scholarly journals Study of pre-treatment of quinoline in aqueous solution using activated carbon made from low-cost agricultural waste (walnut shells) modified with ammonium persulfate

2019 ◽  
Vol 79 (11) ◽  
pp. 2086-2094 ◽  
Author(s):  
Tao Yang ◽  
Xuansheng Hu ◽  
Peijuan Zhang ◽  
Xiaogang Chen ◽  
Weiwei Wang ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Adsorption Isotherms ◽  
Low Cost ◽  
Agricultural Waste ◽  
Ammonium Persulfate ◽  
Order Kinetic ◽  
Walnut Shells ◽  
Column Adsorption ◽  
Initial Adsorption

Abstract Activated carbon made from agricultural waste (walnut shells) was investigated as a suitable adsorbent for effectively removing quinoline from industrial wastewater. The activated carbon was treated with phosphoric acid and oxidized by ammonium persulfate and its ability to adsorb pyridine and quinoline in aqueous solution was investigated. Kinetic parameters for the adsorption process were determined through pseudo-first-order and pseudo-second-order kinetic models and intraparticle diffusion models. Equilibrium experiments and adsorption isotherms were analyzed using Langmuir and Freundlich adsorption isotherms. After reaching equilibrium, the activated carbon adsorbed quinoline in preference to pyridine: the equilibrium adsorptions from individual aqueous solutions (200 μL L−1) of quinoline and pyridine were 166.907 mg g−1 and 72.165 mg g−1, respectively. Thermodynamic studies of quinoline adsorption were conducted at different temperatures and indicated that quinoline adsorption was an endothermic and spontaneous process. The column-adsorption of quinoline and pyridine was consistent with the Thomas model and the Yoon-Nelson model. The removal efficiency of quinoline reached more than 97% for a velocity of 6 mL min−1 at the initial adsorption stage.

Adsorption of Chromium (VI) from Aqueous Solution by Agricultural Waste Derived Activated Carbon

2013 ◽  
Vol 726-731 ◽  
pp. 2100-2106 ◽  
Author(s):  
Hua Zhang ◽  
Xue Hong Zhang ◽  
Yi Nian Zhu ◽  
Shou Rui Yuan
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Agricultural Waste ◽  
Order Kinetic ◽  
Chromium Vi ◽  
Initial Ph ◽  
Order Kinetic Model ◽  
Grapefruit Peel ◽  
Pseudo Second Order ◽  
C 30

Activated carbon prepared from grapefruit peel, an agricultural solid waste by-product, has been used for the adsorption of Cr(VI) from aqueous solution. The effects of adsorbent dosage, pH and temperature on adsorption of Cr(VI) were investigated. The maximum adsorption yield was obtained at the initial pH of 3. The dynamical data fit very well with the pseudo-second-order kinetic model and the calculated adsorption capacities (23.98, 24.33 and 24.81 mg/g) were in good agreement with experiment results at 20°C, 30°C and 40 °C for the 100 mg/L Cr(VI) solution. The Freundlich model (R2 values were 0.9198-0.9871) fitted adsorption data better than the Langmuir model. The calculated parameters confirmed the favorable adsorption of Cr(VI) on the activated carbon prepared from grapefruit peel.

scholarly journals Adsorptive removal of malachite green dye from aqueous solution onto activated carbon of Catha edulis stem as a low cost bio-adsorbent

2020 ◽  
Vol 9 (1) ◽  
Author(s):  
Gietu Yirga Abate ◽  
Adugna Nigatu Alene ◽  
Adere Tarekegne Habte ◽  
Desiew Mekuanint Getahun
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Low Cost ◽  
Aqueous System ◽  
Point Of Zero Charge ◽  
Isotherm Models ◽  
Synthetic Dyes ◽  
Order Kinetic ◽  
Operational Parameters ◽  
Catha Edulis

