Displacement Efficiency of Supercritical CO2 Flooding in Tight Carbonate Rocks Under Immiscible Conditions

Author(s):  
Abdulrazag Yusef Zekri ◽  
Reyadh A. Almehaideb ◽  
Shedid A. Shedid
2021 ◽  
Author(s):  
Kangxu Ren ◽  
Junfeng Zhao ◽  
Jian Zhao ◽  
Xilong Sun

Abstract At least three very different oil-water contacts (OWC) encountered in the deepwater, huge anticline, pre-salt carbonate reservoirs of X oilfield, Santos Basin, Brazil. The boundaries identification between different OWC units was very important to help calculating the reserves in place, which was the core factor for the development campaign. Based on analysis of wells pressure interference testing data, and interpretation of tight intervals in boreholes, predicating the pre-salt distribution of igneous rocks, intrusion baked aureoles, the silicification and the high GR carbonate rocks, the viewpoint of boundaries developed between different OWC sub-units in the lower parts of this complex carbonate reservoirs had been better understood. Core samples, logging curves, including conventional logging and other special types such as NMR, UBI and ECS, as well as the multi-parameters inversion seismic data, were adopted to confirm the tight intervals in boreholes and to predicate the possible divided boundaries between wells. In the X oilfield, hundreds of meters pre-salt carbonate reservoir had been confirmed to be laterally connected, i.e., the connected intervals including almost the whole Barra Velha Formation and/or the main parts of the Itapema Formation. However, in the middle and/or the lower sections of pre-salt target layers, the situation changed because there developed many complicated tight bodies, which were formed by intrusive diabase dykes and/or sills and the tight carbonate rocks. Many pre-salt inner-layers diabases in X oilfield had very low porosity and permeability. The tight carbonate rocks mostly developed either during early sedimentary process or by latter intrusion metamorphism and/or silicification. Tight bodies were firstly identified in drilled wells with the help of core samples and logging curves. Then, the continuous boundary were discerned on inversion seismic sections marked by wells. This paper showed the idea of coupling the different OWC units in a deepwater pre-salt carbonate play with complicated tight bodies. With the marking of wells, spatial distributions of tight layers were successfully discerned and predicated on inversion seismic sections.


Fuel ◽  
2019 ◽  
Vol 238 ◽  
pp. 412-424 ◽  
Author(s):  
Yan Lan ◽  
Zhongqing Yang ◽  
Peng Wang ◽  
Yunfei Yan ◽  
Li Zhang ◽  
...  

2019 ◽  
Vol 9 (8) ◽  
pp. 1686 ◽  
Author(s):  
Sai Wang ◽  
Kouqi Liu ◽  
Juan Han ◽  
Kegang Ling ◽  
Hongsheng Wang ◽  
...  

The low recovery of oil from tight liquid-rich formations is still a major challenge for a tight reservoir. Thus, supercritical CO2 flooding was proposed as an immense potential recovery method for production improvement. While up to date, there have been few studies to account for the formation properties’ variation during the CO2 Enhanced Oil Recovery (EOR) process, especially investigation at the micro-scale. This work conducted a series of measurements to evaluate the rock mechanical change, mineral alteration and the pore structure properties’ variation through the supercritical CO2 (Sc-CO2) injection process. Corresponding to the time variation (0 days, 10 days, 20 days, 30 days and 40 days), the rock mechanical properties were analyzed properly through the nano-indentation test, and the mineralogical alterations were quantified through X-ray diffraction (XRD). In addition, pore structures of the samples were measured through the low-temperature N2 adsorption tests. The results showed that, after Sc-CO2 injection, Young’s modulus of the samples decreases. The nitrogen adsorption results demonstrated that, after the CO2 injection, the mesopore volume of the sample would change as well as the specific Brunauer–Emmett–Teller (BET) surface area which could be aroused from the chemical reactions between the CO2 and some authigenic minerals. XRD analysis results also indicated that mesopore were altered due to the chemical reaction between the injected Sc-CO2 and the minerals.


