Study of turbulence in the high betap discharge using only RF heating on EAST

High poloidal beta scenarios with favorable energy confinement (β_p~1.9, H_98y2~1.4) have been achieved on Experimental Advanced Superconducting Tokamak (EAST) using only radio frequency waves heating. Gyrokinetic simulations are carried out with experimental plasma parameters and tokamak equilibrium data of a typical high β_p discharge by the GTC code. Linear simulations show that electron temperature scale length and electron density scale length destabilize the turbulence, collision effects stabilize the turbulence, and the instability propagates in the electron diamagnetic direction. These indicate that the dominant instability in the core of high β_p plasma is collisionless trapped electron mode. Ion thermal diffusivities calculated by nonlinear gyrokinetic simulations are consistent with the experimental value, in which the electron collision effects play an important role. Further analyses show that instabilities with k_θ ρ_s>0.38 are suppressed by collision effects and collision effects reduce the radial correlation length of turbulence, resulting in the suppression of the turbulence.

A quantitive microscale dynamic column breakthrough apparatus for measurement of unary and binary adsorption equilibrium on milligram quantities of adsorbent

A microscale dynamic column breakthrough (μDCB) apparatus with the ability to measure unary and binary adsorption equilibrium on a milligram-scale quantity of adsorbent is described. The μDCB is a low cost system that can be constructed through minor modifications of a commercial gas chromatograph and uses a thermal conductivity detector. The small scale of the apparatus allows for the rapid collection of dynamic column breakthrough experiments. The mass balances for adsorption and desorption experiments were derived along with a description of the blank. The μDCB apparatus was tested with 238.9 mg of zeolite 13X and 180.2 mg of activated carbon with single-component N2/He and CH4/He adsorption and desorption measurements. The measured equilibrium data agreed well with volumetrically collected data. These measurements are both accurate and precise. Multicomponent adsorption was also studied on zeolite 13X and activated carbon for CH4/N2 and CO2/CH4 mixtures. This data was compared with ideal and adsorbed solution theory, extended dual-site Langmuir calculations and the literature.

(3-Aminopropyl) Triethoxysilane (APTES) Functionalized Magnetic Nanosilica Graphene Oxide (MGO) Nanocomposite for the Comparative Adsorption of the Heavy Metal (Pb(II), Cd(II) and Ni(II)) ions from Aqueous Solution

(3-aminopropyl) triethoxysilane (APTES) modified magnetic graphene oxide was synthesized and applied in the adsorption of three heavy metals, Pb(II), Cd(II) and Ni(II) from aqueous solution. An approach to prepare magnetic GO was adopted by using (3-aminopropyl) triethoxysilane (APTES) as a functionalizing agent on magnetic nanosilica coupled with GO to form the Fe3O4@SiO2-NH2/GO nanocomposite. FT-IR, XRD, BET, UV, VSM, SAXS, SEM and TEM were used to characterize the synthesized nanoadsorbents. Batch adsorption studies were conducted to investigate the effect of solution pH, initial metal ion concentration, adsorbent dosage and contact time. The maximum equilibrium time was found to be 30 min for Pb(II), Cd(II) and 60 min for Ni(II). The kinetics studies showed that the adsorption of Pb(II), Cd(II) and Ni(II) onto Fe3O4@SiO2-NH2/GO followed the pseudo-second-order kinetics. All the adsorption equilibrium data were well fitted to Langmuir isotherm model and maximum monolayer adsorption capacity for Pb(II), Cd(II) and Ni(II) were 13.46, 18.58 and 13.52 mgg-1, respectively. The Fe3O4@SiO2-NH2/GO adsorbents were reused for at least 7 cycles without the leaching of mineral core, showing the enhanced stability and potential application of Fe3O4@SiO2-NH2/GO adsorbents in water/wastewater treatment.

