Survey on production quality of electrodialysis reversal and reverse osmosis on municipal wastewater desalination

2012 ◽  
Vol 66 (10) ◽  
pp. 2185-2193 ◽  
Author(s):  
Yi-Che Hsu ◽  
Hsin-Hsu Huang ◽  
Yu-De Huang ◽  
Ching-Ping Chu ◽  
Yu-Jen Chung ◽  
...  

Water shortage has become an emerging environmental issue. Reclamation of the effluent from municipal wastewater treatment plant (WWTP) is feasible for meeting the growth of water requirement from industries. In this study, the results of a pilot-plant setting in Futian wastewater treatment plant (Taichung, Taiwan) were presented. Two processes, sand filter – ultrafiltration – reverse osmosis (SF-UF-RO) and sand filter – electrodialysis reversal (SF-EDR), were operated in parallel to evaluate their stability and filtrate quality. It has been noticed that EDR could accept inflow with worse quality and thus required less pretreatment compared with RO. During the operation, EDR required more frequent chemical cleaning (every 3 weeks) than RO did (every 3 months). For the filtrate quality, the desalination efficiency of SF-EDR ranged from 75 to 80% in continuous operation mode, while the conductivity ranged from 100 to 120 μS/cm, with turbidity at 0.8 NTU and total organic carbon at 1.3 mg/L. SF-EDR was less efficient in desalinating the multivalent ions than SF-UF-RO was. However for the monovalent ions, the performances of the two processes were similar to each other. Noticeably, total trihalomethanes in SF-EDR filtrate was lower than that of SF-UF-RO, probably because the polarization effects formed on the concentrated side of the EDR membrane were not significant. At the end of this study, cost analysis was also conducted to compare the capital requirement of building a full-scale wastewater reclamation plant using the two processes. The results showed that using SF-EDR may cost less than using SF-UF-RO, if the users were to accept the filtrate quality of SF-EDR.

2019 ◽  
Vol 252 ◽  
pp. 09009
Author(s):  
Dariusz Majerek ◽  
Sylwia Duda ◽  
Roman Babko ◽  
Marcin K. Widomski

The assessment of the ratio of self-purification processes in the natural environment, including the water bodies of streams and rivers is possible by the means of the numerical modelling. Nonetheless, the reliability of results of the qualitative numerical calculations may be affected by the quality of the collected input data and efficiency of the model calibration. The commonly required input data include pollutants characteristics and coefficients for empirical equations of their transport and decay, while calibration of a model requires series of measurements of selected pollutants concentration in water. This paper presents studies of concentration of pollutants measured in the treated sanitary wastewater discharged to the Bystrzyca river from municipal wastewater treatment plant, and their concentrations measured directly in the river, above and below the location of discharge point. The performed qualitative measurements of treated sewage discharged from municipal wastewater treatment plant and water of the Bystrzyca river included determination of COD, BOD5, N-NH4, N-NO2, N-NNO3, TKN, TN, TP and TSS concentration. The presented results of measurements are the first step in development and calibration of the model, allowing to successfully predict the influence of discharged sanitary wastewater on quality of water in the river.


2016 ◽  
Vol 2016 ◽  
pp. 1-8 ◽  
Author(s):  
A. Vantarakis ◽  
S. Paparrodopoulos ◽  
P. Kokkinos ◽  
G. Vantarakis ◽  
K. Fragou ◽  
...  

The objective of the study was to investigate the impact on the quality of life of people living close to a municipal wastewater treatment plant. A case control study, including 235 inhabitants living within a 500 m radius by a municipal wastewater treatment plant (cases) and 97 inhabitants living in a different area (controls), was conducted. A standardized questionnaire was self-completed by the participants which examined the general health perception and the overall life satisfaction. Also, the concentration of airborne pathogenic microorganisms in aerosol samples collected around the wastewater treatment plant was investigated. Significant risk for symptoms such as headache, unusual tiredness, and concentration difficulties was recorded and an increased possibility for respiratory and skin diseases was reported. A high rate of the cases being irritable and moody was noticed. Significantly higher gastrointestinal symptoms were also reported among the cases in relation to the controls. The prevalence of pathogenic airborne microorganisms originating from the wastewater treatment plant was reported in high numbers in sampling points close to the wastewater treatment plant. More analytical epidemiological investigations are needed to determine the cause as well as the burden of the diseases to inhabitants living surrounding the wastewater treatment plant.


Water ◽  
2021 ◽  
Vol 13 (10) ◽  
pp. 1339
Author(s):  
Javier Bayo ◽  
Sonia Olmos ◽  
Joaquín López-Castellanos

This study investigates the removal of microplastics from wastewater in an urban wastewater treatment plant located in Southeast Spain, including an oxidation ditch, rapid sand filtration, and ultraviolet disinfection. A total of 146.73 L of wastewater samples from influent and effluent were processed, following a density separation methodology, visual classification under a stereomicroscope, and FTIR analysis for polymer identification. Microplastics proved to be 72.41% of total microparticles collected, with a global removal rate of 64.26% after the tertiary treatment and within the average retention for European WWTPs. Three different shapes were identified: i.e., microfiber (79.65%), film (11.26%), and fragment (9.09%), without the identification of microbeads despite the proximity to a plastic compounding factory. Fibers were less efficiently removed (56.16%) than particulate microplastics (90.03%), suggesting that tertiary treatments clearly discriminate between forms, and reporting a daily emission of 1.6 × 107 microplastics to the environment. Year variability in microplastic burden was cushioned at the effluent, reporting a stable performance of the sewage plant. Eight different polymer families were identified, LDPE film being the most abundant form, with 10 different colors and sizes mainly between 1–2 mm. Future efforts should be dedicated to source control, plastic waste management, improvement of legislation, and specific microplastic-targeted treatment units, especially for microfiber removal.


Sign in / Sign up

Export Citation Format

Share Document