scholarly journals Viability of using enamel and dentin from bovine origin as a substitute for human counterparts in an intraoral erosion model

2010 ◽  
Vol 21 (4) ◽  
pp. 332-336 ◽  
Author(s):  
Cecilia Pedroso Turssi ◽  
Danielle Furtado Messias ◽  
Silmara Milori Corona ◽  
Mônica Campos Serra
Keyword(s):  
Mineral Water ◽  
Real Life ◽  
Dental Erosion ◽  
Human Enamel ◽  
Erosion Models ◽  
Human Counterpart ◽  
Real Life Situation ◽  
Root Dentin ◽  
Bovine Enamel

This study ascertained whether under dental erosion models that closely mimics the real-life situation enamel and root dentin from bovine origin would be reliable substitutes for human counterparts. Through a 2x2 crossover design, in a first trial, 14 volunteers wore a palatal device containing slabs of bovine and human enamel. Half of the participants ingested (4x daily, for 10 days) orange juice first, crossing over to mineral water, while the remainder received the reverse sequence. In a second trial, volunteers wore devices with slabs of bovine and human root dentin. Except for the duration of each intraoral phase, which lasted 2 rather 10 days, the experiment with root dentin run exactly as for enamel. Dental substrates were analyzed for surface microhardness. Two-way ANOVAs (α=0.05) indicated no difference between the microhardness values recorded for human and bovine enamel (p=0.1350), but bovine root dentin had lower microhardness compared to its human counterpart (p=0.0432). While bovine enamel can reliably substitute its human counterpart in in situ dental erosion models, bovine root dentin does not seem to be a viable alternative to the corresponding human tissue.

The Effect of Lesion Characteristic on Remineralization and Model Sensitivity

1992 ◽  
Vol 71 (3_suppl) ◽  
pp. 811-813 ◽  
Author(s):  
F. Schäfer ◽  
S.J. Raven ◽  
T.A. Parr
Keyword(s):  
Real Life ◽  
High Sensitivity ◽  
Lesion Size ◽  
Experimental Conditions ◽  
Treatment Groups ◽  
Human Enamel ◽  
Enamel Sample ◽  
Two Factors ◽  
Treatment Bias

A major criterion for assessing the value of any experimental model in scientific research is the degree of correspondence between its results and data from the real-life process it is designed to model. Intra-oral models aimed at predicting the anti-caries efficacy of toothpastes or other topical treatments should therefore be calibrated against treatments proven to be effective in a caries clinical trial. For this to be achieved, it is necessary that a model with high sensitivity be designed, while at the same time retaining relevance to the process to be modeled. This means that the effects of the various experimental conditions and parameters of the model on its performance must be understood. The purpose of this paper was to assess the influence of two specific factors on the performance of an in situ enamel remineralization model, which is based on human enamel slabs attached to partial dentures. The two factors are initial lesion severity and origin of enamel sample. The results indicated that initial lesion size affected whether net remineralization or net demineralization occurred during in situ treatment. Samples with an initial range of from 1500 to 2500 (ΔZ) tended more toward demineralization than did samples with ΔZ > 3500. This means that treatment groups must be well-balanced with respect to initial lesion size. Differences in initial demineralization severity between different tooth locations must also be considered so that systematic treatment bias can be avoided. The solution used in the model discussed here is based on a balanced experimental design, which allows this effect to be taken into account in the data analysis.

Hard-tissue Substrates for Evaluation of Cariogenic and Anti-cariogenic Activity in situ

1992 ◽  
Vol 71 (3_suppl) ◽  
pp. 913-919 ◽  
Author(s):  
J.R. Mellberg
Keyword(s):  
Root Surface ◽  
Hard Tissue ◽  
Suitable Alternative ◽  
Human Enamel ◽  
Human Dentin ◽  
Bovine Enamel ◽  
Root Surface Caries

