Synthesis of Organic-Intercalated Zn/Fe Layered Double Hydroxides from the Electroplating Wastewater

2012 ◽  
Vol 610-613 ◽  
pp. 538-541
Author(s):  
Xiu Xiu Ruan ◽  
Song Huang ◽  
Hua Chen
Keyword(s):  
Charge Density ◽  
Layered Double Hydroxides ◽  
Removal Rate ◽  
Interlamellar Spacing ◽  
Organic Contaminant ◽  
Precipitation Method ◽  
Synthesis Product ◽  
High Concentration ◽  
Electroplating Wastewater ◽  
Double Hydroxides

A series of dodecyl sulfate (DS-) intercalated Zn/Fe layered double hydroxides (DS-Zn/Fe-LDHs) were prepared by co-precipitation method from the electroplating wastewater containing high concentration of zinc (Zn2+). In addition, the influences of their charge density on the interlayer structure of LDHs were investigated by XRD and FT-IR. The removal rate of Zn2+ in the electroplating wastewater was reached 99.9%. The charge density decreased with the increasing of the ratio of Zn/Fe. The results showed that with the increase of the charge density, the interlamellar spacing of organic-LDH increased. The synthesis product was applied in the sorption of organic contaminant ( nitrobenzene ) and the sorption mechanism was partition. The synthetic DS-Zn/Fe LDHs were good sorbents for organic contaminant.

scholarly journals Mixed Oxide Layered Double Hydroxide Materials: Synthesis, Characterization and Efficient Application for Mn2+ Removal from Synthetic Wastewater

Materials ◽  
2020 ◽  
Vol 13 (18) ◽  
pp. 4089
Author(s):  
Cristina Modrogan ◽  
Simona Cǎprǎrescu ◽  
Annette Madelene Dǎncilǎ ◽  
Oanamari Daniela Orbuleț ◽  
Eugeniu Vasile ◽  
...  
Keyword(s):  
Adsorption Capacity ◽  
Layered Double Hydroxides ◽  
Synthetic Wastewater ◽  
Precipitation Method ◽  
Metallic Ions ◽  
Materials Synthesis ◽  
Experimental Conditions ◽  
Edx Analysis ◽  
Co Precipitation ◽  
Double Hydroxides

Magnesium–aluminum (Mg-Al) and magnesium–aluminum–nickel (Mg-Al-Ni) layered double hydroxides (LDHs) were synthesized by the co-precipitation method. The adsorption process of Mn2+ from synthetic wastewater was investigated. Formation of the layered double hydroxides and adsorption of Mn2+ on both Mg-Al and Mg-Ni-Al LDHs were observed by X-ray diffraction (XRD), Scanning Electron Microscopy (SEM) and Energy Dispersive Spectrometry (EDX) analysis. XRD patterns for prepared LDHs presented sharp and symmetrical peaks. SEM studies revealed that Mg-Al LDH and Mg-Al-Ni LDH exhibit a non-porous structure. EDX analysis showed that the prepared LDHs present uniformly spread elements. The adsorption equilibrium on these LDHs was investigated at different experimental conditions such as: Shaking time, initial Mn2+ concentration, and temperatures (10 and 20 °C). The parameters were controlled and optimized to remove the Mn2+ from synthetic wastewater. Adsorption isotherms of Mn2+ were fitted by Langmuir and Freundlich models. The obtained results indicated that the isotherm data fitted better into the Freundlich model than the Langmuir model. Adsorption capacity of Mn2+ gradually increased with temperature. The Langmuir constant (KL) value of Mg-Al LDH (0.9529 ± 0.007 L/mg) was higher than Mg-Al-Ni LDH (0.1819 ± 0.004 L/mg), at 20 °C. The final adsorption capacity was higher for Mg-Al LDH (91.85 ± 0.087%) in comparison with Mg-Al-Ni LDH (35.97 ± 0.093%), at 20 °C. It was found that the adsorption kinetics is best described by the pseudo-second-order model. The results indicated that LDHs can be considered as a potential material for adsorption of other metallic ions from wastewater.

scholarly journals High efficient photocatalytic activity of Zn-Al-Ti layered double hydroxides nanocomposite

2018 ◽  
Vol 149 ◽  
pp. 01087 ◽  
Author(s):  
F. Amor ◽  
A. Diouri ◽  
I. Ellouzi ◽  
F. Ouanji ◽  
M. Kacimi
Keyword(s):  
Methylene Blue ◽  
Photocatalytic Activity ◽  
Uv Irradiation ◽  
Layered Double Hydroxides ◽  
Removal Rate ◽  
X Ray Diffraction ◽  
Simple Method ◽  
X Ray ◽  
High Efficient ◽  
Double Hydroxides

