scholarly journals Assessment of Root and Root Canal Shapes of Supernumerary Teeth in Maxillary Incisor Region Using Cone-Beam Computed Tomography

2020 ◽  
Vol 29 (2) ◽  
pp. 85-90
Author(s):  
Munetaka Naitoh ◽  
Shoko Tamaki Takada ◽  
Satoshi Nishida ◽  
Hiroyuki Nawa ◽  
Akiko Kato ◽  
...  
Keyword(s):  
Computed Tomography ◽  
Cone Beam Computed Tomography ◽  
Root Canal ◽  
Cone Beam ◽  
Maxillary Incisor ◽  
Supernumerary Teeth

scholarly journals Diagnosis of invasive cervical resorption by using cone beam computed tomography: report of two cases

2012 ◽  
Vol 23 (5) ◽  
pp. 602-607 ◽  
Author(s):  
Karla de Faria Vasconcelos ◽  
Yuri Nejaim ◽  
Francisco Haiter Neto ◽  
Frab Norberto Bóscolo
Keyword(s):  
Computed Tomography ◽  
Differential Diagnosis ◽  
Cone Beam Computed Tomography ◽  
Root Canal ◽  
Root Resorption ◽  
Imaging Modality ◽  
Relevant Information ◽  
Cone Beam ◽  
Short Period ◽  
Radiographic Interpretation

A radiographic interpretation is essential to the diagnosis of invasive cervical resorption (ICR) and the difficulty in distinguishing this lesion from internal root resorption has been highlighted in the literature. This paper reports the use of cone beam computed tomography (CBCT) in the diagnosis of ICR. The cases reports describe how CBCT can be used to make a differential diagnosis and also show that the use of this technology can provide relevant information on the location and nature of root resorption, which conventional radiographs cannot. As a result, the root canal treatment was not initially considered. The patients will be monitored and will undergo a scan after a short period of time to detect any small changes. It was observed that both cases benefited from CBCT in the diagnosis of ICR, because this imaging modality determined the real extent of resorption and possible points of communication with the periodontal space.

scholarly journals Use of Cone Beam Computed Tomography to Identify the Morphology of Maxillary and Mandibular Premolars in Chennai Population

2019 ◽  
Vol 22 (1) ◽  
pp. Process
Author(s):  
Rajamohan Rajakeerthi ◽  
Malli Suresh Babu Nivedhitha
Keyword(s):  
Computed Tomography ◽  
Cone Beam Computed Tomography ◽  
Root Canal ◽  
Treatment Success ◽  
Cone Beam ◽  
Type I ◽  
Root Canals ◽  
Computed Tomographic ◽  
Root Canal Anatomy ◽  
Computed Tomography Scanning

Objective: The complex root canal anatomy is inherently colonised by microbial flora. Endodontic treatment success is always related to adequate disinfection of the root canal space, which ultimately affects the treatment outcome. A thorough understanding of the external and internal root canal anatomy by using adequately imaging modalities is essential before planning any treatment. The aim of this study was to investigate the number and morphology of the root canals of maxillary and mandibular premolars in Chennai population. Material and Methods: Full-size cone-beam computed tomographic images were randomly collected from 100 patients, resulting in a total of 200 first and 200 second maxillary premolars as well as 200 first and 200 second mandibular premolars. All the eight premolars were analysed in single patients, who underwent cone-beam computed tomography scanning during pre-operative assessment (before implant surgery, orthodontic treatment, diagnosis of dental-alveolar trauma or difficult root canal treatment). Total number of roots and root canals, frequency and correlations between men and women were recorded and statistically analysed by using chi-square tests. The root canal configurations were rated according to the Vertucci’s classification. Results: In the maxillary first premolar group (n = 200), 36.3% had 1 root, 56.7% had 2 roots and 7.0% had 3 roots, with most exhibiting a type IV canal configuration. In the maxillary second premolar group (n = 200), 60% had 1 root, 29.8% had 2 roots and 10.2% had 3 roots, with the majority of single-rooted second premolars exhibiting a type I canal configuration. In the mandibular first premolar group (n = 200), 80.5% had 1 root, 9.8% had 2 roots and 5% had 3 roots. In the mandibular second premolar group (n=200), 90.1% had 1 root, 6.4% had 2 roots and 3.5 % had 3 roots, with most exhibiting a type I canal configuration. No statistical correlation was found between number of roots, gender and tooth position. Conclusion: This cone-beam computed tomographic study confirmed previous anatomical and morphological investigations. Therefore, the possibility of additional root canals should be considered when treating premolars. Keywords: Cone-beam computed tomography; Mandibular; Maxillary; Premolar; Root canal; Morphology.

