In Situ Shear Wave Velocity From Multichannel Analysis of Surface Waves (MASW) Tests at Six Sites of Delhi Technological University

2020 ◽  
Author(s):  
Rajat Gautam ◽  
A.K. Srivastava Srivastava ◽  
Shubham Gupta ◽  
Vishal Sharma
Keyword(s):  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Multichannel Analysis ◽  
Technological University

scholarly journals In situ shear wave velocity from multichannel analysis of surface waves (MASW) tests at eight Norwegian research sites

2007 ◽  
Vol 44 (5) ◽  
pp. 533-544 ◽  
Author(s):  
Michael Long ◽  
Shane Donohue
Keyword(s):  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Small Strain ◽  
Soft Clays ◽  
Small Strain Stiffness ◽  
Wave Measurements ◽  
Multichannel Analysis

The multichannel analysis of surface waves (MASW) technique, which is used to determine shear wave velocity (Vs) and hence small strain stiffness (Gmax), has recently generated considerable interest in the geophysics community. This is because of the ease of carrying out the test and analysis of the data. The objective of this work was to assess the repeatability, accuracy, and reliability of MASW surface wave measurements for use in engineering studies. Tests were carried out at eight well-characterized Norwegian clay, silt, and sand research sites where Vs had already been assessed using independent means. As well as being easy and quick to use, the MASW technique gave consistent and repeatable results, and the MASW Vs profiles for the clay sites were similar to those obtained from other techniques. Reasonable results were also obtained for the silt and sand sites, with the best result being obtained for the finer silt. This work also confirms that MASW Vs clay profiles are comparable to those obtained by correlation with cone penetration test (CPT) data. For these sites there also seems to be a good correlation between normalized small strain shear modulus and in situ void ratio or water content, and the data fit well with published correlations for clays.Key words: soft clays, silts, sands, small strain stiffness, shear wave velocity.

Shear Wave Velocity Profiles of Roadway Substructures from Multichannel Analysis of Surface Waves and Waveform Tomography

2017 ◽  
Vol 2655 (1) ◽  
pp. 36-44
Author(s):  
Khiem T. Tran ◽  
Justin Sperry ◽  
Michael McVay ◽  
Scott J. Wasman ◽  
David Horhota
Keyword(s):  
Data Acquisition ◽  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Test System ◽  
Acquisition Time ◽  
Low Velocity ◽  
Multichannel Analysis ◽  
Waveform Tomography

Assessment of roadway subsidence caused by embedded low-velocity anomalies is critical to the health and safety of the traveling public. Surface-based seismic techniques are often used to assess roadways because of data acquisition convenience and large depths of characterization. To mitigate the negative impact of closing a traffic lane under traditional seismic testing, a new test system that uses a land streamer is presented. The main advantages of the system are the elimination of the need to couple the geophones to the roadway, the use of only one source at the end of the geophone array, and the movement of the whole test system along the roadway quickly. For demonstration, experimental data were collected on asphalt pavement overlying a backfilled sinkhole that was experiencing further subsidence. For the study, a 24-channel land streamer and a propelled energy generator to generate seismic energy were used. The test system was pulled by a pickup truck along the roadway and the data were collected with 81 shots at every 3 m for a road segment of 277.5 m, with a total data acquisition time of about 1 h. The measured seismic data set was analyzed by the standard multichannel analysis of surface waves (MASW) and advanced two-dimensional (2-D) waveform tomography methods. Eighty-one one-dimensional shear wave velocity (VS) profiles from the MASW were combined to obtain a single 2-D profile. The waveform tomography method was able to characterize subsurface structures at a high resolution (1.5- × 1.5-m cells) along the test length to a depth of 22.5 m. Very low S-wave velocity was obtained at the repaired sinkhole location. The 2-D VS profiles from the MASW and waveform tomography methods are consistent. Both methods were able to delineate high- and low-velocity soil layers and variable bedrock.

scholarly journals Investigation of Soil Characterization in Hatay Province in Turkey by Using Seismic Refraction, Multichannel Analysis of Surface Waves and Microtremor

2021 ◽  
Vol 24 (4) ◽  
pp. 473-484
Author(s):  
Cengiz Kurtuluş ◽  
Ibrahim Sertcelik ◽  
Fadime Sertçelik ◽  
Hamdullah Livaoğlu ◽  
Cüneyt Şaş
Keyword(s):  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Seismic Refraction ◽  
Strong Motion ◽  
Site Classification ◽  
Eurocode 8 ◽  
Site Class ◽  
Multichannel Analysis

In this study, shallow seismic surveys, including seismic refraction, Multichannel Analysis of Surface Waves (MASW), Refraction Microtremor (ReMi), and Microtremor measurements were conducted to estimate site characterization at 26 strong-motion stations of AFAD (Disaster and Emergency Management Presidency) in the province of Hatay, situated in one of the most seismically active regions in southern Turkey. The Horizontal to vertical spectral ratio (HVSR) technique was applied, using smoothed Fourier spectra derived from a long duration series to determine dominant frequency values at different amplification levels. Shear wave velocity up to 30 m of the ground was detected with MASW analysis. In the ReMi analysis, up to 80 m was reached with a corresponding average of 650 m/s shear wave velocity. The shear wave velocities estimated by the MASW method up to 30 m were compared with those found by the ReMi method, and they were observed to be very compatible. The province of Hatay was classified according to Vs30 based NEHRP Provisions, Eurocode-8, the Turkish Building Earthquake Regulation (TBDY-2018), and Rodriguez-Marek et al. (2001). The shear-wave velocity (Vs30), Horizontal to Vertical ratio’s (H/V) peak amplitude, dominant period, and site class of each site were determined. The H/V peak amplitudes range between 1.9 and 7.6, while the predominant periods vary from 0.23 sec to 2.94sec in the study area. These results are investigated to explain the consistency of site classification schemes.

