scholarly journals Experimental and Simulation Investigation on the Kinetic Energy Dissipation Rate of a Fixed Spray-Plate Sprinkler

Water ◽  
2018 ◽  
Vol 10 (10) ◽  
pp. 1365 ◽  
Author(s):  
Yisheng Zhang ◽  
Bin Sun ◽  
Hongyuan Fang ◽  
Delan Zhu ◽  
Lingxia Yang ◽  
...  
Keyword(s):  
Energy Consumption ◽  
Energy Dissipation ◽  
Kinetic Energy ◽  
Water Conservation ◽  
Dissipation Rate ◽  
Water Distribution ◽  
Sprinkler Irrigation ◽  
High Energy ◽  
Nozzle Diameter ◽  
Working Pressure

Sprinkler irrigation is promoted due to its remarkable advantages in water conservation, but the high energy consumption limits its development in a situation of energy scarcity. In order to determine the energy consumption of a fixed spray-plate sprinkler (FSPS), its discharge and initial trajectory velocity were investigated using a particle image velocimetry (PIV) technique and computational fluid dynamics (CFD) analyses. A nozzle diameter of 4.76 mm was used under windless conditions. Overall, good agreement between simulation results and experimental values was obtained. On the premise that the simulation method produced high accuracy, a series of simulations was performed with different nozzle diameters. The water distribution pattern, stream trajectory velocity and kinetic energy dissipation were analyzed. The results show that the jet produced at the nozzle is split by grooves after it hits the plate, with separation occurring earlier with decreasing nozzle diameter. The area of the flow cross-section of the outlet is mainly influenced by nozzle diameter rather than working pressure. The initial trajectory velocity of the grooves increases logarithmically with increasing working pressure. A high working pressure may not cause large kinetic energy dissipation. The dissipation rate of the FSPS ranged from 28.01–50.97%, i.e., a large kinetic energy rate was observed. To reduce this energy dissipation and improve water use efficiency, the structure of the FSPS should be optimized in further research.

Effects of Plate Structure and Nozzle Diameter on Hydraulic Performance of Fixed Spray Plate Sprinklers at Low Working Pressures

2021 ◽  
Vol 64 (1) ◽  
pp. 231-242
Author(s):  
Rui Chen ◽  
Hong Li ◽  
Jian Wang ◽  
Chao Chen
Keyword(s):  
Water Distribution ◽  
Sprinkler Irrigation ◽  
Hydraulic Performance ◽  
Nozzle Diameter ◽  
Water Application ◽  
Working Pressure ◽  
Plate Structure ◽  
Irrigation Uniformity ◽  
Application Depth ◽  
Peak Value

HighlightsThe hydraulic performance of fixed spray plate sprinklers (FSPS) was evaluated at low working pressures.The effects of geometric structure on the hydraulic performance of FSPS were studied.A model was developed for estimating the application depth and uniformity of FSPS under a linear-move system.The recommended values of the most effective sprinkler combination spacing for FSPS are given.Abstract. Reducing the working pressure of sprinklers can effectively reduce the energy consumption of sprinkler irrigation systems. Fixed spray plate sprinklers (FSPS) have a simple structure, and their working pressure has potential to be reduced to 40 kPa. To evaluate the hydraulic performance of FSPS at low pressure, an experiment was conducted to investigate the effects of working pressure, plate structure, and nozzle diameter on sprinkler flow rate, wetted radius, and water application distribution. Two plates (FSPSB and FSPSY) and five nozzles were used in the tests. The cumulative water application depth and irrigation uniformity coefficient were calculated under a linear-move system. The results show that sprinklers with larger nozzle diameters and higher working pressures produce greater coefficients of discharge. The wetted radius gradually increases with the increase in working pressure and nozzle diameter. Two empirical equations for estimating the wetted radius of the two plates are proposed. The FSPSB has a concave trajectory structure that produces a longer wetted radius than the FSPSY, which has a flat trajectory structure. Along the wetted radius, the water application rate increases and then decreases, with a peak value at a certain distance. For the FSPSB, the peak rate of water application decreases with increasing working pressure. However, the FSPSY shows the opposite trend, with the maximum peak value occurring at the highest working pressure of 250 kPa. The water distribution for a single FSPSB sprinkler is discrete due to the greater water dispersal caused by the deeper grooves in the plate. In contrast, a single FSPSY sprinkler provides a more uniform water distribution. The irrigation uniformity of the FSPSY is higher than that of the FSPSB. The recommended values for the most effective sprinkler combination spacings for FSPSB and FSPSY are given in this article. The results may be useful for selecting appropriate sprinklers in hydraulic design procedures. Keywords: Cumulative spray water depth, Irrigation uniformity, Sprinkler irrigation, Water distribution, Working condition.

Evaluation of Turbulent Kinetic Energy Dissipation Rate in a Free Jet Flow from PIV Measurements

2012 ◽  
Vol 7 (1) ◽  
pp. 53-69
Author(s):  
Vladimir Dulin ◽  
Yuriy Kozorezov ◽  
Dmitriy Markovich
Keyword(s):  
Energy Dissipation ◽  
Kinetic Energy ◽  
Turbulent Kinetic Energy ◽  
Dissipation Rate ◽  
Energy Dissipation Rate ◽  
Turbulent Velocity ◽  
Small Scale ◽  
Velocity Fluctuations ◽  
Piv Measurements ◽  
Free Jet