scholarly journals Comparative evaluation of shaping ability of trunatomy and protaper gold files in curved canals using cone?beam computed tomography: An invitro study

2021 ◽  
Vol 6 (2) ◽  
pp. 101-105
Author(s):  
Kadam Krutika Kiran ◽  
Vagarali Hemant ◽  
Pujar Madhu A ◽  
Tamase Aishwarya S ◽  
Sahana Umesh
Keyword(s):  
Computed Tomography ◽  
Cone Beam Computed Tomography ◽  
Root Canal ◽  
Cone Beam ◽  
Human Teeth ◽  
Root Canals ◽  
Before And After ◽  
Canal Transportation ◽  
Group 2 ◽  
Shaping Ability

This study aimed to compare the canal transportation and canal centering ability in the preparation of curved root canals after instrumentation with TruNatomy (TN) (TN; Dentsply Sirona, Maillefer, Ballaigues, Switzerland) and ProTaper Gold (PG) (PG; Dentsply, Tulsa Dental Specialties, Tulsa, OK, USA) files using cone‑beam computed tomography (CBCT). 30 Single rooted extracted human teeth with root curvature ranging from 20-30° according to Schneider’s method were selected. Teeth with any visible cracks or fractures, calcifications, previous root canal treatments were excluded. The teeth were randomly assigned into two groups i.e. Group 1-TN and Group 2-PG (n = 15 each). The teeth were instrumented according to manufacturer’s guidelines for both the groups. Canals were scanned using a CBCT scanner before and after preparation to evaluate the transportation and centering ratio at 3 mm, 5 mm, and 7 mm from the apex. The data analysis was done using SPSS software and the test used was independent sample t test for comparison between the 2 groups.Data obtained suggested that TN group presented lesser canal transportation at the middle third of the root. The PG group showed better centering abitily at apical third of the root canal when both the groups were compared. TN resulted in less transportation than PG at the middle third, and PG showed better centering ability at the apical third. Overall, both systems safely prepared root canals, causing minimal errors.

scholarly journals Inferior alveolar nerve paraesthesia after overfilling into the mandibular canal, confirmed by cone-beam computed tomography: a case report

2021 ◽  
Vol 24 (2) ◽  
Author(s):  
Claudemir de Souza Júnior ◽  
Ricardo Machado ◽  
Renee Ashley Batts ◽  
Lucas da Fonseca Roberti Garcia
Keyword(s):  
Computed Tomography ◽  
Case Report ◽  
Cone Beam Computed Tomography ◽  
Root Canal ◽  
Inferior Alveolar Nerve ◽  
Mandibular Canal ◽  
Cone Beam ◽  
Filling Material ◽  
Mandibular Molar ◽  
Patient Reported

The filling material should be restricted to the root canal, and not extend to the periradicular tissues. Overextension occurs when there is an overflow of gutta-percha and sealer, whereas overfilling refers to the overflow only of sealer beyond the apical foramen. Both may cause several negative clinical consequences. Nevertheless, an accurate diagnosis of where they occurred cannot always be performed by conventional radiographic examination, because of the two-dimensional aspect of the image. This paper describes a clinical case of labiomandibular paraesthesia after overfilling into the mandibular canal (MC), as diagnosed by cone-beam computed tomography (CBCT), later used to perform the treatment planning. A 34-year-old Caucasian female patient sought a private dental clinic complaining of pain in the right mandibular posterior region. After taking the anamnesis and performing clinical and radiographic exams, the patient was diagnosed with pulp necrosis in the second right mandibular molar, and underwent root canal treatment. The final radiography showed overextension or overfilling, probably into the MC. About 2 hours after the procedure, the patient reported paraesthesia of her lower right lip and chin. A CBCT confirmed a small overfilling into the MC. For this reason, vitamin B12 was prescribed as the first treatment option. After 7 days, the patient reported a significant decrease in paraesthesia, and was completely normal after 15 days. This case report shows that CBCT is an effective radiographic diagnostic tool that can be used as an alternative in clinical cases of labiomandibular paraesthesia caused by overextension or overfilling.   Keywords Endodontic treatment; Overfilling; Paraesthesia; Conebeam computed tomography.