1981 ◽  
Vol 21 (04) ◽  
pp. 480-492 ◽  
Author(s):  
F.M. Orr ◽  
A.D. Yu ◽  
C.L. Lien

Abstract Phase behavior of CO2/Crude-oil mixtures which exhibit liquid/liquid (L/L) and liquid/ liquid/vapor (L/L/V) equilibria is examined. Results of single-contact phase behavior experiments for CO2/separator-oil mixtures are reported. Experimental results are interpreted using pseudoternary phase diagrams based on a review of phase behavior data for binary and ternary mixtures of CO2 with alkanes. Implications for the displacement process of L/L/V phase behavior are examined using a one-dimensional finite difference simulator. Results of the analysis suggest that L/L and L/L/V equilibria will occur for CO2/crude-oil mixtures at temperatures below about 120 degrees F (49 degrees C) and that development of miscibility occurs by extraction of hydrocarbons from the oil into a CO2-rich liquid phase in such systems. Introduction The efficiency of a displacement of oil by CO2 depends on a variety of factors, including phase behavior of CO2/crude-oil mixtures generated during the displacement, densities and viscosities of the phases present, relative permeabilities to individual phases, and a host of additional complications such as dispersion, viscous fingering, reservoir heterogeneities, and layering. It generally is acknowledged that phase behavior and attendant compositional effects on fluid properties strongly influence local displacement efficiency, though it also is clear that on a reservoir scale, poor vertical and areal sweep efficiency (caused by the low viscosity of the displacing CO2) may negate the favorable effects of phase behavior.Interpretation of the effects of phase behavior on displacement efficiency is made difficult by the complexity of the behavior of CO2/crude-oil mixtures. The standard interpretation of CO2 flooding phase behaviour, given first by Rathmell et al. is that CO2 flooding behaves much like a vaporizing gas drive, as described originally by Hutchinson and Braun. During a flood, vaporphase CO2 mixes with oil in place and extracts light and intermediate hydrocarbons. After multiple contacts, the CO2-rich phase vaporizes enough hydrocarbons to develop a composition that can displace oil efficiently, if not miscibly. The picture presented by Rathmell et al. appears to be consistent with phase behavior observed for CO2/ crudeoil mixtures as long as the reservoir temperature is high enough. Table 1 summarizes data reported for CO2/crude-oil mixtures. Of the 10 systems studied, all those at temperatures above 120 degrees F (50 degrees C) show only L/V equilibria while those below 120 degrees F exhibit L/L/V separations (Stalkup also reports two phase diagrams that are qualitatively similar to the other low-temperature diagrams but does not give temperatures). Thus, at temperatures not too far above the critical temperature of CO2 [88 degrees F (31 degrees C)], mixtures of CO2 and crude oil exhibit multiple liquid phases, and at some pressures L/L/V equilibria are observed. It has not been established whether Rathmell et al.'s interpretation of the process mechanism can be extended to cover the more complex phase behavior of low-temperature CO2/crude-oil mixtures. In a recent paper, Metcalfe and Yarborough argued critical temperature CO2 floods behave more like condensing gas drives, whereas Kamath et al. concluded that an increase in the solubility of liquid-phase CO2 in crude oil at temperatures near the critical temperature of CO2 should cause more efficient displacements of oil by CO2. SPEJ P. 480^


2009 ◽  
Vol 6 (3) ◽  
pp. 277-283 ◽  
Author(s):  
Rui Wang ◽  
Xiang’an Yue ◽  
Renbao Zhao ◽  
Pingxiang Yan ◽  
Dave Freeman

Geofluids ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-9
Author(s):  
Zhang Jie ◽  
Cai Ming-Jun ◽  
Ge Dangke ◽  
Lu Ning ◽  
Cheng Hai-Ying ◽  
...  

The CO2 huff-n-puff is an effective substitute technology to further improve oil recovery of natural fractured tight oil reservoirs after water flooding, for its high displacement efficiency and superior injectivity. The CO2 huff-n-puff process is influenced by many factors, such as miscible degree, complex fracture networks, and production schemes. What is worse, those influence facts affect each other making the process more complex. Many researchers concentrated on mechanisms and single sensitivity analysis of CO2 huff-n-puff process, whereas few optimized this process with the consideration of all influence factors and multiobjective to get favorable performance. We built multiobjective consisted of miscible degree, oil recovery, and gas replacing oil rate considering the aspects of CO2 flooding special characteristic, technical effectiveness, and economic feasibility, respectively. We have taken Yuan 284 tight oil block as a case, firstly investigated sensitivity analysis, and then optimized CO2 huff-n-puff process using orthogonal experiment design with multifactors and multiobjectives. The optimization results show CO2 huff-n-puff can significantly improve oil recovery by 8.87% original oil in place (OOIP) compared with water flooding, which offers guidelines for field operations.


2011 ◽  
Vol 14 (8) ◽  
pp. 699-708 ◽  
Author(s):  
R. Z. Moreno ◽  
R. G. Santos ◽  
C. Okabe ◽  
D. J. Schiozer ◽  
O. V. Trevisan ◽  
...  

2018 ◽  
Vol 49 (7) ◽  
pp. 631-652 ◽  
Author(s):  
Fei Tian ◽  
Weimin Wang ◽  
Naigui Liu ◽  
Jiaqi Jiang ◽  
Congkai Niu ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document