scholarly journals Dopamine Assisted One-Step Pyrolysis of Glucose for the Preparation of Porous Carbon with A High Surface Area

Nanomaterials ◽  
2018 ◽  
Vol 8 (10) ◽  
pp. 854 ◽  
Author(s):  
Hanbo Xiao ◽  
Cheng-an Tao ◽  
Yujiao Li ◽  
Xianzhe Chen ◽  
Jian Huang ◽  
...  
Keyword(s):  
Surface Area ◽  
Porous Carbon ◽  
Carbon Materials ◽  
High Current Density ◽  
High Surface ◽  
High Surface Area ◽  
Energy Storage Materials ◽  
One Pot ◽  
Component Structure ◽  
Porous Carbon Materials

Herein, a facile dopamine assisted one-pot synthesis approach is proposed for the preparation of porous carbon with a specific surface area (SSA) up to 2593 m2/g through the direct pyrolysis of a mixture of glucose, NH4Cl, and dopamine hydrochloride (DAH). The glucose is adopted as the carbon source and foaming agent, NH4Cl is used as the blowing agent, and DAH is served as collaborative carbon precursor as well as the nitrogen source for the first time. The effect of dopamine on the component, structure, and SSA of the as-prepared porous carbon materials are systematically studied. The moderate addition of dopamine, which influences the condensation and polymerization of glucose, matches better with ammonium salt decomposition. The SSA of porous carbon increases first and then decreases with the increasing amount of dopamine. In our case, the porous carbon produced with 5 wt% dopamine (PC-5) achieves the maximum SSA of up to 2593 m2/g. Accordingly, it also shows the greatest electrochemical performance. The PC-5 shows a capacitance of 96.7 F/g calculated from the discharge curve at 1 A/g. It also has a good capacitive rate capacity, the specific capacitance can still maintain 80%, even at a high current density of 10 A/g. Moreover, PC-5 exhibits a good cycling stability of 98.1% capacitive retention after 1000 cycles. The proposed method may show promising prospects for preparing porous carbon materials as advanced energy storage materials, storage, and catalyst supports.

scholarly journals Effect of Air Oxidation on Texture, Surface Properties and Dye Adsorption of Wood-Derived Porous Carbon Materials

Materials ◽  
2019 ◽  
Vol 12 (10) ◽  
pp. 1675 ◽  
Author(s):  
Suhong Ren ◽  
Liping Deng ◽  
Bo Zhang ◽  
Yafang Lei ◽  
Haiqing Ren ◽  
...  
Keyword(s):  
Surface Area ◽  
Functional Groups ◽  
Porous Carbon ◽  
Carbon Materials ◽  
Dye Adsorption ◽  
Carbon Surface ◽  
Air Oxidation ◽  
Activation Temperature ◽  
Porous Carbon Materials ◽  
Hierarchical Porous

Hierarchical porous carbon materials made from cork were fabricated using a facile and green method combined with air activation, without any templates and chemical agents. The influence of air activation on the texture and other surface characteristics of the carbon materials were evaluated by various characterization techniques. Results indicate that air oxidation can effectively improve the surface area and the hierarchical porous structure of carbon materials, as well as increase the number of oxygen-containing functional groups on the carbon surface. The specific surface area and the pore volume of the carbon material activated by air at 450 °C (C800-M450) can reach 580 m2/g and 0.379 cm3/g, respectively. These values are considerably higher than those for the non-activated material (C800, 376 m2/g, 0.201 cm3/g). The contents of the functional groups (C–O, C=O and O–H) increased with rising activation temperature. After air activation, the adsorption capacity of the carbon materials for methylene blue (MB) and methyl orange (MO) was increased from 7.7 and 6.4 mg/g for C800 to 312.5 and 97.1 mg/g for C800-M450, respectively. The excellent dye removal of the materials suggests that the porous carbon obtained from biomass can be potentially used for wastewater treatment.

scholarly journals Highly Porous Carbon Materials from Biomass by Chemical and Carbonization Method: A Comparison Study

2013 ◽  
Vol 2013 ◽  
pp. 1-6 ◽  
Author(s):  
Wan Nor Roslam Wan Isahak ◽  
Mohamed Wahab Mahamed Hisham ◽  
Mohd Ambar Yarmo
Keyword(s):  
Sulfuric Acid ◽  
Thermal Behavior ◽  
Surface Area ◽  
Porous Carbon ◽  
High Surface ◽  
High Surface Area ◽  
Empty Fruit Bunches ◽  
Heating Treatment ◽  
Concentrated Sulfuric Acid ◽  
Highly Porous

Porous carbon obtained by dehydrating agent, concentrated sulfuric acid (H2SO4), from biomass containing high cellulose (filter paper (FP), bamboo waste, and empty fruit bunches (EFB)) shows very high surface area and better thermal behavior. At room temperature (without heating), treatment of H2SO4removed all the water molecules in the biomass and left the porous carbon without emitting any gaseous byproducts. Brunauer-Emmett-Teller (BET) surface analysis has shown that bamboo-based carbon has good properties with higher surface area (507.8 m2/g), micropore area (393.3 m2/g), and better thermal behavior (compared to FP and EFB) without any activation or treatment process. By acid treatment of biomass, it was shown that higher carbon composition obtained from FP (85.30%), bamboo (77.72%), and EFB (76.55%) is compared to carbon from carbonization process. Under optimal sulfuric acid (20 wt.%) uses, high carbon yield has been achieved for FP (47.85 wt.%), bamboo (62.4 wt.%), and EFB (55.4 wt.%).

