scholarly journals FEM Analysis and Sensor-Based Measurement Scheme of Current Distribution for Grounding Electrode

2020 ◽  
Vol 10 (22) ◽  
pp. 8151
Author(s):  
Li Zhu ◽  
Hui Jiang ◽  
Fan Yang ◽  
Hanwu Luo ◽  
Wenzhen Li ◽  
...  

The current distribution of the grounding electrode in a high-voltage direct current (HVDC) transmission system affects the state of power equipment in its vicinity, which depends on the soil resistivity and shape of the grounding electrode. In this paper, current distribution in the vicinity of an ±800 kV grounding electrode is investigated by simulation and experiments. Firstly, the model to calculate the current distribution with two typical frozen soils is set up, and simulation models and experimental platforms are established; meanwhile, the finite element method (FEM) is used to calculate the current and potential dispersion of linear, cross-shaped, and ring-shaped grounding electrodes in the simulation models. After obtaining the lab current data from the simulation, an innovative method based on a “drainage wire” with a Hall sensor is proposed to measure the current in an experimental setup. The results show that current and potential distribution characteristics are related to the shape of the grounding electrode and soil resistivity. Meanwhile, the current measurement scheme can measure the current in soil with a lower error. This article concludes that these two typical models can reduce the complexity of frozen soil analysis, and the measurement scheme can accurately monitor the current to reduce the damage to the surrounding power equipment.

2021 ◽  
Vol 11 (12) ◽  
pp. 5623
Author(s):  
Nur Alia Farina Mohd Nasir ◽  
Mohd Zainal Abidin Ab Kadir ◽  
Miszaina Osman ◽  
Muhamad Safwan Abd Rahman ◽  
Ungku Anisa Ungku Amirulddin ◽  
...  

This paper presents a comparative analysis of different earthing designs’ performances, with particular interest on the use of earthing enhancing compound (EEC) for a selected earthing design of 500 kV transmission towers in a rocky soil, using the SESCAD tool of the Current distribution, electromagnetic field grounding and soil structure analysis (CDEGS) software. The simulation included the interpretation of soil profile and comparison between designs A, B and C, which are currently used for the 500 kV tower footing resistance (TFR) improvement. Results showed each design had reduced the TFR by 66%, 54.7% and 63.2% for the towers T42, T48 and T50, respectively. In some cases, further improvement of TFR is required, especially in the rocky area where the soil resistivity (SR) value is of more than 500 Ω⋅m. In this case, EEC was used in Design C, encasing both the vertical and horizontal electrodes, and it reduced the TFR further by 16% to 20%. The characteristics of the soil and earthing arrangement design play an important role in achieving a low TFR value, which is directly proportional to the backflashover occurrence and thus to the transmission line performance.


Author(s):  
Mahyar Asadi ◽  
Ghazi Alsoruji

Weld sequence optimization, which is determining the best (and worst) welding sequence for welding work pieces, is a very common problem in welding design. The solution for such a combinatorial problem is limited by available resources. Although there are fast simulation models that support sequencing design, still it takes long because of many possible combinations, e.g. millions in a welded structure involving 10 passes. It is not feasible to choose the optimal sequence by evaluating all possible combinations, therefore this paper employs surrogate modeling that partially explores the design space and constructs an approximation model from some combinations of solutions of the expensive simulation model to mimic the behavior of the simulation model as closely as possible but at a much lower computational time and cost. This surrogate model, then, could be used to approximate the behavior of the other combinations and to find the best (and worst) sequence in terms of distortion. The technique is developed and tested on a simple panel structure with 4 weld passes, but essentially can be generalized to many weld passes. A comparison between the results of the surrogate model and the full transient FEM analysis all possible combinations shows the accuracy of the algorithm/model.


2007 ◽  
Vol 17 (2) ◽  
pp. 1696-1699 ◽  
Author(s):  
Daisuke Miyagi ◽  
Satoru Iwata ◽  
Norio Takahashi ◽  
Shinji Torii

2003 ◽  
Vol 117 (3) ◽  
pp. 399 ◽  
Author(s):  
Rehaume Courtois ◽  
Jean-Pierre Ouellet ◽  
André Gingras ◽  
Claude Dussault ◽  
Laurier Breton ◽  
...  

