scholarly journals Collecting Microplastics in Gardens: Case Study (i) of Soil

2021 ◽  
Vol 9 ◽  
Author(s):  
Zahra Sobhani ◽  
Yunlong Luo ◽  
Christopher T. Gibson ◽  
Youhong Tang ◽  
Ravi Naidu ◽  
...  

As an emerging contaminant, microplastic is receiving increasing attention. However, the contamination source is not fully known, and new sources are still being identified. Herewith, we report that microplastics can be found in our gardens, either due to the wrongdoing of leaving plastic bubble wraps to be mixed with mulches or due to the use of plastic landscape fabrics in the mulch bed. In the beginning, they were of large sizes, such as > 5 mm. However, after 7 years in the garden, owing to natural degradation, weathering, or abrasion, microplastics are released. We categorize the plastic fragments into different groups, 5 mm–0.75 mm, 0.75 mm–100 μm, and 100–0.8 μm, using filters such as kitchenware, meaning we can collect microplastics in our gardens by ourselves. We then characterized the plastics using Raman image mapping and a logic-based algorithm to increase the signal-to-noise ratio and the image certainty. This is because the signal-to-noise ratio from a single Raman spectrum, or even from an individual peak, is significantly less than that from a spectrum matrix of Raman mapping (such as 1 vs. 50 × 50) that contains 2,500 spectra, from the statistical point of view. From the 10 g soil we sampled, we could detect the microplastics, including large (5 mm–100 μm) fragments and small (<100 μm) ones, suggesting the degradation fate of plastics in the gardens. Overall, these results warn us that we must be careful when we do gardening, including selection of plastic items for gardens.

1989 ◽  
Vol 11 (2) ◽  
pp. 76-79
Author(s):  
K. M. Hangos ◽  
L. Leisztner

It is of great practical importance to develop simple methods for the automatic detection ofthe controlled state of the analytical method being applied. The key point is to find quantities that greatly affect the quality of the analytical results and that can be easily estimated during the measurement process from the measured data. The signal-to-noise ratio has proved to be such a quantity in gas chromatographic methods. The statistical properties of the estimation of the signal-to-noise ratio from gas chromatographic data have been investigated. The suggested practical method for estimating the signal-to-noise ratio proved to be biased from a mathematical statistical point of view, but the bias is usually not greater than 10%. It has been shown by practical examples that the signal-to-noise ratio affects the quality of the analytical results and it is easy to estimate its value from practical data.


Atmosphere ◽  
2021 ◽  
Vol 12 (5) ◽  
pp. 525
Author(s):  
Cataldo Godano ◽  
Vincenzo Convertito ◽  
Nicola Alessandro Pino

We analyse the earthquakes catalogues for Italy, South California, and Greece across the COVID-19 lockdown period for each country. The results for Italy and Greece show that, even if the reduction of the signal to noise ratio has improved the earthquake detection capability, the completeness magnitude remains substantially unchanged, making the improved detection capability ineffective from the statistical point of view. A slight reduction (0.2) of the completeness magnitude is observed for South California, likely related to the relatively higher number of seismic stations located close to urban areas. Our findings suggest that—given the present configuration of the seismic network considered here—only an important decrease in the station spacing can produce a significant decrease of the completeness magnitude.


1994 ◽  
Vol 04 (02) ◽  
pp. 441-446 ◽  
Author(s):  
V.S. ANISHCHENKO ◽  
M.A. SAFONOVA ◽  
L.O. CHUA

Using numerical simulation, we establish the possibility of realizing the stochastic resonance (SR) phenomenon in Chua’s circuit when it is excited by either an amplitude-modulated or a frequency-modulated signal. It is shown that the application of a frequency-modulated signal to a Chua’s circuit operating in a regime of dynamical intermittency is preferable over an amplitude-modulated signal from the point of view of minimizing the signal distortion and maximizing the signal-to-noise ratio (SNR).