The present paper reports PIV (Particle Image Velocimetry) measurements of turbulent velocity fluctuations statistics in development region of an axisymmetric free jet (Re = 28 000). To minimize measurement uncertainty, adaptive calibration, image processing and data post-processing algorithms were utilized. On the basis of theoretical analysis and direct measurements, the paper discusses effect of PIV spatial resolution on measured statistical characteristics of turbulent fluctuations. Underestimation of the second-order moments of velocity derivatives and of the turbulent kinetic energy dissipation rate due to a finite size of PIV interrogation area and finite thickness of laser sheet was analyzed from model spectra of turbulent velocity fluctuations. The results are in a good agreement with the measured experimental data. The paper also describes performance of possible ways to account for unresolved small-scale velocity fluctuations in PIV measurements of the dissipation rate. In particular, a turbulent viscosity model can be efficiently used to account for the unresolved pulsations in a free turbulent flow

Modeling the kinetic energy dissipation of road system considering actual weather conditions

2019 ◽  
Vol 33 (07) ◽  
pp. 1950073
Author(s):  
Lei Huang ◽  
De-Yong Guan ◽  
Xin-Hong Qiang
Keyword(s):  
Energy Consumption ◽  
Friction Coefficient ◽  
Energy Dissipation ◽  
Kinetic Energy ◽  
Traffic Management ◽  
Weather Conditions ◽  
Flow Speed ◽  
Flow Density ◽  
Cellular Automata Model ◽  
Density Flow

Traffic flow dynamics and energy consumption differs under dissimilar weather conditions, while seldom investigations have been conducted with a cellular automata model. In this paper, the friction coefficient between ground and tire is considered as the quantitative label of weather, a dynamic safe gap based on friction coefficient to avoid rear-end crash is introduced. We developed a safer one-dimensional model to examine the kinetic energy consumption under different weathers. Numerical results show that previous models overestimated the kinetic energy consumption in medium density flow (density [Formula: see text]0.5). In medium flow, speed limit will not reduce energy consumption on rainy and snowy days in most cases, but is necessary for prevention of accidents. Inversely, the effect of speed control on energy consumption is obvious under extreme weather. Our work can promote a better understanding of traffic dynamics, reduce energy dissipation and be applied to real traffic management.

Study on Hydraulic Characteristics and Optimization of Siphon Channel with Two Inlets in Drydock

2014 ◽  
Vol 638-640 ◽  
pp. 1285-1292
Author(s):  
Peng Zhao ◽  
Yu Chuan Bai
Keyword(s):  
Energy Dissipation ◽  
Numerical Model ◽  
Kinetic Energy ◽  
Dissipation Rate ◽  
Three Dimensional ◽  
Flow State ◽  
Hydraulic Characteristics ◽  
Channel System ◽  
Guide Wall ◽  
Low Efficiency

Compared with the siphon channel with one inlet, the siphon channel with two inlets has some problems such as low efficiency of flooding. Combining with the model test of siphon channel with two inlets in a drydock, three-dimensional numerical model was built to study the hydraulic characteristics of siphon channel system. The reliability of numerical model was confirmed by comparing the calculated value and measured value of hump pressure and flooding rate. Results of turbulent kinetic energy and dissipation rate indicate that flow kinetic energy is mainly dissipated by the friction and its impacting the wall behind partition and the effect of energy dissipation pillars are not obvious. By comparing flow state in front of energy dissipation section and flooding rate between design scheme and modified scheme, it is suggested that the guide wall should be dismantled to ameliorate flow state.

scholarly journals Modeling and Dynamic-Simulating the Water Distribution of a Fixed Spray-Plate Sprinkler on a Lateral-Move Sprinkler Irrigation System

Water ◽  
2019 ◽  
Vol 11 (11) ◽  
pp. 2296 ◽  
Author(s):  
Yisheng Zhang ◽  
Jinjun Guo ◽  
Bin Sun ◽  
Hongyuan Fang ◽  
Delan Zhu ◽  
...  
Keyword(s):  
Distribution Pattern ◽  
Water Distribution ◽  
Irrigation System ◽  
Translational Motion ◽  
Simulated Data ◽  
Sprinkler Irrigation ◽  
Distribution Patterns ◽  
Superposition Method ◽  
Working Pressure ◽  
Uniformity Coefficient

Uniformity of water distribution plays an important role in evaluating irrigation quality. As necessities in calculating irrigation uniformity during designing a lateral-move sprinkler irrigation system (LMSIS), the water distribution patterns of individual sprinkler in motion are crucial. Considering the limitation of the experiment platform, dynamic water distribution of an isolated sprinkler is difficult to measure, especially for a fixed spray plate sprinkler (FSPS) which LMSIS has been widely equipped with in China, therefore developing a model to simulate dynamic water distribution of a moving sprinkler is necessary. The objective of this study was to develop and validate the theoretical basis for calculating water distribution characteristics of a single FSPS in translational motion applying a superposition method, and provide an optimized operation management of LMSIS. The theoretical model’s validity was verified in an indoor experiment using a Nelson D3000 FSPS in motion with 36 grooves and blue-plate spray heads. The software was programmed using the Eclipse Platform and the software was capable of simulating water distribution pattern and Christiansen uniformity coefficient (Cu). The results indicated that the water distribution simulated by the software presents three peaks of maximum application under varying conditions, and the value of water application peaks decreased as working pressure and/or mounting height increased. Conversely, the wetted diameter increased as working pressure and/or mounting height increased. Working pressure, mounting height, and sprinkler spacing each had a significant effect on the Cu. The Cu increased as working pressure and/or mounting height increased but decreased as sprinkler spacing increased. As a consequence, the model can be used to predict the relative water distribution pattern; and the Cu can be calculated with the simulated data, thus providing a tool for designing a new LMSIS.

Sign in / Sign up

Export Citation Format

Share Document