Effect of Doped Iron on Fluoride Sorption by Calcined MgAlFe-CO3 Layered Double Hydroxides

2013 ◽  
Vol 681 ◽  
pp. 21-25
Author(s):  
Yu Bing Pu ◽  
Jia Rui Wang ◽  
Hong Zheng ◽  
Peng Cai ◽  
Si Yuan Wu
Keyword(s):  
Layered Double Hydroxides ◽  
Synthetic Wastewater ◽  
Precipitation Method ◽  
Molar Ratio ◽  
Fluoride Removal ◽  
Maximum Sorption Capacity ◽  
Fluoride Adsorption ◽  
Maximum Sorption ◽  
Co Precipitation ◽  
Double Hydroxides

A series of MgAlFe-CO3 layered double hydroxides (LDHs) were successfully prepared by co-precipitation method. With synthetic wastewater, the effect of doped iron on fluoride sorption by calcined MgAlFe-CO3 layered double hydroxides (CLDH) under different pH and contact time conditions was investigated. The sorption isotherm data were fitted well to Langmuir isotherm at 25 °C. The maximum sorption capacity of fluoride on CLDH increases first and then decreases with the increase of Fe/Al molar ratio and attains maximum of 71.94 mg/g when Fe/Al molar ratio is 1:2, although doped iron is unfavorable to the regeneration of original layered structure for CLDH after fluoride adsorption. No aluminium in the solution after fluoride adsorption was detected when Fe/Al molar ratio is equal to or larger than 1:2. The results indicate that CLDH with proper Fe/Al molar ratio is a promising candidate as an adsorbent material for fluoride removal from aqueous solutions.

scholarly journals Mixed Oxide Layered Double Hydroxide Materials: Synthesis, Characterization and Efficient Application for Mn2+ Removal from Synthetic Wastewater

Materials ◽  
2020 ◽  
Vol 13 (18) ◽  
pp. 4089
Author(s):  
Cristina Modrogan ◽  
Simona Cǎprǎrescu ◽  
Annette Madelene Dǎncilǎ ◽  
Oanamari Daniela Orbuleț ◽  
Eugeniu Vasile ◽  
...  
Keyword(s):  
Adsorption Capacity ◽  
Layered Double Hydroxides ◽  
Synthetic Wastewater ◽  
Precipitation Method ◽  
Metallic Ions ◽  
Materials Synthesis ◽  
Experimental Conditions ◽  
Edx Analysis ◽  
Co Precipitation ◽  
Double Hydroxides

Magnesium–aluminum (Mg-Al) and magnesium–aluminum–nickel (Mg-Al-Ni) layered double hydroxides (LDHs) were synthesized by the co-precipitation method. The adsorption process of Mn2+ from synthetic wastewater was investigated. Formation of the layered double hydroxides and adsorption of Mn2+ on both Mg-Al and Mg-Ni-Al LDHs were observed by X-ray diffraction (XRD), Scanning Electron Microscopy (SEM) and Energy Dispersive Spectrometry (EDX) analysis. XRD patterns for prepared LDHs presented sharp and symmetrical peaks. SEM studies revealed that Mg-Al LDH and Mg-Al-Ni LDH exhibit a non-porous structure. EDX analysis showed that the prepared LDHs present uniformly spread elements. The adsorption equilibrium on these LDHs was investigated at different experimental conditions such as: Shaking time, initial Mn2+ concentration, and temperatures (10 and 20 °C). The parameters were controlled and optimized to remove the Mn2+ from synthetic wastewater. Adsorption isotherms of Mn2+ were fitted by Langmuir and Freundlich models. The obtained results indicated that the isotherm data fitted better into the Freundlich model than the Langmuir model. Adsorption capacity of Mn2+ gradually increased with temperature. The Langmuir constant (KL) value of Mg-Al LDH (0.9529 ± 0.007 L/mg) was higher than Mg-Al-Ni LDH (0.1819 ± 0.004 L/mg), at 20 °C. The final adsorption capacity was higher for Mg-Al LDH (91.85 ± 0.087%) in comparison with Mg-Al-Ni LDH (35.97 ± 0.093%), at 20 °C. It was found that the adsorption kinetics is best described by the pseudo-second-order model. The results indicated that LDHs can be considered as a potential material for adsorption of other metallic ions from wastewater.

