The Simulation of SPWM in Voltage Source STATCOM

2012 ◽  
Vol 614-615 ◽  
pp. 887-890 ◽  
Author(s):  
Lin Suo Zeng ◽  
Hong Yu Liu
Keyword(s):  
Pulse Width ◽  
Pulse Width Modulation ◽  
Sine Wave ◽  
Voltage Source ◽  
Modulation Wave ◽  
Important Link ◽  
Three Phase

The inverter part is an important link of the voltage source STATCOM, and a key problem of inverter is how to generate PWM switch signals according to given parameter. The part of SPWM inverter in STATCOM was simulated in Matlab. The result shows that the inverter bridge was controlled by the three-phase pulse width modulation wave produced by the SPWM and the three-phase sine wave at the side of the inverter bridge is outputted. This method is suitable for studying of the STATCOM system.

scholarly journals INVERTER PWM UNTUK MENGGERAKKAN MESIN ARUS SEARAH TANPA SIKAT BERBASIS ARDUINO

2020 ◽  
Vol 7 (4) ◽  
pp. 68
Author(s):  
Sony Prakarsa Putra ◽  
Zulwisli Zulwisli
Keyword(s):  
Electric Vehicles ◽  
Duty Cycle ◽  
Pulse Width ◽  
Pulse Width Modulation ◽  
Voltage Source ◽  
Pwm Inverter ◽  
Dc Voltage ◽  
Unidirectional Flow ◽  
Three Phase ◽  
Frequency Pulse

This study aims to create a PWM inverter that can drive the Brushless Unidirectional Flow Machine (MASTS). PWM inverters are intended to correct deficiencies in six-step inverters. Inverter is a circuit that is used to convert a DC voltage source into an AC voltage with a certain frequency. The use of inverters is found in electric vehicles. The system often used to control an inverter is a Pulse Width Modulation (PWM) based control, where pulse width is used to regulate speed. The inverter is tested using 3 pairs of mosfets as a switch to control the three-phase output of the inverter. In the inverter, PWM is used to adjust the width of the frequency pulse that will be given to the mosfet. This research used 3 variations of duty cycle 30%, 60%, 90% to determine the effect of MASTS speed on PWM by using a PWM inverter. The results of this study the speed of MASTS can be influenced by changes in duty cycle, with increasing value of the duty cycle, the faster the speed of MASTS, and vice versa. Keywords:Mosfet, Sensor Hall, MASTS, PWM, Inverter.

Carrier-Based PWM Technique for Inverter-Fed Multiphase Induction Motor 

2016 ◽  
Vol 6 (5) ◽  
pp. 1967
Author(s):  
Jyothi B ◽  
M.Venugopala Rao
Keyword(s):  
Induction Motor ◽  
Pulse Width ◽  
Pulse Width Modulation ◽  
Voltage Source ◽  
Matlab Software ◽  
Third Harmonic ◽  
Voltage Source Inverters ◽  
Three Phase ◽  
Simulation Results ◽  
Multiphase Machine

<p>Multiphase (more than three phases) is very much popular due to their eminent features compared to conventional three-phase counter parts. In order to drive the multiphase machine, it requires same phase input w.r.t the no of phases at the output. This paper mainly focuses on five phase, because even after failure of one phase, the performance does not degraded much. Voltage source inverters (VSIs) are used to feed the induction motor. voltage source inverters (VSIs) switches are ON and OFF precisely to control the output. In order to implement harmonic waveform characteristic, carrier based PWM (pulse width modulation) is performed. By using with and without third harmonic injection machine torque is highly improved. Using MATLAB software, the simulation results are presented in the form of computer traces and high traded performance of the machine are discussed.</p>

scholarly journals Common-Mode Reduction SVPWM for Three-Phase Motor Fed by Two-Level Voltage Source Inverter

Energies ◽  
2020 ◽  
Vol 13 (15) ◽  
pp. 3884
Author(s):  
Jian Zheng ◽  
Mingcheng Lyu ◽  
Shengqing Li ◽  
Qiwu Luo ◽  
Keyuan Huang
Keyword(s):  
High Frequency ◽  
Pulse Width ◽  
Pulse Width Modulation ◽  
Voltage Source ◽  
Switching Frequency ◽  
Voltage Source Inverter ◽  
Large Magnitude ◽  
Common Mode ◽  
Common Mode Voltage ◽  
Three Phase

Aiming at the problem of large magnitude and high frequency of common-mode voltage (CMV) when space vector pulse width modulation (SVPWM) is used in a three-phase motor fed by a two-level voltage source inverter, a common-mode reduction SVPWM (CMRSVPWM) is studied. In this method, six new sectors are obtained by rotating six sectors of conventional SVPWM by 30°. In odd-numbered sectors, only three non-zero vectors with odd subscripts are used for synthesis, while in even-numbered sectors, only three non-zero vectors with even subscripts are used for synthesis. The actuation durations of three non-zero vectors in each switching period in each sector are given. Simulation and experimental results show that, compared with the conventional SVPWM, the CMV magnitude of CMRSVPWM is reduced by 66.67% and the CMV frequency of CMRSVPWM is reduced from the original switching frequency to the triple fundamental frequency. At the same time, the current, torque and speed of the motor are still good.

scholarly journals Simulation of Processes in Dual Three-Phase System on the Base of Four Inverters with Synchronized Modulation

2011 ◽  
Vol 2011 ◽  
pp. 1-9 ◽  
Author(s):  
Valentin Oleschuk ◽  
Gabriele Grandi ◽  
Padmanaban Sanjeevikumar
Keyword(s):  
Pulse Width ◽  
Pulse Width Modulation ◽  
Continuous Phase ◽  
Power Sharing ◽  
Voltage Source ◽  
Phase System ◽  
Voltage Source Inverters ◽  
Synchronous Control ◽  
Three Phase ◽  
Novel Method

Novel method of space-vector-based pulse-width modulation (PWM) has been disseminated for synchronous control of four inverters feeding six-phase drive on the base of asymmetrical induction motor which has two sets of windings spatially shifted by 30 electrical degrees. Basic schemes of synchronized PWM, applied for control of four separate voltage-source inverters, allow both continuous phase voltages synchronization in the system and required power sharing between DC sources. Detailed MATLAB-based simulations show a behavior of six-phase system with continuous and discontinuous versions of synchronized PWM.

Sign in / Sign up

Export Citation Format

Share Document