scholarly journals Reducing Mobile Air Conditioner (MAC) Power Consumption Using Active Cabin-Air-Recirculation in A Plug-In Hybrid Electric Vehicle (PHEV)

2018 ◽  
Vol 9 (4) ◽  
pp. 51 ◽  
Author(s):  
Chengguo Li ◽  
Eli Brewer ◽  
Liem Pham ◽  
Heejung Jung
Keyword(s):  
Air Quality ◽  
Power Consumption ◽  
Electric Vehicle ◽  
Fuel Economy ◽  
Hybrid Electric Vehicle ◽  
Driving Cycle ◽  
Total Power ◽  
Air Conditioner ◽  
Hybrid Electric ◽  
Cabin Air Quality

Air conditioner power consumption accounts for a large fraction of the total power used by hybrid and electric vehicles. This study examined the effects of three different cabin air ventilation settings on mobile air conditioner (MAC) power consumption, such as fresh mode with air conditioner on (ACF), fresh mode with air conditioner off (ACO), and air recirculation mode with air conditioner on (ACR). Tests were carried out for both indoor chassis dynamometer and on-road tests using a 2012 Toyota Prius plug-in hybrid electric vehicle. Real-time power consumption and fuel economy were calculated from On-Board Diagnostic-II (OBD-II) data and compared with results from the carbon balance method. MAC consumed 28.4% of the total vehicle power in ACR mode when tested with the Supplemental Federal Test Procedure (SFTP) SC03 driving cycle on the dynamometer, which was 6.1% less than in ACF mode. On the other hand, ACR and ACF mode did not show significant differences for the less aggressive on-road tests. This is likely due to the significantly lower driving loads experienced in the local driving route compared to the SC03 driving cycle. On-road and SC03 test results suggested that more aggressive driving tends to magnify the effects of the vehicle HVAC (heating, ventilation, and air conditioning) system settings. ACR conditions improved relative fuel economy (or vehicle energy efficiency) to that of ACO conditions by ~20% and ~8% compared to ACF conditions for SC03 and on-road tests, respectively. Furthermore, vehicle cabin air quality was measured and analyzed for the on-road tests. ACR conditions significantly reduced in-cabin particle concentrations, in terms of aerosol diffusion charger signal, by 92% compared to outside ambient conditions. These results indicate that cabin air recirculation is a promising method to improve vehicle fuel economy and improve cabin air quality.

scholarly journals Support vector machine–based driving cycle recognition for dynamic equivalent fuel consumption minimization strategy with hybrid electric vehicle

2018 ◽  
Vol 10 (11) ◽  
pp. 168781401881102
Author(s):  
QIN Shi ◽  
Duoyang Qiu ◽  
Lin He ◽  
Bing Wu ◽  
Yiming Li
Keyword(s):  
Support Vector Machine ◽  
Fuel Consumption ◽  
Electric Vehicle ◽  
Fuel Economy ◽  
Hybrid Electric Vehicle ◽  
Driving Cycle ◽  
Support Vector ◽  
Equivalent Fuel ◽  
Hybrid Electric ◽  
Equivalent Fuel Consumption

For a great influence on the fuel economy and exhaust, driving cycle recognition is becoming more and more widely used in hybrid electric vehicles. The purpose of this study is to develop a method to identify the type of driving cycle in real time with better accuracy and apply the driving cycle recognition to minimize the fuel consumption with dynamic equivalent fuel consumption minimization strategy. The support vector machine optimized by the particle swarm algorithm is created for building driving cycle recognition model. Furthermore,the influence of the two parameters of window width and window moving velocity on the accuracy is also analyzed in online application. A case study of driving cycle in a medium-sized city is introduced based on collecting four typical driving cycle data in real vehicle test. A series of characteristic parameters are defined and principal component analysis is used for data processing. Finally, the driving cycle recognition model is used for equivalent fuel consumption minimization strategy with a parallel hybrid electric vehicle. Simulation results show that the fuel economy can improve by 9.914% based on optimized support vector machine, and the fluctuations of battery state of charge are more stable so that system efficiency and batter life are substantially improved.

Powertrain Matching Based on Driving Cycle for Fuel Cell Hybrid Electric Vehicle

2013 ◽  
Vol 288 ◽  
pp. 142-147 ◽  
Author(s):  
Shang An Gao ◽  
Xi Ming Wang ◽  
Hong Wen He ◽  
Hong Qiang Guo ◽  
Heng Lu Tang
Keyword(s):  
Fuel Cell ◽  
Electric Vehicle ◽  
Cell Hybrid ◽  
Hybrid Electric Vehicle ◽  
Combustion Engine ◽  
Driving Cycle ◽  
Power Performance ◽  
Matching Method ◽  
Hybrid Electric ◽  
Fuel Cell Hybrid

Fuel cell hybrid electric vehicle (FCHEV) is one of the most efficient technologies to solve the problems of the energy shortage and the air pollution caused by the internal-combustion engine vehicles, and its performance strongly depends on the powertrains’ matching and its energy control strategy. The theoretic matching method only based on the theoretical equation of kinetic equilibrium, which is a traditional method, could not take fully use of the advantages of FCHEV under a certain driving cycle because it doesn’t consider the target driving cycle. In order to match the powertrain that operates more efficiently under the target driving cycle, the matching method based on driving cycle is studied. The powertrain of a fuel cell hybrid electric bus (FCHEB) is matched, modeled and simulated on the AVL CRUISE. The simulation results show that the FCHEB has remarkable power performance and fuel economy.