This work establishes a simple method for synthesising layered double hydroxides (LDHs) powders with coprecipitation. The characteristics of the samples were investigated y X-ray diffraction (XRD), scanning electron microscopy (SEM) and spectrophotometer UV–Vis (DRS). Non-uniform distribution was shown for LDHs samples by SEM. Photocatalytic efficiencies were tested using methylene blue (MB) dye as a model contaminant under UV irradiation. In particular, Zn–Al-Ti LDH exhibited an excellent performance towards MB degradation compared with commercial TiO2 nanoparticles. Methylene blue removal percentage was reached at almost 100%, whereas commercial TiO2 reached a removal rate of only 66% under the same conditions within 20 min. The aim of the current work is to prepare Zn-Al-Ti layered double hydroxides nanocomposite and to evaluate their photocatalytic activity in the removal of methylene blue under UV irradiation.

Enhanced catalytic phenol hydroxylation by CuZnFeAl layered double hydroxides: synergistic effects of Cu+ and oxygen vacancies

2021 ◽  
Vol 45 (1) ◽  
pp. 179-188
Author(s):  
Yong Jiang ◽  
Wenlong Xu ◽  
Jinhua Liang ◽  
Jiecan Shen ◽  
Xiaomin Fu ◽  
...  
Keyword(s):  
Layered Double Hydroxides ◽  
Oxygen Vacancies ◽  
Synergistic Effects ◽  
Phenol Oxidation ◽  
Precipitation Method ◽  
Phenol Hydroxylation ◽  
Co Precipitation ◽  
Double Hydroxides

In this work, a series of CuZnFeAl-LDH catalysts for phenol oxidation to dihydroxybenzene have been prepared through a co-precipitation method.

scholarly journals Improving the flame retardancy of ethylene vinyl acetate composites by incorporating layered double hydroxides based on Bayer red mud

e-Polymers ◽  
2019 ◽  
Vol 19 (1) ◽  
pp. 129-140 ◽  
Author(s):  
Yi Qian ◽  
Kangjia Jiang ◽  
Long Li
Keyword(s):  
Vinyl Acetate ◽  
Flame Retardancy ◽  
Layered Double Hydroxides ◽  
Red Mud ◽  
Ethylene Vinyl Acetate ◽  
Precipitation Method ◽  
Infrared Spectrometry ◽  
Cone Calorimeter Test ◽  
Bayer Red Mud ◽  
Double Hydroxides

AbstractNowadays, reducing the hazards of bayer red mud (BRM) is an important research direction in the fields of environmental and safety. In this article, Mg/Al/Fe ternary layered double hydroxides (Mg/Al/Fe-LDHs) were synthesized successfully by a co-precipitation method based on introducing Mg2+ into the BRM suspension. The thermogravimetric analysis (TGA) results showed that the decomposition rate of LDHs is higher than that of BRM, which indicates that LDHs can absorb more heat than BRM during the decomposition process. Subsequently, BRM and LDHs were added into the ethylene vinyl acetate (EVA) to investigate its effects on reducing flammability of the composites. The cone calorimeter test (CCT) results demonstrated that 50 wt% LDH-B can make the peak value of HRR (PHRR) decrease from 1694.8 kW/m2 (EVA) to 199.2 kW/m2 (ELDH2). The smoke density test (SDT) results showed that the luminous flux of ELDH2 is nearly 95% at the end of test with a pilot flame, which is much higher than that of EVA and EBRM. The thermogravimetry-Fourier transform infrared spectrometry (TG-FTIR) results confirmed that LDHs can improve the thermal stability of composites and reduce the production of some toxic gases. Compared with BRM, the improved flame retardancy of Mg/Al/Fe-LDHs is ascribed to the introduction of Mg2+, which offering an enhanced catalytic carbonization capability, as well as the physical barrier effect of char residue layer catalyzed by the lamellar LDHs

scholarly journals Gas-Phase Hydrogenation of Furfural to Furfuryl Alcohol over Cu-ZnO-Al2O3 Catalysts Prepared from Layered Double Hydroxides

