scholarly journals Tool for analysis of multichannel analysis of surface waves (MASW) field data and evaluation of shear wave velocity profiles of soils

2018 ◽  
Vol 55 (2) ◽  
pp. 217-233 ◽  
Author(s):  
Elin Asta Olafsdottir ◽  
Sigurdur Erlingsson ◽  
Bjarni Bessason
Keyword(s):  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Velocity Profiles ◽  
Dispersion Analysis ◽  
Silty Sand ◽  
Analysis Tool ◽  
Multichannel Analysis ◽  
Inversion Analysis

Multichannel analysis of surface waves (MASW) is a fast, low-cost, and environmentally friendly technique to estimate shear wave velocity profiles of soil sites. This paper introduces a new open-source software, MASWaves, for processing and analysing multichannel surface wave records using the MASW method. The software consists of two main parts: a dispersion analysis tool (MASWaves Dispersion) and an inversion analysis tool (MASWaves Inversion). The performance of the dispersion analysis tool is validated by comparison with results obtained by the Geopsy software package. Verification of the inversion analysis tool is carried out by comparison with results obtained by the software WinSASW and theoretical dispersion curves presented in the literature. Results of MASW field tests conducted at three sites in south Iceland are presented to demonstrate the performance and robustness of the new software. The soils at the three test sites ranged from loose sand to cemented silty sand. In addition, at one site, the results of existing spectral analysis of surface waves (SASW) measurements were compared with the results obtained by MASWaves.

Shear Wave Velocity Profiles of Roadway Substructures from Multichannel Analysis of Surface Waves and Waveform Tomography

2017 ◽  
Vol 2655 (1) ◽  
pp. 36-44
Author(s):  
Khiem T. Tran ◽  
Justin Sperry ◽  
Michael McVay ◽  
Scott J. Wasman ◽  
David Horhota
Keyword(s):  
Data Acquisition ◽  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Test System ◽  
Acquisition Time ◽  
Low Velocity ◽  
Multichannel Analysis ◽  
Waveform Tomography

Assessment of roadway subsidence caused by embedded low-velocity anomalies is critical to the health and safety of the traveling public. Surface-based seismic techniques are often used to assess roadways because of data acquisition convenience and large depths of characterization. To mitigate the negative impact of closing a traffic lane under traditional seismic testing, a new test system that uses a land streamer is presented. The main advantages of the system are the elimination of the need to couple the geophones to the roadway, the use of only one source at the end of the geophone array, and the movement of the whole test system along the roadway quickly. For demonstration, experimental data were collected on asphalt pavement overlying a backfilled sinkhole that was experiencing further subsidence. For the study, a 24-channel land streamer and a propelled energy generator to generate seismic energy were used. The test system was pulled by a pickup truck along the roadway and the data were collected with 81 shots at every 3 m for a road segment of 277.5 m, with a total data acquisition time of about 1 h. The measured seismic data set was analyzed by the standard multichannel analysis of surface waves (MASW) and advanced two-dimensional (2-D) waveform tomography methods. Eighty-one one-dimensional shear wave velocity (VS) profiles from the MASW were combined to obtain a single 2-D profile. The waveform tomography method was able to characterize subsurface structures at a high resolution (1.5- × 1.5-m cells) along the test length to a depth of 22.5 m. Very low S-wave velocity was obtained at the repaired sinkhole location. The 2-D VS profiles from the MASW and waveform tomography methods are consistent. Both methods were able to delineate high- and low-velocity soil layers and variable bedrock.

scholarly journals Investigation of Soil Characterization in Hatay Province in Turkey by Using Seismic Refraction, Multichannel Analysis of Surface Waves and Microtremor

2021 ◽  
Vol 24 (4) ◽  
pp. 473-484
Author(s):  
Cengiz Kurtuluş ◽  
Ibrahim Sertcelik ◽  
Fadime Sertçelik ◽  
Hamdullah Livaoğlu ◽  
Cüneyt Şaş
Keyword(s):  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Seismic Refraction ◽  
Strong Motion ◽  
Site Classification ◽  
Eurocode 8 ◽  
Site Class ◽  
Multichannel Analysis

In this study, shallow seismic surveys, including seismic refraction, Multichannel Analysis of Surface Waves (MASW), Refraction Microtremor (ReMi), and Microtremor measurements were conducted to estimate site characterization at 26 strong-motion stations of AFAD (Disaster and Emergency Management Presidency) in the province of Hatay, situated in one of the most seismically active regions in southern Turkey. The Horizontal to vertical spectral ratio (HVSR) technique was applied, using smoothed Fourier spectra derived from a long duration series to determine dominant frequency values at different amplification levels. Shear wave velocity up to 30 m of the ground was detected with MASW analysis. In the ReMi analysis, up to 80 m was reached with a corresponding average of 650 m/s shear wave velocity. The shear wave velocities estimated by the MASW method up to 30 m were compared with those found by the ReMi method, and they were observed to be very compatible. The province of Hatay was classified according to Vs30 based NEHRP Provisions, Eurocode-8, the Turkish Building Earthquake Regulation (TBDY-2018), and Rodriguez-Marek et al. (2001). The shear-wave velocity (Vs30), Horizontal to Vertical ratio’s (H/V) peak amplitude, dominant period, and site class of each site were determined. The H/V peak amplitudes range between 1.9 and 7.6, while the predominant periods vary from 0.23 sec to 2.94sec in the study area. These results are investigated to explain the consistency of site classification schemes.