2018 ◽  
Vol 42 (1) ◽  
pp. 167-174 ◽  
Author(s):  
V. I. Parfenov ◽  
D. Y. Golovanov

An algorithm for estimating time positions and amplitudes of a periodic pulse sequence from a small number of samples was proposed. The number of these samples was determined only by the number of pulses. The performance of this algorithm was considered on the assumption that the spectrum of the original signal is limited with an ideal low-pass filter or the Nyquist filter, and conditions for the conversion from one filter to the other were determined. The efficiency of the proposed algorithm was investigated through analyzing in which way the dispersion of estimates of time positions and amplitudes depends on the signal-to-noise ratio and on the number of pulses in the sequence. It was shown that, from this point of view, the efficiency of the algorithm decreases with increasing number of sequence pulses. Besides, the efficiency of the proposed algorithm decreases with decreasing signal-to-noise ratio.It was found that, unlike the classical maximum likelihood algorithm, the proposed algorithm does not require a search for the maximum of a multivariable function, meanwhile characteristics of the estimates are practically the same for both these methods. Also, it was shown that the estimation accuracy of the proposed algorithm can be increased by an insignificant increase in the number of signal samples.The results obtained may be used in the practical design of laser communication systems, in which the multipulse pulse-position modulation is used for message transmission. 


2015 ◽  
Vol 3 (1) ◽  
pp. SB1-SB4 ◽  
Author(s):  
Donald A. Herron

Interpreters use horizon autopicking in many seismic interpretations in the modern workstation environment. When properly used and with data quality permitting this technique enables efficient and accurate tracking of horizons but is not without its pitfalls. Four common pitfalls are improper selection of the input control or seed grid, not accounting for the “directional” behavior of tracking algorithms, attempting autopicking in areas with poor reflection continuity and/or low signal-to-noise ratio, and failing to recognize elements of geology that are not suitable for autopicking.


Geophysics ◽  
2009 ◽  
Vol 74 (6) ◽  
pp. V133-V141 ◽  
Author(s):  
J. Wang ◽  
F. Tilmann ◽  
R. S. White ◽  
P. Bordoni

Hydraulic fracture-induced microseismic events in producing oil and gas fields are usually small, and noise levels are high at the surface as a result of the heavy equipment in use. Similarly, in nonhydrocarbon settings, arrays for detecting local earthquakes will benefit from reduced noise levels and the ability to detect smaller events will be increased. We propose a frequency-dependent multichannel Wiener filtering technique with linear constraints that uses an adaptive least-squares method to remove coherent noise in seismic array data. The noise records on several reference channels are used to predict the noise on a primary channel and then can be subtracted from the observed data. On a test with an unconstrained version of this filter, maximal noise suppression leads to signal distortion. Two methods of im-posing constraints then achieve signal preservation. In one case study, synthetic signals are added to noise from a pilot deployment of a hexagonal array (nine three-component seismometers, approximately [Formula: see text]) above a gas field; noise levels are suppressed by up to [Formula: see text] (at [Formula: see text]). In a second case study, natural seismicity recorded at a dense array ([Formula: see text] spacing) in Italy is used, where the application of the filter improves the signal-to-noise ratio (S/N) more than [Formula: see text] (at [Formula: see text]) using 35 stations. In both cases, the performance of the multichannel Wiener filters is significantly better than stacking, espe-cially at lower frequencies where stacking does not help to suppress the coherent noise. The unconstrained version of the filter yields the best improvement in signal-to-noise ratio, but the constrained filter is useful when waveform distortion is unacceptable.


1994 ◽  
Vol 38 ◽  
pp. 691-698
Author(s):  
K. Kansai ◽  
K. Toda ◽  
H. Kohno ◽  
T. Arai ◽  
R. Wilson

Advancements in trace clement analysis require improvements in both the signal-to-noise ratio and accurate background correction. With a sequential spectrometer, one can obtain detection limits of around 0.1 ppm for medium to heavy Z elements. Conditions can be individually optimized for each element, for example, selection of filters, collimators, crystals and background subtraction. The disadvantage is that the analysis time may become “long” if many elements are to be analyzed. This long exposure time can lead to the deterioration of some samples.


Sign in / Sign up

Export Citation Format

Share Document