scholarly journals The Uplift of Unteraargletscher at the Beginning of the Melt Season—a Consequence of Water Storage at the Bed?

1979 ◽  
Vol 23 (89) ◽  
pp. 430-432 ◽  
Author(s):  
A. Iken ◽  
A. Flotron ◽  
W. Haeberli ◽  
H. Röthlisberger

AbstractThe results of systematic movement studies carried out by means of an automatic camera on the Unteraargletscher since 1969 (Flotron, 1973) are discussed together with more recent findings from theodolite measurements made at shorter intervals and over a longer section of the glacier.In addition to the typical spring/early-summer maximum of velocity known from other glaciers, an upward movement of up to 0.6 m has been recorded at the beginning of the melt season. It was followed, after various fluctuations of the vertical velocity, by a similar but slower downward movement which continued at an almost constant rate for about three months. The uplift was not confined to the section covered by the camera but occurred nearly simultaneously in profiles located 1 km below and 2 km above. The times of maximum upward velocity (increases of up to 140 mm/d) coincided approximately with periods of large horizontal velocity and occurred after increases of melt-rate.The following explanations for the variations of vertical velocity are considered: (1) Changes of longitudinal strain-rate. (2) Changes of the sliding velocity in a channel of variable width and with a bed slope deviating from horizontal. (3) Changes of volume due to opening or closing of crevasses. (4) Swelling or contraction of veins at the grain edges. (5) Growth (and closure) of cavities in the interior of the glacier. (6) Changes of large-scale water storage at the bed.Although all of the mechanisms (1)–(5) have some effect on the vertical ice movement, they cannot account for the observed variations of vertical velocity. We therefore conclude that large-scale water storage at the bed is the main cause of the uplift. Apparently the storage system is efficiently connected with the main subglacial drainage channels only during times of very high water pressure in the channels.The findings are of some interest to the concepts of glacier sliding: As mentioned above the maxima of horizontal velocity—and thus of the sliding velocity—have not been measured at the time when the storage had attained a maximum, but at the time of maximum vertical velocity, which we assume to be the time of most rapid growth of cavities at the bed. This behaviour of the sliding velocity agrees with that predicted by a simple finite-element model of the basal ice on a wavy bed with water-filled cavities. In particular, the model shows that the sliding velocity is larger during the process of cavity growth than at the final stage when the cavities have grown to the size which is stable for the applied water pressure.

1979 ◽  
Vol 23 (89) ◽  
pp. 430-432 ◽  
Author(s):  
A. Iken ◽  
A. Flotron ◽  
W. Haeberli ◽  
H. Röthlisberger

Abstract The results of systematic movement studies carried out by means of an automatic camera on the Unteraargletscher since 1969 (Flotron, 1973) are discussed together with more recent findings from theodolite measurements made at shorter intervals and over a longer section of the glacier. In addition to the typical spring/early-summer maximum of velocity known from other glaciers, an upward movement of up to 0.6 m has been recorded at the beginning of the melt season. It was followed, after various fluctuations of the vertical velocity, by a similar but slower downward movement which continued at an almost constant rate for about three months. The uplift was not confined to the section covered by the camera but occurred nearly simultaneously in profiles located 1 km below and 2 km above. The times of maximum upward velocity (increases of up to 140 mm/d) coincided approximately with periods of large horizontal velocity and occurred after increases of melt-rate. The following explanations for the variations of vertical velocity are considered: (1) Changes of longitudinal strain-rate. (2) Changes of the sliding velocity in a channel of variable width and with a bed slope deviating from horizontal. (3) Changes of volume due to opening or closing of crevasses. (4) Swelling or contraction of veins at the grain edges. (5) Growth (and closure) of cavities in the interior of the glacier. (6) Changes of large-scale water storage at the bed. Although all of the mechanisms (1)–(5) have some effect on the vertical ice movement, they cannot account for the observed variations of vertical velocity. We therefore conclude that large-scale water storage at the bed is the main cause of the uplift. Apparently the storage system is efficiently connected with the main subglacial drainage channels only during times of very high water pressure in the channels. The findings are of some interest to the concepts of glacier sliding: As mentioned above the maxima of horizontal velocity—and thus of the sliding velocity—have not been measured at the time when the storage had attained a maximum, but at the time of maximum vertical velocity, which we assume to be the time of most rapid growth of cavities at the bed. This behaviour of the sliding velocity agrees with that predicted by a simple finite-element model of the basal ice on a wavy bed with water-filled cavities. In particular, the model shows that the sliding velocity is larger during the process of cavity growth than at the final stage when the cavities have grown to the size which is stable for the applied water pressure.


1983 ◽  
Vol 29 (101) ◽  
pp. 28-47 ◽  
Author(s):  
A. Iken ◽  
H. Röthlisberger ◽  
A. Flotron ◽  
W. Haeberli

Abstract Results of systematic movement studies carried out by means of an automatic camera on Unteraargletscher since 1969 are discussed together with supplementary theodolite measurements made at shorter intervals and over a longer section of the glacier. In addition to the typical spring/early summer maximum of velocity known from other glaciers, an upward movement of up to 0.6 m has been recorded at the beginning of the melt season. It was followed, after a few fluctuations of the vertical velocity, by an equal but slower downward movement which continued at an almost constant rate for about three months. Possible explanations of the uplift are discussed, the most satisfactory explanation being water storage at the bed. The observations then suggest that this storage system is efficiently connected with the main subglacial drainage channels only during times of very high water pressure in the channels. Detailed measurements showed that the times of maximum horizontal velocity coincided with the times of maximum upward velocity rather than with the times when the elevation of the surveyed poles had reached a maximum. On the basis of the hypothesis of water storage at the bed this finding means that the sliding velocity is influenced mainly by the subglacial water pressure and the actual, transient stage of cavity development, while the amount of stored water is of lesser influence.