Hard-tissue substrates include primarily human and bovine enamel and human dentin. They have been used for in situ studies in a natural or sound condition, as well as flattened or containing an in vitro-formed caries-like lesion. Human enamel and dentin are generally the substrates of choice for studies of coronal and root-surface caries, respectively, but bovine enamel appears to offer a suitable alternative for many studies of enamel caries. Substrates with caries-like lesions will respond more rapidly to changes in the intra-oral mineral equilibrium and will allow both demineralization and remineralization to be determined. Findings from some studies suggest that caries-like lesions may respond somewhat differently, depending upon the degree of mineralization of the surface layer. Because in vitro findings with dentin show it to be significantly more soluble in acid than enamel, results from a study that used dentin may not be directly applicable to enamel. Both enamel and dentin substrates can be used in thin-section models. Hard-tissue substrates can also differ, depending upon their intra-oral location. Locations that result in the accumulation of plaque will behave differently from those that are plaque-free. So that plaque would accumulate, substrates have been placed approximally, beneath a fabric or steel mesh, in a protected trough, beneath a metal band or within a depression on the buccal surface. For studies requiring a determination of both demineralization and remineralization, human enamel or dentin containing a surface-softened caries-like lesion and covered with a uniform natural plaque are the substrates of choice.

Resin-Based Materials Protect Against Erosion/Abrasion—a Prolonged In Situ Study

2019 ◽  
Vol 44 (3) ◽  
pp. 302-311
Author(s):  
D Rios ◽  
GC Oliveira ◽  
CR Zampieri ◽  
MC Jordão ◽  
EJ Dionisio ◽  
...  
Keyword(s):  
Dental Erosion ◽  
Additional Treatment ◽  
The Other ◽  
Control Group ◽  
Material Loss ◽  
In Situ Study ◽  
Phase Study ◽  
And Control ◽  
Bovine Enamel

SUMMARY While patient compliance is key to preventive measures related to dental erosion, the application of resin-based materials could serve as an additional treatment to inhibit erosion progression. This in situ study evaluated the effect of applying resin-based materials, including resin infiltrant, on previously eroded enamel subjected to prolonged erosive and abrasive challenges. The factors under study were types of treatment (infiltrant [Icon], sealant [Helioseal Clear], adhesive [Adper Scotchbond Multi-Purpose Plus], and control [no treatment]); wear conditions (erosion [ERO] and erosion + abrasion [ERO + ABR]) and challenge time (5 and 20 days) in a single-phase study. The blocks were prepared from bovine enamel, eroded (0.01 M HCl, pH 2.3 for 30 seconds) and randomized among treatments, wear conditions, and volunteers. The application of resin-based materials followed the manufacturers' recommendations. Twenty-one volunteers wore the palatal intraoral device, in which one row corresponded to ERO and the other to ERO + ABR. In each row, all treatments were represented (2 blocks per treatment). For 20 days, the erosive challenge was performed 4 times/day (immersion in 0.01 M HCl, pH 2.3, for 2 minutes) for the ERO condition. For the ERO + ABR condition, two of the erosive challenges were followed by abrasion for 15 seconds with fluoride dentifrice slurry. Enamel and/or material loss was measured using profilometry (initial, after treatment, and after the end of the fifth and 20th days of in situ erosive challenge) and analyzed by ANOVA models and Tukey's test (α=0.05). The results showed that the application of resin-based materials did not cause superficial enamel loss. The infiltrant group showed a thicker layer of material above the enamel compared with the other materials (p=0.001). After the erosive challenge, there was no difference between the conditions ERO and ERO + ABR (p=0.869). All materials protected the enamel against erosion progression compared with the control group (p=0.001). Based on these results, we conclude that the application of resin-based materials results in protection of previously eroded enamel subjected to in situ erosive and abrasive challenge for 20 days.

