scholarly journals Examination of Material Compatibilities with Ionized and Vaporized Hydrogen Peroxide Decontamination

2020 ◽  
Vol 59 (6) ◽  
pp. 703-711
Author(s):  
Tohru Kimura ◽  
Hiroyuki Yahata ◽  
Yoshimichi Uchiyama
Keyword(s):  
Hydrogen Peroxide ◽  
Stainless Steel ◽  
Wide Spectrum ◽  
Steel Corrosion ◽  
Material Damage ◽  
Severe Damage ◽  
Coating Materials ◽  
Aeration Time ◽  
Dry Conditions ◽  
High Concentrations

Hydrogen peroxide (HP) decontamination is effective for a wide spectrum of pathogenic microorganisms. However, exposure to HP causes deleterious effects on some materials. The purpose of this study was to examine material compatibilities with ionized and vaporized hydrogen peroxide (iHP and VHP). With regard to iHP, 24 kinds of materials were exposed up to 100 cycles to iHP. The tested materials included plastics, metals, woods and plated or coated goods. The procedure of iHP decontamination was as following: gas time (11 min), dwell time (15 min) and aeration time (120 min). iHP decontamination caused some damage to copper, brass, chromium plate and galvanized iron immediately after exposure. Repeated iHP decontamination caused marked damage in stainless steel and urethane-, silicone- or epoxy-coating materials. Condensation of iHP decontamination posed severe damage for the material surfaces. With regard to VHP, 36 kinds of materials were exposed for up to 200 cycles to VHP decontamination. Under dry (dehumidified) conditions, VHP decontamination caused few changes on the surfaces of resin materials in dry conditions, although some resins began to develop hardening or softening. Discoloration was found in the stainless steel and changes in its coating materials. Bleaching was also observed in wooden materials. Under condensation conditions of VHP, nylon softened and butyl rubber hardened. Condensation of VHP caused material damage such as discoloration in the stainless steel, corrosion of zinc-plated steel, and air-bubbling under the color-steel sheet. The high concentrations of HP with condensation caused severe changes in metals and resins after repeated exposure. The VHP decontamination tests provided evidence that the material damage was more severe under condensation conditions than under dry conditions. Our results demonstrate the importance of condensation of HP when using it to decontaminate equipment.

Protective postaction of inhibitor IFKhAN-92 for chromium-nickel stainless steel corrosion in hydrochloric acid

2019 ◽  
pp. 20-25
Author(s):  
Ya.G. Avdeev ◽  
◽  
Yu.B. Makarychev ◽  
D.S. Kuznetsov ◽  
L.P. Kazanskii ◽  
...  
Keyword(s):  
Stainless Steel ◽  
Hydrochloric Acid ◽  
Steel Corrosion

Effects of hydrogen peroxide and hypochlorite on membrane potential of mitochondria in situ in rat heart cells

1991 ◽  
Vol 69 (11) ◽  
pp. 1705-1712 ◽  
Author(s):  
Noburu Konno ◽  
K. J. Kako
Keyword(s):  
Hydrogen Peroxide ◽  
Membrane Potential ◽  
Mitochondrial Membrane Potential ◽  
Rat Heart ◽  
Mitochondrial Membrane ◽  
Isolated Rat Heart ◽  
Heart Mitochondria ◽  
High Concentrations ◽  
Isolated Rat

