scholarly journals Polymorphism and Conformational Equilibrium of Nitro-Acetophenone in Solid State and under Matrix Conditions

Molecules ◽  
2021 ◽  
Vol 26 (11) ◽  
pp. 3109
Author(s):  
Łukasz Hetmańczyk ◽  
Przemysław Szklarz ◽  
Agnieszka Kwocz ◽  
Maria Wierzejewska ◽  
Magdalena Pagacz-Kostrzewa ◽  
...  
Keyword(s):  
Phase Transition ◽  
Density Functional Theory ◽  
Nitro Group ◽  
Conformational Changes ◽  
Density Functional ◽  
Conformational Equilibrium ◽  
Inelastic Neutron Scattering ◽  
Hydroxyl Group ◽  
Resonance Spectroscopy ◽  
Functional Theory

Conformational and polymorphic states in the nitro-derivative of o-hydroxy acetophenone have been studied by experimental and theoretical methods. The potential energy curves for the rotation of the nitro group and isomerization of the hydroxyl group have been calculated by density functional theory (DFT) to estimate the barriers of the conformational changes. Two polymorphic forms of the studied compound were obtained by the slow and fast evaporation of polar and non-polar solutions, respectively. Both of the polymorphs were investigated by Infrared-Red (IR) and Raman spectroscopy, Incoherent Inelastic Neutron Scattering (IINS), X-ray diffraction, nuclear quadrupole resonance spectroscopy (NQR), differential scanning calorimetry (DSC) and density functional theory (DFT) methods. In one of the polymorphs, the existence of a phase transition was shown. The position of the nitro group and its impact on the crystal cell of the studied compound were analyzed. The conformational equilibrium determined by the reorientation of the hydroxyl group was observed under argon matrix isolation. An analysis of vibrational spectra was achieved for the interpretation of conformational equilibrium. The infrared spectra were measured in a wide temperature range to reveal the spectral bands that were the most sensitive to the phase transition and conformational equilibrium. The results showed the interrelations between intramolecular processes and macroscopic phenomena in the studied compound.

DENSITY FUNCTIONAL THEORY STUDY OF H2O ADSORPTION AND DISSOCIATION ON Al (111) SURFACE

2013 ◽  
Vol 12 (05) ◽  
pp. 1350035 ◽  
Author(s):  
LIXIA YANG ◽  
XIAOLI LEI ◽  
JUN FENG ◽  
YUXIN ZHANG ◽  
MINGXING LIU
Keyword(s):  
Density Functional Theory ◽  
Density Functional ◽  
Catalytic Effect ◽  
Geometry Optimization ◽  
Vacancy Defect ◽  
Hydroxyl Group ◽  
Dissociation Pathway ◽  
Functional Theory ◽  
Lower Activation ◽  
Adsorption And Dissociation

Comparative study about the adsorption and dissociation behaviors of H2O molecule on clean and vacancy defective Al (111) surface was conducted by extensive density functional theory (DFT) calculations, the interaction mechanisms between H2O molecule and Al (111) surface were also figured out. Geometry optimization results indicated that H2O molecule was apt to be adsorbed at top site on these two kinds of surfaces, whereas, the adsorption configurations, the adsorption type and inclination of H2O molecule planes away from the normal were different. The calculated adsorption energies demonstrated that the adsorption of H2O molecule occurred more readily on vacancy defective Al (111) surface. The electron density distribution indicated that the vacancy defect enhanced the interactions between H2O molecule and surface Al atoms. Further analysis of the density of states (DOS) showed that the vacancy defect increased the number of bonding electrons between H2O molecule and surface Al atoms. The detailed exploration of dissociation pathways demonstrated that the dissociation of H2O molecule on these two kinds of surfaces was a two-step process: (1) H2O → H + OH , (2) OH → H + O . However, for each step the dissociation pathway variations on vacancy defective Al (111) surface were different with those on clean Al (111) surface. Compared with the first step, the dissociation of hydroxyl group into O atom and H atom was kinetically difficult. The calculated lower activation energy barriers on vacancy defective Al (111) surface showed that the vacancy defect had catalytic effect for the dissociation of H2O molecule to some extent, especially for the first step.

scholarly journals Structure and vibrational spectroscopy of methanesulfonic acid