1983 ◽  
Vol 29 (101) ◽  
pp. 28-47 ◽  
Author(s):  
A. Iken ◽  
H. Röthlisberger ◽  
A. Flotron ◽  
W. Haeberli

AbstractResults of systematic movement studies carried out by means of an automatic camera on Unteraargletscher since 1969 are discussed together with supplementary theodolite measurements made at shorter intervals and over a longer section of the glacier. In addition to the typical spring/early summer maximum of velocity known from other glaciers, an upward movement of up to 0.6 m has been recorded at the beginning of the melt season. It was followed, after a few fluctuations of the vertical velocity, by an equal but slower downward movement which continued at an almost constant rate for about three months. Possible explanations of the uplift are discussed, the most satisfactory explanation being water storage at the bed. The observations then suggest that this storage system is efficiently connected with the main subglacial drainage channels only during times of very high water pressure in the channels. Detailed measurements showed that the times of maximum horizontal velocity coincided with the times of maximum upward velocity rather than with the times when the elevation of the surveyed poles had reached a maximum. On the basis of the hypothesis of water storage at the bed this finding means that the sliding velocity is influenced mainly by the subglacial water pressure and the actual, transient stage of cavity development, while the amount of stored water is of lesser influence.


2021 ◽  
Author(s):  
Rupert Gladstone ◽  
Yufang Zhang ◽  
Thomas Zwinger ◽  
Fabien Gillet-Chaulet ◽  
Michael Wolovick ◽  
...  

<p>Computer models for ice sheet dynamics are the primary tools for making future predictions of ice sheet behaviour, marine ice sheet instability, and ice sheet contributions to sea level change.  Such modelling studies face a number of challenges, and we consider here two examples.  The dominant mode of flow for ice streams is sliding at the bed, and the physical processes that control sliding are hard to observe. Ice sheet models often prescribe basal resistance as a function of sliding velocity.  But laboratory experiments and real-world observations indicate that basal resistance is also dependent on the water pressure in the sub-glacial hydrologic system, a property that is hard to constrain.  Initialising an ice sheet model for future projections is usually implemented either by a multi-millennial spin up or else by optimisation simulations, both of which have significant drawbacks.  In particular, long spin-up simulations cannot easily ensure a close match to present-day ice geometry, and optimisations cannot easily ensure an overall ice sheet mass balance that matches the present-day mass balance.</p><p>Using a 3D Stokes-flow ice dynamic model, we carry out optimisations for two Antarctic catchments: The Pine Island Glacier (PIG) in West Antarctica and the Lambert-Amery Glacier System (LAGS) in East Antarctica.  We optimise both the basal resistance and flow enhancement in order to minimise discrepancy between modelled and observed (from satellite) horizontal velocities at the ice upper surface.  We use these optimised model configurations to estimate the transient mass trend and also look at the 3D velocity field, its sensitivity to choice of boundary conditions in the normal direction at upper and lower surfaces, and its implications for the 3D temperature structure.  These simulations provide an estimate of the present-day thermo-mechanical state of the PIG and LAGS.</p><p>We demonstrate that constraining only horizontal velocity in the optimisations can lead to unrealistic normal velocities at the upper surface.  We show that this can, in turn, strongly impact on the catchment’s total mass budget (through locally unconstrained thinning/thickening rates) and lead to a large-scale bias in temperatures simulated using the optimised model with the steady state assumption, due to unphysical advection of heat through the ice upper surface.</p><p>We employ the optimised model to estimate basal melt, due mainly to friction heat, and drive a subglacial hydrology model beneath the PIG, providing a model-based estimate of the distribution of basal water pressure.  We use this, along with simulated sliding velocity and basal resistance, to evaluate some commonly used sliding relations.</p>


1999 ◽  
Vol 45 (151) ◽  
pp. 533-538 ◽  
Author(s):  
Niels Reeh ◽  
Søren Nørvang Madsen ◽  
Johan Jakob Mohr

AbstractUntil now, an assumption of surface-parallel glacier flow has been used to express the vertical velocity component in terms of the horizontal velocity vector, permitting all three velocity components to be determined from synthetic aperture radar interferometry. We discuss this assumption, which neglects the influence of the local mass balance and a possible contribution to the vertical velocity arising if the glacier is not in steady state. We find that the mass-balance contribution to the vertical surface velocity is not always negligible as compared to the surface-slope contribution. Moreover, the vertical velocity contribution arising if the ice sheet is not in steady state can be significant. We apply the principle of mass conservation to derive an equation relating the vertical surface velocity to the horizontal velocity vector. This equation, valid for both steady-state and non-steady-state conditions, depends on the ice-thickness distribution. Replacing the surface-parallel-flow assumption with a correct relationship between the surface velocity components requires knowledge of additional quantities such as surface mass balance or ice thickness.


2020 ◽  
Vol 185 ◽  
pp. 01023
Author(s):  
Yuan An ◽  
Jianing Li ◽  
Cenyue Chen

The intermittence and uncertainty of wind power and photovoltaic power have hindered the large-scale development of both. Therefore, it is very necessary to properly configure energy storage devices in the wind-solar complementary power grid. For the hybrid energy storage system composed of storage battery and supercapacitor, the optimization model of hybrid energy storage capacity is established with the minimum comprehensive cost as the objective function and the energy saving and charging state as the constraints. A simulated annealing artificial fish school algorithm with memory function is proposed to solve the model. The results show that the hybrid energy storage system can greatly save costs and improve system economy.


2020 ◽  
Author(s):  
Clément Beust ◽  
Erwin Franquet ◽  
Jean-Pierre Bédécarrats ◽  
Pierre Garcia ◽  
Jérôme Pouvreau ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document