scholarly journals Changes of Coal Strength under Hydrostatic Pressure Caused by CO2 and N2 Injection

2020 ◽  
Vol 136 (11) ◽  
pp. 134-139
Author(s):  
Takashi TAKEHARA ◽  
Yasuki OIKAWA ◽  
Takashi FUJII ◽  
Kuniyuki MIYAZAKI
Keyword(s):  
Hydrostatic Pressure ◽  
Coal Strength

The Hydrostatic Pressure Effect on Elastic Properties of B2-Phase Single Crystals Ti50Ni48Fe2and Ti50Ni45Fe5Alloys

1995 ◽  
Vol 05 (C8) ◽  
pp. C8-729-C8-734
Author(s):  
A.I. Lotkov ◽  
V.P. Lapshin ◽  
V.A. Goncharova ◽  
H.V Chernysheva ◽  
V.N. Grishkov ◽  
...  
Keyword(s):  
Hydrostatic Pressure ◽  
Single Crystals ◽  
Elastic Properties ◽  
Pressure Effect ◽  
B2 Phase

ELECTRICAL CONDUCTIVITY BEHAVIOUR OF Gd DOPED EuO UNDER HYDROSTATIC PRESSURE

1980 ◽  
Vol 41 (C5) ◽  
pp. C5-219-C5-222
Author(s):  
J. P. Desfours ◽  
C. Godart ◽  
J. P. Nadai ◽  
A. Mauger ◽  
G. Weill ◽  
...  
Keyword(s):  
Electrical Conductivity ◽  
Hydrostatic Pressure ◽  
Conductivity Behaviour

Action of hydrostatic pressure and applications in food technologies

2019 ◽  
Author(s):  
Viktoriya Kotkova ◽  
◽  
Aleksei Volkov ◽  
Lyudmila Donskova ◽  
◽  
...  
Keyword(s):  
Hydrostatic Pressure

Survival of mouse blastocysts after low-temperature preservation under high pressure

2004 ◽  
Vol 52 (4) ◽  
pp. 479-487 ◽  
Author(s):  
Cs. Pribenszky ◽  
M. Molnár ◽  
S. Cseh ◽  
L. Solti
Keyword(s):  
Phase Transition ◽  
Hydrostatic Pressure ◽  
Low Temperature ◽  
High Hydrostatic Pressure ◽  
Room Temperature ◽  
Freezing Point ◽  
Significant Loss ◽  
Embryo Cryopreservation ◽  
Subzero Temperatures ◽  
Survival Capacity

Cryoinjuries are almost inevitable during the freezing of embryos. The present study examines the possibility of using high hydrostatic pressure to reduce substantially the freezing point of the embryo-holding solution, in order to preserve embryos at subzero temperatures, thus avoiding all the disadvantages of freezing. The pressure of 210 MPa lowers the phase transition temperature of water to -21°C. According to the results of this study, embryos can survive in high hydrostatic pressure environment at room temperature; the time embryos spend under pressure without significant loss in their survival could be lengthened by gradual decompression. Pressurisation at 0°C significantly reduced the survival capacity of the embryos; gradual decompression had no beneficial effect on survival at that stage. Based on the findings, the use of the phenomena is not applicable in this form, since pressure and low temperature together proved to be lethal to the embryos in these experiments. The application of hydrostatic pressure in embryo cryopreservation requires more detailed research, although the experience gained in this study can be applied usefully in different circumstances.

Fabrication and study the effect of the laser on the properties of the compound Tl2-xHgxBa2-ySryCa2Cu3O10+δ superconductor

2018 ◽  
pp. 168
Author(s):  
A. Kareem Dahash Ali ◽  
Nihad Ali Shafeek
Keyword(s):  
Transition Temperature ◽  
Solid State ◽  
Hydrostatic Pressure ◽  
Electrical Properties ◽  
Co2 Laser ◽  
Temperature Shift ◽  
Unit Cell ◽  
X Ray Diffraction ◽  
X Ray ◽  
Structural And Electrical Properties

This study included the fabrication of    compound (Tl2-xHgxBa2-ySryCa2Cu3O10+δ) in a manner solid state and under hydrostatic pressure ( 8 ton/cm2) and temperature annealing(850°C), and determine the effect of the laser on the structural and electrical properties elements in the compound, and various concentrations of x where (x= 0.1,0.2,0.3 ). Observed by testing the XRD The best ratio of compensation for x is 0.2 as the value of a = b = 5.3899 (A °), c = 36.21 (A °) show that the installation of four-wheel-based type and that the best temperature shift is TC= 142 K  .When you shine a CO2 laser on the models in order to recognize the effect of the laser on these models showed the study of X-ray diffraction of these samples when preparing models with different concentrations of the values ​​of x, the best ratio of compensation is 0.2 which showed an increase in the values ​​of the dimensions of the unit cell a=b = 5.3929 (A °), c = 36.238 (A°). And the best transition temperature after shedding laser is TC=144 K. 

Sign in / Sign up

Export Citation Format

Share Document