scholarly journals Prevalence of non-single canals in mandibular premolars and correlations with other anatomical variants: an in vivo cone beam computed tomography study

2019 ◽  
Author(s):  
Young-Eun Jang ◽  
Yemi Kim ◽  
Bom Sahn Kim ◽  
Sin-Young Kim ◽  
Hyung-Jong Kim
Keyword(s):  
Computed Tomography ◽  
Regression Analysis ◽  
Cone Beam Computed Tomography ◽  
Root Canal ◽  
Odds Ratio ◽  
Cone Beam ◽  
Anatomical Variants ◽  
Morphologic Characteristics ◽  
Type V

Abstract Background A knowledge regarding anatomical variants is important to achieve success in endodontic treatment. Root canal treatment of mandibular first premolars (PM1s) is challenging due to the existence of numerous variations in canal configurations, including a C-shaped variant. We aim to determine the prevalence and morphologic characteristics of non-single canals of mandibular first (PM1s) and second (PM2s) premolars in a Korean population using cone beam computed tomography (CBCT) and to evaluate correlations between non-single canals of PM1s and other anatomical variants, such as distolingual roots (DLRs) in mandibular first molars (M1s) and C-shaped canals in mandibular second molars (M2s). Methods A total of 971 PM1s and 997 PM2s from 500 patients were examined in vivo by CBCT. Root canal configurations and C-shaped canals were determined in accordance with the Vertucci classification and Fan classification, respectively. The correlation between non-single canals in PM1s and DLRs in M1s was evaluated using logistic regression analysis. Results PM2s typically had one root (99.89%) with one canal (98.4%). Among PM1s with non-single canals (21.2%), Vertucci type V (10.9%) and C-shaped (3.7%) canals were prevalent. Among C-shaped PM1 canals, the majority were Vertucci type V (77.8%); a C-shaped configuration (C2) was predominant mostly at the middle and/or apical third of the root. After adjusting for other variables (i.e., sex, age, and side), C-shaped canals in PM1s was significantly correlated with the presence of DLRs in M1s (odds ratio = 2.616; 95% confidence interval, 1.257–5.443; p = 0.010). Conclusions The presence of C-shaped PM1 canals was positively related to the presence of DLRs in M1s. Although C-shaped canals in PM1s are difficult to distinguish, this finding could aid clinicians in predicting C-shaped canal configurations in PM1s of patients who exhibit DLRs in M1s.

scholarly journals Evaluating the Iatrogenic Errors and the Quality of Root Canal Treatment of Mandibular Premolars in Ardabil Population Using the Cone Beam Computed Tomography in 2018

2019 ◽  
Vol 11 (2) ◽  
pp. 61-65
Author(s):  
Ahmad Nouroloyouni ◽  
Rohollah Basser ◽  
Zhila Salehi ◽  
Robab Farhang ◽  
Firooz Zadfattah ◽  
...  
Keyword(s):  
Computed Tomography ◽  
Cone Beam Computed Tomography ◽  
Root Canal ◽  
Root Canal Treatment ◽  
Cone Beam

Shark teeth: a case of multiple supernumerary teeth

2021 ◽  
Vol 14 (3) ◽  
pp. 135-137
Author(s):  
Fionnuala Loy ◽  
Victoria Elton
Keyword(s):  
Computed Tomography ◽  
Cone Beam Computed Tomography ◽  
Unusual Case ◽  
Treatment Options ◽  
Cone Beam ◽  
Supernumerary Teeth ◽  
Shark Teeth ◽  
Adjacent Structures ◽  
The Family ◽  
Dental Hospital

A 44-year-old male was referred to the Department of Orthodontics at Manchester Dental Hospital. He presented with pain from his heavily restored, lower right second premolar, which had an apical supplemental tooth, visible radiographically. The dentist queried whether the second premolar tooth could be extracted and the supplemental tooth aligned in its place. Clinical examination revealed no relevant abnormalities. The family and medical history were non-contributory. Panoramic tomography revealed multiple supplemental supernumerary teeth in the canine and premolar regions. Cone beam computed tomography and multidisciplinary team input were required to plan the treatment for this unusual case. CPD/Clinical Relevance: These findings highlight the management and treatment options for a case of non-syndromic, multiple supernumerary teeth. Consideration must be given to the risk of damage to adjacent structures if surgically removing supernumerary teeth, and the risk that supernumerary teeth may be ankylosed and not amenable to alignment within the arch.

Sign in / Sign up

Export Citation Format

Share Document