Numerical Simulation Research on Reasonable Production Time Limit Optimization of Advanced Water Injection in Low Permeability Oilfield

2013 ◽  
Vol 411-414 ◽  
pp. 3121-3124
Author(s):  
Guo Liang Song ◽  
Cheng Li Zhang ◽  
Chun Yan Li ◽  
Jian Zhang

Based on the characteristics of low permeability, low pressure, poor effect of conventional waterflood development and low recovery efficiency in Chao Yanggou oilfield, advanced water injection is applied. Taking the Chang 10th block of Chao Yanggou oilfield as an example, the research on reasonable production time and pressure limit of advanced water injection in low permeability oilfield are carried out using methods of numerical simulation and reservoir engineering. The result shows that the average permeability of the Chang 10th block is 7.0×10-3μm2, the reasonable time of advanced water injection is about 6 months, and the recovery efficiency increases 2.26% compared with synchronized water injection. The successful application of advanced water injection development technology has some guidance on low-permeability oilfield development.

2011 ◽  
Vol 361-363 ◽  
pp. 483-486
Author(s):  
Fan Liu ◽  
Han Qiao Jiang ◽  
Jun Jian Li ◽  
Xue Lin Wu

Conducted by the results of numerical simulation and reservoir engineering method, the limit of layers combination and the optimum starting time of water injection are present in this paper. It was shown that in order to improve the development effect of relatively low permeability formation and increase economic efficiency of this kind of field, the reasonable multiple factor after subdividing layers should be less than 5, which means that the permeability difference should be less than 8. Meanwhile, in view of the actual situations and difficulties of offshore development, the injection and production project should be started synchronously.


2013 ◽  
Vol 680 ◽  
pp. 295-300
Author(s):  
Ye Fei Chen ◽  
Zi Fei Fan ◽  
Jun Ni ◽  
Yun Juan Li ◽  
Qing Ying Hou

Kenkiyak oilfield in kazakstan is a low porosity, extremely low permeability and overpressure carbonate reservoir. There are different reservoir and fracture characteristics in different region. The formation pressure decline seriously and water cannot be injected into the low permeability zone. Referring to the domestic and oversea research achievement, integrating regional geologic characteristics, numerical simulation results and reservoir engineering research results, we optimize a series of the development technology policy, including the reasonable gas and water injection modes and injection opportunity, the suitable well patterns and well spacing. Meanwhile, the development mode of energy supplement in the extremely low permeability and overpressure reservoir is explored.


2013 ◽  
Vol 274 ◽  
pp. 153-156
Author(s):  
Rong Hua Li ◽  
Jun Ting Zhang ◽  
Cheng Lin Zhang ◽  
Huan Huan Zhang ◽  
Peng Qu

Layer system subdivision and adjustment is applied in oilfield development to ease the contradiction in inner-layer and interlayer and implement separated layer water flooding well, which is a major adjustment measure to improve developing effects. YSL is a typical low-permeability oil field, whose petrophysics is poor, and which exist many problems, such as apparent contradictions between layers, and poor development effects through separated zone water injection and so on. In this article, the thickness of barriers, injection profile, permeability contrast and remaining oil distribution are analyzed comprehensively. So a reasonable method is also proposed. Much weakness that factors are not comprehensive in adjustment method and that the problems in the development process are not accurately reflected is overcome, which exists in the past methods. The adjustment means can utilize poor thin layers better, reduce invalid water injection and ease the contradictions between layer, and oilfield development effects are improved eventually. It is a reference and guidance for other blocks or oilfield which exist the same problems.


2014 ◽  
Vol 522-524 ◽  
pp. 1355-1358
Author(s):  
Jiang Tao Yu ◽  
Jin Liang Zhang ◽  
Jun Xie ◽  
Li Yao Li

This paper, using ECLIPSE for the research of reservoir numerical simulation, got the oil-water distribution and the situation of reserves distribution based on three-dimensional visualization of geological model in 110 block. Combining the effects of development experiment, this paper implemented the optimization of development scheme and parameter design of reservoir engineering which used the method of numerical simulation for Chang110 block. At last the optimal reservoir development model was chosen to attain the goal of gradual development of Changchunling reservoir.


2021 ◽  
Author(s):  
Qing Liu ◽  
Xiangfang Li ◽  
Jian Yang ◽  
Sen Feng ◽  
Minxia He ◽  
...  