Real-life Field Studies of the NOx Removing Properties of Photocatalytic Surfaces in Roskilde and Copenhagen Airport, Denmark

2020 ◽  
Vol 01 ◽  
Author(s):  
Henrik Jensen ◽  
Pernille D. Pedersen
Keyword(s):  
Air Quality ◽  
High Stability ◽  
Reference Site ◽  
Real Life ◽  
Field Studies ◽  
The Real ◽  
Before And After ◽  
Parking Lot ◽  
Photocatalytic Concrete

Aims: To evaluate the real-life effect of photocatalytic surfaces on the air quality at two test-sites in Denmark. Background: Poor air quality is today one of the largest environmental issues, due to the adverse effects on human health associated with high levels of air pollution, including respiratory issues, cardiovascular disease (CVD), and lung cancer. NOx removal by TiO2 based photocatalysis is a tool to improve air quality locally in areas where people are exposed. Methods: Two test sites were constructed in Roskilde and Copenhage airport. In Roskilde, the existing asphalt at two parking lots was treated with TiO2 containing liquid and an in-situ ISO 22197-1 test setup was developed to enable in-situ evaluation of the activity of the asphalt. In CPH airport, photocatalytic concrete tiles were installed at the "kiss and fly" parking lot, and NOx levels were continuously monitored in 0.5 m by CLD at the active site and a comparable reference site before and after installation for a period of 2 years. Results: The Roskilde showed high stability of the photocatalytic coating with the activity being largely unchanged over a period of 2 years. The CPH airport study showed that the average NOx levels were decreased by 12 % comparing the before and after NOx concentrations at the active and reference site. Conclusion: The joined results of the two Danish demonstration projects illustrate a high stability of the photocatalytic coating as well as a high potential for improvements of the real-life air quality in polluted areas.

scholarly journals Chlorosulfuric acid-assisted production of functional 2D materials

2021 ◽  
Vol 5 (1) ◽  
Author(s):  
Mohsen Moazzami Gudarzi ◽  
Maryana Asaad ◽  
Boyang Mao ◽  
Gergo Pinter ◽  
Jianqiang Guo ◽  
...  
Keyword(s):  
Hexagonal Boron Nitride ◽  
2D Materials ◽  
Real Life ◽  
Large Area ◽  
Polar Solvents ◽  
Aspect Ratios ◽  
Two Dimensional Materials ◽  
Liquid Phase Exfoliation

AbstractThe use of two-dimensional materials in bulk functional applications requires the ability to fabricate defect-free 2D sheets with large aspect ratios. Despite huge research efforts, current bulk exfoliation methods require a compromise between the quality of the final flakes and their lateral size, restricting the effectiveness of the product. In this work, we describe an intercalation-assisted exfoliation route, which allows the production of high-quality graphene, hexagonal boron nitride, and molybdenum disulfide 2D sheets with average aspect ratios 30 times larger than that obtained via conventional liquid-phase exfoliation. The combination of chlorosulfuric acid intercalation with in situ pyrene sulfonate functionalisation produces a suspension of thin large-area flakes, which are stable in various polar solvents. The described method is simple and requires no special laboratory conditions. We demonstrate that these suspensions can be used for fabrication of laminates and coatings with electrical properties suitable for a number of real-life applications.

Treadmill Walking in Old Age May Not Reproduce the Real Life Situation

1993 ◽  
Vol 41 (1) ◽  
pp. 15-18 ◽  
Author(s):  
Carolyn Greig ◽  
Felicity Butler ◽  
Dawn Skelton ◽  
Siti Mahmud ◽  
Archie Young
Keyword(s):  
Old Age ◽  
Real Life ◽  
Treadmill Walking ◽  
Life Situation ◽  
The Real ◽  
Real Life Situation

scholarly journals Waterpipe effects on pulmonary function and cardiovascular indices: a comparison to cigarette smoking in real life situation

2014 ◽  
Vol 26 (10) ◽  
pp. 620-627 ◽  
Author(s):  
Nelly Layoun ◽  
Nadine Saleh ◽  
Bernadette Barbour ◽  
Sanaa Awada ◽  
Samar Rachidi ◽  
...  
Keyword(s):  
Cigarette Smoking ◽  
Pulmonary Function ◽  
Real Life ◽  
Life Situation ◽  
Real Life Situation
Sign in / Sign up

Export Citation Format

Share Document