We examined published historical information, reports on aerial surveys conducted since 1953, and harvest data collected since 1971 to describe changes in the distribution and abundance of Caribou (Rangifer tarandus) in Québec. The southern limit of the Caribou distribution diminished considerably in the late 19th century, and the decline in numbers probably continued until the 1960s and 1970s east of the 62nd meridian. South of the 49th parallel, only four small populations still persist. Despite the fact that all Caribou of the province were assigned to the same sub-species (R. t. caribou), three ecotypes with specific habitats and behaviour are found. The Barren-Ground ecotype, the only migratory form, is found north of the 52nd parallel. This ecotype currently occupies ≈ 255 000 km2 in fall and winter, mainly in the ecological subzones of the forest tundra and the taiga. The Barren-Ground Caribou was characterized by a very low abundance from the end of the 19th century until the mid-1950s, but increased markedly thereafter reaching over a million individuals at the beginning of the 1990s. Populations of the Mountain ecotype have been identified in the southeastern and, possibly, in the northeastern parts of the province. The latter Mountain population is virtually unknown. The southeastern population is sedentary and uses mainly the boreal forest. This population has decreased over the last century and currently numbers only ≈ 140 individuals. Finally, the Forest-Dwelling ecotype is found discontinuously, mainly between the 49th and 55th parallels. Its current distribution covers ≈ 235 000 km2, mainly east of the 72nd meridian. This sedentary ecotype is found almost exclusively in the boreal forest, principally in areas with long forest fire cycles. Its abundance has also decreased over the years. Large Forest-Dwelling populations still persisted during the 1950s and 1960s, but they apparently disappeared. The current abundance is not known precisely, but based on density estimates and considering the current distribution, it probably does not exceed 3000 individuals. Current data are insufficient to identify precisely the causes of the population decline, although hunting seems to be an important proximal cause.Nous avons utilisé les données historiques publiées, les rapports d’inventaires aériens réalisés depuis 1953 et les statistiques de récolte sportive colligées depuis 1971 pour décrire les changements dans la répartition et l’abondance du Caribou (Rangifer tarandus) au Québec. La limite méridionale de l’aire de répartition a beaucoup diminué à la fin du 19e siècle et la régression s’est probablement poursuivie durant les années 1960 et 1970 à l’est du 62e méridien. Au sud du 49e parallèle, on ne retrouve plus que quatre petites populations. Bien que tous les caribous du Québec soient considérés appartenir à la même sous-espèce (R. t. caribou), on distingue trois écotypes fréquentant des milieux différents et arborant des comportements spécifiques. Au nord du 52e parallèle, on retrouve l’écotype Toundrique, lequel est migrateur. Ces Caribous se répartissent sur ≈ 255 000 km2 durant l’automne et l’hiver, principalement dans les sous-zones écologiques de la toundra forestière et de la taïga. Cet écotype était peu abondant entre la fin du 19e siècle et le milieu des années 1950, mais il s’est accru considérablement pour atteindre plus d’un million d’individus au début des années 1990. Une population de l’écotype Montagnard est présente au sud-est de la province et une autre existe possiblement au nord-est. Cette dernière n’est pas bien connue. Celle du sud-est utilise principalement la forêt boréale. Cette population sédentaire a diminué considérablement depuis une centaine d’années et elle ne compte plus qu’environ 140 individus. Finalement, l’écotype Forestier est présent de façon discontinue, principalement entre les 49e et 55e parallèles. Ces Caribous sont également sédentaires. On les retrouve presque exclusivement en forêt boréale, principalement là où le cycle des feux de forêt est long. Leur répartition actuelle couvre ≈ 234 000 km2, principalement à l’est du 72e méridien. D’importantes populations forestières existaient encore durant les années 1950 et 1960, mais elles semblent avoir disparu. L’abondance actuelle n’est pas connue mais elle pourrait difficilement dépasser 3000 individus si l’on se base sur les estimations de la densité et de l’aire de répartition. Les données disponibles sont insuffisantes pour identifier les causes exactes des diminutions d’effectifs bien que la chasse semble une cause proximale importante.


2013 ◽  
Vol 9 (2) ◽  
pp. 137 ◽  
Author(s):  
Silvestar Šesnić ◽  
Dragan Poljak

The paper deals with an assessment of the influence of finite conductivity to the current induced along the horizontal grounding electrode. Analysis is performed in frequency and time domain, respectively. Current distribution along the grounding electrode buried in a lossy half-space is determined via analytical solution of the corresponding Pocklington equation in the frequency domain. The corresponding time domain response is obtained by means of Inverse Fast Fourier Transform (IFFT). The electrode is excited via an equivalent current source. Presence of the earth-air interface is taken into account via the simplified reflection coefficient arising from the Modified Image Theory (MIT). The electrode current is calculated for the case of perfectly conducting (PEC) electrode and for the electrodes made of copper and aluminum. Comparison of results shows no significant discrepancy between these electrodes, justifying the use of a PEC electrode approximation.


CORROSION ◽  
10.5006/3377 ◽  
2020 ◽  
Vol 76 (4) ◽  
pp. 385-397 ◽  
Author(s):  
Mehdi Attarchi ◽  
Marco Ormellese ◽  
Andrea Brenna

Linear anode-pipe arrangement cathodic protection system with a complete nonlinear cathode boundary condition is analyzed by finite element method numerical simulation to extract the effective parameters for both coated and uncoated pipe. The results show that defect size ratio, linear anode-to-pipe distance, and pipe diameter are fundamental parameters to design an effective cathodic protection system able to guarantee a proper current distribution. Soil resistivity has a significant effect on the current distribution of both coated and uncoated pipe. The results show that the 100 mV potential shift criterion for a single linear anode-pipe arrangement can be ineffective and a two anode system may be required.


Sign in / Sign up

Export Citation Format

Share Document