Abstract Unconventional fractured ultra-low-permeability reservoirs play an important role in continental sedimentary basins in China, and their formation characteristics and seepage laws are greatly different from that of traditional reservoirs. In this paper, the influence of microfractures and unsteady waterflooding on the productivity of fractured ultra-low permeability reservoirs are studied deeply. The reservoir parameters used in the study are from an actual fractured ultra-low-permeability reservoir in Ordos Basin, where microfractures are developed but macroscopic fractures are not. The microfractures have a small opening and are widely distributed in the reservoir, so the reservoir numerical simulation model adopts the equivalent continuous matrix model to simulate waterflooding. On one hand, the physical model of micro-fractured reservoir and the permeability tensor model of the equivalent continuous matrix are established. The results show that the existence of microfractures can increase the permeability of matrix by 1.4 times. On the other hand, an ideal heterogeneous numerical simulation model composed of pure matrix and equivalent continuous matrix considering microfracture is established according to actual geological parameters of the fractured ultra-low-permeability reservoir. To simulate and compare the unsteady waterflooding and continuous waterflooding development in 10-year development under the condition of constant annual injection rate, the results indicate that unsteady waterflooding development make higher productivity and lower water cut and lower formation water saturation than that of continuous waterflooding. By conducting unsteady waterflooding development simulation for sensitivity analysis, the results demonstrate that the greater the capillary force, the better the role of capillary imbibition in a certain range, meanwhile, the unsteady waterflooding has the best exploitation effect when the value of water injection cycle time is 100 days and the fluctuation amplitude of water injection rate is 1. At the above situation, the displacement and capillary imbibition and pressure disturbance achieve the desired effect of reducing water cut and increasing oil production.


2019 ◽  
Vol 118 ◽  
pp. 01029
Author(s):  
Xiulan Zhu ◽  
Yanlong Ran ◽  
Yidong Yuan

There are poor physical properties and insufficient natural energy in the low-permeability and low-pressure reservoir of the Yangbaishan Block. Early this reservoir was mined by natural energy with a serious producing energy deficit. Subsequently, it was developed with mild water injection. During the water injection development, water quickly slid into the oil well along the crack, oil production decreased sharply and water content increased rapidly in the oil well, the water flooded well and the ineffective well gradually increased. Therefore, based on the reservoir geological characteristics, principle of injection and production balance is used to optimize reasonably for the development technology policy. Research indicates that the square inverted nine spot flooding pattern is recommended with a reasonable injection well direction of NE 72°and technical well spacing of 150 m. Reasonable injection-production ratio should be 2.16, reasonable technical well pattern density is 23 wells per square kilometer, and the average daily water injection rate of single well should be 11 m3. When injection-production system and injection proration are improved, water drive controlled degree is expected to increase by 16 %. This research can provide reference for the efficient development and safety management of other similar reservoirs.


2021 ◽  
Vol 2021 ◽  
pp. 1-10
Author(s):  
Shuangshuang Ren ◽  
Fei Shen ◽  
Shenglai Yang ◽  
Xiangyang Zhang ◽  
Hongwu Luo ◽  
...  

Oilfield water injection is one of the important means to supplement energy to the formation and enhance oil recovery in the process of oilfield development. The level of water injection technology determines the effect of oilfield development and also determines the length of oilfield development life. Research on seepage law of water injection development in low-permeability reservoir is the basis and important technical means of low-permeability reservoir development, and the key point of seepage law is to analyze the starting pressure gradient law. In previous studies, either static test or dynamic experimental value is used, so the error of pseudo starting pressure gradient derived from experimental value is too large, which makes people expand the starting pressure value in low-permeability reservoir in practical engineering application, and the starting pressure gradient obtained from laboratory test cannot be applied in actual reservoir. To accurately calculate the threshold pressure gradient for low-permeability reservoirs, the threshold permeability is proposed through the study of the seepage law and laboratory experiments. It is recognized that the threshold pressure gradient and the threshold permeability had been changing during the seepage. Through steady-state “flow rate-pressure difference” displacement experiment, with natural cores from a low-permeability reservoir, based on a capillary bundle model, the method for calculating the gradient is innovatively proposed. The experimental data show that the whole low-permeability seepage flow is nonlinear, divided into three stages according to the physical stages with obvious changes. Through processing and analyzing of the experimental results, first, it is showed that both threshold pressure gradient and threshold permeability increase with the rise of flow rate and the increasing amplitude is gradually decreasing. Second, the study proposes the permeability is the main controlling reason of the threshold pressure gradient, and the flow velocity is an important reason. Third, we obtain the formulas of the minimum threshold pressure gradient, the threshold pressure gradient, and the corresponding threshold permeability of different cores and the power function relationship between the threshold pressure gradient and the core permeability is obtained. And further, the one-dimensional experimental results are applied to the radial fluid flow, and the recognition that the threshold pressure gradient decreases with increasing distance and the ratio of the threshold pressure to the total displacement pressure difference are obtained. The ratio of starting pressure to total pressure drop is about 0.5, and the higher the permeability is, the lower the ratio is lower under 0.5. These findings significantly help in understanding how to effectively develop low-permeability reservoir by water injection. Through the dynamic macro experiment and microcapillary bundle principle, the experiment can be divided into several sections for analysis, which can be more accurate. The minimum start-up pressure gradient can not only guide the later development of the oilfield, but also enrich the theoretical study of non-Darcy low-velocity seepage. At the same time, the law of flow velocity and start-up pressure gradient indirectly proves the boundary layer theory of the generation mechanism of start-up pressure gradient and supports and guides the effective development of various development methods of low-permeability reservoir.


Sign in / Sign up

Export Citation Format

Share Document