Modeling VLE and LLE of Deep Eutectic Solvents (DES) and Ionic Liquids (IL) Using PC-SAFT Equation of State. Part II

This study aims to use Perturbed-Chain Statistical Associating Fluid Theory (PC-SAFT) to describe the phase behavior of systems containing DESs and ILs. The DESs are based on Tetrabutylammonium chloride ([N4444]Cl) and Tetrabutylammonium bromide (TBAB) as hydrogen bond acceptors, and levulinic acid (LevA) and Diethylene Glycol (DEG) as hydrogen bond donors in the mole ratio of 1:2 and 1:4, respectively. The predicted phase equilibrium data from PC-SAFT has been compared to those from COSMO-RS and NRTL predictions. ILs studied in this work are low viscosity ether-functionalized pyridinium-based ILs [EnPy][NTf2] and [CmPy][NTf2], while 1-(2-methoxyethyl)-1-methylpyrrolidiniumbis(trifluoromethylsulfonyl)-amide) ([COC2mPYR][NTf2]) and 1-propyl-3-methylimidazolium bis{trifluoromethylsulfonyl}imide ([Pmim][NTf2]) were used for the study of the LLE systems with n-heptane + thiophene and n-hexane + ethylbenzene, respectively. In the last part, mixtures of linear alkanes and perfluoroalkanes have been studied to predict the phase behavior of perfluoroalkylalkanes with their linear alkane counterparts and comparisons have been made against SAFT-Mie pair potential.

Experimental Determination of Phase Equilibria in the Na2O-SiO2-WO3 System

The present study investigated phase equilibria in the Na2O-SiO2-WO3 system experimentally using high-temperature equilibration, quenching, and electron probe X-ray microanalysis (EPMA). New thermodynamic information on the Na2O-SiO2-WO3 system was derived based on the newly obtained experimental results and data from the literature. The primary phase fields of sodium metasilicate, sodium disilicate, and tridymite were determined along with the isotherms at 1073, 1173, and 1273 K. The solubilities of WO3 in SiO2, Na2Si2O5, and Na2SiO3, and the solubility of SiO2 in Na2WO4 were accurately measured using EPMA. Comparisons between the existing and newly constructed phase diagram were carried out and the differences are discussed. The phase equilibrium data will be beneficial to the future development of sustainable tungsten industries and thermodynamic modelling in WO3 related systems.

Ionic Liquid Extraction Behavior of Cr(VI) Absorbed on Humic Acid–Vermiculite

Cr(VI) can be released into soil as a result of mining, electroplating, and smelting operations. Due to the high toxicity of Cr(VI), its removal is necessary in order to protect ecosystems. Vermiculite is applied in situations where there is a high degree of metal pollution, as it is helpful during the remediation process due to its high cation exchange capacity. The Cr(VI) contained in the vermiculite should be extracted in order to recover it and to reduce the impact on the environment. In this work, adsorption equilibrium data for Cr(VI) in a simulated sorbent for soil remediation (a mixture that included both humic acid (HA) and vermiculite) were a good fit with the Langmuir isotherm model. The simulated sorbent for soil remediation was a favorable sorbent for Cr(VI) when it was in the test soil. An ionic liquid, [C4mim]Cl (1-butyl-3-methylimidazolium chloride), was studied to determine its efficiency in extracting Cr(VI) from the Cr- contaminated simulated sorbent in soil remediation. At 298 K and within 30 min, approximately 33.48 ± 0.79% of Cr(VI) in the simulated sorbent in soil remediation was extracted into [C4mim]Cl. Using FTIR spectroscopy, the absorbance intensities of the bands at 1032 and 1010 cm−1, which were attributed to C-O bond stretching in the polysaccharides of HA, were used to detect the changes in HA in the Cr-contaminated simulated sorbent for soil remediation before and after extraction. The results showed that Cr(VI) that has been absorbed on HA can be extracted into [C4mim]Cl. Using 1H NMR, it was observed that the 1-methylimizadole of [C4mim] Cl played an important role in the extraction of Cr(VI), which bonded with HA on vermiculite and was able to be transformed into the [C4mim]Cl phase.

COMPARISON OF STINGING NETTLE ADSORPTION PERFORMANCE TOWARDS ANIONIC AND CATIONIC DYES

Stinging nettle was used as lignocellulosic adsorbent for the removal of cationic dye – malachite green (MG), and anionic dye – Congo red (CR), from aqueous solution, without any chemical pretreatment. The adsorption equilibrium data fitted well with the Langmuir model for the adsorption of both dyes, with the calculated maximum adsorption capacity of 270.27 mgg-1 and 172.14 mgg-1 for MG and CR, respectively. The adsorption process was controlled by the pseudo-second-order model in the adsorption of MG and by the pseudo-first-order model in the adsorption of CR. The thermodynamics modelling displayed that the process was spontaneous and endothermic. The π–π electron–donor interaction, hydrogen bonds and pore diffusion may also be effective, besides electrostatic interaction between the adsorbate and the adsorbent in the mechanism of MG and CR uptake.