Hydrogen peroxide (H2O2) and hypochlorite (HOCl) cause a variety of cellular dysfunctions. In this study we examined the effects of these agents on the electrical potential gradient across the inner membrane of mitochondria in situ in isolated rat heart myocytes. Myocytes were prepared by collagenase digestion and incubated in the presence of H2O2 or HOCl. Transmembrane electrical gradients were measured by distribution of [3H]triphenylmethylphosphonium+, a lipophilic cation. The particulate fraction was separated from the cytosolic compartment first by permeabilization using digitonin, followed by rapid centrifugal sedimentation through a bromododecane layer. We found that the mitochondrial membrane potential (161 ± 7 mV, negative inside) was relatively well maintained under oxidant stress, i.e., the potential was decreased only at high concentrations of HOCl and H2O2 and gradually with time. The membrane potential of isolated rat heart mitochondria was affected similarly by H2O2 and HOCl in a concentration- and time-dependent manner. High concentrations of oxidants also reduced the cellular ATP level but did not significantly change the matrix volume. When the extra-mitochondrial free calcium concentration was increased in permeabilized myocytes, the transmembrane potential was decreased proportionally, and this decrease was potentiated further by H2O2. These results support the view that heart mitochondria are equipped with well-developed defense mechanisms against oxidants, but the action of H2O2 on the transmembrane electrical gradient is exacerbated by an increase in cytosolic calcium. Keywords: ATP, calcium, cardiomyocyte, cell defense, mitochondrial membrane potential, oxidant, triphenylmethylphosphonium.

Leaching of Am-241 from a Radioactive Waste Glass Corroded in the Presence of Stainless Steel Corrosion Products and/or Bentonite

1987 ◽  
Vol 112 ◽  
Author(s):  
Masaki Tsukamoto ◽  
Inga-Kari Björner ◽  
Hilbert Christensen ◽  
Hans-Peter Hermansson ◽  
Lars Werme
Keyword(s):  
Stainless Steel ◽  
Radioactive Waste ◽  
Mass Loss ◽  
Total Mass ◽  
Corrosion Behaviour ◽  
Steel Corrosion ◽  
Waste Glass ◽  
Corrosion Products ◽  
Total Mass Loss ◽  
Elemental Mass

AbstractThe release of Am-241 during corrosion of the radioactive waste glass, JSS-A, has been studied in the presence of corrosion products and/or uncom-pacted bentonite. The corrosion behaviour of Am-241 has been analyzed using gamma spectrometry. Adsorption of Am-241 on bentonite is observed in all cases. The contents of Am-241 in centrifuged leachates are in most cases less than 1/100 of total values. The normalized elemental mass loss of Am increases initially with corrosion time, and the values in the presence of bentonite and corrosion products are larger than those in the presence of bentonite alone. This tendency is in agreement with results previously found for other elements. The release of Am is low, only about 10–20 % of the corresponding total mass loss.

scholarly journals From Waste to Valuable Resource: Lignin as a Sustainable Anti-Corrosion Coating

Coatings ◽  
2018 ◽  
Vol 8 (12) ◽  
pp. 454 ◽  
Author(s):  
Arman Dastpak ◽  
Kirsi Yliniemi ◽  
Mariana de Oliveira Monteiro ◽  
Sarah Höhn ◽  
Sannakaisa Virtanen ◽  
...  
Keyword(s):  
Stainless Steel ◽  
Open Circuit Potential ◽  
Electrochemical Impedance ◽  
Steel Corrosion ◽  
Linear Sweep Voltammetry ◽  
Corrosion Current ◽  
Polymer Coatings ◽  
Open Circuit ◽  
Linear Sweep ◽  
Cyclic Potentiodynamic Polarization

In this study, a waste of biorefinery—lignin—is investigated as an anticorrosion coating on stainless steel. Corrosion behavior of two lignin types (hardwood beech and softwood spruce) was studied by electrochemical measurements (linear sweep voltammetry, open circuit potential, potentiostatic polarization, cyclic potentiodynamic polarization, and electrochemical impedance measurements) during exposure to simulated body fluid (SBF) or phosphate buffer (PBS). Results from linear sweep voltammetry of lignin-coated samples, in particular, demonstrated a reduction in corrosion current density between 1 and 3 orders of magnitude cf. blank stainless steel. Furthermore, results from cross cut adhesion tests on lignin-coated samples demonstrated that the best possible adhesion (grade 0) of ISO 2409 standard was achieved for the investigated novel coatings. Such findings suggest that lignin materials could transform the field of organic coatings towards more sustainable alternatives by replacing non-renewable polymer coatings.

Sign in / Sign up

Export Citation Format

Share Document