The complementarity of H/V and dispersion curves

Geophysics ◽  
2016 ◽  
Vol 81 (6) ◽  
pp. T323-T338 ◽  
Author(s):  
Silvia Castellaro
Keyword(s):  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Love Wave ◽  
Velocity Profiles ◽  
Dispersion Curves ◽  
Source Surface ◽  
Diagnostic Features ◽  
Single Station

Noninvasive geophysical techniques based on the dispersion of surface waves in layered media are commonly used approaches for measuring shear-wave velocity profiles of the subsoil. Acquiring surface waves is a simple task, but the interpretation of their dispersion curves poses a number of challenges. In an increasing number of cases, shear-wave velocity profiles are derived from the inversion of dispersion curves of surface waves and single-station passive horizontal-to-vertical (H/V) spectral ratios, mostly using a blind joint fit of the two sets of curves. Here we emphasize the benefits of carrying out H/V surveys prior to any array acquisition. We propose to start by collecting at least two H/V recordings at a site to verify the 1D plane-parallel soil condition, as this is essential in dispersion curve inversion/modeling. Then, we look for the diagnostic features of velocity inversions in the H/V curves: when they occur, the interpretation of dispersion curves is made difficult by mode splitting/superposition and Love wave arrays will not be effective. Then we inspect the shape of the H/V curves: flat curves acquired on rock usually imply poor dispersion curves. Large receiver spacings are recommended in the arrays and Love wave arrays will not be efficient. Flat curves on soft material sites represent gently increasing [Formula: see text] gradients and Rayleigh wave arrays should be preferred. H/V curves with high frequency peaks indicate shallow impedance contrasts: this makes Love wave arrays efficient for the soft layer characterization, but provide little information at depth. H/V curves with low frequency peaks indicate deep bedrock and their inversion can provide approximate [Formula: see text] profiles down to greater depths than from an array. Equipped with the information coming from accurate H/V observations, practitioners could make better-informed decisions about array acquisition geometries, source/surface wave types, and inversion strategies.

scholarly journals Multi-channel analysis of surface wave method for geotechnical site characterization in Yogyakarta, Indonesia

2019 ◽  
Vol 76 ◽  
pp. 03006
Author(s):  
Nwai Le Ngal ◽  
Subagyo Pramumijoyo ◽  
Iman Satyarno ◽  
Kirbani Sri Brotopuspito ◽  
Junji Kiyono ◽  
...  
Keyword(s):  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Rayleigh Waves ◽  
Influential Factors ◽  
Multichannel Analysis ◽  
Average Shear ◽  
Channel Analysis ◽  
Masw Method

On May 27th 2006, Yogyakarta earthquake happened with 6.3 Mw. It was causing widespread destruction and loss of life and property. The average shear wave velocity to 30 m (Vs30) is useful parameter for classifying sites to predict their potential to amplify seismic shaking (Boore, 2004) [1]. Shear wave velocity is one of the most influential factors of the ground motion. The average shear wave velocity for the top 30 m of soil is referred to as Vs30. In this study, the Vs30 values were calculated by using multichannel analysis of surface waves (MASW) method. The Multichannel Analysis of Surface Waves (MASW) method was introduced by Park et al. (1999). Multi-channel Analysis of Surface Waves (MASW) is non-invasive method of estimating the shear-wave velocity profile. It utilizes the dispersive properties of Rayleigh waves for imaging the subsurface layers. MASW surveys can be divided into active and passive surveys. In active MASW method, surface waves can be easily generated by an impulsive source like a hammer, sledge hammer, weight drops, accelerated weight drops and explosive. Seismic measurements were carried out 44 locations in Yogyakarta province, in Indonesia. The dispersion data of the recorded Rayleigh waves were processed by using Seisimager software to obtain shear wave velocity profiles of the studied area. The average shear wave velocities of the soil obtained are ranging from 200 ms-1 to 988 ms-1, respectively.

Evaluation of ground densification using spectral analysis of surface waves (SASW) and resonant column (RC) tests

1999 ◽  
Vol 36 (2) ◽  
pp. 291-299 ◽  
Author(s):  
D S Kim ◽  
H C Park
Keyword(s):  
Spectral Analysis ◽  
Surface Waves ◽  
Shear Wave ◽  
Wave Velocity ◽  
Shear Wave Velocity ◽  
Velocity Profiles ◽  
Operation Technique ◽  
Resonant Column ◽  
Before And After

In order to assess the quality and depth of ground densification due to compaction, standard and (or) cone penetration tests are often performed before and after compaction. Both methods are intrusive and one-location tests and require a substantial amount of time to evaluate a large area, and evaluation quality is quite dependent on the operation technique and soil type. In this paper, the quality and extent of ground densification by compaction were evaluated using the results from in situ spectral analysis of surface waves (SASW) tests and laboratory resonant column (RC) tests. The SASW test was used to determine the shear wave velocity profiles before and after compaction, and the RC test was adopted to determine the correlation between the normalized shear wave velocity and density of the site, which is almost independent of confinement. Testing and data-reduction procedures of both tests were discussed, and a simplified procedure for evaluating ground densification was proposed by effectively combining in situ shear wave velocity profiles determined by SASW tests with the correlation between normalized shear wave velocity and density determined by RC tests. Finally, the feasibility of the proposed method was verified by performing field studies at the Inchon International Airport project. Field densities determined by the proposed method matched well with those determined by sand cone tests.Key words: density evaluation, densification, compaction, shear wave velocity, spectral analysis of surface waves test, resonant column test.

Sign in / Sign up

Export Citation Format

Share Document