scholarly journals Start-up of Hybrid Upflow Anaerobic Sludge Blanket Reactor with Organic Wastewater

2019 ◽  
Vol 8 (3) ◽  
pp. 1826-1829
Keyword(s):  
Hydraulic Retention Time ◽  
Ph Value ◽  
Biogas Production ◽  
Upflow Anaerobic Sludge Blanket ◽  
Anaerobic Sludge ◽  
Start Up ◽  
Anaerobic Sludge Blanket ◽  
Maximum Removal ◽  
Organic Wastewater

In the process of treating wastewaters from different industries by using anaerobic reactor, initially the start-up process is the first step to stabilize the reactor. The aim of this research is to conduct the start-up process and to evaluate the characterization of synthetic organic wastewater using Hybrid up flow Anaerobic Sludge Blanket reactor (HUASBR) with the effective volume of 20L. Initially the reactor was processed with synthetic organic wastewater with COD of 3200 mg/l. The processes were continuously operated with hydraulic retention time of 24 hours for 48 days. The results obtained after the process of stabilization were, COD removal is 87.8%, VFA was Stable for the operating condition, Biogas production was increased as 13.2 l/d during the maximum removal of COD and the pH value of outlet is ranging from 5.5-7.9.

Comparison of start-up of an upflow anaerobic sludge blanket reactor and a polyurethane carrier reactor

1996 ◽  
Vol 34 (5-6) ◽  
pp. 509-515 ◽  
Author(s):  
Huub J. Gijzen ◽  
Frank Kansiime
Keyword(s):  
Volatile Fatty Acids ◽  
Biogas Production ◽  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Organic Loading Rate ◽  
Anaerobic Sludge ◽  
Operational Conditions ◽  
Start Up ◽  
And Performance ◽  
Anaerobic Sludge Blanket

The start-up and performance of an Upflow Anaerobic Sludge Blanket (UASB) reactor and a Polyurethane Carrier Reactor (PCR) was investigated under similar operational conditions. The presence of polyurethane cubes as a carrier material in the PCR resulted in fast reactor start-up due to quick immobilization of methanogenic associations. Start-up of the UASB was slower compared to the PCR, which was mainly reflected in a lower biogas production and acetate degradation efficiency. However, when enough biomass had accumulated in the UASB reactor after 15 weeks of operation, the performance of the two reactors was almost the same in terms of biogas production and volatile fatty acids degradation. Efficient VFA degradation (about 90%) and biogas production (5.2 l/l.d) were achieved at an organic loading rate of 13.2 g/l.d) and HRT of 6 h. When hydraulic retention time was subsequently reduced from 6 to 2 h, the performance of the UASB reactor was better than that of the PCR. The inferior performance of the PCR may have been attributed to channelling of the influent in the reactor at high liquid flow rate.

Biomass Acclimatization to Sequentially Varying Substrates in an Upflow Anaerobic Sludge Blanket (UASB) Bioreactor

2006 ◽  
Vol 41 (4) ◽  
pp. 437-448 ◽  
Author(s):  
Yee Ying Jennifer Tan ◽  
Mohd. Ali Hashim ◽  
K.B. Ramachandran
Keyword(s):  
Loading Rate ◽  
Biogas Production ◽  
Domestic Wastewater ◽  
High Strength ◽  
Upflow Anaerobic Sludge Blanket ◽  
Anaerobic Sludge ◽  
Start Up ◽  
Time Required ◽  
Volumetric Loading ◽  
Anaerobic Sludge Blanket

Abstract In this study, an upflow anaerobic sludge blanket (UASB) bioreactor was sequentially subjected to high-strength synthetic, low-strength synthetic and domestic wastewaters. From COD removal data, supported by volumetric loading rate, hydraulic retention time, pH and qualitative biogas production data, it was observed that the biomass in the bioreactor took about twice the time required to acclimatize to a change in substrate characteristics or composition compared to a much more drastic quantitative change, i.e., more than 95% difference, in substrate concentration. As the initial experiment coincided with the bioreactor start-up, it could also be concluded that the feeding regime did not shorten the overall start-up time of a UASB bioreactor meant to treat domestic wastewater, but its eventual success was probably more assured.