Abstract Background The release of hazardous synthetic dyes into industrial effluents has emerged as an environmental problem requiring remediation. The present study focused on the preparation of a new and environmentally-friendly material (adsorbent) for the remediation of hazardous dyes from aqueous solution. The low cost adsorbent was prepared from locally available khat (Catha edulis) stem which considered as waste and accumulated on waste disposal areas of Woldia town, Ethiopia. Comprehensive characterization studies were carried out on the bio-adsorbent such as proximate analyses, specific surface area, point of zero charge and FT-IR analysis. Results The proximate analysis shows the prepared adsorbent has very high fixed carbon content (83.65%), which refers to high quality of the adsorbent. The adsorption performance of the prepared activated carbon was optimized by varying operational parameters such as initial dye concentration (10 mg/L), pH (10), dosage (0.5 g), and contact time (60 min). The maximum removal efficiency of the prepared adsorbent at those optimum conditions was 98.8%. The experimental data was tested by most common kinetics and isotherm models. It was observed that the pseudo-second-order kinetic model fits better with good correlation coefficient and the equilibrium data fitted well with the Freundlich isotherm model. Conclusion In summery this study demonstrated that the waste bio sorbent could be employed as an effective and eco-friendly alternative for the cleanup of dye-polluted aqueous system.

scholarly journals Adsorptive removal of malachite green dye from aqueous solution onto activated carbon of Catha edulis stem as a low cost bio-adsorbent

2020 ◽  
Author(s):  
Gietu yirga Abate ◽  
Adugna Nigatu Alene ◽  
Adere Tarekegne Habte ◽  
Desiew Mekuanint Getahun
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Low Cost ◽  
Aqueous System ◽  
Point Of Zero Charge ◽  
Isotherm Models ◽  
Synthetic Dyes ◽  
Order Kinetic ◽  
Operational Parameters ◽  
Catha Edulis

Abstract Background: The release of hazardous synthetic dyes into industrial effluents has emerged as an environmental problem requiring remediation. The present study focused on the preparation of a new and environmentally-friendly material (adsorbent) for the remediation of hazardous dyes from aqueous solution. The low cost adsorbent was prepared from locally available khat (Catha edulis) stem which considered as waste and accumulated on waste disposal areas of Woldia town, Ethiopia. Comprehensive characterization studies were carried out on the bio-adsorbent such as proximate analyses, specific surface area, point of zero charge and FT-IR analysis. Results: The proximate analysis shows the prepared adsorbent has very high fixed carbon content (83.65%), which refers to high quality of the adsorbent. The adsorption performance of the prepared activated carbon was optimized by varying operational parameters such as initial dye concentration (10 mg/L), pH (10), dosage (0.5 g), and contact time (60 min). The maximum removal efficiency of the prepared adsorbent at those optimum conditions was 98.8%. The experimental data was tested by most common kinetics and isotherm models. It was observed that the pseudo-second-order kinetic model fits better with good correlation coefficient and the equilibrium data fitted well with the Freundlich isotherm model.Conclusion: In summery this study demonstrated that the waste bio sorbent could be employed as an effective and eco-friendly alternative for the cleanup of dye-polluted aqueous system.

Adsorptive Removal of Ni2+ from Aqueous Solution onto Rice Husk-Based Activated Carbon

2014 ◽  
Vol 625 ◽  
pp. 893-896
Author(s):  
Mohd Faisal Taha ◽  
Anis Shuib ◽  
Maizatul Shima Shaharun ◽  
Azry Borhan
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Rice Husk ◽  
Room Temperature ◽  
Low Cost ◽  
Textural Properties ◽  
Order Kinetic ◽  
Adsorption Studies ◽  
Equilibrium Data ◽  
Maximum Removal

The potential of rice husk-based activated carbon (RHAC) as an alternative low-cost adsorbent for the removal of Ni2+ from aqueous solution was studied. RHAC was prepared via chemical treatment using NaOH followed by the carbonization process. The textural properties of rice husk-based activated carbon, i.e. surface area (253 m2/g) and pore volume (0.17 cm2/g), were determined by N2 adsorption. The adsorption studies to remove Ni2+ from aqueous solution using RHAC were carried out at a fixed initial concentration of Ni2+ (150 ppm) with varying RHAC as a function of contact time at room temperature. The concentration of Ni2+ was determined by atomic absorption spectrophotometer (AAS). The maximum removal of Ni2+ was increased from 40% to 89% when the amount of RHAC was increased from 0.1 g to 0.5 g. The isotherm and kinetic analyses showed that equilibrium data of adsorption studies fitted well Langmuir, Freundlich and second order kinetic models.

scholarly journals Magnetic Steel Slag Biochar for Ammonium Nitrogen Removal from Aqueous Solution

Energies ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2682
Author(s):  
Gyuhyeon Kim ◽  
Young-Mo Kim ◽  
Su-Min Kim ◽  
Hyun-Uk Cho ◽  
Jong-Moon Park
Keyword(s):  
Aqueous Solution ◽  
Magnetic Properties ◽  
Low Cost ◽  
Steel Slag ◽  
Maximum Adsorption Capacity ◽  
Order Kinetic ◽  
Magnetic Biochar ◽  
N Removal ◽  
Magnetic Steel ◽  
Slag Waste

