scholarly journals Undrained shear of soft clay after a cyclic stress history.

1985 ◽  
pp. 113-122 ◽  
Author(s):  
Kazuya YASUHARA ◽  
Kazutoshi HIRAO
Keyword(s):  
Soft Clay ◽  
Cyclic Stress ◽  
Stress History ◽  
Undrained Shear

Shear modulus and damping of soft Bangkok clays

2002 ◽  
Vol 39 (5) ◽  
pp. 1201-1208 ◽  
Author(s):  
Supot Teachavorasinskun ◽  
Pipat Thongchim ◽  
Panitan Lukkunaprasit
Keyword(s):  
Shear Modulus ◽  
Seismic Analysis ◽  
Damping Ratio ◽  
Soft Clay ◽  
Cyclic Stress ◽  
Large Strains ◽  
Cyclic Triaxial ◽  
Stress History ◽  
Load Frequency ◽  
Equivalent Shear Modulus

The shear modulus and damping ratio of undisturbed Bangkok clay samples were measured using a cyclic triaxial apparatus. Although abundant literature on this topic exists, selection of the most suitable empirical correlation for a seismic analysis cannot be done unless site specific data are obtained. The apparatus used in this research can measure the stress–strain relationships from strain levels of about 0.01%. The equivalent shear modulus measured at these strains was about 80% of the value obtained from the shear wave velocity measurements. The degradation curves of the equivalent shear modulus fell into the ranges reported in the literature, for clay having similar plasticity. The damping ratios varied from about 4–5% at small strains (0.01%) to about 25–30% at large strains (10%). The effects of load frequency and cyclic stress history on the shear modulus and damping ratio were also investigated. An increase in load frequency from 0.1 to 1.0 Hz had no influence on the shear modulus characteristic, but it did result in a slight decrease in the damping ratio. The effects of the small amplitude cyclic stress history on the subsequently measured shear modulus and damping ratio were almost negligible when the changes in void ratio were taken into account.Key words: soft clay, shear modulus, damping ratio, cyclic triaxial test, cyclic stress history.

Experimental Study on the Combined Effect of Cyclic and Static Loads on the Mechanical Properties of the Saturated Soft Clay Material

2016 ◽  
Vol 723 ◽  
pp. 843-848
Author(s):  
Yi Wei ◽  
Ying Zhu ◽  
Jing Ni
Keyword(s):  
Mechanical Properties ◽  
Cyclic Load ◽  
Stress Ratio ◽  
Axial Strain ◽  
Soft Clay ◽  
Cyclic Stress ◽  
Excess Pore Pressure ◽  
Static Loads ◽  
Cyclic Stress Ratio ◽  
Excess Pore

The combined effect of cyclic and static loads on the mechanical properties of the soft clay was experimentally investigated by conducting undrained cyclic triaxial tests on Shanghai clay. The results show that an increment in either static or cyclic load increases excess pore pressures and axial strains. For a given value of combined cyclic and static loads, the mechanical properties of the soft clay are more sensitive to the cyclic load. Furthermore, the accumulated excess pore pressure and axial strain for a larger cyclic stress ratio and a lower combined stress ratio might overcome that for a lower cyclic stress ratio and a higher combined stress ratio. The mechanical properties of the soft clay after the cyclic load was unloaded were also discussed. It was observed that the excess pore pressure and axial strain under the static load alone decrease gradually with time. The trend of them largely depends on the ratio of cyclic load to static load.

scholarly journals Scour Effects on the Lateral Behavior of a Large-Diameter Monopile in Soft Clay: Role of Stress History

2019 ◽  
Vol 7 (6) ◽  
pp. 170 ◽  
Author(s):  
Ben He ◽  
Yongqing Lai ◽  
Lizhong Wang ◽  
Yi Hong ◽  
Ronghua Zhu
Keyword(s):  
Large Diameter ◽  
Soft Clay ◽  
Small Diameter ◽  
Initial Stiffness ◽  
Stress History ◽  
Soil Stiffness ◽  
Hypoplastic Model ◽  
History Effects ◽  
Conservative Estimation ◽  
Lateral Behavior

Scouring of soil around large-diameter monopile will alter the stress history, and therefore the stiffness and strength of the soil at shallow depth, with important consequence to the lateral behavior of piles. The existing study is mainly focused on small-diameter piles under scouring, where the soil around a pile is analyzed with two simplified approaches: (I) simply removing the scour layers without changing the strength and stiffness of the remaining soils, or (II) solely considering the effects of stress history on the soil strength. This study aims to investigate and quantify the scour effect on the lateral behavior of monopile, based on an advanced hypoplastic model considering the influence of stress history on both soil stiffness and strength. It is revealed that ignorance about the stress history effect (due to scouring) underestimates the extent of the soil failure wedge around the monopile, while overestimates soil stiffness and strength. As a result, a large-diameter pile (diameter D = 5 m) in soft clay subjected to a souring depth of 0.5 D has experienced reductions in ultimate soil resistance and initial stiffness of the p-y curves by 40% and 26%, and thus an increase of pile head deflection by 49%. Due to the inadequacy to consider the stress history effects revealed above, the existing approach (I) has led to non-conservative estimation, while the approach (II) has resulted in an over-conservative prediction.

Uplift tests on full-scale pipe segment in lumpy soft clay backfill

2016 ◽  
Vol 53 (4) ◽  
pp. 578-588 ◽  
Author(s):  
R.P. Chen ◽  
B. Zhu ◽  
W.J. Ni
Keyword(s):  
Shear Strength ◽  
Soft Clay ◽  
Vertical Displacement ◽  
Undrained Shear Strength ◽  
Full Scale ◽  
Scale Model ◽  
Pressure Transducers ◽  
Pipe Segment ◽  
Clay Ground ◽  
Undrained Shear

Upheaval buckling of pipelines caused by thermal- and pressure-induced loading is an important issue in pipeline design. The uplift capacity of pipelines is determined by the pipe–soil interaction during pipeline upheaval in soil. Pipelines to be installed in soft clay are usually placed into trenches and then backfilled. In this paper, a set of test devices were developed and a series of full-scale model tests were carried out on a pipe segment buried in lumpy soft clay backfill, including backfilling tests, load-controlled uplift tests, and a displacement-controlled test. Eight total pressure transducers were embedded in the wall of the pipe segment to measure soil pressures on the pipe segment, and five linear variable differential displacement transducers (LVDTs) were arranged to record the vertical displacement of the pipe segment and the surface of the soft clay ground. The stabilizing force keeping the pipe segment in place during the backfilling process was found to fit a nearly linear relationship with the dimensionless undrained shear strength of soft clay. The variation of soil pressures on the pipe segment during uplift loading was significantly affected by the buried depth of the pipe segment and the undrained shear strength of the soil. For all present load-controlled tests in lumpy soft clay backfill, the test ultimate uplift resistances were only about 19%–81% of the results calculated by the Det Norske Veritas approach. Mainly due to the voids’ compression, shearing and strain softening of lumpy soft clay backfill, the difference between initial and stable displacements in a loading step for a load-controlled test or initial and stable loads in a displacement step for a displacement-controlled test is remarkable. The limits of uplift resistances are recommended for the instant and sustaining behaviors of the pipe segment, respectively.

Sign in / Sign up

Export Citation Format

Share Document