Match and Optimization of Series Hybrid Bus Powertrain Parameters

2011 ◽  
Vol 121-126 ◽  
pp. 2710-2714
Author(s):  
Ling Cai ◽  
Xin Zhang
Keyword(s):  
Electric Vehicle ◽  
Fuel Economy ◽  
Hybrid Electric Vehicle ◽  
Simulation Platform ◽  
Optimal Method ◽  
Orthogonal Method ◽  
Series Hybrid Electric Vehicle ◽  
Hybrid Bus ◽  
Promising Solution ◽  
Hybrid Electric

With the requirements for reducing emissions and improving fuel economy, it has been recognized that the electric, hybrid electric powered drive train technologies are the most promising solution to the problem of land transportation in the future. In this paper, the parameters of series hybrid electric vehicle (SHEV), including engine-motor, battery and transmission, are calculated and matched. Advisor software is chosen as the simulation platform, and the major four parameters are optimized in orthogonal method. The results show that the optimal method and the parameters can improve the fuel economy greatly.

An adaptive equivalent consumption minimization strategy considering catalyst temperature for plug-in hybrid electric vehicle

2021 ◽  
pp. 095440702110434
Author(s):  
Tao Deng ◽  
Ke Zhao ◽  
Haoyuan Yu
Keyword(s):  
Fuel Consumption ◽  
Electric Vehicle ◽  
Fuel Economy ◽  
Hybrid Electric Vehicle ◽  
Test Procedure ◽  
Catalyst Temperature ◽  
Equivalent Factor ◽  
Simulation Results ◽  
Hybrid Electric ◽  
Equivalent Consumption Minimization Strategy

In the process of sufficiently considering fuel economy of plug-in hybrid electric vehicle (PHEV), the working time of engine will be reduced accordingly. The increased frequency that the three-way catalytic converter (TWCC) works in abnormal operating temperature will lead to the increasing of emissions. This paper proposes the equivalent consumption minimization strategy (ECMS) to ensure the catalyst temperature of PHEV can work in highly efficient areas, and the influence of catalyst temperature on fuel economy and emissions is considered. The simulation results show that the fixed equivalent factor of ECMS has great limitations for the underutilized battery power and the poor fuel economy. In order to further reduce fuel consumption and keep the emission unchanged, an equivalent factor map based on initial state of charge (SOC) and vehicle mileage is established by the genetic algorithm. Furthermore, an Adaptive changing equivalent factor is achieved by using the following strategy of SOC trajectory. Ultimately, adaptive equivalent consumption minimization strategy (A-ECMS) considering catalyst temperature is proposed. The simulation results show that compared with ordinary ECMS, HC, CO, and NOX are reduced by 14.6%, 20.3%, and 25.8%, respectively, which effectively reduces emissions. But the fuel consumption is increased by only 2.3%. To show that the proposed method can be used in actual driving conditions, it is tested on the World Light Vehicle Test Procedure (WLTC).

scholarly journals Modeling and energy management strategy research of a power-split hybrid electric vehicle

2020 ◽  
Vol 12 (10) ◽  
pp. 168781402096262
Author(s):  
Yupeng Zou ◽  
Ruchen Huang ◽  
Xiangshu Wu ◽  
Baolong Zhang ◽  
Qiang Zhang ◽  
...  
Keyword(s):  
Electric Vehicle ◽  
Energy Management ◽  
Fuel Economy ◽  
Hybrid Electric Vehicle ◽  
Research Work ◽  
Energy Management Strategy ◽  
Power Sources ◽  
Power Split ◽  
Hybrid Electric ◽  
The Impact

A power-split hybrid electric vehicle with a dual-planetary gearset is researched in this paper. Based on the lever analogy method of planetary gearsets, the power-split device is theoretically modeled, and the driveline simulation model is built by using vehicle modeling and simulation toolboxes in MATLAB. Six operation modes of the vehicle are discussed in detail, and the kinematic constraint behavior of power sources are analyzed. To verify the rationality of the modeling, a rule-based control strategy (RB) and an adaptive equivalent consumption minimization strategy (A-ECMS) are designed based on the finite state machine and MATLAB language respectively. In order to demonstrate the superiority of A-ECMS in fuel-saving and to explore the impact of different energy management strategies on emission, fuel economy and emission performance of the vehicle are simulated and analyzed under UDDS driving cycle. The simulation results of the two strategies are compared in the end, shows that the modeling is rational, and compared with RB strategy, A-ECMS ensures charge sustaining better, enables power sources to work in more efficient areas, and improves fuel economy by 8.65%, but significantly increases NOx emissions, which will be the focus of the next research work.

scholarly journals Real-Time Co-optimization of Vehicle Route and Speed Using Generic Algorithm for Improved Fuel Economy

2019 ◽  
Vol 141 (03) ◽  
pp. S08-S15
Author(s):  
Guoming G. Zhu ◽  
Chengsheng Miao
Keyword(s):  
Electric Vehicle ◽  
Electric Vehicles ◽  
Fuel Economy ◽  
Autonomous Vehicles ◽  
Hybrid Electric Vehicle ◽  
High Efficiency ◽  
Combustion Engine ◽  
Cruise Control ◽  
Vehicle Performance ◽  
Hybrid Electric

Making future vehicles intelligent with improved fuel economy and satisfactory emissions are the main drivers for current vehicle research and development. The connected and autonomous vehicles still need years or decades to be widely used in practice. However, some advanced technologies have been developed and deployed for the conventional vehicles to improve the vehicle performance and safety, such as adaptive cruise control (ACC), automatic parking, automatic lane keeping, active safety, super cruise, and so on. On the other hand, the vehicle propulsion system technologies, such as clean and high efficiency combustion, hybrid electric vehicle (HEV), and electric vehicle, are continuously advancing to improve fuel economy with satisfactory emissions for traditional internal combustion engine powered and hybrid electric vehicles or to increase cruise range for electric vehicles.

Sign in / Sign up

Export Citation Format

Share Document