Low Polymer Retention Possible in Flooding of High-Salinity Carbonate Reservoirs

This article, written by JPT Technology Editor Chris Carpenter, contains highlights of paper SPE 202809, “Low Polymer Retention Opens for Field Implementation of Polymer Flooding in High-Salinity Carbonate Reservoirs,” by Arne Skauge, SPE, and Tormod Skauge, SPE, Energy Research Norway, and Shahram Pourmohamadi, Brent Asmari, et al., prepared for the 2020 Abu Dhabi International Petroleum Exhibition and Conference, Abu Dhabi, held virtually 9–12 November. The paper has not been peer reviewed. Polymer flooding has been a successful enhanced-oil-recovery method in sandstone reservoirs for decades. Extending polymer flooding to carbonate reservoirs has been challenging because of adsorption loss and polymer availability for high-temperature, high-salinity (HT/HS) reservoirs. In this study, the authors establish that HT/HS polymers can exhibit low adsorption and retention in carbonate reservoir rock at ultrahigh salinity conditions. Introduction Retention is a key factor for polymer propagation and acceleration of oil production by polymer flooding. In the complete paper, the authors consider HT/HS applications for carbonate reservoirs. Synthetic polymers such as partially hydrolyzed polyacrylamide are not thermally stable at temperatures above 60°C. The thermal stability of the synthetic polymers can be improved by incorporating monomers. To evaluate the retention of polymer in reservoir rock, dynamic retention experiments were performed in the presence and absence of oil. In homogeneous rock, the presence of residual oil typically will reduce the retention proportional to the surface covered by the oil saturation. Strongly heterogeneous rock containing fractures also may have low retention because the fluid flow mainly may be through highly permeable fractures or channels and, consequently, only part of the porous medium will contact polymer. Retention in carbonate matrix displacement (homogeneous rock) was performed on outcrop Indiana limestone for reference, but most experiments were made on reservoir rock material. The polymer used is SAV 10. Experimental Methods The easiest and, in many cases, most-accurate method for quantifying retention in dynamic coreflow experiments is by material balance. This refers to the measurement of the polymer in the effluent. The injected amount minus the backproduced amount of polymer gives the loss caused by transport through the porous medium. The retention includes both adsorption of polymer onto the rock and dynamic loss as the result of mechanical entrapment such as molecular straining and concentration blocking. In most cases, the authors used a passive tracer injected with the polymer and applied two slugs. The first slug quantifies the retention by material balance, but the difference in effluent of the second slug minus the first slug also can give an alternative measurement of the polymer retention. Comparing tracer and polymer effluent concentrations from the second polymer slug quantifies the inaccessible pore volume (IPV). The experimental setup is illustrated in Fig. 1.