scholarly journals Gas-Phase Hydrogenation of Furfural to Furfuryl Alcohol over Cu-ZnO-Al2O3 Catalysts Prepared from Layered Double Hydroxides

Catalysts ◽  
2020 ◽  
Vol 10 (5) ◽  
pp. 486
Author(s):  
Guillermo R. Bertolini ◽  
Carmen P. Jiménez-Gómez ◽  
Juan Antonio Cecilia ◽  
Pedro Maireles-Torres
Keyword(s):  
Gas Phase ◽  
Aging Time ◽  
Layered Double Hydroxides ◽  
Furfuryl Alcohol ◽  
Precipitation Method ◽  
Molar Ratio ◽  
X Ray ◽  
General Chemical ◽  
Co Precipitation ◽  
Double Hydroxides

Several layered double hydroxides (LDHs) with general chemical composition (Cu,Zn)1−xAlx(OH)2(CO3)x/2·mH2O have been synthesized by the co-precipitation method, maintaining a (M2+/M3+) molar ratio of 3, and varying the Cu2+/Zn2+ molar ratio between 0.2 and 6.0. After calcination and reduction steps, Cu/ZnO/Al2O3 catalysts were synthesized. These catalysts were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), H2 thermoprogrammed reduction (H2-TPR), N2 adsorption-desorption at −196 °C, N2O titration, X-ray photoelectron miscroscopy (XPS), NH3-thermoprogramed desorption (NH3-TPD) and CO2- thermoprogrammed desorption (CO2-TPD). The characterization data revealed that these catalysts are mainly meso-and macroporous, where Cu, ZnO and Al2O3 are well dispersed. The catalytic results show that these catalysts are active in the gas-phase hydrogenation of furfural, being highly selective to furfuryl alcohol (FOL) and reaching the highest FOL yield for the catalyst with a Cu2+/Zn2+ molar ratio of 1. In an additional study, the influence of the aging time on the synthesis of the LDHs was also evaluated. The catalytic data revealed that the use of shorter aging time in the formation of the LDH has a beneficial effect on the catalytic behavior, since more disordered structures with a higher amount of available Cu sites is obtained, leading to a higher yield towards FOL (71% after 5 h of time-on-stream at 210 °C).

Enhanced catalytic phenol hydroxylation by CuZnFeAl layered double hydroxides: synergistic effects of Cu+ and oxygen vacancies

2021 ◽  
Vol 45 (1) ◽  
pp. 179-188
Author(s):  
Yong Jiang ◽  
Wenlong Xu ◽  
Jinhua Liang ◽  
Jiecan Shen ◽  
Xiaomin Fu ◽  
...  
Keyword(s):  
Layered Double Hydroxides ◽  
Oxygen Vacancies ◽  
Synergistic Effects ◽  
Phenol Oxidation ◽  
Precipitation Method ◽  
Phenol Hydroxylation ◽  
Co Precipitation ◽  
Double Hydroxides

In this work, a series of CuZnFeAl-LDH catalysts for phenol oxidation to dihydroxybenzene have been prepared through a co-precipitation method.

Nanoparticles of Cu–Co alloy derived from layered double hydroxides and their catalytic performance for higher alcohol synthesis from syngas

RSC Advances ◽  
2015 ◽  
Vol 5 (72) ◽  
pp. 58804-58812 ◽  
Author(s):  
Ang Cao ◽  
Guilong Liu ◽  
Yizhi Yue ◽  
Lihong Zhang ◽  
Yuan Liu
Keyword(s):  
Layered Double Hydroxides ◽  
Catalytic Performance ◽  
Precipitation Method ◽  
Higher Alcohol Synthesis ◽  
Higher Alcohol ◽  
Alcohol Synthesis ◽  
Co Precipitation ◽  
Double Hydroxides

A series of layered double hydroxides (LDHs) with different Cu/Co ratios were prepared according to the co-precipitation method and used as catalyst precursors for higher alcohol synthesis.