scholarly journals Multi-channel analysis of surface wave method for geotechnical site characterization in Yogyakarta, Indonesia

2019 ◽  
Vol 76 ◽  
pp. 03006
Author(s):  
Nwai Le Ngal ◽  
Subagyo Pramumijoyo ◽  
Iman Satyarno ◽  
Kirbani Sri Brotopuspito ◽  
Junji Kiyono ◽  
...  
Keyword(s):  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Rayleigh Waves ◽  
Influential Factors ◽  
Multichannel Analysis ◽  
Average Shear ◽  
Channel Analysis ◽  
Masw Method

On May 27th 2006, Yogyakarta earthquake happened with 6.3 Mw. It was causing widespread destruction and loss of life and property. The average shear wave velocity to 30 m (Vs30) is useful parameter for classifying sites to predict their potential to amplify seismic shaking (Boore, 2004) [1]. Shear wave velocity is one of the most influential factors of the ground motion. The average shear wave velocity for the top 30 m of soil is referred to as Vs30. In this study, the Vs30 values were calculated by using multichannel analysis of surface waves (MASW) method. The Multichannel Analysis of Surface Waves (MASW) method was introduced by Park et al. (1999). Multi-channel Analysis of Surface Waves (MASW) is non-invasive method of estimating the shear-wave velocity profile. It utilizes the dispersive properties of Rayleigh waves for imaging the subsurface layers. MASW surveys can be divided into active and passive surveys. In active MASW method, surface waves can be easily generated by an impulsive source like a hammer, sledge hammer, weight drops, accelerated weight drops and explosive. Seismic measurements were carried out 44 locations in Yogyakarta province, in Indonesia. The dispersion data of the recorded Rayleigh waves were processed by using Seisimager software to obtain shear wave velocity profiles of the studied area. The average shear wave velocities of the soil obtained are ranging from 200 ms-1 to 988 ms-1, respectively.

scholarly journals Tool for analysis of multichannel analysis of surface waves (MASW) field data and evaluation of shear wave velocity profiles of soils

2018 ◽  
Vol 55 (2) ◽  
pp. 217-233 ◽  
Author(s):  
Elin Asta Olafsdottir ◽  
Sigurdur Erlingsson ◽  
Bjarni Bessason
Keyword(s):  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Velocity Profiles ◽  
Dispersion Analysis ◽  
Silty Sand ◽  
Analysis Tool ◽  
Multichannel Analysis ◽  
Inversion Analysis

Multichannel analysis of surface waves (MASW) is a fast, low-cost, and environmentally friendly technique to estimate shear wave velocity profiles of soil sites. This paper introduces a new open-source software, MASWaves, for processing and analysing multichannel surface wave records using the MASW method. The software consists of two main parts: a dispersion analysis tool (MASWaves Dispersion) and an inversion analysis tool (MASWaves Inversion). The performance of the dispersion analysis tool is validated by comparison with results obtained by the Geopsy software package. Verification of the inversion analysis tool is carried out by comparison with results obtained by the software WinSASW and theoretical dispersion curves presented in the literature. Results of MASW field tests conducted at three sites in south Iceland are presented to demonstrate the performance and robustness of the new software. The soils at the three test sites ranged from loose sand to cemented silty sand. In addition, at one site, the results of existing spectral analysis of surface waves (SASW) measurements were compared with the results obtained by MASWaves.

Evaluation of ground densification using spectral analysis of surface waves (SASW) and resonant column (RC) tests

1999 ◽  
Vol 36 (2) ◽  
pp. 291-299 ◽  
Author(s):  
D S Kim ◽  
H C Park
Keyword(s):  
Spectral Analysis ◽  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Velocity Profiles ◽  
Operation Technique ◽  
Resonant Column ◽  
Before And After

In order to assess the quality and depth of ground densification due to compaction, standard and (or) cone penetration tests are often performed before and after compaction. Both methods are intrusive and one-location tests and require a substantial amount of time to evaluate a large area, and evaluation quality is quite dependent on the operation technique and soil type. In this paper, the quality and extent of ground densification by compaction were evaluated using the results from in situ spectral analysis of surface waves (SASW) tests and laboratory resonant column (RC) tests. The SASW test was used to determine the shear wave velocity profiles before and after compaction, and the RC test was adopted to determine the correlation between the normalized shear wave velocity and density of the site, which is almost independent of confinement. Testing and data-reduction procedures of both tests were discussed, and a simplified procedure for evaluating ground densification was proposed by effectively combining in situ shear wave velocity profiles determined by SASW tests with the correlation between normalized shear wave velocity and density determined by RC tests. Finally, the feasibility of the proposed method was verified by performing field studies at the Inchon International Airport project. Field densities determined by the proposed method matched well with those determined by sand cone tests.Key words: density evaluation, densification, compaction, shear wave velocity, spectral analysis of surface waves test, resonant column test.

Sign in / Sign up

Export Citation Format

Share Document