Wettability Alteration During Low-Salinity Waterflooding in Carbonate Reservoir Cores

Author(s):  
Waleed Alameri ◽  
Tadesse Weldu Teklu ◽  
Ramona M. Graves ◽  
Hossein Kazemi ◽  
Ali M AlSumaiti
SPE Journal ◽  
2017 ◽  
Vol 23 (01) ◽  
pp. 84-101 ◽  
Author(s):  
Maxim P. Yutkin ◽  
Himanshu Mishra ◽  
Tadeusz W. Patzek ◽  
John Lee ◽  
Clayton J. Radke

Summary Low-salinity waterflooding (LSW) is ineffective when reservoir rock is strongly water-wet or when crude oil is not asphaltenic. Success of LSW relies heavily on the ability of injected brine to alter surface chemistry of reservoir crude-oil brine/rock (COBR) interfaces. Implementation of LSW in carbonate reservoirs is especially challenging because of high reservoir-brine salinity and, more importantly, because of high reactivity of the rock minerals. Both features complicate understanding of the COBR surface chemistries pertinent to successful LSW. Here, we tackle the complex physicochemical processes in chemically active carbonates flooded with diluted brine that is saturated with atmospheric carbon dioxide (CO2) and possibly supplemented with additional ionic species, such as sulfates or phosphates. When waterflooding carbonate reservoirs, rock equilibrates with the injected brine over short distances. Injected-brine ion speciation is shifted substantially in the presence of reactive carbonate rock. Our new calculations demonstrate that rock-equilibrated aqueous pH is slightly alkaline quite independent of injected-brine pH. We establish, for the first time, that CO2 content of a carbonate reservoir, originating from CO2-rich crude oil and gas, plays a dominant role in setting aqueous pH and rock-surface speciation. A simple ion-complexing model predicts the calcite-surface charge as a function of composition of reservoir brine. The surface charge of calcite may be positive or negative, depending on speciation of reservoir brine in contact with the calcite. There is no single point of zero charge; all dissolved aqueous species are charge determining. Rock-equilibrated aqueous composition controls the calcite-surface ion-exchange behavior, not the injected-brine composition. At high ionic strength, the electrical double layer collapses and is no longer diffuse. All surface charges are located directly in the inner and outer Helmholtz planes. Our evaluation of calcite bulk and surface equilibria draws several important inferences about the proposed LSW oil-recovery mechanisms. Diffuse double-layer expansion (DLE) is impossible for brine ionic strength greater than 0.1 molar. Because of rapid rock/brine equilibration, the dissolution mechanism for releasing adhered oil is eliminated. Also, fines mobilization and concomitant oil release cannot occur because there are few loose fines and clays in a majority of carbonates. LSW cannot be a low-interfacial-tension alkaline flood because carbonate dissolution exhausts all injected base near the wellbore and lowers pH to that set by the rock and by formation CO2. In spite of diffuse double-layer collapse in carbonate reservoirs, surface ion-exchange oil release remains feasible, but unproved.


Author(s):  
Tao Zhang ◽  
Yiteng Li ◽  
Chenguang Li ◽  
Shuyu Sun

The past decades have witnessed a rapid development of enhanced oil recovery techniques, among which the effect of salinity has become a very attractive topic due to its significant advantages on environmental protection and economical benefits. Numerous studies have been reported focusing on analysis of the mechanisms behind low salinity waterflooding in order to better design the injected salinity under various working conditions and reservoir properties. However, the effect of injection salinity on pipeline scaling has not been widely studied, but this mechanism is important to gathering, transportation and storage for petroleum industry. In this paper, an exhaustive literature review is conducted to summarize several well-recognized and widely accepted mechanisms, including fine migration, wettability alteration, double layer expansion, and multicomponent ion exchange. These mechanisms can be correlated with each other, and certain combined effects may be defined as other mechanisms. In order to mathematically model and numerically describe the fluid behaviors in injection pipelines considering injection salinity, an exploratory phase-field model is presented to simulate the multiphase flow in injection pipeline where scale formation may take place. The effect of injection salinity is represented by the scaling tendency to describe the possibility of scale formation when the scaling species are attached to the scaled structure. It can be easily referred from the simulation result that flow and scaling conditions are significantly affected if a salinity-dependent scaling tendency is considered. Thus, this mechanism should be taken into account in the design of injection process if a sustainable exploitation technique is applied by using purified production water as injection fluid. Finally, remarks and suggestions are provided based on our extensive review and preliminary investigation, to help inspire the future discussions.


2016 ◽  
Author(s):  
Ramez A. Nasralla ◽  
Hilbert A. van der Linde ◽  
Fons H. M. Marcelis ◽  
Hassan Mahani ◽  
Shehadeh K. Masalmeh ◽  
...  

2021 ◽  
Author(s):  
N. Singh ◽  
P. H. Gopani ◽  
H. K. Sarma ◽  
F. Wu ◽  
P. S. Mattey ◽  
...  

Abstract This study focusses on the investigation of wettability alteration behavior during low salinity waterflood (LSWF) process in a tight carbonate reservoir through Zeta potential studies in conjunction with spontaneous imbibition tests and estimation of the contact angle between the wetting fluid and the rock surface. This will help in understanding the role rock-oil-brine interactions play during an LSWF process. The classical streaming potential technique were used to determine Zeta potential. Measurements were carried out with diluted brines using different rock samples of in two states: oil-saturated and brine-saturated. The experimental results imply that the value of zeta potential becomes more negative with increasing percentage of dilution (25%, 10%, and 1%). This is attributed to electrical double-layer expansion which is caused, primarily, by the reduced ionic strength. We concluded that rock saturated with oil may give an insight on oil rock interactions while the rock saturated with brine may give insight on rock-brine interactions. The dilution of water helps increase the electrostatic repulsive forces between the two interfaces, which in turns, leads to the incremental recovery during LSWF process. This observation was also confirmed by coreflooding and wettability experiments through spontaneous imbibition tests and contact angle measurements conducted using the same oil-brine-rock systems. This is an investigative study of oil-brine-rock interaction behavior during a LSWF process that is difficult to accomplish through and during a conventional coreflooding displacement test. In addition, this study also couples the relationship between the wettability alteration and oil-brine-rock interactions during an LSWF process.


2019 ◽  
Vol 9 (1) ◽  
Author(s):  
Rimsha Aziz ◽  
Vahid Joekar-Niasar ◽  
Pedro J. Martínez-Ferrer ◽  
Omar E. Godinez-Brizuela ◽  
Constantinos Theodoropoulos ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document