scholarly journals Microbial Removal of Pb(II) Using an Upflow Anaerobic Sludge Blanket (UASB) Reactor

Catalysts ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 512
Author(s):  
Jeremiah Chimhundi ◽  
Carla Hörstmann ◽  
Evans M. N. Chirwa ◽  
Hendrik G. Brink
Keyword(s):  
Treatment Process ◽  
Removal Rate ◽  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Anaerobic Sludge ◽  
Reduction Potentials ◽  
Oxidation Reduction ◽  
Anaerobic Sludge Blanket ◽  
Microbial Removal ◽  
Maximum Removal

The main objective of this study was to achieve the continuous biorecovery and bioreduction of Pb(II) using an industrially obtained consortia as a biocatalyst. An upflow anaerobic sludge blanket reactor was used in the treatment process. The bioremediation technique that was applied made use of a yeast extract as the microbial substrate and Pb(NO3)2 as the source of Pb(II). The UASB reactor exhibited removal efficiencies of between 90 and 100% for the inlet Pb concentrations from 80 to 2000 ppm and a maximum removal rate of 1948.4 mg/(L·d) was measured. XRD and XPS analyses of the precipitate revealed the presence of Pb0, PbO, PbS and PbSO4. Supporting experimental work carried out included growth measurements, pH, oxidation–reduction potentials and nitrate levels.

scholarly journals Bioenergy recovery from cattle wastewater in an UASB-AF hybrid reactor

2017 ◽  
Vol 76 (9) ◽  
pp. 2268-2279 ◽  
Author(s):  
Henrique Vieira de Mendonça ◽  
Jean Pierre Henry Balbaud Ometto ◽  
Marcelo Henrique Otenio ◽  
Alberto José Delgado dos Reis ◽  
Isabel Paula Ramos Marques
Keyword(s):  
Biogas Production ◽  
Upflow Anaerobic Sludge Blanket ◽  
Hybrid Reactor ◽  
Anaerobic Sludge ◽  
The Novel ◽  
Organic Loading ◽  
Loading Rates ◽  
Volatile Solids ◽  
Anaerobic Sludge Blanket

Abstract New data on biogas production and treatment of cattle wastewater were registered using an upflow anaerobic sludge blanket-anaerobic filter (UASB-AF) hybrid reactor under mesophilic temperature conditions (37 °C). The reactor was operated in semi-continuous mode with hydraulic retention times of 6, 5, 3 and 2 days and organic loading rates of 3.8, 4.6, 7.0 and 10.8 kg CODt m−3 d−1. Biogas volumes of 0.6–0.8 m3 m−3 d−1 (3.8–4.6 kg CODt m−3 d−1) and 1.2–1.4 m3 m−3 d−1 (7.0–10.8 kg CODt m−3 d−1), with methane concentrations between 69 and 75%, were attained. The removal of organic matter with values of 60–81% (CODt) and 51–75% (CODs) allowed methane yields of 0.155–0.183 m3 CH4 kg−1 CODt and 0.401–0.513 m3 CH4 kg−1 CODs to be obtained. Volatile solids were removed in 34 to 69%, with corresponding methane yields of 0.27 to 0.42 m3 CH4 kg−1 VSremoved. The good performance of the novel hybrid reactor was demonstrated by biogas outputs higher than reported previously in the literature, along with the quality of the gas obtained in the various experimental phases. The hybrid reactor investigated in this study presents comparative advantages, particularly in relation to conventional complete mixture units, considering economic factors such as energy consumption, reactor volume and installation area.