In this study, magnetic steel slag biochar (MSSB) was synthesized from low-cost steel slag waste to investigate the effectiveness of steel slag biochar composite for NH4-N removal and magnetic properties in aqueous solution. The maximum adsorption capacity of NH4-N by MSSB was 4.366 mg/g according to the Langmuir model. The magnetic properties of MSSB indicated paramagnetic behavior and a saturation magnetic moment of 2.30 emu/g at 2 Tesla. The NH4-N adsorption process was well characterized by the pseudo-second order kinetic model and Temkin isotherm model. This study demonstrated the potential of magnetic biochar synthesized from steel slag waste for NH4-N removal in aqueous solution.

scholarly journals Removal of Ni (II) from Aqueous Solution by Adsorption onto Activated Carbon Prepared from Lapsi (Choerospondias axillaris) Seed Stone

2014 ◽  
Vol 9 (1) ◽  
pp. 166-174 ◽  
Author(s):  
Rajeshwar M. Shrestha ◽  
Margit Varga ◽  
Imre Varga ◽  
Amar P. Yadav ◽  
Bhadra P. Pokharel ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Activated Carbon ◽  
Activated Carbons ◽  
Low Cost ◽  
Chemical Characterization ◽  
Maximum Adsorption Capacity ◽  
Adsorption Data ◽  
Optimum Ph ◽  
Nickel Adsorption

Activated carbons were prepared from Lapsi seed stone by the treatment with H2SO4 and HNO3 for the removal of Ni (II) ions from aqueous solution. Two activated carbon have been prepared from Lapsi seed stones by treating with conc.H2SO4 and a mixture of H2SO4 and HNO3 in the ratio of 1:1 by weight for removal of Ni(II) ions. Chemical characterization of the resultant activated carbons was studied by Fourier Transform Infrared Spectroscopy and Boehm titration which revealed the presence of oxygen containing surface functional groups like carboxyl, lactones and phenols in the carbons. The optimum pH for nickel adsorption is found to be 5. The adsorption data were better fitted with the Langmuir equations than Freundlich adsorption equation to describe the equilibrium isotherms. The maximum adsorption capacity of Ni (II) on the resultant activated carbons was 28.25.8 mg g-1 with H2SO4 and 69.49 mg g-1 with a mixture of H2SO4 and HNO3. The waste material used in the preparation of the activated carbons is inexpensive and readily available. Hence the carbons prepared from Lapsi seed stones can act as potential low cost adsorbents for the removal of Ni (II) from water. DOI: http://dx.doi.org/10.3126/jie.v9i1.10680Journal of the Institute of Engineering, Vol. 9, No. 1, pp. 166–174

scholarly journals Organic Dyes Adsorption on the Almond Shell (Prunus dulcis) as Agricultural Solid Waste from Aqueous Solution in Single and Binary Mixture Systems

2021 ◽  
Vol 12 (2) ◽  
pp. 2022-2040
Keyword(s):  
Aqueous Solution ◽  
Binary Mixture ◽  
Contact Time ◽  
Binary Systems ◽  
Organic Dyes ◽  
Low Cost ◽  
Kinetic Studies ◽  
Prunus Dulcis ◽  
Order Kinetic ◽  
Almond Shell

Almond shell (AS) is a low-cost adsorbent used in this study for the removal of methylene blue (MB), crystal violet (CV), and Congo red (CR) from an aqueous solution in single and mixture binary systems. The low-cost adsorbent was characterized by FTIR and SEM analysis. The effects of AS dose, contact time, initial dye concentration, pH, and temperature on MB, CV, and CR adsorption were studied in a single system. In a binary system, the MB, CV, and CR were removed from the mixture of MB+CR, CV+MB, and CV+CR with a percentage in volume ranging from 0 to 100 % in MB and CV, and CR. Kinetic studies showed rapid sorption following a second-order kinetic model with of contact time of 10 min. The modulation of adsorption isotherms showed that retention follows the Langmuir model. The thermodynamic parameters proved that the MB, CV, and CR adsorption process was feasible, spontaneous, and exothermic. The synergy adsorption between dyes in a binary mixture of MB+CR and CV+CR, while the competition adsorption between dyes in a binary mixture of MB+ CV.

Sign in / Sign up

Export Citation Format

Share Document