg ◽  
A.N. Tiwari ◽  
...  
Keyword(s):  
Solar Cells ◽  
Soda Lime ◽  
Film Deposition ◽  
Soda Lime Glass ◽  
Temperature Growth ◽  
Polymer Substrates ◽  
Cell Efficiency ◽  
A Cell ◽  
Lift Off ◽  
Substrate Temperatures

ABSTRACTLow substrate temperatures have to be used for polymer substrates. Therefore, using soda- lime glass (SLG) substrates with and without an alkali barrier (Al2O3), a three-step CIGS coevaporation process for a substrate temperature of 450 °C has been developed and compared to film deposition with constant evaporation rates. The three-step process was found to enhance grain nucleation. An efficiency of 14.0 % has been achieved with this process for solar cells on SLG. Since polymers in general do not contain Na, a way of Na addition to the absorber is needed. It is shown that NaF coevaporation can be used to control the Na content in CIGS. Also incorporation of Na in CIGS by diffusion from a NaCl layer through a polyimide is demonstrated. With such SLG/NaCl/polyimide structures flexible solar cells can be obtained using a lift-off process. A cell efficiency of 11.6 % (0.99 cm2 area) has been achieved.

Optimal conditions and significant factors for fabrication of soda lime glass foam from industrial waste using nano AlN

2018 ◽  
Vol 747 ◽  
pp. 408-415 ◽  
Author(s):  
Emad Mohamed M. Ewais ◽  
Mohammed A.A. Attia ◽  
Ahmed A.M. El-Amir ◽  
Ahmed M.H. Elshenway ◽  
Thomas Fend
Keyword(s):  
Industrial Waste ◽  
Soda Lime ◽  
Soda Lime Glass ◽  
Optimal Conditions ◽  
Glass Foam ◽  
Significant Factors

The Coherence of Mary Barton: Romance, Realism, and Utopia

2015 ◽  
Vol 5 (3) ◽  
pp. 185-200
Author(s):  
Robert Z. Birdwell
Keyword(s):  
Thomas Carlyle ◽  
The Novel ◽  
Second Stage ◽  
The Third ◽  
Third Stage ◽  
Three Stages ◽  
Mode Of Production

Critics have argued that Elizabeth Gaskell's first novel, Mary Barton (1848), is split by a conflict between the modes of realism and romance. But the conflict does not render the novel incoherent, because Gaskell surpasses both modes through a utopian narrative that breaks with the conflict of form and gives coherence to the whole novel. Gaskell not only depicts what Thomas Carlyle called the ‘Condition of England’ in her work but also develops, through three stages, the utopia that will redeem this condition. The first stage is romantic nostalgia, a backward glance at Eden from the countryside surrounding Manchester. The second stage occurs in Manchester, as Gaskell mixes romance with a realistic mode, tracing a utopian drive toward death. The third stage is the utopian break with romantic and realistic accounts of the Condition of England and with the inadequate preceding conceptions of utopia. This third stage transforms narrative modes and figures a new mode of production.

Bankruptcy Model Construction and its Limitation in Input Data Quality

2019 ◽  
Vol 10 (2) ◽  
pp. 117-125
Author(s):  
Dana Kubíčková ◽  
◽  
Vladimír Nulíček ◽  
Keyword(s):  
Data Quality ◽  
Normal Distribution ◽  
Input Data ◽  
Model Construction ◽  
The Third ◽  
Third Stage ◽  
Discriminant Analyses ◽  
One Year ◽  
The University ◽  
Multivariate Discriminant

The aim of the research project solved at the University of Finance and administration is to construct a new bankruptcy model. The intention is to use data of the firms that have to cease their activities due to bankruptcy. The most common method for bankruptcy model construction is multivariate discriminant analyses (MDA). It allows to derive the indicators most sensitive to the future companies’ failure as a parts of the bankruptcy model. One of the assumptions for using the MDA method and reassuring the reliable results is the normal distribution and independence of the input data. The results of verification of this assumption as the third stage of the project are presented in this article. We have revealed that this assumption is met only in a few selected indicators. Better results were achieved in the indicators in the set of prosperous companies and one year prior the failure. The selected indicators intended for the bankruptcy model construction thus cannot be considered as suitable for using the MDA method.

How well do voice-hearing assessment measures capture the positive experiences of individuals?

2019 ◽  
Author(s):  
Lucy Armstrong ◽  
Lorna Hogg ◽  
Pamela Charlotte Jacobsen
Keyword(s):  
Systematic Review ◽  
Lived Experience ◽  
Second Stage ◽  
The Third ◽  
Third Stage ◽  
Hearing Assessment ◽  
Positive Experiences ◽  
Assessment Measures ◽  
Stage 1 ◽  
The Voice

The first stage of this project aims to identify assessment measures which include items on voice-hearing by way of a systematic review. The second stage is the development of a brief framework of categories of positive experiences of voice hearing, using a triangulated approach, drawing on views from both professionals and people with lived experience. The third stage will involve using the framework to identify any positve aspects of voice-hearing included in the voice hearing assessments identified in stage 1.

Highly efficient biocide silver-doped soda lime glass for application in water quality optical sensors

2020 ◽  
Vol 111 (10) ◽  
pp. 857-862
Author(s):  
Branimir Bajac ◽  
Jovana Stanojev ◽  
Slobodan Birgermajer ◽  
Milena Radojevic ◽  
Jovan Matovic
Keyword(s):  
Water Quality ◽  
Optical Sensors ◽  
Soda Lime ◽  
Soda Lime Glass ◽  
Highly Efficient

Pèlerinages barrésiens

2013 ◽  
pp. 116-123
Author(s):  
Claire Bompaire-Evesque
Keyword(s):  
Large Scale ◽  
The Self ◽  
Joan Of Arc ◽  
The Third ◽  
National Importance ◽  
The Earth ◽  
Third Stage ◽  
The Dead

This article is a inquiry about how Barrès (1862-1923) handles the religious rite of pilgrimage. Barrès stages in his writings three successive forms of pilgrimage, revealing what is sacred to him at different times. The pilgrimage to a museum or to the birthplace of an artist is typical for the egotism and the humanism of the young Barrès, expressed in the Cult of the Self (1888-1891). After his conversion to nationalism, Barrès tries to unite the sons of France and to instill in them a solemn reverence for “the earth and the dead” ; for that purpose he encourages in French Amities (1903) pilgrimages to historical places of national importance (battlefields; birthplace of Joan of Arc), building what Nora later called the Realms of Memory. The third stage of Barrès’ intellectual evolution is exemplified by The Sacred Hill (1913). In this book the writer celebrates the places where “the Spirit blows”, and proves open to a large scale of spiritual forces, reaching back to paganism and forward to integrative syncretism, which aims at unifying “the entire realm of the sacred”.

Sign in / Sign up

Export Citation Format

Share Document