Research and Development on Control System of Multicoil Inside Solidification Combined Winding Machine

2006 ◽  
pp. 463-468
Author(s):  
Bo You ◽  
Liang Ding ◽  
Jia Zhong Xu ◽  
Zhen Zhong Yu ◽  
De Li Jia
Keyword(s):  
Control System ◽  
Research And Development ◽  
Winding Machine

Research and Development on Control System of Multicoil Inside Solidification Combined Winding Machine

2006 ◽  
Vol 505-507 ◽  
pp. 463-468 ◽  
Author(s):  
Bo You ◽  
Liang Ding ◽  
Jia Zhong Xu ◽  
Zhen Zhong Yu ◽  
De Li Jia
Keyword(s):  
High Pressure ◽  
Control System ◽  
Remote Control ◽  
Research And Development ◽  
Software Architecture ◽  
Machining Efficiency ◽  
Reinforced Plastic ◽  
Key Technologies ◽  
Winding Machine ◽  
Mutual Communication

Multicoil inside solidification combined winding machine, which can wind, solidify inside and extract high-pressure glass reinforced plastic (GRP) tubes, combines three conventional working procedures. The machine tool has four spindles of two groups working coordinately, improving machining efficiency greatly. This paper presents the realization of its control system, including the hardware and software architecture of the winding, inside solidification and extraction subsystems, and the mutual communication among them. Several key technologies such as the realization of openness, multicoil winding for heavy caliber tubes and remote control are also introduced.

Dynamic Simulation of the Stack-Manipulator to Aluminum-Ingot Based on ADAMS

2014 ◽  
Vol 541-542 ◽  
pp. 700-703
Author(s):  
Da Wei Xu ◽  
Hai Tao Wu ◽  
Hong Bin Liu ◽  
Jia Cheng Cai ◽  
Tian Chang Yao
Keyword(s):  
Control System ◽  
Angular Velocity ◽  
Research And Development ◽  
Dynamic Simulation ◽  
3D Model ◽  
Scientific Basis ◽  
Aluminum Ingot

On the research and development of the Stack-Manipulator to Aluminum-Ingot, the Stack-Manipulator 3D model was established by using SolidWorks and imported into ADAMS via the interface between them. And then the authors got the torque and angular velocity curves after adding the driving and constraints. Finally, this paper chose the servo motors by using the simulated results. The results provide a reliable and scientific basis for the development of the control system.

The Simulation Analysis and Modeling of the Coupling Vibration Absorber System for the Wheel Loader

2011 ◽  
Vol 121-126 ◽  
pp. 2358-2362 ◽  
Author(s):  
Zhun Wang
Keyword(s):  
Control System ◽  
Research And Development ◽  
Dynamic Models ◽  
Simulation Analysis ◽  
Vibration Reduction ◽  
Simulation Software ◽  
Vibration Absorber ◽  
Coupling Vibration ◽  
Matlab Simulink ◽  
Wheel Loader

In accordance with the Coupling vibration absorber system, introduced to reduce the vibration of the wheel loader at driving, designed are two dynamic models for the loaders either with the application of vibration absorber system or without that of it. The simulation analysis of the vibration reduction, with the help of the simulation software Matlab/ Simulink, shows that the vibration absorber system may reduce not only the vehicle vibration effectively but also that of the work device, thus providing the basis for the further research and development of the riding control system.

Sign in / Sign up

Export Citation Format

Share Document