Research Progress on Plastic Processing Techniques of Particulate Reinforced Aluminium Matrix Composites

2017 ◽  
Vol 898 ◽  
pp. 971-983 ◽  
Author(s):  
Hai Bao Wu ◽  
De Fu Li ◽  
Xing Gang Li ◽  
Guo Qiang Chai

Particulate Reinforced Aluminium Matrix Composites (PRAMCs) have been widely applied in military and civilian areas such as aviation, aerospace, advanced weapon applications and electrical industries due to their good mechanical properties at elevated temperature, low thermal expansion coefficient, excellent wear resistance and low production cost. The main preparation techniques of the PRAMCs include stir casting, powder metallurgy, pressureless infiltration and spray deposition. However, the problems such as low densification and particle cluster encountered in these techniques often reduce the material properties. It has reported that the homogeneity of the distribution of particulate reinforcements in metal matrix can be improved by plastic processing, thus enhancing the material densification. This paper summarized recent progress in the plastic processing methods of the PRAMCs, with an emphasis on the spinning technique. The effects of various process parameters on the material properties were discussed in detail. A summary of research progress on the numerical simulation of plastic processing of the PRAMCs was presented. In the end, an outlook was given on the prospect of the PRAMCs’ development.

2014 ◽  
Vol 612 ◽  
pp. 151-155 ◽  
Author(s):  
S Dhinakaran ◽  
T.V. Moorthy

Aluminium matrix composites (AMCs) play a vital role as advanced engineering materials due to their excellent mechanical properties like light weight, strength, wear resistance, toughness. This work focuses on the fabrication of aluminium (AA6061) matrix composites reinforced with 3%, 6% and 9% B4C particle of 104μm using stir casting method. The wettability of B4C particles in the matrix has been improved by adding K2TiF6flux in to the molten metal. The microstructure and mechanical properties of the fabricated AMCs are analyzed. Uniform distribution of B4C particle in the matrix was confirmed using scanning electron microscope (SEM) images. It was found that the tensile strength and hardness of the fabricated AMCs increases with increased B4C particle content.


2019 ◽  
Vol 821 ◽  
pp. 81-88 ◽  
Author(s):  
Samuel Olukayode Akinwamide ◽  
Serge Mudinga Lemika ◽  
Babatunde J. Obadele ◽  
Ojo Jeremiah Akinribide ◽  
Oluwasegun Eso Falodun ◽  
...  

The limitations of aluminium in most engineering applications has led to the development of aluminium matrix composites with improved microstructural and mechanical properties. Nanoindentation techniques was used in assessing the mechanical properties of fabricated aluminium matrix composites with ferrotitanium and silicon carbide as reinforcements. Results from nanoindentation experiments shows the dependence of modulus of elasticity, microhardness and contact depth on the dispersion of ferrotitanium and silicon carbide reinforcements within the aluminium matrix. Highest nanohardness value was observed in composite with 7 wt. % silicon carbide, while the lowest elastic modulus was recorded in as-cast aluminium. Further analysis of specimens confirmed a decrease in maximum penetration depth with respective increase in the addition of silicon carbide reinforcements in the fabricated composites.


Sign in / Sign up

Export Citation Format

Share Document