scholarly journals A Polyoxometalate Composite Based on Hierarchical MIL-101 with Enhanced Catalytic Activity in Methanolysis of Styrene Oxide

Catalysts ◽  
2020 ◽  
Vol 10 (7) ◽  
pp. 772
Author(s):  
Tian Zhao ◽  
Hexin Zhu ◽  
Ming Dong
Keyword(s):  
Catalytic Activity ◽  
Inductively Coupled Plasma ◽  
Styrene Oxide ◽  
Optical Emission ◽  
Catalytic Performance ◽  
Emission Spectrometry ◽  
Composite Catalyst ◽  
Immersion Method ◽  
X Ray ◽  
Inductively Coupled

A new efficient polyoxometalate composite catalyst of hierarchical MIL-101 and phosphotungstic acid (PTA) was facilely prepared by the immersion method. The material was thoroughly characterized by powder x-ray diffraction (PXRD), scanning electron microscopy (SEM), energy dispersive x-ray spectroscopy (EDX) and inductively coupled plasma‒optical emission spectrometry (ICP-OES). Compared to the pristine nonhierarchical MIL-101 composite, the hierarchical composite demonstrated much higher catalytic performance in methanolysis of styrene oxide, such as catalytic activity and reusability.

scholarly journals Environmentally benign copper nanoparticles supported on walnut shell as a highly durable nanocatalyst for the synthesis of propargylamines

2017 ◽  
Vol 82 (11) ◽  
pp. 1211-1221 ◽  
Author(s):  
Fariba Saadati ◽  
Vahid Leghaei ◽  
Asghar Zamani
Keyword(s):  
Copper Nanoparticles ◽  
Inductively Coupled Plasma ◽  
Optical Emission ◽  
Practical Method ◽  
Catalytic Performance ◽  
Emission Spectrometry ◽  
Walnut Shell ◽  
X Ray ◽  
Inductively Coupled ◽  
Three Component Reaction

This study was an attempt to prepare copper nanoparticles and to determine their catalytic activity employing walnut shell (WS) residue as a green support and a reusable material. The nanocatalyst was characterized though inductively coupled plasma optical emission spectrometry (ICP-OES), N2-sorption analysis, X-ray powder diffraction (XRD), energy-dispersive X-ray spectroscopy (EDS), and transmission electron microscopy (TEM). The catalytic performance of CuNPs@WS was then studied in the preparation of propargylamines via a three-component reaction. The catalyst could be recovered and reused without a significant decrease in its activity over eight reaction cycles. The simple methodology described herein is an economic, ecofriendly and practical method accompanied by higher yields.

scholarly journals The Effect of Mg and Zn Dopants on Pt/Al2O3 for the Dehydrogenation of Perhydrodibenzyltoluene

Catalysts ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 490
Author(s):  
Rudaviro Garidzirai ◽  
Phillimon Modisha ◽  
Innocent Shuro ◽  
Jacobus Visagie ◽  
Pieter van Helden ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Inductively Coupled Plasma ◽  
Flow Reactor ◽  
Plug Flow ◽  
Optical Emission ◽  
Catalytic Performance ◽  
Emission Spectrometry ◽  
Hydrogen Yield ◽  
X Ray ◽  
Temperature Programmed

The effects of Mg and Zn dopants on the catalytic performance of Pt/Al2O3 catalyst were investigated for dehydrogenation of perhydrodibenzyltoluene (H18-DBT) as a liquid organic hydrogen carrier. Al2O3 supports were modified with Mg and Zn to produce Mg-Al2O3 and Zn-Al2O3 with a target loading of 3.8 wt.% for dopants. The modified supports were impregnated with chloroplatinic acid solution to produce the catalysts Pt/Al2O3, Pt/Mg-Al2O3 and Pt/Zn-Al2O3 of 0.5 wt.% Pt loading. Thereafter, the catalysts were characterised using inductively coupled plasma- optical emission spectrometry, scanning electron microscopy-energy dispersive X-ray spectroscopy, hydrogen temperature-programmed reduction, carbon-monoxide pulse chemisorption, ammonia temperature-programmed desorption, X-ray diffraction and transmission electron microscopy. The dehydrogenation experiments were performed using a horizontal plug flow reactor system and the catalyst time-on-stream was 22 h. Pt/Mg-Al2O3 showed the highest average hydrogen flowrate of 29 nL/h, while an average of 27 nL/h was obtained for both Pt/Al2O3 and Pt/Zn-Al2O3. This has resulted in a hydrogen yield of 80% for Pt/Mg-Al2O3, 71% for Pt/Zn-Al2O3 and 73% for Pt/Al2O3. In addition, the conversion of H18-DBT ranges from 99% to 92%, Pt 97–90% and 96–90% for Pt/Mg-Al2O3, Pt/Zn-Al2O3 and Pt/Al2O3, respectively. Following the latter catalyst order, the selectivity to dibenzyltoluene (H0-DBT) ranges from 78% to 57%, 75–51% and 71–45%. Therefore, Pt/Mg-Al2O3 showed improved catalytic performance towards dehydrogenation of H18-DBT.

scholarly journals Paramagnetism of cobalt-doped ZnO nanoparticles obtained by microwave solvothermal synthesis