Co-precipitation based on layered double hydroxides and anionic surfactants for preconcentration of six benzoylurea insecticides in soft drinks before simultaneous analysis by high-performance liquid chromatography

2021 ◽  
Author(s):  
Yanawath Santaladchaiyakit ◽  
Wisansaya Sila-am ◽  
Suwanida Sribunrueng ◽  
Netsirin Gissawong ◽  
Supalax Srijaranai
Keyword(s):  
High Performance Liquid Chromatography ◽  
Liquid Chromatography ◽  
Layered Double Hydroxides ◽  
High Performance ◽  
Anionic Surfactants ◽  
Simultaneous Analysis ◽  
Precipitation Method ◽  
Benzoylurea Insecticides ◽  
Co Precipitation ◽  
Double Hydroxides

Layered-double hydroxides (LDHs) modified with anionic surfactants via the co-precipitation method was developed for preconcentrating and simultaneous analysis of six benzoylurea insecticides (BUs) by high-performance liquid chromatography (HPLC). The anionic...

scholarly journals Water defluoridation by carbonate calcined and uncalcined Layered Double Hydroxides (LDHs)

2019 ◽  
Vol 98 ◽  
pp. 09005
Author(s):  
Elisabetta Dore ◽  
Franco Frau
Keyword(s):  
Anion Exchange ◽  
Sorption Capacity ◽  
Layered Double Hydroxides ◽  
Lamellar Structure ◽  
Ph Value ◽  
Molar Ratio ◽  
Fluoride Removal ◽  
Cationic Composition ◽  
Removal Capacity ◽  
Double Hydroxides

Carbonate Layered Double Hydroxides (LDHs) with different cationic composition and M2+/M3+ molar ratio were tested, both untreated and calcined, for water defluoridation. The defluoridation capacity of calcined LDHs, produced by intercalation during the reconstruction of lamellar structure, is more effective than the anion exchange of untreated LDHs. Among the calcined LDHs tested, that with 3Mg/(0.5Al+0.5Fe) molar ratio yields a maximum fluoride sorption capacity up to 92.3 mg/g, in spite of the high pH value (up to 12) of the experiments. After four cycles of regeneration by calcination and subsequent water defluoridation, this LDH composition maintains more than 80% of its fluoride removal capacity.

Behavior of Layered Double Hydroxides Having Different Divalent Transition Metal Groups

2014 ◽  
Vol 563 ◽  
pp. 94-101 ◽  
Author(s):  
Mazidah Mamat ◽  
Tei Tagg ◽  
Wan Mohd Khairul ◽  
Mohd Aidil Adhha Abdullah ◽  
Norhayati Mohd Tahir ◽  
...  
Keyword(s):  
Weight Loss ◽  
Transition Metal ◽  
Layered Double Hydroxides ◽  
Divalent Cations ◽  
Precipitation Method ◽  
Basal Spacing ◽  
Highest Weight ◽  
Ft Ir ◽  
Co Precipitation ◽  
Double Hydroxides

The layered double hydroxides (LDHs) with different divalent transition metal groups and nitrate as a counter anion were investigated. Three d-block divalent metals namely cobalt (Co), nickel (Ni) and copper (Cu) were selected. The cobalt/aluminium (CoAN)-, nickel/aluminium (NiAN)- and copper/aluminium (CuAN)-layered double hydroxides were successfully synthesized via co-precipitation method. All the obtained LDHs were characterized by PXRD, FT-IR, ICP-OES, CHNS and TGA/DTG analysis. Interestingly, behavior of the LDHs was dependent on the size of divalent cations. PXRD showed the basal spacing decrease in the order NiAN (0.88nm)> CuAN (0.87nm) > CoAN (0.74nm), and in a linear correlation with the increasing radii of the divalent cations. Similar trend is observed for the weight loss of LDHs, where NiAN has the highest weight loss (53%), followed by CuAN (43%) and CoAN (34%). Further elemental analysis showed the content of trivalent metal cations, nitrate anions and water molecules in the LDHs decrease with the increasing radii.

Facile synthesis of MgAl layered double hydroxides by co-precipitation method for efficient nitrate removal from water: Kinetics and mechanisms

2021 ◽  
Author(s):  
Zhu wu Jiang ◽  
Jiangnan Wu ◽  
Xinru Liu ◽  
Hai Yu ◽  
Chenyuan Jiao ◽  
...  
Keyword(s):  
Wastewater Treatment ◽  
Layered Double Hydroxides ◽  
Nitrate Removal ◽  
Precipitation Method ◽  
Facile Synthesis ◽  
Co Precipitation ◽  
Double Hydroxides

Recently, layered double hydroxides (LDH) have been proven to be promising adsorbents in the field of wastewater treatment mainly due to their unique characteristics. In this study, a series of...

Sign in / Sign up

Export Citation Format

Share Document