High-Breakdown-Voltage GaN Vertical Schottky Barrier Diodes with Field Plate Structure

2009 ◽  
Vol 615-617 ◽  
pp. 963-966 ◽  
Author(s):  
Taku Horii ◽  
Tomihito Miyazaki ◽  
Yu Saito ◽  
Shin Hashimoto ◽  
Tatsuya Tanabe ◽  
...  

Gallium nitride (GaN) vertical Schottky barrier diodes (SBDs) with a SiNx field plate (FP) structure on low-dislocation-density GaN substrates have been designed and fabricated. We have successfully achieved the SBD breakdown voltage (Vb) of 680V with the FP structure, in contrast to that of 400V without the FP structure. There was no difference in the forward current-voltage characteristics with a specific on-resistance (Ron) of 1.1mcm2. The figure of merit V2b/Ron of the SBD with the FP structure was 420MWcm-2. The FP structure and the high quality drift layers grown on the GaN substrates with low dislocation densities have greatly contributed to the obtained results.

1999 ◽  
Vol 572 ◽  
Author(s):  
Q. Zhang ◽  
V. Madangarli ◽  
S. Soloviev ◽  
T. S. Sudarshan

ABSTRACTP-type 6H SiC Schottky barrier diodes with good rectifying characteristics upto breakdown voltage as high as 1000V have been successfully fabricated using metal-overlap over a thick oxide layer (∼ 6000 Å) as edge termination and Al as the barrier metal. The influence of the oxide layer edge termination in improving the reverse breakdown voltage as well as the forward current – voltage characteristics is presented. The terminated Schottky diodes indicate a factor of two higher breakdown voltage and 2–3 times larger forward current densities than those without edge termination. The specific series resistance of the unterminated diodes was ∼228 mΩ-cm2, while that of the terminated diodes was ∼84 mΩ-cm2.


2021 ◽  
Vol 15 (1) ◽  
pp. 016501
Author(s):  
Fumio Otsuka ◽  
Hironobu Miyamoto ◽  
Akio Takatsuka ◽  
Shinji Kunori ◽  
Kohei Sasaki ◽  
...  

Abstract We fabricated high forward and low leakage current trench MOS-type Schottky barrier diodes (MOSSBDs) in combination with a field plate on a 12 μm thick epitaxial layer grown by halide vapor phase epitaxy on β-Ga2O3 (001) substrate. The MOSSBDs, measuring 1.7 × 1.7 mm2, exhibited a forward current of 2 A (70 A cm−2) at 2 V forward voltage and a leakage current of 5.7 × 10–10 A at −1.2 kV reverse voltage (on/off current ratio of > 109) with an ideality factor of 1.05 and wafer-level specific on-resistance of 17.1 mΩ · cm2.


1992 ◽  
Vol 28 (3) ◽  
pp. 296 ◽  
Author(s):  
R.S. Spraggs ◽  
G. Pananakakis ◽  
D. Bauza ◽  
K.J. Reeson ◽  
B.J. Sealy

Sign in / Sign up

Export Citation Format

Share Document