Preparing high surface area porous carbon from biomass by carbonization in a molten salt medium

RSC Advances ◽  
2015 ◽  
Vol 5 (92) ◽  
pp. 75728-75734 ◽  
Author(s):  
Huishan Shang ◽  
Yanjie Lu ◽  
Feng Zhao ◽  
Cong Chao ◽  
Bing Zhang ◽  
...  
Keyword(s):  
Molten Salt ◽  
Surface Area ◽  
Porous Carbon ◽  
High Surface ◽  
High Surface Area ◽  
Molten Salt Synthesis ◽  
Synthesis Process ◽  
Salt Medium ◽  
Peanut Shells

Peanut shells were transformed into porous carbon with a high surface area through a simple ZnCl2-molten salt synthesis process.

Rich N/O/S co-doped porous carbon with a high surface area from silkworm cocoons for superior supercapacitors

2019 ◽  
Vol 43 (48) ◽  
pp. 19372-19378 ◽  
Author(s):  
Jianyu Huang ◽  
Simin Liu ◽  
Zifang Peng ◽  
Zhuoxian Shao ◽  
Yuanyuan Zhang ◽  
...  
Keyword(s):  
Surface Area ◽  
Porous Carbon ◽  
Electrode Materials ◽  
Synergistic Effects ◽  
High Surface ◽  
High Surface Area ◽  
Porous Carbons ◽  
Co Doped

The synergistic effects of high surface area and abundant heteroatoms make porous carbons superior electrode materials.

scholarly journals Impact of Thermal Treatment of Nb2O5 on Its Performance in Glucose Dehydration to 5-Hydroxymethylfurfural in Water

Nanomaterials ◽  
2020 ◽  
Vol 10 (9) ◽  
pp. 1685
Author(s):  
Katarzyna Morawa Eblagon ◽  
Anna Malaika ◽  
Karolina Ptaszynska ◽  
Manuel Fernando R. Pereira ◽  
José Luís Figueiredo
Keyword(s):  
Thermal Treatment ◽  
Surface Area ◽  
Pure Water ◽  
High Surface ◽  
High Surface Area ◽  
Acid Sites ◽  
High Ratio ◽  
Total Acidity ◽  
One Pot ◽  
Niobic Acid

The cascade dehydration of glucose to 5-hydroxymethylfurfural (HMF) was carried out in water over a series of Nb2O5 catalysts, which were derived from the thermal treatment of niobic acid at 300 and 550 °C, under air or inert atmosphere. Amorphous niobic acid showed high surface area (366 m2/g) and large acidity (2.35 mmol/g). With increasing the temperature of the thermal treatment up to 550 °C, the amorphous Nb2O5 was gradually transformed into a pseudohexagonal phase, resulting in a decrease in surface area (27–39 m2/g) and total acidity (0.05–0.19 mmol/g). The catalysts’ performance in cascade dehydration of glucose realized in pure water was strongly influenced by the total acidity of these materials. A remarkable yield of 37% HMF in one-pot reaction in water was achieved using mesoporous amorphous niobium oxide prepared by thermal treatment of niobic acid at 300 °C in air. The best-performing catalyst displayed a total acidity lower than niobic acid (1.69 mmol/g) which afforded a correct balance between a high glucose conversion and limited further conversion of the target product to numerous polymers and humins. On the other hand, the treatment of niobic acid at 550 °C, independently of the atmosphere used during the sample preparation (i.e., air or N2), resulted in Nb2O5 catalysts with a high ratio of Lewis to Brønsted acid sites and poor total acidity. These materials excelled at catalyzing the isomerization step in the tandem process.

scholarly journals Sorghum-Waste-Derived High-Surface Area KOH-Activated Porous Carbon for Highly Efficient Methylene Blue and Pb(II) Removal

ACS Omega ◽  
2020 ◽  
Vol 5 (23) ◽  
pp. 13548-13556 ◽  
Author(s):  
Junhua Hou ◽  
Yijian Liu ◽  
Shikai Wen ◽  
Weitao Li ◽  
Riquan Liao ◽  
...  
Keyword(s):  
Methylene Blue ◽  
Surface Area ◽  
Porous Carbon ◽  
High Surface ◽  
High Surface Area ◽  
Highly Efficient
Sign in / Sign up

Export Citation Format

Share Document