2018 ◽  
Vol 5 (12) ◽  
pp. 181363 ◽  
Author(s):  
Lisha Zhong ◽  
Stewart F. Parker
Keyword(s):  
Density Functional Theory ◽  
Hydrogen Bonding ◽  
Vibrational Spectroscopy ◽  
Density Functional ◽  
Inelastic Neutron Scattering ◽  
Linear Chain ◽  
Methanesulfonic Acid ◽  
Chain Structure ◽  
Trifluoromethanesulfonic Acid ◽  
Functional Theory

In this work, we have used a combination of vibrational spectroscopy (infrared, Raman and inelastic neutron scattering) and periodic density functional theory to investigate the structure of methanesulfonic acid (MSA) in the liquid and solid states. The spectra clearly show that the hydrogen bonding is much stronger in the solid than the liquid state. The structure of MSA is not known; however, mineral acids typically adopt a chain structure in condensed phases. A periodic density functional theory (CASTEP) calculation based on the linear chain structure found in the closely related molecule trifluoromethanesulfonic acid gave good agreement between the observed and calculated spectra, particularly with regard to the methyl and sulfonate groups. The model accounts for the large widths of the asymmetric S-O stretch modes; however, the external mode region is not well described. Together, these observations suggest that the basic model of four molecules in the primitive unit cell, linked by hydrogen bonding into chains, is correct, but that MSA crystallizes in a different space group than that of trifluoromethanesulfonic acid.

scholarly journals A High-Pressure Investigation of the Synthetic Analogue of Chalcomenite, CuSeO3∙2H2O

Crystals ◽  
2019 ◽  
Vol 9 (12) ◽  
pp. 643 ◽  
Author(s):  
Javier Gonzalez-Platas ◽  
Placida Rodriguez-Hernandez ◽  
Alfonso Muñoz ◽  
U. R. Rodríguez-Mendoza ◽  
Gwilherm Nénert ◽  
...  
Keyword(s):  
Phase Transition ◽  
Density Functional Theory ◽  
Raman Spectroscopy ◽  
Pressure Dependence ◽  
Density Functional ◽  
Unit Cell ◽  
X Ray Diffraction ◽  
Functional Theory ◽  
X Ray ◽  
Raman Modes

Synthetic chalcomenite-type cupric selenite CuSeO3∙2H2O has been studied at room temperature under compression up to pressures of 8 GPa by means of single-crystal X-ray diffraction, Raman spectroscopy, and density-functional theory. According to X-ray diffraction, the orthorhombic phase undergoes an isostructural phase transition at 4.0(5) GPa with the thermodynamic character being first-order. This conclusion is supported by Raman spectroscopy studies that have detected the phase transition at 4.5(2) GPa and by the first-principles computing simulations. The structure solution at different pressures has provided information on the change with pressure of unit–cell parameters as well as on the bond and polyhedral compressibility. A Birch–Murnaghan equation of state has been fitted to the unit–cell volume data. We found that chalcomenite is highly compressible with a bulk modulus of 42–49 GPa. The possible mechanism driving changes in the crystal structure is discussed, being the behavior of CuSeO3∙2H2O mainly dominated by the large compressibility of the coordination polyhedron of Cu. On top of that, an assignation of Raman modes is proposed based upon density-functional theory and the pressure dependence of Raman modes discussed. Finally, the pressure dependence of phonon frequencies experimentally determined is also reported.

scholarly journals Predicted polymorph manipulation in an exotic double perovskite oxide

2019 ◽  
Vol 7 (39) ◽  
pp. 12306-12311 ◽  
Author(s):  
He-Ping Su ◽  
Shu-Fang Li ◽  
Yifeng Han ◽  
Mei-Xia Wu ◽  
Churen Gui ◽  
...  
Keyword(s):  
Phase Transition ◽  
Density Functional Theory ◽  
First Principles ◽  
Density Functional ◽  
Double Perovskite ◽  
Density Functional Theory Calculations ◽  
Perovskite Oxide ◽  
Functional Theory ◽  
First Time ◽  
Perovskite Type

First-principles density functional theory calculations, for the first time, was used to predict the Mg3TeO6-to-perovskite type phase transition in Mn3TeO6 at around 5 GPa.

Sign in / Sign up

Export Citation Format

Share Document