Catalysts ◽  
2020 ◽  
Vol 10 (5) ◽  
pp. 486
Author(s):  
Guillermo R. Bertolini ◽  
Carmen P. Jiménez-Gómez ◽  
Juan Antonio Cecilia ◽  
Pedro Maireles-Torres
Keyword(s):  
Gas Phase ◽  
Aging Time ◽  
Layered Double Hydroxides ◽  
Furfuryl Alcohol ◽  
Precipitation Method ◽  
Molar Ratio ◽  
X Ray ◽  
General Chemical ◽  
Co Precipitation ◽  
Double Hydroxides

Several layered double hydroxides (LDHs) with general chemical composition (Cu,Zn)1−xAlx(OH)2(CO3)x/2·mH2O have been synthesized by the co-precipitation method, maintaining a (M2+/M3+) molar ratio of 3, and varying the Cu2+/Zn2+ molar ratio between 0.2 and 6.0. After calcination and reduction steps, Cu/ZnO/Al2O3 catalysts were synthesized. These catalysts were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), H2 thermoprogrammed reduction (H2-TPR), N2 adsorption-desorption at −196 °C, N2O titration, X-ray photoelectron miscroscopy (XPS), NH3-thermoprogramed desorption (NH3-TPD) and CO2- thermoprogrammed desorption (CO2-TPD). The characterization data revealed that these catalysts are mainly meso-and macroporous, where Cu, ZnO and Al2O3 are well dispersed. The catalytic results show that these catalysts are active in the gas-phase hydrogenation of furfural, being highly selective to furfuryl alcohol (FOL) and reaching the highest FOL yield for the catalyst with a Cu2+/Zn2+ molar ratio of 1. In an additional study, the influence of the aging time on the synthesis of the LDHs was also evaluated. The catalytic data revealed that the use of shorter aging time in the formation of the LDH has a beneficial effect on the catalytic behavior, since more disordered structures with a higher amount of available Cu sites is obtained, leading to a higher yield towards FOL (71% after 5 h of time-on-stream at 210 °C).

Effect of Doped Iron on Fluoride Sorption by Calcined MgAlFe-CO3 Layered Double Hydroxides

2013 ◽  
Vol 681 ◽  
pp. 21-25
Author(s):  
Yu Bing Pu ◽  
Jia Rui Wang ◽  
Hong Zheng ◽  
Peng Cai ◽  
Si Yuan Wu
Keyword(s):  
Layered Double Hydroxides ◽  
Synthetic Wastewater ◽  
Precipitation Method ◽  
Molar Ratio ◽  
Fluoride Removal ◽  
Maximum Sorption Capacity ◽  
Fluoride Adsorption ◽  
Maximum Sorption ◽  
Co Precipitation ◽  
Double Hydroxides

A series of MgAlFe-CO3 layered double hydroxides (LDHs) were successfully prepared by co-precipitation method. With synthetic wastewater, the effect of doped iron on fluoride sorption by calcined MgAlFe-CO3 layered double hydroxides (CLDH) under different pH and contact time conditions was investigated. The sorption isotherm data were fitted well to Langmuir isotherm at 25 °C. The maximum sorption capacity of fluoride on CLDH increases first and then decreases with the increase of Fe/Al molar ratio and attains maximum of 71.94 mg/g when Fe/Al molar ratio is 1:2, although doped iron is unfavorable to the regeneration of original layered structure for CLDH after fluoride adsorption. No aluminium in the solution after fluoride adsorption was detected when Fe/Al molar ratio is equal to or larger than 1:2. The results indicate that CLDH with proper Fe/Al molar ratio is a promising candidate as an adsorbent material for fluoride removal from aqueous solutions.

Nanoparticles of Cu–Co alloy derived from layered double hydroxides and their catalytic performance for higher alcohol synthesis from syngas

RSC Advances ◽  
2015 ◽  
Vol 5 (72) ◽  
pp. 58804-58812 ◽  
Author(s):  
Ang Cao ◽  
Guilong Liu ◽  
Yizhi Yue ◽  
Lihong Zhang ◽  
Yuan Liu
Keyword(s):  
Layered Double Hydroxides ◽  
Catalytic Performance ◽  
Precipitation Method ◽  
Higher Alcohol Synthesis ◽  
Higher Alcohol ◽  
Alcohol Synthesis ◽  
Co Precipitation ◽  
Double Hydroxides

A series of layered double hydroxides (LDHs) with different Cu/Co ratios were prepared according to the co-precipitation method and used as catalyst precursors for higher alcohol synthesis.

Sign in / Sign up

Export Citation Format

Share Document