Acid Endurance and Sorption of Zn2+ of Anaerobic Granular Sludge Acclimated by Flue Gas Pretreatment Wastewater

2013 ◽  
Vol 634-638 ◽  
pp. 182-186
Author(s):  
Juan Wang ◽  
Qin Zhong
Keyword(s):  
Flue Gas ◽  
Ph Value ◽  
Granular Sludge ◽  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Anaerobic Sludge ◽  
Anaerobic Granular Sludge ◽  
Methanogenic Activity ◽  
Activity Inhibition ◽  
Anaerobic Sludge Blanket

With the aim to use anaerobic granular sludge, the methanogenic activity inhibition and recovery of anaerobic granular sludge from an industrial anaerobic reactor (s1) were investigated by measuring the methane volume at low pH. A lab-scale upflow anaerobic sludge blanket (UASB) reactor was inoculated with s1.s1 was used to remove Zn2+ in wastewater. The results show that activity of s1 is similar when the pH value is 6.5 to 7.0. The methane volume is obviously decreased when the pH value is 6.0. The activity is completely inhibited when the pH value is 4.5. The activity is fully recovered when the pH is above 6.5 and hardly recovers when the pH fell to 4.5. The main Zn2+ removal mechanism is chemical adsorption.

Denitrification on the top of UASB reactors of rice wastewaters

2001 ◽  
Vol 44 (4) ◽  
pp. 79-82 ◽  
Author(s):  
L. F. Lopes ◽  
P. R. Koetz ◽  
M. S. Santos
Keyword(s):  
Upflow Anaerobic Sludge Blanket ◽  
Uasb Reactor ◽  
Anaerobic Sludge ◽  
Food Industries ◽  
Denitrification Reactor ◽  
Mixed Reactor ◽  
South Of Brazil ◽  
Anaerobic Sludge Blanket ◽  
Uasb Reactors ◽  
Maximum Removal

Parboiled rice industry is one of main food industries in the south of Brazil. The main parts of the processing are the humidification and gelatinization of the grain. This procedure increases the productivity and nutritive and cooking values of the product. Some of these industries in the region utilize upflow anaerobic sludge blanket (UASB) reactors as a biological treatment for carbon removal. For nitrogen removal, the proposed system aims to eliminate an extra denitrification reactor, making this step in the top of the UASB, an anoxic zone of the reactor. Nitrification was performed in aerated mixed reactor of 3,6 L. A fraction of the NR was recycled in the top of UASB reactor above the sludge blanket. Recycled ratio varied from 0; 1:0.5; 1:1.0; to 1:1.5. The maximum removal efficiency of NTK was 80%. The results confirm the viability of the proposed system for denitrification.

Start-Up Strategy to Achieve Excellent Efficiency of Degradation Acetate,Ethanol and Propionate in UASB

2011 ◽  
Vol 71-78 ◽  
pp. 2103-2106
Author(s):  
Ming Yue Zheng ◽  
Ming Xia Zheng ◽  
Kai Jun Wang ◽  
Hai Yan
Keyword(s):  
Loading Rate ◽  
Anaerobic Treatment ◽  
Upflow Anaerobic Sludge Blanket ◽  
Organic Loading Rate ◽  
Anaerobic Sludge ◽  
Organic Loading ◽  
Metabolic Intermediate ◽  
Loading Rates ◽  
Start Up ◽  
Anaerobic Sludge Blanket

The performance of upflow anaerobic sludge blanket (UASB) fed with three metabolic intermediate (acetate, ethanol, and propionate) respectively was studied. The degradation of metabolic intermediate were investigated to discuss the reason for propionate inhibition problem in anaerobic treatment. The hydraulic retention time (HRT) in the reactors started with 8.0h.The yield rate of biogas were 237ml/gCOD, 242ml/gCOD, 218ml/gCOD for acetate, ethanol and propionate, respectively when finishing start-up under OLR of 5.0 kgCOD/(m3·d) (HRT=9.6h).The HRT remained constant 9.6h,and the substrate concentration was gradually increased from 1,000 to 16,000mg/L as COD,and the organic loading rates(OLR) was from 3.0 to 40.0 kgCOD/(m3·d).The maximum propionate concentration was 41.6 gHPr-COD/L at the organic loading rate of 43.9 kgCOD/(m3·d) (HRT, 9.6h) as well as acetate and ethanol.

Sign in / Sign up

Export Citation Format

Share Document