2015 ◽  
Vol 6 ◽  
pp. 1957-1969 ◽  
Author(s):  
Jacek Wojnarowicz ◽  
Sylwia Kusnieruk ◽  
Tadeusz Chudoba ◽  
Stanislaw Gierlotka ◽  
Witold Lojkowski ◽  
...  
Keyword(s):  
Solvothermal Synthesis ◽  
Quantum Interference ◽  
Inductively Coupled Plasma ◽  
Optical Emission ◽  
Spherical Particles ◽  
Emission Spectrometry ◽  
Initial State ◽  
X Ray ◽  
Inductively Coupled ◽  
State Present

Zinc oxide nanopowders doped with 1–15 mol % cobalt were produced by the microwave solvothermal synthesis (MSS) technique. The obtained nanoparticles were annealed at 800 °C in nitrogen (99.999%) and in synthetic air. The material nanostructure was investigated by means of the following techniques: X-ray diffraction (XRD), helium pycnometry density, specific surface area (SSA), inductively coupled plasma optical emission spectrometry (ICP-OES), extended X-ray absorption fine structure (EXAFS) spectroscopy, scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS) and with magnetometry using superconducting quantum interference device (SQUID). Irrespective of the Co content, nanoparticles in their initial state present a similar morphology. They are composed of loosely agglomerated spherical particles with wurtzite-type crystal structure with crystallites of a mean size of 30 nm. Annealing to temperatures of up to 800 °C induced the growth of crystallites up to a maximum of 2 μm in diameter. For samples annealed in high purity nitrogen, the precipitation of metallic α-Co was detected for a Co content of 5 mol % or more. For samples annealed in synthetic air, no change of phase structure was detected, except for precipitation of Co3O4 for a Co content of 15 mol %. The results of the magentometry investigation indicated that all as-synthesized samples displayed paramagnetic properties with a contribution of anti-ferromagnetic coupling of Co–Co pairs. After annealing in synthetic air, the samples remained paramagnetic and samples annealed under nitrogen flow showed a magnetic response under the influences of a magnetic field, likely related to the precipitation of metallic Co in nanoparticles.

scholarly journals Synthesis and characterization of Na-P1 (GIS) zeolite using a kaolinitic rock

2020 ◽  
Author(s):  
Daniela Novembre ◽  
Domingo Gimeno ◽  
Alessandro Del Vecchio
Keyword(s):  
Inductively Coupled Plasma ◽  
Rietveld Method ◽  
Ambient Pressure ◽  
Optical Emission ◽  
Emission Spectrometry ◽  
Quantitative Phase Analysis ◽  
X Ray Diffraction ◽  
X Ray ◽  
Cell Parameters ◽  
Inductively Coupled

Abstract This work focuses on the hydrothermal synthesis of Na-P1 zeolite by using a kaolinite rock coming from Romana (Sassari, Italy). The kaolin is calcined at a temperature of 650 °C and then mixed with calculated quantities of NaOH. The synthesis runs are carried out at ambient pressure and at variable temperatures of 65 ° and 100 °C. For the first time compared to the past, the Na-P1 zeolite is synthesized without the use of additives and through a protocol that reduces both temperatures and synthesis times. The synthesis products are analysed by X-ray diffraction, high temperature X-ray diffraction, infrared spectroscopy, scanning electron microscopy and inductively coupled plasma optical emission spectrometry. The cell parameters are calculated using the Rietveld method. Density and specific surface area are also calculated. The absence of amorphous phases and impurities in synthetic powders is verified through quantitative phase analysis using the combined Rietveld and reference intensity ratio methods.The results make the experimental protocol very promising for an industrial transfer.

scholarly journals Multi-Analytical Investigation of Stains on Dimension Stones in Master Valentim’s Fountain, Brazil

Minerals ◽  
2018 ◽  
Vol 8 (10) ◽  
pp. 465 ◽  
Author(s):  
Roberto da Conceição Ribeiro ◽  
Patrícia Marques Ferreira de Figueiredo ◽  
Daniel Silva Barbutti
Keyword(s):  
Inductively Coupled Plasma ◽  
Optical Emission ◽  
Xrd Analysis ◽  
Analytical Investigation ◽  
Main Element ◽  
Emission Spectrometry ◽  
X Ray ◽  
Inductively Coupled ◽  
Light Staining ◽  
Metallic Plates

Master Valentim’s fountain has become an important historical patrimony for Brazil, being portrayed by famous artists, among them Jean-Baptiste Debret. In 1938, it was registered as cultural heritage by the Brazilian National Historical and Artistic Heritage Institute (IPHAN), and in 1990 it was subjected to excavation and restoration works. The fountain was built in Gneiss and Lioz limestone, with metallic plates and mortar connecting the Gneiss blocks. Currently, deteriorations in the fountain stones can be observed, such as light stains and some aesthetic modifications caused by inadequate restorations. Petrography, X-ray fluorescence (XRF), XRD, physical properties, colorimetry, electrical conductivity, inductively coupled plasma optical emission spectrometry (ICP-OES), scanning electron microscopy-energy dispersive X-ray (SEM-EDX), and TGA were performed in order to characterize the Gneiss blocks, the metallic plates, and the stones used in previous restorations, as well as light stains observed on the Gneiss blocks. The petrography and XRD analyses inferred that the light stains may have been caused by the formation of an insoluble salt as a result of the association of the lead from the plates with other elements. The XRD analysis on the light staining area indicated the presence of cerussite (PbCO3) and anglesite (PbSO4), which are the probable cause of the light stains. The SEM-EDX results suggested that sulfur is the main element associated to lead.

Sign in / Sign up

Export Citation Format

Share Document