Research on Multi-Stage Series-Connection High-Voltage High-Power Matrix Converter

2011 ◽  
Vol 347-353 ◽  
pp. 843-847
Author(s):  
Ting Jiang ◽  
Jian Feng Jiang ◽  
Xi Jun Yang
Keyword(s):  
High Voltage ◽  
High Power ◽  
Single Phase ◽  
Frequency Converter ◽  
Charge Storage ◽  
Series Connection ◽  
Multi Stage ◽  
Three Phase ◽  
Voltage Frequency ◽  
Step Down

Charge storage is an important research topic in smart grid and distributed generation system, pumped storage as one of the most popular large-scale charge storage methods has attracted increasing attention. However, the motor generator of the pumped charge station has high input voltage and heavy load, so in order to get grid connected safely, being soft started by a high voltage converter is necessary. In the view of the existing high voltage high power converters, only the voltage source inverter Multi-stage Series-connection high voltage frequency converters are suitable for this application, and this paper gives analysis of such converters. Based on Carrier Wave Phase-Shifted modulation, this paper proposes a multi-stage Series-connection high voltage frequency converter with balanced output power of the step-down transformer’s secondary windings, in which a winding burdens three symmetry three-phase to single-phase MC outputs, and the same phase outputs of the MC are cascaded at the secondary side of the transformers, letting out one phase of high-voltage AC output. The circuit is consisted of a step-down industry frequency transformer at the network side, three-phase to single-phase MC arrays, a step-up high frequency transformer at the load side and filter components. The simulation result based on MATLAB/SIMULINK shows that the proposed multi-stage Series-connection high voltage frequency converter is feasible and low-cost.

scholarly journals Cascade frequency converters control features

2020 ◽  
Vol 241 ◽  
pp. 37
Author(s):  
A. Vorontsov ◽  
V. Glushakov ◽  
M. Pronin ◽  
Yu. Sychev
Keyword(s):  
High Voltage ◽  
Single Phase ◽  
Power Converters ◽  
Low Voltage ◽  
Frequency Converter ◽  
Frequency Converters ◽  
Three Phase ◽  
In Series ◽  
Load Characteristics ◽  
Active Rectifiers

The structures of systems with high-voltage cascade frequency converters containing multi-winding transformers and low-voltage low-power converters connected in series at each output phase of the load are considered. Low-voltage blocks contain three-phase diode or active rectifiers, DC capacitor filters, single-phase stand-alone voltage inverters and block disconnecting devices in partial modes (in case of failure when part of the blocks are disconnected). The possibilities of operation of cascade converters are determined, equations for correcting tasks to units in partial modes are given, tables of correction of tasks with estimates of achievable load characteristics are proposed. The results of experiments on the model of a powerful installation with a cascade frequency converter are presented, confirming the possibility of ensuring the symmetry of the load currents when disconnecting part of the blocks and the asymmetry of the circuit.  

scholarly journals Non-conventional Cascade Multilevel Inverter with Lower Number of Switches by Using Multilevel PWM

2021 ◽  
Vol 17 (1) ◽  
pp. 1-13
Author(s):  
Adala Abdali ◽  
Ali Abdulabbas ◽  
Habeeb Nekad
Keyword(s):  
High Voltage ◽  
High Power ◽  
Power Loss ◽  
Output Voltage ◽  
Lower Number ◽  
Multilevel Inverter ◽  
Three Phase ◽  
Multi Level ◽  
Simulation Results ◽  
Circuit Configuration

The multilevel inverter is attracting the specialist in medium and high voltage applications, among its types, the cascade H bridge Multi-Level Inverter (MLI), commonly used for high power and high voltage applications. The main advantage of the conventional cascade (MLI) is generated a large number of output voltage levels but it demands a large number of components that produce complexity in the control circuit, and high cost. Along these lines, this paper presents a brief about the non-conventional cascade multilevel topologies that can produce a high number of output voltage levels with the least components. The non-conventional cascade (MLI) in this paper was built to reduce the number of switches, simplify the circuit configuration, uncomplicated control, and minimize the system cost. Besides, it reduces THD and increases efficiency. Two topologies of non-conventional cascade MLI three phase, the Nine level and Seventeen level are presented. The PWM technique is used to control the switches. The simulation results show a better performance for both topologies. THD, the power loss and the efficiency of the two topologies are calculated and drawn to the different values of the Modulation index (ma).

scholarly journals Design and Experimental Research of Agricultural Low Power Singlephase Frequency Conversion Control System Based on SPWM

2015 ◽  
Vol 9 (1) ◽  
pp. 490-495
Author(s):  
Chuanlai Yuan ◽  
Lingshuang Kong ◽  
Can Hu ◽  
Weilong Zhou
Keyword(s):  
Low Power ◽  
Power Supply ◽  
Rational Design ◽  
Single Phase ◽  
Frequency Conversion ◽  
Frequency Converter ◽  
Ac Motor ◽  
Ac Power ◽  
Three Phase ◽  
Power Frequency

In the countryside of China, the main power supply mode is 220V single-phase power, which affects the widely application of three-phase agricultural appliances. What’s more, it means a block to the development of modern agriculture. However, frequency converter technique research is focused on three-phase high power frequency conversion technology at present, and there are very few achievements on the agricultural low power single-phrase frequency conversion research. In this paper, considering the difficulty of widely application of agricultural low power three-phase AC motor because it is not easy to obtain the three-phase power supply, a three-phase AC frequency conversion system under the condition of agricultural 220V single-phase AC power is designed, which can achieve the stepless regulation of the voltage amplitude and guarantee the widely use of the three-phase AC motor under the condition of agricultural 220V singlephase AC power. The experimental results show that the system can output the controlled three-phase AC power when the input is 220V single-phase AC power. And the rational design of the system hardware also provides the technical support for the application of agricultural low power frequency conversion.

Sign in / Sign up

Export Citation Format

Share Document