scholarly journals Effect of Particle Concentration and Pipe Materials on the Formation of Biofilms in Drinking Water Distribution Systems

Water ◽  
2022 ◽  
Vol 14 (2) ◽  
pp. 224
Author(s):  
Zhiling Zhao ◽  
Yongji Zhang ◽  
Lu Wang ◽  
Wenhang Shi

Microorganism rebreeding and biofilm shedding enter the water body in the process of a drinking water distribution system (DWDS), which poses a threat to public health. Particles in water can gather pollutants as well as providing favorable growth conditions for bacteria. To date, there are a few studies which focus on the relationship between particles and biofilm formation. Therefore, the microbial diversity of biofilms in the different pipe materials and the effect on particle concentration on biofilm formation were investigated in this study. Experiments were carried out under a simulative DWDS (including iron (DI) and polyvinyl chloride (PVC) pipe). The results showed that the microbial diversity in biofilms followed this order: DI pipe > PVC pipe > DI pipe (upper). Moreover, the microbial biomass of biofilm and the fluorescence intensity of extracellular polymeric substances (EPS, produced by microorganisms) were the largest in the absence of particles. The amount of biofilm bacterial and the fluorescence intensity of EPS both showed first an increasing and then decreasing trend with particle concentration increasing. When particle concentration was relatively low, the absorption of particles and bacteria played a major role, however, with the increasing particle concentration, more stable particle–particle were formed and thus, EPS was easily extracted, resulting in the increase of fluorescence intensity of EPS.

2007 ◽  
Vol 55 (5) ◽  
pp. 169-176 ◽  
Author(s):  
K.E. Wiesenthal ◽  
I.H. Suffet

A study of the production of odour-causing compounds was conducted from the leaching of polyvinylchloride (PVC) pipe and its joints, primer and cement, into drinking water distribution systems. Flavour Profile Analysis (FPA), closed-loop stripping analysis – gas chromatography/mass spectrometry (CLSA-GC/MS) and sensory-GC analysis of white or grey PVC alone found no odour-causing compounds produced during the leaching experiments. FPA analysis of the PVC's primer and cement leached alone and/or when applied to grey or white PVC pipes produced a glue/varnish odour. A sweet/phenolic odour replaced the glue/varnish odour after the leached media were diluted with Milli-Q water to threshold odour intensity. Three compounds were responsible for the sweet/phenolic odour and were observed by sensory-GC analysis. The leaching study of the PVC pipe with its joint solvents (primer and cement) concluded that the original solvent compounds, and their reaction products that formed during the bonding process on the PVC pipe, were a primary source of the glue/varnish odour. The original compounds of the PVC primer and cement were not detected by CLSA-GC/MS, due to their high volatility during the CLSA extraction method and/or these compounds appeared in a solvent peak of the GC/MS analysis. However, the original primer and cement chemicals (acetone, tetrahydrofuran, methyl ethyl ketone, and cyclohexanone) had a glue/varnish odour. A total of nine odorous GC peaks were produced as reaction products from leaching of primer in water and white or grey PVC pipe with primer and cement, and white or grey PVC with primer only. None of these compounds were among the chemical ingredients in the original primer or cement. Four GC peaks with a sweet/phenolic odour were present due to the reaction products of the cement leached with white or grey PVC. None of these compounds were positively identified.


RSC Advances ◽  
2020 ◽  
Vol 10 (52) ◽  
pp. 31295-31304 ◽  
Author(s):  
Zebing Zhu ◽  
Lili Shan ◽  
Fengping Hu ◽  
Zehua Li ◽  
Dan Zhong ◽  
...  

Biofilms are the main carrier of microbial communities throughout drinking water distribution systems (DWDSs), and strongly affect the safety of drinking water.


1995 ◽  
Vol 32 (8) ◽  
pp. 61-65 ◽  
Author(s):  
D. van der Kooij ◽  
H. S. Vrouwenvelder ◽  
H. R. Veenendaal

Biofilm formation in drinking water distribution systems should be limited to prevent the multiplication of undesirable bacteria and other organisms. Certain types of drinking water with an AOC concentration below 10 μg of acetate-C eq/l can support the growth of Aeromonas. Therefore, the effect of acetate at a concentration of 10 μg of C/l on the biofilm formation rate (BFR) of drinking water with a low AOC concentration (3.2 μg C/l) was determined. Drinking water without acetate had a BFR of 3.9 pg ATP/cm2.day, whereas a BFR value of 362 pg ATP/cm2.day was found with acetate added. These data indicate that a low acetate concentration strongly affects biofilm formation, and that only a small fraction of AOC is available for biofilm formation. Aeromonads did not multiply in the biofilm despite their ability to grow at a concentration of 10 μg of acetate-C/l. Further investigations are needed to elucidate the relationship between substrate concentration and biofilm formation in drinking water distribution systems and the growth of undesirable bacteria in these biofilms.


2010 ◽  
Vol 61 (1) ◽  
pp. 163-171 ◽  
Author(s):  
J. Yu ◽  
D. Kim ◽  
T. Lee

The effects of pipe materials on biofilm formation potential (BFP) and microbial communities in biofilms were analyzed. Pipe coupons made of six different materials (CU, copper; CP, chlorinated poly vinyl chloride; PB, polybutylene; PE, polyethylene; SS, stainless steel; ST, steel coated with zinc) were incubated in drinking water, mixed water (inoculated with 10% (v/v) of river water) and drinking water inoculated with Escherichia coli JM109 (E. coli), respectively. The highest BFPs were observed from steel pipes, SS and ST, while CU showed the lowest BFP values. Of the plastic materials, the BFP of CP in drinking water (96 pg ATP/cm2) and mixed water (183 pg ATP/cm2) were comparable to those of CU, but the other plastic materials, PB and PE, displayed relatively high BFP. The Number of E. coli in the drinking water inoculated with cultures of E. coli strain showed similar trends with BFP values of the pipe coupons incubated in drinking water and mixed water. Molecular analysis of microbial communities indicated the presence of α- and β-proteobacteria, actinobacteria and bacteroidetes in biofilm on the pipe materials. However, the DGGE profile of bacterial 16S rDNA fragments showed significant differences among different materials, suggesting that the pipe materials affect not only BFP but also microbial diversity. Some plastic materials, such as CP, would be suitable for plumbing, particularly for drinking water distribution pipes, due to its low BFP and little microbial diversity in biofilm.


Sign in / Sign up

Export Citation Format

Share Document