Effect of Mineral Fillers on the Oxidative Aging of Asphalt Binders

Author(s):  
Raquel Moraes ◽  
Hussein Bahia
2011 ◽  
Vol 2207 (1) ◽  
pp. 107-116 ◽  
Author(s):  
Nathan Morian ◽  
Elie Y. Hajj ◽  
Charles J. Glover ◽  
Peter E. Sebaaly

Author(s):  
Ruxin Jing ◽  
Panos Apostolidis ◽  
Xueyan Liu ◽  
Sandra Erkens ◽  
Tom Scarpas

Materials ◽  
2020 ◽  
Vol 13 (19) ◽  
pp. 4438
Author(s):  
Ingrid Gabrielle do Nascimento Camargo ◽  
Bernhard Hofko ◽  
Johannes Mirwald ◽  
Hinrich Grothe

Aging of asphalt binders is one of the main causes of its hardening, which negatively affects the cracking and fatigue resistance of asphalt binders. Understanding asphalt aging is crucial to improve the durability of asphalt pavements. In this regard, this study aims at understanding and differentiating the effect of temperature and oxygen uptake on the aging mechanisms of unmodified asphalt binders. For that, four laboratory aging procedures were employed. The two standardized procedures, rolling thin-film oven test (RTFOT) and pressure aging vessel (PAV), were considered to simulate the short-term and long-term aging of the asphalt binders, respectively. In addition, two thin-film aging test procedures, the nitrogen atmosphere oven aging test (NAAT) and ambient atmosphere oven aging test (OAAT) were employed to assess the effect of thermal and oxidative aging on unmodified asphalt binder properties. The NAAT procedure is based on the principle that the inert gas minimizes the oxidative aging. The rheological and chemical characterization showed that the high temperatures considered during the NAAT procedure did not change the properties of the unmodified asphalt binders. Therefore, it can be hypothesized that no significant thermal and oxidative aging was observed during NAAT aging procedure for the considered binders and that oxidative aging is the main cause for the hardening.


Author(s):  
Shin-Che Huang ◽  
J. Claine Petersen ◽  
Raymond Robertson ◽  
Jan F. Branthaver

An experiment involving neat asphalts AAD-1, ABD, and their mixtures with two different grades of hydrated lime was conducted to investigate the effect of lime on the long-term aging characteristics of asphalt binders. Rheological properties of unaged and aged asphalt-lime mixtures were measured with a dynamic shear rheometer at 25°C (77°F) and 60°C (140°F). The addition of hydrated lime to one asphalt (AAD-1) effectively reduced oxidative age hardening. In addition, the phase angle reached the same value as aging time reached after approximately 800 h at 60°C in the pressure-aging vessel for AAD-1 and its mixtures with lime. After 800 h of aging, the phase angle was greater for the limetreated asphalt than for the untreated asphalt, and it continued to decrease at a slower rate. This result indicates that the addition of lime to this asphalt increases the initial stiffness of the binder, but, more importantly, it preserves elasticity during long-term oxidative aging. Thus, for this asphalt, at a level of oxidation typical of pavements, limetreated and untreated asphalts arrived at the same viscosity with time, but the lime-treated asphalt had better viscous flow properties than the untreated asphalt. It could then be predicted that the aged, lime-treated asphalt would be more resistant to fatigue cracking. The other asphalt tested (ABD) did not exhibit substantial effects of lime on the rate of oxidative age hardening. This highly compatible, low-asphaltene asphalt is not typical of most paving asphalts. Because hydrated lime has been shown to reduce oxidative age hardening both in the laboratory and during the first few years in the pavement, adding hydrated lime should extend the useful lifetime of most asphalt pavements.


2020 ◽  
Vol 2020 ◽  
pp. 1-7
Author(s):  
Mithil Mazumder ◽  
Raju Ahmed ◽  
Moon-Sup Lee ◽  
Soon-Jae Lee

In between thermal-oxidative (heat and oxygen) and photo-oxidative (ultraviolet irradiation and oxygen) aging process of bitumen, photo-oxidative aging mainly depends on the optical properties of the asphalt binder. The higher the reflection (or the lower the absorption of the binders), the better the pavement serviceability. The literature review indicates that there is limited research conducted on the optical properties of the binder with wax additives. In this paper, the optical properties of commonly used binders (PG 64-22, Rubber modified binder, and SBS modified binder) containing wax additives (LEADCAP and Sasobit) were investigated using UV-Vis spectrometer. The result of this study showed that (1) the addition of modifiers (crumb rubber and SBS) with the base binder slightly increases the absorption of the binder; (2) the binder types and aging level have significant contribution on optical properties; (3) in general, the aged binders were observed to have higher reflectivity compared to the unaged binders; and (4) the addition of wax additives is observed to have a significant effect on the optical properties.


Author(s):  
Rafiqul A. Tarefder ◽  
Jielin Pan ◽  
Mohammad I. Hossain

An attempt is made to understand the chemical composition, oxidation mechanisms, and property changes of asphalt binders before and after oxidative aging using molecular dynamics (MD) simulations. Unoxidized and oxidized asphalts are subjected to different compressive and tensile stress rates, and moisture contents at room temperature. Results show that density, energy, and viscosity of the oxidized asphalt are higher than the unoxidized asphalt, indicating hardening and rheological property changes of asphalt after oxidation. Both the unoxidized and oxidized asphalts deform more and fail faster with an increase in stress rates, especially under tensile stress. The oxidized asphalt is stronger than the unoxidized asphalt under mechanical stress. Moisture inclusion affects viscosity more by decreasing the viscosity of the oxidized asphalt faster compared to the unoxidized asphalt. The viscosity of the oxidized asphalt is lower than that of the unoxidized asphalt above 5% moisture inclusion. This indicates that oxidized asphalt pavement might be exposed to more moisture-induced damage.


Author(s):  
Panos Apostolidis ◽  
Xueyan Liu ◽  
Sandra Erkens ◽  
Tom Scarpas

Miscibility, and lack of it, is decisive for durable polymer-modified asphalt binders and reflects the long-term performance of asphalt materials in terms of fatigue and thermal cracking. In this work, the glass transition behavior of epoxy asphalt will be assessed extensively after different oxidative aging time periods using differential scanning calorimetry. The composition dependence of glass transition in epoxy asphalt binders over oxidative aging is evaluated by emphasizing the deviation of glass transition temperature ( Tg) with the change in sign and magnitude. An entropy-based analysis of glass transitions in epoxy asphalt is discussed as well. The blends formulated by epoxy and asphalt binder have shown an increase of the Tg deviation from the ideal mixing rule over oxidative aging. Two different shapes of the composition dependence of the Tg values are observed between the blends with and without fillers but showing both distinct positive deviations from the case of mixing ideal materials. The Tg and heat capacity ( Cp) parameters determined in relation to the epoxy asphalt composition provide insights into the effect of limestone fillers on the oxidation-induced embrittlement of epoxy asphalt materials. The results could help select the epoxy proportion in asphalt to develop super-durable and long-lasting pavement materials.


Sign in / Sign up

Export Citation Format

Share Document